Calcium carbonate reaction with hydrochloric acid

Insoluble gases are often formed by the breakdown of an xmstable doubledisplacement reaction product. For example, carbonates react with acids to form carbonic acid (H2CO3), an unstable substance that readily decomposes into water and carbon dioxide. Calcium carbonate reacts with hydrochloric acid to form calcium chloride and carbonic acid ... 

In another process, strontium sulfate can be converted to strontium carbonate direcdy by a metathesis reaction wherein strontium sulfate is added to a solution of sodium carbonate to produce strontium carbonate and leave sodium sulfate in solution (6). Prior to this reaction, the finely ground ore is mixed with hydrochloric acid to convert the calcium carbonates and iron oxides to water-soluble chlorides. 

Calcium chloride is obtained as a by-product in the manufacture of sodium carbonate (soda ash) by ammonia-soda (Solvay) process. The process involves the reaction of sodium chloride with calcium carbonate and ammonia. Calcium chloride is currently produced in bulk amounts by evaporation of natural underground brines. In the laboratory, calcium chloride can be prepared by treating bmestone with hydrochloric acid followed by evaporation of solution to obtain crystals. The crystals are dehydrated to obtain anhydrous salt. Calcium oxide or hydroxide may be used instead of carbonate. 

Precipitate with aq. ammonia. Evaporate the soln. down to about 100 c.c., and filter the ot liquid so as to remove calcium sulphate. The cone. soln. is sat. with ammonium alum and allowed to stand for some time. The mixed crystals of potassium, rubidium, and oeesium alums and of lithium salt are dissolved in 100 c.c. of distilled water and recrystal-lized. The recrystallization is repeated until the crystals show no spectroscopic reaction for potassium or lithium. The yield naturally depends on the variety of lepidolite employed. 100. grms of an average sample gives about 10 grms. of crude crystals and about 3 grms. of the purified caesium and rubidium alums. For the purification of caesium and rubidium salts, see the chlorides. The mother-liquors are treated with an excess of barium carbonate, boiled, and filtered. The filtrate is acidified with hydrochloric acid, and evaporated to dryness. The residue is extracted with absolute alcohol in which lithium chloride is soluble, and the other alkali chlorides are sparingly soluble. 

An intimate mixture ot 274 grms. of rubidium iron alum, or 260 grms. of rubidium aluminium alum with 100 grms. of calcium carbonate, and 27 grms. of ammonium chloride, is heated in a nickel crucible to a dull red heat until ammonia vapours are no longer evolved, and then the temp, is raised to redness. The product is ground with a litre of cold water for 15 minutes filtered by suction and washed with 400 c.c. of water, added in small portions at a time. The combined sulphuric acid is precipitated by the addition of barium hydroxide, and the filtered liquid boiled while a stream of carbon dioxide is passed through the soln. If the soln. loses its alkaline reaction, and yet retains some calcium, a little rubidium carbonate must be added to precipitate calcium carbonate. The soln. is then treated with hydrochloric acid and evaporated. 

Wear nitrile rubber gloves, laboratory coat, and eye protection. Cover spill with a 1 1 1 mixture by weight of sodium carbonate or calcium carbonate, clay cat litter (bentonite), and sand. Scoop into a container and remove to fume hood. Slowly add the solid mixture to a large volume of stirred water and crushed ice in a beaker. When the reaction is complete, neutralize with sodium carbonate or dilute hydrochloric acid. Decant the liquid... 

A major chemical plant dissolved inorganic slurry solids in a series of three fiberglass vessels. Most employees considered this section of the plant as one of the nonhazardous areas of this chemical complex. This area handled a relatively cool sodium chloride (table salt) water stream that was saturated with insoluble salts such as calcium carbonate and magnesium carbonate. The slurry contained about 30-percent calcium carbonate. Insoluble carbonates are treated with hydrochloric acid in two agitated vessels to allow a reaction to liberate carbon dioxide and form a soluble salt. The reaction is a simple one ... 

Carbonate Spot Test. The presence of carbonates in a soil is important because carbonates affect the properties of a soil. Such properties include the cation exchange capacity and the water holding capacity. It is important for a soil scientist to determine if carbonates are present and to also quantitatively analyze for carbonates. The carbonate spot test determines if carbonates are present. The reaction of carbonates with acids yields carbon dioxide gas and, thus, an effervescence is observed upon contact. The reaction of hydrochloric acid with calcium carbonate is ... 

