Polyaromatic hydrocarbons, determination

Chlorinated hydrocarbons, determination of 244 Chlorinated polyaromatic hydrocarbons, determination of 132 Chlorinated insecticides,... 

Plutonium, determination of 154-157 Polyacrylamide, determination of 217 Polyaromatic hydrocarbons, determination of 110-112,127-133,... 

This publication provides several examples of the use of solid-phase extractions for separating analytes from their matrices. Some of the examples included are caffeine from coffee, polyaromatic hydrocarbons from water, parabens from cosmetics, chlorinated pesticides from water, and steroids from hydrocortisone creams. Extracted analytes maybe determined quantitatively by gas (GC) or liquid chromatography (LG). 

Petrick et al. [375] extracted up to 2000 dm3 of Atlantic Ocean waters using various solid resins. Down to 5 ng/dm were determined of chlorinated biphenyls, HCB, DDE, and polyaromatic hydrocarbons in samples taken at depths down to 4000 metres. 

Haapakka and Kankare have studied this phenomenon and used it to determine various analytes that are active at the electrode surface [44-46], Some metal ions have been shown to catalyze ECL at oxide-covered aluminum electrodes during the reduction of hydrogen peroxide in particular. These include mercu-ry(I), mercury(II), copper(II), silver , and thallium , the latter determined to a detection limit of <10 10 M. The emission is enhanced by organic compounds that are themselves fluorescent or that form fluorescent chelates with the aluminum ion. Both salicylic acid and micelle solubilized polyaromatic hydrocarbons have been determined in this way to a limit of detection in the order of 10 8M. 

Boeda et al. (1996) identified bitumen on a flint scraper and a Levallois flake, discovered in Mousterian levels (about 40 000 BP) at the site of Umm el Tlel in Syria. The occurrence of polyaromatic hydrocarbons such as fluoranthene, pyrene, phenanthrenes and chrysenes suggested that the raw bitumen had been subjected to high temperature. The distribution of the sterane and terpane biomarkers in the bitumen did not correspond to the well-known bitumen occurrences in these areas. In other studies of bitumen associated with a wide variety of artefacts of later date, especially from the 6th Millennium BC onwards, molecular and isotopic methods have proved successful in recognizing different sources of bitumen enabling trade routes to be determined through time (Connan et al., 1992 Connan and Deschesne, 1996 Connan, 1999 Harrell and Lewan, 2002). 

Spectrofluorimetric methods are applicable to the determination of aliphatic hydrocarbons, and humic and fulvic acids in soil, aliphatic hydrocarbons polyaromatic hydrocarbons, optical whiteners, and selenium in non-saline sediments, aliphatic aromatic and polyaromatic hydrocarbons and humic and fulvic acids in saline sediments. The only application found in luminescence spectroscopy is the determination of polychlorobiphenyl in soil. Generally speaking, concentrations down to the picogram (pg L 1), level can be determined by this technique with recovery efficiencies near f00%. 

Phosphorescence can also be detected when the phosphor is incorporated into an ionic micelle. Deoxygenation is still required either by degassing with nitrogen or by the addition of sodium sulphite. Micellestabilized room-temperature phosphorescence (MS RTP) promises to be a useful analytical tool for determining a wide variety of compounds such as pesticides and polyaromatic hydrocarbons. 

This technique has been applied to the determination of heteroaromatic compounds, anthropogenic hydrocarbons, polymers, haloaromatic compounds in soils, polyaromatic hydrocarbons, cationic surfactants and polychlorobiphenyls and mixtures of organic compounds in non-saline sediments and bacteria identification in sludges. 

Despite the advances made in high-performance liquid chromatography in recent years, there are still occasionally applications in which conventional column chromatography is employed. These methods lack the sensitivity, resolution and automation of HPLC. They include the determination of urea herbicides in soil, polyaromatic hydrocarbons, carbohydrates, chloroaliphatic compounds and humic and fulvic acids in non-saline sediments. The technique has also been applied in sludge analysis, e.g. aliphatic hydrocarbons and carboxylic acids. 

Electrophoretic and isotachoelectrophoretic techniques are gaining in popularity in soil analysis with applications to polyaromatic hydrocarbons, polychlorobiphenyls, tetrahydrothiophene and triazine herbicides, Paraquat and Diquat and growth regulators. Other lesser-used techniques include spectrophotometric methods (five determinants), spectrofluorimetric methods (two determinants), luminescence methods (one determinant), titration methods (one determinant), thin-layer chromatography (five applications), NHR spectroscopy (two applications) and enzymic immunoassays (one determinant). 

Vowles and Mantoura [38] determined sediment-water partition coefficients and the high-performance liquid chromatography capacity factors for 14 alkylbenzene and polyaromatic hydrocarbons. The partition coefficients correlated well with the alkyl-cyano capacity factors, and it was concluded that this phase gave a better indication of sorption on sediment than either the octanol or octadecylsilane phases. 

