High content

The gas oil cut from catalytic cracking called Light Cycle Oil (LCO), is characterized by a very low cetane number (about 20), high contents in aromatics, sulfur and nitrogen, all of which strongly limit its addition to the diesel fuel pool to a maximum of 5 to 10%. 

Several conditions need to be satisfied for the existence of a hydrocarbon accumulation, as indicated in Figure 2.1. The first of these is an area in which a suitable sequence of rocks has accumulated over geologic time, the sedimentary basin. Within that sequence there needs to be a high content of organic matter, the source rock. Through elevated temperatures and pressures these rocks must have reached maturation, the condition at which hydrocarbons are expelled from the source rock. 

A separator is fed with a condensate/gas mixture. The condensate leaves the bottom of the separator, passes a flowmeter and is followed by a choke valve, after which the condensate is boiling. The flow can not be measured using the transit time method, due to the combination of short piping, the absence of a suitable injection point and the flow properties of the condensate, which is non-newtonian due to a high contents of wax particles The condensate can not be representatively sampled, as it boils upon depressuratioh... 

Fats and oils may be synthesized in enantiomerically pure forms in the laboratory (30) or derived from vegetable sources (mainly from nuts, beans, and seeds), animal depot fats, fish, or marine mammals. Oils obtained from other sources differ markedly in their fatty acid distribution. Table 2 shows compositions for a wide variety of oils. One variation in composition is the chain length of the fatty acid. Butterfat, for example, has a fairly high concentration of short- and medium-chain saturated fatty acids. Oils derived from cuphea are also a rich source of capric acid which is considered to be medium in chain length (32). Palm kernel and coconut oils are known as lauric oils because of their high content of C-12 saturated fatty acid (lauric acid). Rapeseed oil, on the other hand, has a fairly high concentration of long-chain (C-20 and C-22) fatty acids. 

The ETEE copolymer can be cross-linked by radiation (30), despite the high content of tetrafluoroethylene units. Cross-linking reduces plasticity but enhances high temperature properties and nondrip performance. The irradiated resia withstands a 400°C solder iron for 10 min without noticeable effect. 

The uranium ore from Elliot Lake, Canada, contains yttrium and lanthanides (see Uranium and uranium compounds). In the Jiangxi province of the People s Repubhc of China a large reserve of a rare-earth-containing clay contains over 1,000,000 t of REO. This ore is characterized by having a low cerium content (<5%) but a high content in samarium, europium, terbium, and yttrium compared to the main base REO ores (Table 6). ... 

Pimento Berry Oil. The pimento or allspice tree, Pimenta dioca L. (syn. P. officinalis, Liadl.), a native of the West Indies and Central America, yields two essential oils of commercial importance pimento berry oil and pimenta leaf oil. The leaf oil finds some use ia perfumery for its resemblance to clove leaf and cinnamon leaf oils as a result of its high content of eugenol. Pimento berry oil is an item of commerce with extensive appHcation by the flavor industry ia food products such as meat sauces, sausages, and pickles, and moderate use ia perfumery, where it is used primarily as a modifier ia the modem spicy types of men s fragrances. The oil is steam-distilled from dried, cmshed, fully grown but unripe fmits. It is a pale yellow Hquid with a warm-spicy, sweet odor with a fresh, clean topnote, a tenacious, sweet-balsamic-spicy body, and a tea-like undertone. A comparative analysis of the headspace volatiles of ripe pimento berries and a commercial oil has been performed and differences are shown ia Table 52 (95). 

Gas-phase polymerization of propylene was pioneered by BASF, who developed the Novolen process which uses stirred-bed reactors (Fig. 8) (125). Unreacted monomer is condensed and recycled to the polymerizer, providing additional removal of the heat of reaction. As in the early Hquid-phase systems, post-reactor treatment of the polymer is required to remove catalyst residues (126). The high content of atactic polymer in the final product limits its usefiilness in many markets. 

Orris. Orris is produced from rhi2omes of Ins pallida and Ins germanica. The plants are found and cultivated mosdy ia Italy, but also ia Morocco and China. It is used ia perfumery as an absolute, a steam-distilled essential oil, and a concrete. The last material, which is a low melting soHd (due to a high content of myristic acid) and therefore erroneously called a concrete, is by far the most used. Orris has a violet-like odor useful ia fine perfumes, luxury soaps, and fragrances for powders and other cosmetic products. Its most important odor contributors are the irones, of which the most important isomer... 

Lignite, generally leonardite, and lignite derivatives are appHed in water-based muds as thinners and filtration control agents. Leonardite is an oxidized lignite having a high content of humic acids, which may be described as carboxylated phenoHc polymers (59,60). Litde is known about the chemical stmcture. 

