Hydrochloric acid concentrated

Andrews deration An important titration for the estimation of reducing agents. The reducing agent is dissolved In concentrated hydrochloric acid and titrated with potassium iodale(V) solution. A drop of carbon tetrachloride is added to the solution and the end point is indicated by the disappearance of the iodine colour from this layer. The reducing agent is oxidized and the iodate reduced to ICl, i.e. a 4-eiectron change. 

CH2CI-CO-CH3. Colourless lachrymatory liquid b.p. 119°C. Manufactured by treating propanone with bleaching powder or chlorine. It is used as a tear gas and is usually mixed with the more potent bromoacetone. chloro acids Complex chloroanions are formed by most elements of the periodic table by solution of oxides or chlorides in concentrated hydrochloric acid. Potassium salts are precipitated from solution when potassium chloride is added to a solution of the chloro acid, the free acids are generally unstable. 

Molisch s test A general test for carbohydrates. The carbohydrate is dissolved in water, alcoholic 1-naphthol added, and concentrated sulphuric acid poured down the side of the tube. A deep violet ring is formed at the junction of the liquids. A modification, the rapid furfural test , is used to distinguish between glucose and fructose. A mixture of the sugar, 1-naphthol, and concentrated hydrochloric acid is boiled. With fructose and saccharides containing fructose a violet colour is produced immediately the solution boils. With glucose the appearance of the colour is slower. 

Thus under standard conditions chloride ions are not oxidised to chlorine by dichromate(Vr) ions. However, it is necessary to emphasise that changes in the concentration of the dichromate(VI) and chloride ions alters their redox potentials as indicated by the Nernst equation. Hence, when concentrated hydrochloric acid is added to solid potassium dichromate and the mixture warmed, chlorine is liberated. 

Lead reacts slowly with hot concentrated hydrochloric acid since the lead II) chloride dissolves in an excess of the hot hydrochloric acid to form the acid H,[Pb"CI ] ... 

Lead(IV) oxide is found to have a considerable oxidising power, again indicating that the oxidation state +2 is generally more stable for lead than oxidation state +4. Concentrated hydrochloric acid, for example, reacts with PbO at room temperature to form lead(II) chloride and chlorine ... 

In concentrated hydrochloric acid solution, the reaction is GeCl -p Cr [GeClj]-and salts of this anion are known. 

It has a covalently bonded structure and is a colourless liquid at room temperature it is hydrolysed reversibly by water, all the germanium being recoverable by distilling the product with concentrated hydrochloric acid GeCl -P 2H2O — Ge02 -P 4HC1... 

This chloride is prepared by dissolving tin in concentrated hydrochloric acid on cooling, the solution deposits crystals of hydrated tin(II) chloride. SnClj. 2H2O ("tin salt ). The anhydrous chloride is prepared by heating tin in a current of hydrogen chloride ... 

The solid is essentially ionic, made up of Pb and Cl ions. The vapour contains bent molecules of PbCh (cf. SnCh). Lead chloride is precipitated when hydrochloric acid (or a solution of a chloride) is added to a cold solution of a lead(ll) salt. It dissolves in hot water but on cooling, is slowly precipitated in crystalline form. It dissolves in excess of concentrated hydrochloric acid to give the acid H2[Pb"Cl4]. 

Lead(IV) chloride is formed from cold concentrated hydrochloric acid and lead(IV) oxide as described earlier. It readily evolves chlorine by the reversible reaction ... 

Antimony forms both a + 3 and a + 5 oxide. The + 3 oxide can be prepared by the direct combination of the elements or by the action of moderately concentrated nitric acid on antimony. It is an amphoteric oxide dissolving in alkalis to give antimonates(III) (for example sodium antimonite , NaSb02), and in some acids to form salts, for example with concentrated hydrochloric acid the trichloride, SbCl3, is formed. 

Hence addition of concentrated hydrochloric acid to a solution of arsenic(III) acid produces arsenic(IIl) chloride in solution. The above equilibrium may be written ... 

The gas is washed with water to remove any hydrogen chloride. Since iron(II) sulphide is a non-stoichiometric compound and always contains some free iron, the hydrogen sulphide always contains some hydrogen, liberated by the action of the iron on the acid. A sample of hydrogen sulphide of better purity can be obtained if antimony(III) sulphide, (stibnite) SbjSj, is warmed with concentrated hydrochloric acid ... 

