HPLC, separation

The peptides generated by proteolysis are separated using reverse-phase HPLC to minimize mass overlap and ionization suppression caused by ion competition in the electrospray source [40]. The optimized LC gradient parameters efficiently separate peptides while minimizing loss of deuterium through back exchange with solvent. Increased sensitivity can be achieved by using capillary HPLC columns and nanoelectrospray methods [47]. 

Both normal-phase and reversed-phase HPLC have been applied in vitamin E analysis. Reversed-phase HPLC is unable to completely separate all tocopherols and toco-trienols. Because (1- and y-vitamers have very similar structures, their separation cannot be obtained with reversed-phase HPLC. It is, however, applicable when only tocopherols or a-tocopheryl esters are analyzed (Gimeno et al., 2000 Iwase, 2000). There are reversed-phase methods to analyze tocopherols together with other lipid constituents from biological and food samples such as carotenoids (Epler et al., 1993 Salo-Vaananen et al., 2000), ubiquinols and ubiquinones (Podda et al., 1996) or sterols (Warner and Mounts, 1990). 

Normal-Phase HPLC Conditions Used to Separate Eight Tocopherol and Tocotrienol Isomers from Food and Feed Samples 

An advanced HPLC system has been developed to separate cisltrans isomers of tocotrienols using a chiral permethylated P-cyclodextrin column and an acetonitrile/ water eluent mixture (Drotleff and Temes, 1999). 

Detection of tocopherols and tocotrienols after HPLC separation is based on their ability to absorb ultraviolet light and create fluorescence. Tocopherols and tocotrienols show typical UV spectra with maximum absorption at 290-300 nm (Table 1.6). If the samples contain sufficient amounts of analytes, e.g., vegetable oils and supplemented products, a UV detector is sensitive enough. When higher sensitivity and better selectivity is needed, a fluorescence detector is the commonly used detector. With a fluorescence detector, it is possible to analyze tocopherols 

Functional Foods BiocFiemical and Processing Aspects, Volume 2 

---

A reverse-phase HPLC separation is carried out using a mobile-phase mixture of 60% v/v water and 40% v/v methanol. What is the mobile phase s polarity index ... 

Solvent triangle for optimizing reverse-phase HPLC separations. Binary and ternary mixtures contain equal volumes of each of the aqueous mobile phases making up the vertices of the triangle. 

As with gas chromatography, numerous detectors have been developed for use in monitoring HPLC separations. To date, the majority of HPLC detectors are not unique to the method, but are either stand-alone instruments or modified versions of the same. 

Capillary Electrochromatography Another approach to separating neutral species is capillary electrochromatography (CEC). In this technique the capillary tubing is packed with 1.5-3-pm silica particles coated with a bonded, nonpolar stationary phase. Neutral species separate based on their ability to partition between the stationary phase and the buffer solution (which, due to electroosmotic flow, is the mobile phase). Separations are similar to the analogous HPLC separation, but without the need for high-pressure pumps, furthermore, efficiency in CEC is better than in HPLC, with shorter analysis times. 

In this experiment a theoretical model is used to optimize the HPLC separation of substituted benzoic acids by adjusting the pH of the mobile phase. An empirical model is then used... 

Cyclodextrin stationary phases utilize cyclodextrins bound to a soHd support in such a way that the cyclodextrin is free to interact with solutes in solution. These bonded phases consist of cyclodextrin molecules linked to siUca gel by specific nonhydrolytic silane linkages (5,6). This stable cyclodextrin bonded phase is sold commercially under the trade name Cyclobond (Advanced Separation Technologies, Whippany, New Jersey). The vast majority of all reported hplc separations on CD-bonded phases utilize this media which was also the first chiral stationary phase (csp) developed for use in the reversed-phase mode. 

In the context of chemometrics, optimization refers to the use of estimated parameters to control and optimize the outcome of experiments. Given a model that relates input variables to the output of a system, it is possible to find the set of inputs that optimizes the output. The system to be optimized may pertain to any type of analytical process, such as increasing resolution in hplc separations, increasing sensitivity in atomic emission spectrometry by controlling fuel and oxidant flow rates (14), or even in industrial processes, to optimize yield of a reaction as a function of input variables, temperature, pressure, and reactant concentration. The outputs ate the dependent variables, usually quantities such as instmment response, yield of a reaction, and resolution, and the input, or independent, variables are typically quantities like instmment settings, reaction conditions, or experimental media. 