Novolaks produced from these catalysts exhibit a high content of 2,2 -methylene units. The mechanism proposed for the ortho-directing effect involves chelation of the phenoHc unit with the metal ion. 

Tallow [61789-97-7] is the fat obtained as a by-product of beef, and to a lesser degree sheep processing, and is the most commonly utilized animal fat in the manufacturing of soaps. The high content of longer chain length fatty acids present in tallow fat necessitates the addition of other oils, such as coconut oil, in order to produce a bar with acceptable performance. 

Compositions of the four oilseeds are given in Table 2. All except soybeans have a high content of seed coat or hull. Because of the high hull content, the cmde fiber content of the other oilseeds is also high. Confectionery varieties of sunflower seed may contain up to 28% cmde fiber on a dry basis (8). Soybeans differ from the other oilseeds in their high protein and low oil content. AH these oilseeds, however, yield high protein meals when dehuUed and defatted. 

In the case of low temperature tar, the aqueous Hquor that accompanies the cmde tar contains between 1 and 1.5% by weight of soluble tar acids, eg, phenol, cresols, and dihydroxybenzenes. Both for the sake of economics and effluent purification, it is necessary to recover these, usually by the Lurgi Phenosolvan process based on the selective extraction of the tar acids with butyl or isobutyl acetate. The recovered phenols are separated by fractional distillation into monohydroxybenzenes, mainly phenol and cresols, and dihydroxybenzenes, mainly (9-dihydroxybenzene (catechol), methyl (9-dihydtoxybenzene, (methyl catechol), and y -dihydroxybenzene (resorcinol). The monohydric phenol fraction is added to the cmde tar acids extracted from the tar for further refining, whereas the dihydric phenol fraction is incorporated in wood-preservation creosote or sold to adhesive manufacturers. Naphthalene Oils. Naphthalene is the principal component of coke-oven tats and the only component that can be concentrated to a reasonably high content on primary distillation. Naphthalene oils from coke-oven tars distilled in a modem pipe stiU generally contain 60—65% of naphthalene. They are further upgraded by a number of methods. 

Although spray-dryiag accommodates relatively high content of surfactants, certain types, such as the alkanolamides and some nonionic surfactants are best added to the product after spray-dryiag. Post additioa aot only protects the surfactant from the heat of the tower but also prevents the formation of aerosols ia the exit gas. Aerosols are more difficult to trap ia the scmbbiag system than soHd fines. They are formed by unsulfonated matter from the manufacture of LAS and nonionic surfactants with short ethylene oxide chains (120). 

At identification of cognacs and cognac alcohols on authenticity use the following characteristic attributes presence in them significant concentration of (15-150 mg/1) bytanol, the high level of acids - acetic, propionic and oil the high contents of polyphenolic bonds. 

Carbopol is widely used in cosmetic and pharmaceutical practice as a gel-former. Carbopol resins are hydrophilic polymers which swell in water solutions and transform into the gel form at neutralization. At the elaboration of special cosmetic preparations in which carbopol is used, the problem of raw materials compatibility appears. For example, some extracts of aromatic pectin containing materials destroy the gel structure of carbopol. High contents of bivalent metal ions, in particular calcium ions, destructively influence onto the gel-making ability of the system too. 

For a lower range of motors, say up to a frame size of 355, the silicon steel normally used for stator and rotor core laminations is universally 0.5-0.65 mm thick and possesses a high content of silicon for achieving better electromagnetic properties. The average content of silicon in such sheets is of the order of 1.3-0.8% and a core loss of roughly 2.3-3.6 W/kg, determined al a flux density of I W[ym and a frequency of 50 Hz. For medium-sized motors, in frames 400-710, silicon steel with a still better content of silicon, of the order of 1.3-1.8% having lower losses of the order of 2.3-1.8 W/kg is prefeired, with a thickness of lamination of 0.5-0.35 mm. 

A very high content of this acidic solution may dissolve the phosphate coating. 

Only a limited number of coal-denved pitches were examined by H NMR because of their low solubility in solvents commonly used m conventional proton magnetic resonance. Table 12 reports the distribution of hydrogen for three of the pitches. Unlike coal-tar pitches, which typically have over 85% of the hydrogen bonded to aromatic carbon, the matenals listed in Table 12 are characterized by a high content of aliphatic hydrogen. 

If the waste stream has a high content of fine particulate matter then, by isolating piarticulate matter, most of the contamination would be isolated. 

Select a cloth filter for a filter press application in which the water is both alkaline and has a high content of solvents. The operating temperature could reach as high as 200° F on excursions. 

---