Halogens can act as ligands and are commonly found in complex ions the ability of fluorine to form stable complex ions with elements in high oxidation states has already been discussed (p. 316). However, the chlorides of silver, lead(Il) and mercury(l) are worthy of note. These chlorides are insoluble in water and used as a test for the metal, but all dissolve in concentrated hydrochloric acid when the complex chlorides are produced, i.e. [AgCl2] , [PbC ] and [Hg Clj]", in the latter case the mercury(I) chloride having also disproportionated. 

Iodine monochloride, formed when iodine reacts with the iodate(V) ion in the presence of an excess of concentrated hydrochloric acid. 

Manganese(IV) oxide is a dark-brown solid, insoluble in water and dilute acids. Its catalytic decomposition of potassium chlor-ate(V) and hydrogen peroxide has already been mentioned. It dissolves slowly in alkalis to form manganates(lW), but the constitution of these is uncertain. It dissolves in ice-cold concentrated hydrochloric acid forming the complex octahedral hexachloromangan-ate(IV) ion ... 

Hence, under ordinary conditions, manganeseflV) oxide oxidises concentrated hydrochloric acid to chlorine, but the above shows that the oxidation process is essentially ... 

Alternatively, a known weight of the pyrolusite may be heated with concentrated hydrochloric acid and the chlorine evolved passed into potassium iodide solution. The iodine liberated is titrated with sodium thiosulphate ... 

For this reaction, charcoal is a catalyst if this is omitted and hydrogen peroxide is used as the oxidant, a red aquopentammino-cobalt(lll) chloride, [Co(NH3)jH20]Cl3, is formed and treatment of this with concentrated hydrochloric acid gives the red chloro-p0itatnmino-coba. t(lll) chloride, [Co(NH3)5Cl]Cl2. In these latter two compounds, one ammonia ligand is replaced by one water molecule or one chloride ion it is a peculiarity of cobalt that these replacements are so easy and the pure products so readily isolated. In the examples quoted, the complex cobalt(III) state is easily obtained by oxidation of cobalt(II) in presence of ammonia, since... 

The anhydrous chloride is prepared by standard methods. It is readily soluble in water to give a blue-green solution from which the blue hydrated salt CuClj. 2H2O can be crystallised here, two water molecules replace two of the planar chlorine ligands in the structure given above. Addition of dilute hydrochloric acid to copper(II) hydroxide or carbonate also gives a blue-green solution of the chloride CuClj but addition of concentrated hydrochloric acid (or any source of chloride ion) produces a yellow solution due to formation of chloro-copper(ll) complexes (see below). 

By warming either copper(I) oxide or a mixture of copper(II) chloride and copper with concentrated hydrochloric acid, until a deep brown solution is formed ... 

The solid readily dissolves chemically in concentrated hydrochloric acid, forming a complex, and in ammonia as the colourless, linear, complex cation [H3N -> Cu <- NHj] (cf AgCl) if air is absent (in the presence of air, this is oxidis to a blue ammino-copper(II) complex). This solution of ammoniacal copper(I) chloride is a good solvent or carbon monoxide, forming an addition compound CuCl. CO. H2O, and as such is used in gas analysis. On passing ethyne through the ammoniacal solution, a red-brown precipitate of hydrated copper(I) dicarbide (explosive when dry) is obtained ... 

Anhydrous cupric sulphate is white but forms a blue hydrate and a blue aqueous solution. The solution turns yellow when treated with concentrated hydrochloric acid, dark blue with ammonia, and gives a white precipitate and brown solution when treated with potassium iodide. A yellow-brown aqueous solution of ferric chloride becomes paler on acidification with sulphuric or nitric... 

When cobalt(II) chloride was dissolved in water, a pink solution A was formed. The addition of concentrated hydrochloric acid to A gave a blue solution B. If solution A was treated with concentrated ammonia solution a blue-green precipitate was formed upon addition of further ammonia solution followed by the passage of air through the mixture, an orange-red solution C was produced. 

Silver chloride is reduced to the metal by zinc. One of the methods of recovering silver from silver residues depends on this. The residue is first treated with concentrated hydrochloric acid and then sulphuric acid and zinc added ... 

