Solutions saline

Maroudas N G 1977 Sulphonated polystyrene as an optimal substratum for the adhesion and spreading of mesenohymal sells in monovalent and divalent saline solutions J. Cell. Physiol. 90 511-20... 

P. E. Smith and B. M. Pettitt. Amino acid side-chain populations in aqueous and saline solution Bis(penicillamine) enkephalin. Biopolymers, 32 1623-1629,... 

The polymers exist in saline solution as tightly coiled chains and are readily adsorbed owing to relatively low solubiUty in hard water. Subsequent injection of soft, low salinity water uncoils the adsorbed polymer chains increasing water viscosity and reducing rock permeabiUty. This technology could also be used to reduce the permeabiUty of thief 2ones adjacent to injection wells. However, mechanical isolation of these 2ones may be necessary for cost-effective treatments. 

Processing in Hquid sterilants results in wet products which require highly specialized packaging. Therefore, Hquid sterilization should only be considered if the sterilized article is to be used almost immediately. Liquid sterilants or their residues can be harmful to living tissues. Therefore it is always necessary to rinse articles with sterile water or saline solution foUowing treatment. Whereas Hquid sterilization is an extremely useful method for articles that caimot withstand the conditions of steam sterilization, the problems associated with its use limit its appHcation. 

Minimal Energy Requirements. The relative effect of the cost of the energy on the cost of the freshwater produced depends on local conditions, and is up to one-half of the total. In attempting to reduce this cost, it is of interest to determine the minimal energy amount thermodynamically needed for separating the water from the saline solution. The physical background to this will be introduced in a simple example. Because of the negligible... 

The ice crystals must be separated from the saline solution surrounding them, and washed with freshwater. This is accompHshed by a downward countercurrent flow of a small amount of freshwater through the ice slurry in the washer—melter unit. Keeping that unit at about 0°C limits the needed pressure rise by the compressor to only about 130—260 Pa, and an auxiUary refrigerator is often used to compensate for heat gains from the ambient and the compression. 

Electrodialysis. In electro dialysis (ED), the saline solution is placed between two membranes, one permeable to cations only and the other to anions only. A direct electrical current is passed across this system by means of two electrodes, causiag the cations ia the saline solution to move toward the cathode, and the anions to the anode. As shown ia Figure 15, the anions can only leave one compartment ia their travel to the anode, because a membrane separating them from the anode is permeable to them. Cations are both excluded from one compartment and concentrated ia the compartment toward the cathode. This reduces the salt concentration ia some compartments, and iacreases it ia others. Tens to hundreds of such compartments are stacked together ia practical ED plants, lea ding to the creation of alternating compartments of fresh and salt-concentrated water. ED is a continuous-flow process, where saline feed is continuously fed iato all compartments and the product water and concentrated brine flow out of alternate compartments. 

The era of modem enzyme technology began in 1874 when the Danish chemist Christian Hansen produced the first industrial batches of chymosin by extracting dried calves stomachs with saline solutions. 

For plasminogen-deficient fibrinogen from blood plasma, the anticoagulated blood was centrifuged and the plasma was frozen and washed with saline solution. Treated with charcoal and freeze-thawed. Dialysed versus Tris/NaCl buffer. [Maxwell and Nikel Biochem Prep 12 16 1968.]... 

There are no films or protective surface films on active metals, e.g., mild steel in acid or saline solutions. Passive metals are protected by dense, less readily soluble surface films (see Section 2.3.1.2). These include, for example, high-alloy Cr steels and NiCr alloys as well as A1 and Ti in neutral solutions. Selective corrosion of alloys is largely a result of local concentration differences of alloying elements which are important for corrosion resistance e.g., Cr [4],... 

Figure 2-11 shows weight loss rate-potential curves for aluminum in neutral saline solution under cathodic protection [36,39]. Aluminum and its alloys are passive in neutral waters but can suffer pitting corrosion in the presence of chloride ions which can be prevented by cathodic protection [10, 40-42]. In alkaline media which arise by cathodic polarization according to Eq. (2-19), the passivating oxide films are soluble ... 

Ferracane, J. L-, Mafiana, P., Cooper, C. and Okabe, T. Time-dependent Dissolution of Amalgams into Saline Solution , Journal of Dental Research, 66, 1331-1335 (1987)... 

Hakansson, B., Yontchev, E., Vannberg, N.-G. and Hedegard, B. An Examination of the Surface Corrosion State of Dental Fillings and Constructions. 1. A Laboratory Investigation of the Corrosion Behaviour of Dental Alloys in Natural Saliva and Saline Solutions , Journal of Oral Rehabilitation, 13, 235-246 (1986)... 

The specimen design used in the study by Rostoker et al. was such that it simulated both galvanic coupling and crevice conditions. Specimens were immersed in a 1% saline solution at 37 C, and examined by optical microscopy after exposures of a few to 100 days. No corrosion was observed on Ti-6A1-4V when the alloy was either uncoupled, coupled with itself (simple crevice). Or coupled with type 316L stainless steel, cast Co-Cr-Mo... 

Beccaria, A. M. e a ., Investigation on Lead Corrosion Products in Sea Water and In Neutral Saline Solutions , Werksloffe und Korros., 33, 416-420 (1982)... 

General rules for corrosion tests applicable to storage conditions Filiform corrosion test on steel Liquefied petroleum gases-corrosiveness to copper. Copper strip test Road vehicles-brake linings-resistance to water, saline solution, oil and brake fluid-test procedure... 

Theory. Conventional anion and cation exchange resins appear to be of limited use for concentrating trace metals from saline solutions such as sea water. The introduction of chelating resins, particularly those based on iminodiacetic acid, makes it possible to concentrate trace metals from brine solutions and separate them from the major components of the solution. Thus the elements cadmium, copper, cobalt, nickel and zinc are selectively retained by the resin Chelex-100 and can be recovered subsequently for determination by atomic absorption spectrophotometry.45 To enhance the sensitivity of the AAS procedure the eluate is evaporated to dryness and the residue dissolved in 90 per cent aqueous acetone. The use of the chelating resin offers the advantage over concentration by solvent extraction that, in principle, there is no limit to the volume of sample which can be used. 

Blood and lymph are approximately isotonic to a cell so that cells do not gain or lose liquid when bathed in these fluids. Pure water is hypotonic and may cause cells to swell and burst. During intravenous feeding, injections, and storage of cell tissue, a salt (saline) solution is used with a concentration of solutes that is essentially isotonic with blood (and hence, with the cell) to prevent cell damage. 

From this material, samples are cut and swelled to constant weight in a buffered saline solution prepared from 8.43 g sodium chloride (NaCl), 9.26 g boric acid (H3BO3), 1.0 g sodium borate (Na3B03), and 0.1 g of the disodium salt of the dihydrate of ethylenediaminetetraacetic acid [Na2 EDTA -(/ 0)21 ini L of distilled water. 

Phosphorus-containing surfactants often possess particular properties by themselves or in combination with other types of surfactants. They are therefore proposed for fields of application which can only be covered by other surfactants with difficulty. Their wide variety enables them to become tailored for different requirements. Further possibilities can be developed in conjunction with other surfactants. Their solubility in saline solution extends their field of application beyond the limits for common surfactants. 

---