Focus On

For vehicles, special attention is most often focused on the knocking potential encountered at high motor speeds in excess of 4000 rpm for which the consequences from the mechanical point of view are considerable and lead very often to mechanical failure such as broken valves or pistons, and rupture of the cylinder head gasket. Between RON and MON, it is the latter which better reflects the tendency to knock at high speeds. Conversely, RON gives the best prediction of the tendency to knock at low engine speeds of 1500 to 2500 rpm. 

Among the compounds susceptible to evaporation, particular attention is focused on benzene. In the two conditions indicated above, for equal benzene contents in the fuel (1.5% volume), the benzene evaporative losses are reduced by 21% and 11%, respectively, when the vapor pressure decreases by 1 psi, that is, 69 mbar. 

Finally it is likely that attention will be focused on emissions of polynuclear aromatics (PNA) in diesel fuels. Currently the analytical techniques for these materials in exhaust systems are not very accurate and will need appreciable improvement. In conventional diesel fuels, emissions of PNA thought to be carcinogenic do not exceed however, a few micrograms per km, that is a car will have to be driven for several years and cover at least 100,000 km to emit one gram of benzopyrene for example These already very low levels can be divided by four if deeply hydrotreated diesel fuels are used. 

The flowscheme of the typical refinery during the period 1950-1970 was essentially focused on the production of gasoline, diesel oil, domestic heating oil and industrial fuel-oil. Except for heavy naphtha, the product streams underwent no deep conversion. 

Imagine for a moment that the exploration activities carried out in the previous section have resulted in a successful discovery well. Some time will have passed before the results of the exploration campaign have been evaluated and documented. The next step will be the appraisal of the accumulation, and therefore at some stage a number of additional appraisal wells will be required. The following section will focus on these drilling activities, and will also investigate the interactions between the drilling team and the other E P functions. 

The operations group will develop general operating and maintenance objectives for the facilities which will address product quality, costs, safety and environmental issues. At a more detailed level, the mode of operations and maintenance tor a particular project will be specified in the field development plan. Both specifications will be discussed in this section, which will focus on the input of the production operations and maintenance departments to a field development plan. The management of the field during the producing period is discussed in Section 14.0. 

The paper focuses on the presentation and discussion of the results of the application of long term, continuous, AE structural monitoring to 2 large superheated (SH) steam outlet headers, belonging to 2 different full-size (600 MW, supercritical multifuel) ENEL power units. Continuous AE surveillance of the 2 SH headers started in October 1996 and is still ongoing. 

The performance of the classifier has been verified using a number of practical applications, such as civil engineering [3], inspection of aerospace composite structures, ball bearings and aircraft multi-layer structures. Here we present shortly some results, focusing on detection of disbonds in adhesively joint multi-layer aerospace structures using Fokker Bond Tester resonance instrument, details can be found in [1]. 

Before starting the realisation of silicium coils, we construct a simpler probe with a 27 mm long excitation coil and 16 wired coil sensors, with 1 mm diameter and 1 mm long. We cannot hope any reconstruction with such a probe, but this allows to validate the whole approach. We tried it with test tubes with longitudinal or circonferential notches, external or internal, 100 pm wide, 100%, 60%, 40%, 20% and 10% deep. Our attention has been especially focused on circonferential notches, which are difficult to detect with usual probes. For example, the measurement signals at 240 kHz standard frequency are shown figure 6 7. 

The computed CWT leads to complex coefficients. Therefore total information provided by the transform needs a double representation (modulus and phase). However, as the representation in the time-frequency plane of the phase of the CWT is generally quite difficult to interpret, we shall focus on the modulus of the CWT. Furthermore, it is known that the square modulus of the transform, CWT(s(t)) I corresponds to a distribution of the energy of s(t) in the time frequency plane [4], This property enhances the interpretability of the analysis. Indeed, each pattern formed in the representation can be understood as a part of the signal s total energy. This representation is called "scalogram". 

Earlier research has been focused on laboratory work to determine the feasibility of the method. Both experiments on real components and FEM simulations have been used. Simulations have been used as a guidance when deciding a suitable measurement arrangement. Examples of the information that can be obtained from FEM simulations will be demonstrated. 

It has become clear that scatter between measurements has to be reduced. At present the work is focused on the understanding of the reason for scatter and how to compensate for it. 

This presentation will not attempt to present all these projects, but instead focus on the ongoing network activities and the available sources for further information through the Commission s information services, with the CORDIS database being the prime source of information (see details at the end of the paper). 

Stale of the art, 8 chapters inch 60 Fig.. Months with special focus on TOFD, Thickness Gauging, Aerospace, Power Generation... 