Hydrolysis of Potassium Ethyl Sulphate. Dissolve about i g. of the crystals in about 4 ml. of cold distilled water, and divide the solution into two portions, a) To one portion, add barium chloride solution. If pure potassium ethyl sulphate were used, no precipitate should now form, as barium ethyl sulphate is soluble in water. Actually however, almost all samples of potassium ethyl sulphate contain traces of potassium hydrogen sulphate formed by slight hydrolysis of the ethyl compound during the evaporation of its solution, and barium chloride almost invariably gives a faint precipitate of barium sulphate. b) To the second portion, add 2-3 drops of concentrated hydrochloric acid, and boil the mixture gently for about one minute. Cool, add distilled water if necessary until the solution has its former volume, and then add barium chloride as before. A markedly heavier precipitate of barium sulphate separates. The hydrolysis of the potassium ethyl sulphate is hastened considerably by the presence of the free acid Caustic alkalis have a similar, but not quite so rapid an effect. 

Place I g. of benzamide and 15 ml. of 10% aqueous sodium hydroxide solution in a 100 ml. conical flask fitted with a reflux water-condenser, and boil the mixture gently for 30 minutes, during which period ammonia is freely evolved. Now cool the solution in ice-water, and add concentrated hydrochloric acid until the mixture is strongly acid. Benzoic acid immediately separates. Allow the mixture to stand in the ice-water for a few minutes, and then filter off the benzoic add at the pump, wash with cold water, and drain. Recrystallise from hot water. The benzoic acid is obtained as colourless crystals, m.p. 121°, almost insoluble in cold water yield, o 8 g. (almost theoretical). Confirm the identity of the benzoic acid by the tests given on p. 347. 

Meanwhile assemble the apparatus shown in Fig. 62, or that in Fig. 23(D), p. 45, having a distilling-flask of at least 500 ml. capacity in either case. If an ordinary condenser C (Fig. 62) is employed, fit the lower end of the condenser by means of a short piece of rubber tubing to a small inverted funnel. Arrange the latter so that its lip is just below the surface of 25 ml. of concentrated hydrochloric acid diluted with 75 ml. of water contained in a 250 ml. beaker B the hydro-. chloric acid is thereby prevented from being sucked back into the... 

Place a few drops of nitromethane in a test tube, add about 3 times as much concentrated hydrochloric acid, and then a piece of granulated tin. The tin dissolves in the acid and the nascent hydrogen produced reduces the nitromethane to monomethylamine ... 

SULPHANILAMIDE. (Reaction C.) Add 15 g. of the above thoroughly drained sulphonamide to 10 ml. of concentrated hydrochloric acid diluted with 20 ml. water, and boil the mixture gently under reflux for i hour. Then add 30 ml. of water and heat the mixture again to boiling, with the addition of a small quantity of animal charcoal. Filter the boiling solution, and add powdered sodium carbonate in small quantities to the filtrate with stirring until all eflFervescence ceases and the sulphanilamide is precipitated as a white powder. Cool the mixture thoroughly and filter oflF the sulphanilamide at the pump, wash with water and dry. Yield, ca. 10 g. 

Dissolve 15 ml. (15-4 g.) of aniline in a mixture of 40 ml. of concentrated hydrochloric acid and 40 ml. of water contained in a 250 ml. conical flask. Place a thermometer in the solution, immerse the flask in a mixture of ice and water, and cool until the temperature of the stirred solution reaches 5°. Dissolve I2 5 g. of powdered sodium nitrite in 30 ml. of water, and add this solution in small quantities (about 2-3 ml. at a time) to the cold aniline hydrochloride solution, meanwhile keeping the latter well stirred by means of a thermometer. Heat is evolved by the reaction, and therefore a short interval should be allowed between consecutive additions of the sodium nitrite, partly to allow the temperature to fall again to 5°, and partly to ensure that the nitrous acid formed reacts as completely as possible with the aniline. The temperature must not be allowed to rise above 10°, otherwise appreciable decomposition of the diazonium compound to phenol will occur on the other hand, the temperature... 

Meanwhile, during the cooling of the cuprous chloride solution, prepare a solution of benzenediazonium chloride by dissolving 20 ml. (20-5 g.) of aniline in a mixture of 50 ml. of concentrated hydrochloric acid and 50 ml. of water, and after cooling to 5°, adding slowly a solution of 17 g. of sodium nitrite in 40 ml. of water. Observe carefully the general conditions for diazotisation given in the preparation of iodobenzene (p. 184). 

Benzenediazonium chloride reacts in solution with sodium sulphite to give benzenediazonium sodium sulphonate, which when treated with sulphurous acid undergoes reduction to phenylhydrazine sodium sulphonate. The latter readily hydrolyses in the presence of concentrated hydrochloric acid to give... 

---