Yield acids

By their oxidising action heating with copper and concen trated sulphuric acid yields brown fumes of nitrogen dioxide. 

Detergents are made by, for example, treating petroleum hydrocarbons with sulphuric acid, yielding sulphonated products which are water soluble. These can also solubilise fats and oils since, like the stearate ion, they have an oil-miscible hydrocarbon chain and a water-soluble ionic end. The calcium salts of these substances, however, are soiu u-ic in water and, therefore, remove hardness without scum formation. 

Oxidation of a sulphur compound with concentrated nitric acid yields sulphuric acid or a sulphate, which can be tested for with barium chloride. This can be used to estimate the sulphur. 

Electrolysis of hydrochloric acid yields hydrogen at the cathode and oxygen at the anode from the dilute acid, but chlorine at the anode (of carbon) from the concentrated acid. Electrolysis of the concentrated acid is used on the large scale to recover chlorine. 

Addition of silver nitrate to a solution of an iodide in dilute nitric acid, yields a yellow precipitate of silver iodide practically insoluble in ammonia. 

N-Benzylamides are recommended when the corresponding acid is liquid and/or water-soluble so that it cannot itself serve as a derivative. Phe benzylamides derived from the simple fatty acids or their esters are not altogether satisfactory (see Table below) those derived from most hydroxy-acids and from poly basic acids or their esters are formed in good yield and are easily purified. The esters of aromatic acids yield satisfactory derivatives but the method must compete with the equally simple process of hydrolysis and precipitation of the free acid, an obvious derivative when the acid is a solid. The procedure fails with esters of keto, sul phonic, inorganic and some halogenated aliphatic esters. 

Secondary amines upon treatment with nitrous acid yield nitrosamiues, which are stable, neutral yellow liquids (or low melting point solids), for example ... 

The latter upon decomposition with dilute hydrochloric acid yields laevo sec.-octyl hydrogen phthalate the crystalline brucine salt, when similarly treated, affords the dextro sec.-octyl hydrogen phthalate. These are reerystallised and separately hydrolysed with sodium hydroxide solution to yield pure I- and d-sec.-octyl alcohols ... 

Nitration of bromobenzene with mixed acid yields largely p-bromo nitrobenzene accompanied by a little of the o-isomeride ... 

Compounds containing two primary amino groups attached to a benzene ring can be prepared by the reduction of dinitro compounds and of nitroanilines, usually with tin or stannous chloride and hydrochloric acid or with iron and very dilute hydrochloric acid. / ara-diamines may also be obtained by the reduction of aromatic amino-azo compounds (e.g., p-aminodimethylanihne from methyl orange, see Section IV,78). p-Phenylenediamine may also be prepared from p-nitroacetanilide reduction with iron and acid yields p-amino-acetaniUde,.which may be hydrolysed to the diamine. 

In order to prepare an acid, a dioxan solution of the diazo ketone is added slowly to a suspension of silver oxide in a dilute solution of sodium thiosulphate Iftheco)iversion to the acid yields unsatisfactory results, it is usually advisable to prepare the ester or amide, which are generally obtained in good yields hydrolysis of the derivative gives the free acid. 

The nitration of phthalic anhydride with a mixture of concentrated sulphuric and nitric acids yields a mixture of 3-nitro- and 4 nitro phthalic acids these are readily separated by taking advantage of the greater solubility of the 4 nitro acid in water. Treatment of 3 nitrophtlialic acid with acetic anhydride gives 3 nitrophthahe anhydride. 

Hydrolysis of saccharin (o-sulphobenzoic imide) (Section IV, 209) with dilute hydrochloric acid yields acid ammonium 0 sulphobenzoate, w hich upon... 

Indanedioiie (III) may also be prepared by condensation of diethyl phthalate (V) with ethyl acetate in the presence of sodium ethoxide the resulting sodium 1 3-indanedione-2-carboxylic ester (VI) upon warming with sulphuric acid yields (HI). 

The nitration of anisole in 40% aq. nitric acid in the presence of some nitrous acid yielded 2,4-dinitrophenol as the main product. In more concentrated solutions of nitric acid 0- and />-nitroanisoles were the main products, less than o-1 % of the weta-isomer being formed. " The isomeric ratios for nitration imder a variety of conditions are given later ( 5.3.4). 

Many examples of insertions of internal alkynes are known. Internal alkynes react with aryl halides in the presence of formate to afford the trisubstituted alkenes[271,272]. In the reaction of the terminal alkyne 388 with two molecules of iodobenzene. the first step is the formation of the phenylacetylene 389. Then the internal alkyne bond, thus produced, inserts into the phenyl-Pd bond to give 390. Finally, hydrogenolysis with formic acid yields the trisubstituted alkene 391(273,274], This sequence of reactions is a good preparative method for trisubstituted alkenes from terminal alkynes. 

Addition of arylhydroxylamines to electrophilic allenes such as methyl propadienoate or l-methancsulfonyl-l,2-propadiene is another route to 0-vinyl derivatives[2]. The addition step is carried out by forming the salt of the hydroxylamine using NaH and the addition is catalysed with LiO CCFj. The intermediate adducts are cyclized by warming in formic acid. Yields are typically 80% or better. 

