Reactions prediction

After approaches to the solution of the major tasks in chemoinformatics have thus been outlined, these methods are put to work in specific applications. Some of these apphcations, such as structure elucidation on the basis of spectral information, reaction prediction, computer-assisted synthesis design or drug design, are presented in Chapter 10. 

Atomic and bond hash codes are helpful in structure manipulation programs, e.g., in reaction prediction or in synthesis design [99]. 

Clearly, for symmetry reasons, the reverse process should also be considered. In fact, early versions of our reaction prediction and synthesis design system EROS [21] contained the reaction schemes of Figures 3-13, 3-15, and 3-16 and the reverse of the scheme shown in Figure 3-16. These four reaction schemes and their combined application include the majority of reactions observed in organic chemistry. Figure 3-17 shows a consecutive application of the reaction schemes of Figures 3-16 and 3-13 to model the oxidation of thioethers to sulfoxides. 

To be able to define reaction planning, reaction prediction, and synthesis design To know how to acquire knowledge from reaction databases To understand reaction simulation systems... 

To become familiar with a knowledge-based reaction prediction system To appreciate the different levels in the evaluation of chemical reactions To know how reaction sequences are modeled To understand kinetic modeling of chemical reactions To become familiar with biochemical pathways... 

This is a question of reaction prediction. In fact, this is a deterministic system. If we knew the rules of chemistry completely, and understood chemical reactivity fully, we should be able to answer this question and to predict the outcome of a reaction. Thus, we might use quantum mechanical calculations for exploring the structure and energetics of various transition states in order to find out which reaction pathway is followed. This requires calculations of quite a high degree of sophistication. In addition, modeling the influence of solvents on... 

On top of that, reaction databases can also be used to derive knowledge on chemical reactions which can then be used for reaction prediction, The huge amount of information in reaction databases can be processed by inductive learning methods in order to condense these individual pieces of information into essential features... 

In spite of the importance of reaction prediction, only a few systems have been developed to tackle this problem, largely due to its complexity it demands a huge amount of work before a system is obtained that can make predictions of sufficient quality to be useful to a chemist. The most difficult task in the development of a system for the simulation of chemical reactions is the prediction of the course of chemical reactions. This can be achieved by using knowledge automatically extracted from reaction databases (see Section 10.3.1.2). Alternatively, explicit models of chemical reactivity will have to be included in a reaction simulation system. The modeling of chemical reactivity is a very complex task because so many factors can influence the course of a reaction (see Section 3.4). 

Two systems, CAMEO and EROS, have been developed that approach the task of reaction prediction in a broad and comprehensive manner. Both systems were initiated around 1975 and are presented in more detail in Sections 10.3.1.4 and 10.3.1.5. 

More elaborate scheme.s can he envisaged. Thus, a. self-organizing neural network as obtained by the classification of a set of chemical reactions as outlined in Section 3,5 can be interfaced with the EROS system to select the reaction that acmaliy occurs from among various reaction alternatives. In this way, knowledge extracted from rcaetion databases can be interfaced with a reaction prediction system,... 

Reaction prediction treats chemical reactions in their forward direction, and synthesis design in their backward, retrosynthetic direction,... 

Reaction databases present a rich source of information for the extraction of knowledge for reaction prediction and synthesis design,... 

Reaction prediction, or reaction simulation, has to concentrate on the reaction center, i.e., the bonds broken and made in a reaction. 

A very large number of Diels-Alder reactions are recorded in the chemical literature many of which involve relatively complicated dienes dienophiles or both On the basis of your knowl edge of Diels-Alder reactions predict the constitution of the Diels-Alder adduct that you would expect to be formed from the following combinations of dienes and dienophiles... 

For the following reactions, predict whether the pressure of the reactants or products increases or remains the same when the volume of the reaction vessel is increased. 

Write the equations for the reaction between each of the following acid-base pairs. For each reaction, predict whether reactants or products are favored (using the values of K given in Appendix 2). 

PROBLEMS For each of the following reactions, predict the expected product, and propose a plausible mechanism for formation of the product ... 

In everyday life, we encounter silver as an unreactive solid that is used for jewelry, and we know that iron, while it msts, is relatively stable. Calcium and magnesium, in contrast, are not normally encountered as pure metals but instead as salts. Thus, the directions of the reactions predicted by the activity series are in accord with everyday observations. 

The two proposed mechanisms for this reaction predict different rate laws. Whereas Mechanism I predicts that the rate is proportional to NO2 concentration. Mechanism II predicts that the rate is proportional to the square of NO2 concentration. Experiments agree with the prediction of Mechanism II, so Mechanism II is consistent with the experimental behavior of the NO2 decomposition reaction. Mechanism I predicts rate behavior contrary to what is observed experimentally, so Mechanism I cannot be correct. 

Priebe, S. (1987). Early subjective reactions predicting outcome of hospital treatment in depressive patients. Acta Psychiatr. Scand., 76, 134-8. 

The F + H2 — HF + FI reaction is one of the most studied chemical reactions in science, and interest in this reaction dates back to the discovery of the chemical laser.79 In the early 1970s, a collinear quantum scattering treatment of the reaction predicted the existence of isolated resonances.80 Subsequent theoretical investigations, using various dynamical approximations on several different potential energy surfaces (PESs), essentially all confirmed this prediction. The term resonance in this context refers to a transient metastable species produced as the reaction occurs. Transient intermediates are well known in many kinds of atomic and molecular processes, as well as in nuclear and particle physics.81 What makes reactive resonances unique is that they are not necessarily associated with trapping... 

Anionic polymerization Narrow molecular weight distribution Limited chain transfer reactions Predictable molecular weight average Possibility of forming living polymers End groups can be tailored for further reactivity Solvent-sensitive due to the possibility of chain transfer to the solvent Can be slow Sensitive to trace impurities Narrow molecular weight distribution... 

A New Treatment of Chemical Reactivity Development of EROS, an Expert System for Reaction Prediction and Synthesis Design... 

The problems are of both industrial and purely scientific importance, and they can also be approached qualitatively and quantitatively. The reaction prediction question, for example, might be directed not so much at what the products might be, but rather how likely the reaction might be in comparison with an analogous system. The scope of the problems is indeed vast, and Figs. 2 and 3 give some indication of the width of the spectrum of organic synthesis and reactivity. 

Synthesis design and reaction prediction can draw benefits from all these features of a computer. Our own work in this area began in 1974, and in 1978 the computer program system EROS (Elaboration of Reactions for Organic Synthesis) was first presented 6. Since then, several reports on certain aspects of the system development have appeared, but sometimes in less easily available journals or books7. Moreover, there has been no description of the overall system as it now stands. This article is intended to rectify this situation. 

Recent developments have been aimed at facilitating EROS s chemistry, and use of the latter in the various evaluation steps necessary to the problem. This has led to a version of EROS which is capable of solving some quite sophisticated reactivity prediction questions, such as those posed in Fig. 3. Further developments of the synthesis design capabilities have intentionally been kept in abeyance, and are following on in the light of our experience with reaction prediction. 

We have already emphasized our view that the evaluation of chemical reactions and synthetic pathways is of preeminent importance in any system for computer-assisted synthesis design or reaction prediction. The quality of the evaluation process will determine to a large extent the overall quality of such a system. 

Particular care is taken in the design of a model to define it in such a way that it can be converted to a procedure characterized by short computation times. This is deemed essential for the evaluation of the large number of molecules which can be generated during a synthesis study or in reaction prediction. Since studies on molecules with up to 70 atoms are quite often performed with EROS, rapid evaluations of many large molecules has to be realistic. 

---