Aliphatic sulphonic acids

This direct sulphonation should be compared with the indirect methods for the preparation of aliphatic sulphonic acids, e.g., oxidation of a thiol (RSH -> RSOjH), and interaction of an alkyl halide with sodium sulphite to give the sodium sulphonate (RBr + Na,SO, -> RSO,Na + NaBr). 

B) SULPHONIC ACIDS. Aliphatic sulphonic acids are rarely encountered, for they are very soluble in water, and many are deliquescent. The aromatic sulphonic acids, although less uncommon, are encountered most frequently as their derivatives e.g.t the sulphonamides, pp. 247, 251), or as nuclear-substituted acids (e.g., sulphanilic acid, p. 384). 

Aliphatic sulphonic acids, 557 Aliphatic sulphur compounds, 496... 

The sulphonic acids of the benzene series are exactly analogous to those of the aliphatic series, i,e, they are non-hydrolyzable, and are represented by the general formula R—SO2— OH. The method of preparation of the aliphatic sulphonic acids from the halogen substitution products and a salt of sulphurous acid is not applicable in the benzene series. 

The former are true aromatic sulphonic acids prepared by direct sulphonation, and reacting like benzene sulphonic acid. The latter are aliphatic sulphonic acids both in methods of preparation and reaction. 

Sulphonic Acids to Hydroxyl Compounds.—(4) Reactions with alkalies by fusion. In the aliphatic series the most important synthetic reaction for the formation of hydroxyl derivatives is the treatment of the alkyl halides with silver hydroxide, which reaction we have said does not occur in the benzene series when the substitution is in the ring and not in the side chain. The most important method for preparing ring-hydroxyl compounds is by the fusion of a sulphonic acid or its salt with alkalies, potassium or sodium hydroxide, a reaction which does not occur with the aliphatic sulphonic acids. 

The Other product of the reaction is a salt of sulphurous acid, which recalls the relation between the aliphatic sulphonic acids and sulphurous acid. 

A product can then be detected or determined. Detection of the S02 has been carried out by standard procedures, e.g. with Fe(III)/ferrocyanide49 or nickel(II) hydroxide50. A pyrohydrogenolysis method was developed by Feigl51 for aliphatic sulphonic acids by heating them with benzoin ... 

Preparatimi.— While most papers relevant to this section deal with aromatic sulphonation, there are interesting developments too in reagents for introduction of the sulphonic acid grouping, and in the chemistry of aliphatic sulphonic acids. 

Salts of aliphatic sulphonic acids and ethereal sulphates are mildly antibacterial if the chain has 12 or more carbon atoms (e.g. sodium tetra-decylsulphate). These function as the anion (Gershenfeld and Milanick, 1941 Putnam and Neurath, 1944). 

Most of the inhibitors in use are organic nitrogen compounds and these have been classified by Bregman as (a) aliphatic fatty acid derivatives, b) imidazolines, (c) quaternaries, (d) rosin derivatives (complex amine mixtures based on abietic acid) all of these will tend to have long-chain hydrocarbons, e.g. CigH, as part of the structure, (e) petroleum sulphonic acid salts of long-chain diamines (preferred to the diamines), (/) other salts of diamines and (g) fatty amides of aliphatic diamines. Actual compounds in use in classes (a) to d) include oleic and naphthenic acid salts of n-tallowpropylenediamine diamines RNH(CH2) NH2 in which R is a carbon chain of 8-22 atoms and x = 2-10 and reaction products of diamines with acids from the partial oxidation of liquid hydrocarbons. Attention has also been drawn to polyethoxylated compounds in which the water solubility can be controlled by the amount of ethylene oxide added to the molecule. 

Several studies confirm an ortho effect leading to a dominating aryl sulphur bond cleavage. For example, the introduction of a bulky ortho substituent17 will provide the formation of the aliphatic sulphinic acid. A series of cyclic sulphones was studied18,19 at the mercury cathode and the results (see Table 2) appear to be fully in agreement with those expected when considering the preliminary works presented above. 

In reality all carbon atoms share equally the pool of electrons which constitute the double bonds and benzene resists addition across the double bonds which would otherwise destroy its unique structure and stability. Single or multiple hydrogen atoms can be substituted to form a host of derivatives containing similar functional groups to those above, e.g. saturated and unsaturated aliphatic chains, amino, carboxylic acidic, halogeno, nitro, and sulphonic acid groups as shown in Table 3.6. 