Butler recently reviewed the diazotization of heterocyclic amines (317). Reactions with nitrous acid yield in most cases N-exocyclic compounds. Since tertiary amines are usually regarded as inen to nitrosation, this... 

Alkoxythiazoles are easily cleaved by acids yielding A-4-thiazoline-2-ones (36). C-5 Nitration of the thiazole ring is favored by the 2-alkoxy group (288. 297, 307). Recent kinetic investigations have shown that the rate enhancement is 3 log units (893). 

A-2-Oxazoline-5-one (2091 when treated with thioacetic acid yields the corresponding thiazoline-5-one (210) (Scheme 107) (458. 461). These results have been questioned recently (365) however, it appears in the later report that a large excess of thioacetic acid was used instead o-f the stoichiometric amount previously used. 

Phenyl-4-methyl-A-2-thiazoline-5-one (220) treated with excess SOjClj in dichloroethane and the crude product treated with thioacetic acid yields the 4-thioacetyl derivative (221) (Scheme 111) (446). 

In the case of 4-(chloromethyl)-2-phenylthiazole, chloration in acetic acid yields only theproductsubstitutedat the 5-position ofthethiazolering(247). 

Thus 2-phenyl-4(hydroxymethyl) thiazole upon oxidation with aqueous chromic acid yields 2-phenyl-4-thiazolecarboxylic acid (25,26). 

Ozonolysis of 2-styryl-4-methylthiazole followed by oxidation of the intermediate carbonyl compound with peracetic acid yields 4-methyl-2-thiazolecarboxylic acid (30). 

An unknown acetylenic ammo acid obtained from the seed of a tropical fruit has the molec ular formula C7H11NO2 On catalytic hydrogenation over platinum this ammo acid yielded homoleucme (an ammo acid of known structure shown here) as the only product What is the structure of the unknown ammo acid" ... 

Reaction of benzamhde (C6H5NHCC6H5) with chlorine in acetic acid yields a mixture of two monochloro denvatives formed by electrophilic aromatic substitution Suggest reasonable structures for these two isomers... 

Acid catalyzed condensation of an alcohol and a carboxylic acid yields an ester and water and IS known as the Fischer esterification... 

Alcohols and carboxylic acids yield an ester and water in the presence of an acid catalyst The reaction is an equilibrium process that can be driven to com pletion by using either the alcohol or the acid in excess or by remov mg the water as it is formed... 

Reaction of benzaldehyde with 1 2 octanediol in benzene containing a small amount of p toluenesulfonic acid yields almost equal quantities of two products in a combined yield of 94% Both products have the molecular formula C15H22O2 Suggest reasonable structures for these products... 

The concentration of chromic acid can be determined from its reduction by alcohols under conditions when the kinetics are pseudo-first-order in analyte. One approach is to monitor the absorbance of the solution at a wavelength of 355 nm. A standard solution of 5.1 X lO " M chromic acid yields absorbances of 0.855 and 0.709 at, 100 s and 300 s, respectively, after the reaction s initiation. When a sample with an unknown amount of chromic acid is analyzed under... 

Acetic anhydride adds to acetaldehyde in the presence of dilute acid to form ethyUdene diacetate [542-10-9], boron fluoride also catalyzes the reaction (78). Ethyfldene diacetate decomposes to the anhydride and aldehyde at temperatures of 220—268°C and initial pressures of 14.6—21.3 kPa (110—160 mm Hg) (79), or upon heating to 150°C in the presence of a zinc chloride catalyst (80). Acetone (qv) [67-64-1] has been prepared in 90% yield by heating an aqueous solution of acetaldehyde to 410°C in the presence of a catalyst (81). Active methylene groups condense acetaldehyde. The reaction of isobutfyene/715-11-7] and aqueous solutions of acetaldehyde in the presence of 1—2% sulfuric acid yields alkyl-y -dioxanes 2,4,4,6-tetramethyl-y -dioxane [5182-37-6] is produced in yields up to 90% (82). 

The important chemical properties of acetyl chloride, CH COCl, were described ia the 1850s (10). Acetyl chloride was prepared by distilling a mixture of anhydrous sodium acetate [127-09-3J, C2H202Na, and phosphorous oxychloride [10025-87-3] POCl, and used it to interact with acetic acid yielding acetic anhydride. Acetyl chloride s violent reaction with water has been used to model Hquid-phase reactions. 

Tetrakis(hydroxymethyl)phosphonium Salts. The reaction of formaldehyde (qv) and phosphine in aqueous hydrochloric or sulfuric acid yields tetrakis-(hydroxymethyl)phosphonium chloride [124-62-1/, Albright Wilson s Retardol C, or the sulfate [55566-30-8] (Retardol S), (C4H 2C4P)2SO [55566-30-8]. 

Pish protein concentrate and soy protein concentrate have been used to prepare a low phenylalanine, high tyrosine peptide for use with phenylketonuria patients (150). The process includes pepsin hydrolysis at pH 1.5 ptonase hydrolysis at pH 6.5 to Hberate aromatic amino acids gel filtration on Sephadex G-15 to remove aromatic amino acids incubation with papain and ethyl esters of L-tyrosine and L-tryptophan, ie, plastein synthesis and ultrafiltration (qv). The plastein has a bland taste and odor and does not contain free amino acids. Yields of 69.3 and 60.9% from PPG and soy protein concentrate, respectively, have been attained. 

---