Except for the high molecular weight range, nearly all substances can be separated by reversed-phase (RP) HPLC. The many different separation mechanisms in RP HPLC, based on hydi ophobic, hydi ophilic and ion-pairing interactions, and size exclusion effects together with the availability of a lai ge number of high quality stationary phases, explain its great populai ity. At present approximately 90% of all HPLC separations are carried out by reversed-phase mode of HPLC, and an estimated 800 different stationai y phases for RP HPLC are manufactured worldwide. 

Polyuzhyn I.P., Smirnova O.Ya., Jatchyshyn J.J., Musyanovich R.Ya., Novikov V.P., Tkachenko V.I. - RP-HPLC Separation of Amino Derivatives of 3-Chloro-l,4-Naphtoquinone. // XVII-th International Symposium on Physico-Chemical Methods of the Mixtures Separation Ars Separatoria 2002 .- June 17-20, 2002.- Borowno n.Bydgoszcz, Poland. - Poster P-37. 

Scheme 2.5. Chiral Stationary Phases for HPLC Separation of Enantiomers...

HPLC separations are one of the most important fields in the preparative resolution of enantiomers. The instrumentation improvements and the increasing choice of commercially available chiral stationary phases (CSPs) are some of the main reasons for the present significance of chromatographic resolutions at large-scale by HPLC. Proof of this interest can be seen in several reviews, and many chapters have in the past few years dealt with preparative applications of HPLC in the resolution of chiral compounds [19-23]. However, liquid chromatography has the attribute of being a batch technique and therefore is not totally convenient for production-scale, where continuous techniques are preferred by far. 

The type of CSPs used have to fulfil the same requirements (resistance, loadabil-ity) as do classical chiral HPLC separations at preparative level [99], although different particle size silica supports are sometimes needed [10]. Again, to date the polysaccharide-derived CSPs have been the most studied in SMB systems, and a large number of racemic compounds have been successfully resolved in this way [95-98, 100-108]. Nevertheless, some applications can also be found with CSPs derived from polyacrylamides [11], Pirkle-type chiral selectors [10] and cyclodextrin derivatives [109]. A system to evaporate the collected fractions and to recover and recycle solvent is sometimes coupled to the SMB. In this context the application of the technique to gas can be advantageous in some cases because this part of the process can be omitted [109]. 

However, the use of a HPLC separation step enabled a remarkable acceleration of the deconvolution process. Instead of preparing all of the sublibraries, the c(Arg-Lys-O-Pro-O-P-Ala) library was fractionated on a semipreparative HPLC column and three fractions as shown in Fig. 3-2 were collected and subjected to amino acid analysis. According to the analysis, the least hydrophobic fraction, which eluted first, did not contain peptides that included valine, methionine, isoleucine, leucine, tyrosine, and phenylalanine residues and also did not exhibit any separation ability for the tested racemic amino acid derivatives (Table 3-1). 

In addition to the development of the powerful chiral additive, this study also demonstrated that the often tedious deconvolution process can be accelerated using HPLC separation. As a result, only 15 libraries had to be synthesized instead of 64 libraries that would be required for the full-scale deconvolution. A somewhat similar approach also involving HPLC fractionations has recently been demonstrated by Griffey for the deconvolution of libraries screened for biological activity [76]. Although demonstrated only for CE, the cyclic hexapeptides might also be useful selectors for the preparation of chiral stationary phases for HPLC. However, this would require the development of non-trivial additional chemistry to appropriately link the peptide to a porous solid support. 

Our group also demonstrated another combinatorial approach in which a CSP carrying a library of enantiomerically pure potential selectors was used directly to screen for enantioselectivity in the HPLC separation of target analytes [93, 94]. The best selector of the bound mixture for the desired separation was then identified in a few deconvolution steps. As a result of the parallelism advantage , the number of columns that had to be screened in this deconvolution process to identify the single most selective selector CSP was much smaller than the number of actual selectors in the library. 

HPLC, about one dozen of the isoforms, aequorins A, B, C, -J, were isolated (Shimomura, 1986a Shimomura et al., 1990). An example of HPLC separation of isoforms is shown in Fig. 4.1.6, and a comparison of the properties of the isoforms is given in Table 4.1.2. 