Generally, the results of the measurements indicated that, where dissociation constants were determined by conductometry and also potentiometric titration, they were in agreement with each other further, KHX is low, e.g., about 10 4-10 6moll 1 for aromatic sulphonic acids and 10 13-10 16 moll-1 for carboxylic acids, Xhx2 is high, e.g., 102-104, and KBis low again, e.g., 10 5-10 6 for aliphatic amines and 10 10 for aromatic amines. 

The sulphonated aromatic condensation products form a large and varied group, since formaldehyde will condense with many aromatic compounds [330], including sulphonated arylamines, phenols and aliphatic ketones the range of commercially important products is relatively limited, however. One of the oldest is the condensation product of naphthalene-2-sulphonic acid and formaldehyde (10.99), in which the degree of condensation is thought to... 

Aliphatic and aromatic sulphonic acids have been reduced to symmetrical disulphides in almost quantitative yields using potassium iodide and ethyl polyphosphate... 

The lower members of the homologous series of 1. Alcohols 2. Aldehydes 3. Ketones 4. Acids 5. Esters 6. Phenols 7. Anhydrides 8. Amines 9. Nitriles 10. Polyhydroxy phenols 1. Polybasic acids and hydro-oxy acids. 2. Glycols, poly-hydric alcohols, polyhydroxy aldehydes and ketones (sugars) 3. Some amides, ammo acids, di-and polyamino compounds, amino alcohols 4. Sulphonic acids 5. Sulphinic acids 6. Salts 1. Acids 2. Phenols 3. Imides 4. Some primary and secondary nitro compounds oximes 5. Mercaptans and thiophenols 6. Sulphonic acids, sulphinic acids, sulphuric acids, and sul-phonamides 7. Some diketones and (3-keto esters 1. Primary amines 2. Secondary aliphatic and aryl-alkyl amines 3. Aliphatic and some aryl-alkyl tertiary amines 4. Hydrazines 1. Unsaturated hydrocarbons 2. Some poly-alkylated aromatic hydrocarbons 3. Alcohols 4. Aldehydes 5. Ketones 6. Esters 7. Anhydrides 8. Ethers and acetals 9. Lactones 10. Acyl halides 1. Saturated aliphatic hydrocarbons Cyclic paraffin hydrocarbons 3. Aromatic hydrocarbons 4. Halogen derivatives of 1, 2 and 3 5. Diaryl ethers 1. Nitro compounds (tertiary) 2. Amides and derivatives of aldehydes and ketones 3. Nitriles 4. Negatively substituted amines 5. Nitroso, azo, hy-drazo, and other intermediate reduction products of nitro com-pounds 6. Sulphones, sul-phonamides of secondary amines, sulphides, sulphates and other Sulphur compounds... 

Reaction LXX. Oxidation of certain Hydrocarbons. (B., 14, 1944 A. Spl., 1869, 300 E.P., 1948 (1869).)—This reaction is confined in the aliphatic series almost exclusively to the replacement by hydroxyl of the hydrogen attached to tertiary carbon atoms. A powerful oxidising agent, e.g., chromic acid in glacial acetic acid, is necessary. In the aromatic series the reaction is somewhat more easy to accomplish when the sodium salt of anthraquinone-jS-monosulphonic acid, for example, is fused under pressure with caustic soda and a little potassium chlorate, replacement of both a hydrogen atom and the sulphonic acid group by hydroxyl occurs, and alizarin ( /f-dihydroxyanthraquinone) is obtained. 

The simpler aliphatic sulphur derivatives considered in this section are the sulphur analogues of oxygen compounds, e.g. the thiols (RSH), and the symmetrical or unsymmetrical thioethers (R-S-R or R -S-R2). Compounds derived from these two groups, where the sulphur atom can attain a higher oxidation state, are the sulphinic and sulphonic acids (R-SO-OH and R-S02 OH), the sulphox-ides (R-SO-R), and the sulphones (R-S02-R). Other compounds of interest which are considered in the following discussion are ... 

N-Benzylamides are recommended when the corresponding acid is liquid and/or water-soluble so that it cannot itself serve as a derivative. The benzyl-amides derived from the simple fatty acids or their esters are not altogether satisfactory since they are often low melting those derived from most hydroxy acids and from polybasic acids or their esters are formed in good yield and are easily purified. The esters of aromatic acids yield satisfactory derivatives but the method must compete with the equally simple process of hydrolysis and precipitation of the free acid, an obvious derivative when the acid is a solid. The procedure fails with esters of keto acids, sulphonic acids and inorganic acids and some halogenated aliphatic esters. 

---