Consolidate

The reservoir section is more consolidated and is the main objective to which the well is being drilled, hence the drilling process has to ensure that any productive interval is not damaged. 

Between the top hole and the reservoir section in most cases an intermediate section will need to be drilled. This section consists of more consolidated rocks than the top hole. The deviation angle is often increased in this interval to reach the subsurface target and eventually a casing is set prior to entering the reservoir sequence. 

The bare foot completion, which leaves an open hole section below the previous casing, is cheap, simple and suitable for consolidated formations which have little tendency to collapse. The slotted liner s an uncemented section of casing with small intermittent slots cut along its length, which prevents the hole from collapsing, but allows no selectivity of the interval which will be produced. The cased and cemented horizontal completion does allow a choice of which intervals will be perforated and produced. None of these examples provides any effective sand exclusion it this is required a gravel pack or a pre-packed liner can be used. 

Sand production from loosely consolidated formations may lead to erosion of tubulars and valves and sand-fill in of both the sump of the A/ell and surface separators. In addition, sand may bridge off in the tubing, severely restricting flow. The presence of sand production may be monitored by in-line detectors. If the quantities of sand produced become unacceptable then downhole sand exclusion should be considered (Section 9.7). 

The Ukrainian Society for Non-Destructive Testing and Technical Diagnostics (US NDT TD) was established at the meeting of the leading experts of the country, on October 28, 1990, The aim of the Society s activity is consolidation of the efforts of scientists and engineers for development of their creative and business activity, information exchange, satisfying the professional interests, development of international contacts on NDT TD. 

Edcfy-cufrent NDT inspections using spatial data (sampled scans) ha >e many benefits. They separate the two conflicting aspects of an inspection scanning and signal interpretation. An instrument/display (client/server) based NDT inspection based on sampled scan data aides in the training and certification of inspectors. It can be used over the Internet or in-house Intranet networks to train or examine inspectors at multiple or remote sites. This saves travel time and resources as defects, instrumentation and teaching can all be consolidated Samples can be maintained and distributed from a central certification body providing more control andflexibility. 

Ewsuk K G 1993 Consolidation of bulk oeramios Characterization of Ceramics ed R E Loehman (Greenwioh, CT Butterworth-Fleinemann) pp 77-101... 

In this way the student s knowledge of the organic reactions is consolidated as he proceeds through the sections, his experience of the general method of identification steadily increases, and the investigation of the unknown compounds forms a welcome break from the systematic pursuit of the sectional work. 

The metal is isolated commercially by a complex chemical process, the final stage of which is the hydrogen reduction of ammonium ruthenium chloride, which yields a powder. The powder is consolidated by powder metallurgy techniques or by argon-arc welding. 

The usual commercial form of the element is powder, but it can be consolidated by pressing and resistance-sintering in a vacuum or hydrogen atmosphere. This process produces a compact shape in excess of 90 percent of the density of the metal. 

From time to time during the programme, 1 shall break off from introducing new ideas and help you consolidate what you ve aheady learnt with some review problems. These are meant to be realistic problems showing why synthesis is important and should let you try out your growing skills. You can either do the review problems as you meet them or come back later and use them as revision material or combine both methods by doing one or two now and the rest later. These remarks apply to all the review problems and 1 won t repeat them each time. 

Since A Aw is the change in interaction energy per 1,2 pair, it can be expressed as some multiple of kT per pair or of RT per mole of pairs. It is also conventional to consolidate the lattice coordination number and x into a single parameter x, since z and x are not measured separately. With this change of notation Az Aw is replaced by its equivalent xRT, and Eq. (8.41) becomes... 

Until now we have looked at various aspects of light scattering under several limiting conditions, specifically, C2 = 0, 0 = 0, or both. Actual measurements, however, are made at finite values of both C2 and 6. In the next section we shall consider a method of treating experimental data that consolidates all of the various extrapolations into one graphical procedure. 

At the research level, spectroscopy continues to flourish and is continually developing with occasional quantum leaps. For example, such a leap resulted from the development of lasers. Not all leaps provide suitable material for inclusion in an undergraduate text such as this. Flowever, even in the relatively short period of seven years since the third edition, there have been either new developments or consolidation of rather less recent ones, which are not only of the greatest importance but which can (1 hope ) be communicated at this level. 

D. L. Dauplaise and M. F. Wemeke, Proceedings of the Consolidation and Dewatering of Fine Particles Conference, University of Alabama, Tuscaloosa, Ala., 1982, pp. 90-113. 

C. G. Amorosa and V. Eassina, Stone Decay and Conservation, Cleaning, Consolidation and Protection, Materials Science Monographs no. 11, Elsevier, Amsterdam, 1983. 

J. Gregory, in B. M. Moudgil and P. Somasundaran, eds.. Flocculation, Sedimentation and Consolidation, American Institute of Chemical Engineers, New York, 1985, pp. 125-138. 

In order for it to perform the reinforcement function, the geotextde must be allowed to deform to develop its strength. When stabilization of a site occurs, there is consolidation of the sod, and with this comes deformation of the geotextde. Due to the deformation of the geotextde, strength is required to ensure that a site fadure does not occur, ie, there can be a reinforcement component in the stabilization process. 

Consolidation. Metal powders are consoHdated by heat or by pressure followed by heat, or by heating during the appHcation of pressure (17). ConsoHdation produces a coherent mass of definitive size and shape for further working, heat treating, or use as is. 

Vibr toiy Consolidation. Powders are vibrated in a mold or other container in which they will be sintered, or in a metal container that will be used for extmsion or other metalworking process (31). Vibratory consoHdation produces packings of UO2 particles up to 95% of theoretical density. 

Metal-Matrix Composites. A metal-matrix composite (MMC) is comprised of a metal ahoy, less than 50% by volume that is reinforced by one or more constituents with a significantly higher elastic modulus. Reinforcement materials include carbides, oxides, graphite, borides, intermetahics or even polymeric products. These materials can be used in the form of whiskers, continuous or discontinuous fibers, or particles. Matrices can be made from metal ahoys of Mg, Al, Ti, Cu, Ni or Fe. In addition, intermetahic compounds such as titanium and nickel aluminides, Ti Al and Ni Al, respectively, are also used as a matrix material (58,59). P/M MMC can be formed by a variety of full-density hot consolidation processes, including hot pressing, hot isostatic pressing, extmsion, or forging. 

Industry consolidation and rationalization have resulted. A shift in production toward wet-acid purification routes has occurred and only the most economically viable elemental phosphoms and thermal acid producers remain in business. There has also been an increased focus on higher value ... 

C. E. Capes, R. D. Coleman, and W. L. Thayer, paper presented at The 1 st International Conference on the Compaction and Consolidation of Particulate Matter, London, 1972. 

The Food and Drugs Met and Regulations Departmental Consolidation of the Eood and Dmgs Act and the Eood and Dmg Regulations, with amendments to Dec. 15, 1994, Minister of Supply and Services, Canada, 1994. 

---