Fig. 9.12 An example of HPLC separation of the isoforms of Mycena citricolor luciferin precursors. The sample adsorbed on a PRP-lcolumn was eluted by a linear increase of acetonitrile from 20% to 40% in a pH 7.5 buffer containing 5 mM tributylamine sulfate. Practically all the peaks have the precursor activity.

Popova and colleagues47 carried out TLC of oxidation products of 4,4 -dinitrodiphenyl sulphide (the sulphoxide and sulphone) on silica gel + a fluorescent indicator, using hexane-acetone-benzene-methanol(60 36 10 l) as solvent mixture. Morris130 performed GLC and TLC of dimethyl sulphoxide. For the latter, he applied a 6% solution of the sample in methanol to silica gel and developed with methanol-ammonia solution(200 3), visualizing with 2% aqueous Co11 thiocyanate-methanol(2 1). HPLC separations of chiral mixtures of sulphoxides have been carried out. Thus Pirkle and coworkers131-132 reported separations of alkyl 2,4-dinitrophenyl sulphoxides and some others on a silica-gel (Porosil)-bonded chiral fluoroalcoholic stationary phase, with the structure ... 

HPLC requires a mobile phase in which the analytes are soluble. The majority of HPLC separations which are carried out utilize reversed-phase chromatography, i.e. the mobile phase is more polar then the stationary phase. In these systems, the more polar analytes elute more rapidly than the less polar ones. 

The maximum flow rate that can be accommodated while still allowing the mass spectrometer to operate is in the range of 10-20 tilmin" Typical flow rates used in conventional HPLC separations are between 500 and 1000 tilmin and therefore only between 1 and 4% of the column eluate, and therefore ana-lyte(s), enter the mass spectrometer source. The sensitivity, or more accurately the lack of sensitivity, of the DLl interface is one of its major limitations. 

The HPLC separation of the fight and heavy chains, together with their electrospray spectra, are shown in Figure 5.8. 

As part of their method development, these same authors studied the effect of a number of experimental variables on the HPLC separation and the mass spectral quality and it is worthwhile considering their results, reproduced in Table 5.3, in some detail. 

The proteolytic digestion of j6-lactoglobulin was carried out with trypsin which, as indicated in Table 5.4 above, is expected to cleave the polypeptide backbone at the carboxy-terminus side of lysine (K) and arginine (R). On this basis, and from the known sequence of the protein, nineteen peptide fragments would be expected, as shown in Table 5.7. Only 13 components were detected after HPLC separation and, of these, ten were chosen for further study, as shown in Table 5.8. 

Matrix-associated laser desorption ionization with a time-of-flight mass analyser (MALDl-ToF) was used to examine the crude tryptic peptide mixture from a number of the proteins, without HPLC separation, to provide a mass map, i.e. a survey of the molecular weights of the peptides generated by the digestion process. 

The fact that APCl and electrospray are soft ionization techniques is often advantageous because the molecular ion alone, in conjunction with HPLC separation, often provides adequate selectivity and sensitivity to allow an analytical method to be developed. Again, method development is important, particularly when more than one analyte is to be determined, when the effect of experimental parameters, such as pH, flow rate, etc., is not likely to be the same for each. Electrospray, in particular, is susceptible to matrix effects and the method of standard additions is often required to provide adequate accuracy and precision. 

Another useful standard Is SRM 1647, priority pollutant polynuclear aromatic hydrocarbons (in acetonitrile). It can be used to calibrate liquid chromatographic Instruments (retention times. Instrument response), to determine percent recoveries, and to fortify aqueous samples with known PAH concentrations. Figure 8 Illustrates the HPLC separation and UV detection (fluorescence is also used extensively) for the 16 priority pollutants. 

Figure 8. Reversed-phase HPLC separation of SRM 1647, priority pollutant polynuclear aromatic hydrocarbons (In acetonitrile), using UV detection.

Fortunately, as the reaction is transferred from a purely organic solvent system to mixed organic-aqueous media, which are employed in most RP-HPLC separations, the apparent multiplicity of maxima in the time profile of the intensity dependence seems to be suppressed or to collapse to a reasonably simple biexponential-like dependence. As shown in Figure 11, simply changing the solvent from ethyl acetate to 95% aqueous acetonitrile and the catalyst from triethylamlne to imidazole produces a single maximum profile, one that is more easily modeled mathematically, as defined in Equation 4 ... 

---