RtI 1 1 a lit)g i.grtrdrochloric acid reacts with calcium carbonate in two stages The first stage forms the bicarbonate ion, which then reacts further to form carbon dioxide. Write equations for these two stages and for the overall reaction, (c) Hydrochloric acid is used to recover oil from the ground. It dissolves rocks (often CaC03) so that the oil can flow more easily. In one process, a 15 percent (by mass) HCl solution is injected into an oil well to dissolve the rocks. If the density of the acid solution is 1.073 g mL , what is the pH of the solution ... 

The chemical operations described in the literature to introduce or into citric acid molecule are based essentially on the Grimaux and Adam synthesis. Labeled citric acid was prepared by Wilcox et al. [35] in the reaction of Na CN with 3-chloro-2-carboxy-2-hydroxybutyric acid and the formed nitrile was hydrolyzed directly with hydrochloric acid. From this solution, citric acid was isolated in the form of calcium citrate and finally converted to the acid. An alternative procedme was proposed by Rothchild and Fields [36] to obtain trimethyl citrate from labeled sodium cyanide and di-chloromethyl glycolate. A more complex synthesis of C labeled citric acid is described by Winkel et al. [39]. They used labeled methyl acetate and acetyl chloride (in the presence of hthium 1,1,1,3,3,3,-hexamethyldisilazide, [(CH3)2Si]2NLi which was dissolved in tetrahydiofuran) to obtain methyl acetoac-etate. It reacts in the presence of lithium diisopropylamide, [(CH3)2CH]2NLi, also dissolved in tetrahydrofuran, with dimethyl carbonate to give dimethyl 1,3-ace-tonedicaiboxylate. It is dicarboxylated by the action of bisulfite and potassium cyanide is converted to 3-cyano-3-hydroxy-l,5 pentanedioate and finally hydrolyzed by hydrochloric acid to citric acid. 

With the news that calcium deficiencies in many women s diets may contribute to the development of osteoporosis (bone weakening), the use of dietary calcium supplements has become increasingly common. Many of these calcium supplements consist of nothing more than calcium carbonate, CaCOs. When a calcium carbonate tablet is ingested, it dissolves by reaction with stomach acid, which contains hydrochloric acid, HCl. The unbalanced equation is... 

Use the apparatus detailed in Section 111,20. Dissolve 100 g. (123 ml.) of methyl n-butyl ketone (2-hexanone) (Section 111,152) in 750 ml. of ether and add 150 ml. of water. Introduce 69 g. of clean sodium in the form of wire (or small pieces) as rapidly as possible the reaction must be kept under control and, if necessary, the flask must be cooled in ice or in running water. When all the sodium has reacted, separate the ethereal layer, wash it with 25 ml. of dilute hydrochloric acid (1 1), then with water, dry with anhydrous potassium carbonate or with anhydrous calcium sulphate, and distil through a fractionating column. Collect the fraction of b.p. 136-138°. The yield of methyl n-butyl carbinol (2-hexanol) is 97 g. 

Fit a 1500 ml. bolt-head flask with a reflux condenser and a thermometer. Place a solution of 125 g. of chloral hydrate in 225 ml. of warm water (50-60°) in the flask, add successively 77 g. of precipitated calcium carbonate, 1 ml. of amyl alcohol (to decrease the amount of frothing), and a solution of 5 g. of commercial sodium cyanide in 12 ml. of water. An exothermic reaction occurs. Heat the warm reaction mixture with a small flame so that it reaches 75° in about 10 minutes and then remove the flame. The temperature will continue to rise to 80-85° during 5-10 minutes and then falls at this point heat the mixture to boiling and reflux for 20 minutes. Cool the mixture in ice to 0-5°, acidify with 107-5 ml. of concentrated hydrochloric acid. Extract the acid with five 50 ml. portions of ether. Dry the combined ethereal extracts with 10 g. of anhydrous sodium or magnesium sulphate, remove the ether on a water bath, and distil the residue under reduced pressure using a Claiseii flask with fractionating side arm. Collect the dichloroacetic acid at 105-107°/26 mm. The yield is 85 g. 

---