The non-destructive department of Laborelec focuses on problems in nuclear, thermal and combined cycle power stations. Some inspections are based on eddy current and ultrasonic testing. 

It is possible that much of the inspection in future years will be focused on areas identified from databases which collate corrosion and damage history in similar ships. The validity of any conclusions derived from assessment programmes or databases can only be accepted if the quality of the original product is known. This would suggest that the NDE inspection programmes applied by some yards will have to be expanded. 

The preceding material of this section has focused on the most important phenomenological equation that thermodynamics gives us for multicomponent systems—the Gibbs equation. Many other, formal thermodynamic relationships have been developed, of course. Many of these are summarized in Ref. 107. The topic is treated further in Section XVII-13, but is worthwhile to give here a few additional relationships especially applicable to solutions. 

The discussion focuses on two broad aspects of electrical phenomena at interfaces in the first we determine the consequences of the presence of electrical charges at an interface with an electrolyte solution, and in the second we explore the nature of the potential occurring at phase boundaries. Even within these areas, frequent reference will be made to various specialized treatises dealing with such subjects rather than attempting to cover the general literature. One important application, namely, to the treatment of long-range forces between surfaces, is developed in the next chapter. 

While much early work with dispersed electrochemical systems focused on silver halide sols [16], more recent studies by Rusling and co-workers and others exploited... 

SAMs are generating attention for numerous potential uses ranging from chromatography [SO] to substrates for liquid crystal alignment [SI]. Most attention has been focused on future application as nonlinear optical devices [49] however, their use to control electron transfer at electrochemical surfaces has already been realized [S2], In addition, they provide ideal model surfaces for studies of protein adsorption [S3]. 

While a number of proteins have been crystallized in this manner, the majority of studies have focused on a robust system comprising the tetrameric protein streptavidin and the vitamin biotin. The choice of this system is primcirily motivated by the strong bond between biotin and streptavidin (having an association equilibrium constant, Ka Tbe binding properties were recently... 

While not unique, the Scluodinger picture of quantum mechanics is the most familiar to chemists principally because it has proven to be the simplest to use in practical calculations. Hence, the remainder of this section will focus on the Schrodinger fomuilation and its associated wavefiinctions, operators and eigenvalues. Moreover, effects associated with the special theory of relativity (which include spin) will be ignored in this subsection. Treatments of alternative fomuilations of quantum mechanics and discussions of relativistic effects can be found in the reading list that accompanies this chapter. 

It should be mentioned that the single-particle Flamiltonians in general have an infinite number of solutions, so that an uncountable number of wavefiinctions [/ can be generated from them. Very often, interest is focused on the ground state of many-particle systems. Within the independent-particle approximation, this state can be represented by simply assigning each particle to the lowest-lying energy level. If a calculation is... 

A good account of the historicai deveiopment of quantum mechanics. Whiie much of the book deais with quantum fieid theory and particie physics, the first third of the book focuses on the period 1850-1930 and the origins of quantum theory. An admirabie job is done in piacing events in a proper historicai context. 

Wliat does one actually observe in the experunental spectrum, when the levels are characterized by the set of quantum numbers n. Mj ) for the nonnal modes The most obvious spectral observation is simply the set of energies of the levels another important observable quantity is the intensities. The latter depend very sensitively on the type of probe of the molecule used to obtain the spectmm for example, the intensities in absorption spectroscopy are in general far different from those in Raman spectroscopy. From now on we will focus on the energy levels of the spectmm, although the intensities most certainly carry much additional infonnation about the molecule, and are extremely interesting from the point of view of theoretical dynamics. 

Of course, condensed phases also exliibit interesting physical properties such as electronic, magnetic, and mechanical phenomena that are not observed in the gas or liquid phase. Conductivity issues are generally not studied in isolated molecular species, but are actively examined in solids. Recent work in solids has focused on dramatic conductivity changes in superconducting solids. Superconducting solids have resistivities that are identically zero below some transition temperature [1, 9, 10]. These systems caimot be characterized by interactions over a few atomic species. Rather, the phenomenon involves a collective mode characterized by a phase representative of the entire solid. 

As discussed above, the nonlinear material response, P f) is the most connnonly encountered nonlinear tenn since vanishes in an isotropic medium. Because of the special importance of P we will discuss it in some detail. We will now focus on a few examples ofP spectroscopy where just one or two of the 48 double-sided Feymnan diagrams are important, and will stress the dynamical interpretation of the signal. A pictorial interpretation of all the different resonant diagrams in temis of wavepacket dynamics is given in [41]. 

---