The extraction procedure described by Karasek et al. [1] in section 2.1.1.1 has been applied to the determination of polyaromatic hydrocarbons in... 

The Curie Point flash evaporation-pyrolysis gas chromatography-mass spectrometric method [32] described in section 2.2.1.2 for the analysis of aliphatic hydrocarbons in soils has also been applied to the determination of polyaromatic hydrocarbons (see Table 2.1). Table 2.2 lists the polyaromatic hydrocarbon contents found by this method in a soil sample. 

Brown et al. [47] have described a cyclodextran modified capillary electrophoretic method for the determination of polyaromatic hydrocarbons... 

Barnabas et al. [51] have discussed an experimental design approach for the extraction of polyaromatic hydrocarbons from soil using supercritical carbon dioxide. They studied 16 different polyaromatic hydrocarbons using pure carbon dioxide and methanol modified carbon dioxide. The technique is capable of determining down to lOOmg kgy1 polyaromatic hydrocarbons in soils. 

Bublitz [62] used time resolved laser induced fluorescence spectroscopy and fibre optics to determine polyaromatic hydrocarbons in oil polluted soils. The detection limit was 5mg kgy1 oil in soil. 

Immunochemical methods have been employed to determine polyaromatic hydrocarbons in soils [63, 64], On-site analysis is possible by this technique. 

Micellar electrokinetic capillary chromatography with photodiode array detection was used for the determination of polyaromatic hydrocarbons in soil [65]. A detection limit of lOpg and linear calibration over five orders were observed. Compared to a standard gas chromatographic analysis method, the miscellar electrokinetic chromatographic method is faster, has a higher mass sensitivity and requires smaller sample sizes. 

Bjorseth et al. [68] described a capillary gas chromatographic method for determining polyaromatic hydrocarbons in sediments. Up to 34 polyaromatic hydrocarbons were identified, some carcinogenic. 

Giger and Schnaffer [69] described a glass capillary gas chromatographic method for the determination of polyaromatic hydrocarbons in lake and river sediments. Polyaromatic hydrocarbons are isolated by a sequence of solvent... 

Readman et al. [70] used flame ionization capillary gas chromatography to determine polyaromatic hydrocarbons in extracts of rivers Mersey, Dee and Tamar estuary sediments. 

Tan [71] devised a rapid simple sample preparation technique for analysing polyaromatic hydrocarbons in sediments. Polyaromatic hydrocarbons are removed from the sediment by ultrasonic extraction and isolated by solvent partition and silica gel column chromatography. The sulphur removal step is combined into the ultrasonic extraction procedure. Identification of polyaromatic hydrocarbon is carried by gas chromatography alone and in conjunction with mass spectrometry. Quantitative determination is achieved by addition of known amounts of standard compounds using flame ionization and multiple ion detectors. 

Thomas etal. [72] used pyrolysis gas chromatography-mass spectrometry as a fast economic screening technique for polyaromatic hydrocarbons. Thomas used reverse-phase liquid chromatography with atmospheric pressure chemical ionization mass spectrometry/mass spectrometry for the determination of polycyclic aromatic sulphur heterocycles in sediments. 

Saber et al. [75] reported on the quantitative determination of polyaromatic hydrocarbons in extracts of lacustrine sediments using high resolution Shpol skii Spectrofluorimetry at 10°K. 

Saber et al. [75] used high resolution Shpol skii spectrofluorimetry at 10°K to quantitatively determine polyaromatic hydrocarbons in lacustral sediments. Polyaromatic hydrocarbons incorporated into w-alkanc matrix... 

Dunn and Stich [78] and Dunn [79] have described a monitoring procedure for polyaromatic hydrocarbons, particularly benzo[a]pyrene in marine sediments. The procedures involve extraction and purification of hydrocarbon fractions from the sediments and determination of compounds by thin layer chromatography and fluorometry, or gas chromatography. In this procedure, the sediment was refluxed with ethanolic potassium hydroxide, then filtered and the filtrate extracted with isooctane. The isooctane extract was cleaned up on a florisil column, then the polyaromatic hydrocarbons were extracted from the isoactive extract with pure dimethyl sulphoxide. The latter phase was contacted with water, then extracted with isooctane to recover polyaromatic hydrocarbons. The overall recovery of polyaromatic hydrocarbons in this extract by fluorescence spectroscopy was 50-70%. 

Aichberger and Reifenauer [81] have reviewed methods for the determination of polyaromatic hydrocarbons in sewage sludge. 

The microwave assisted extraction for organic compounds including polyaromatic hydrocarbons, phenols and organochlorine insecticides, described in section 11.1.8 [25] has been applied to sediments. The application of supercritical fluid extraction to the determination of various insecticides in soils described in section 11.1.7 [23] has been applied to river sediments. 

Japenga et al. [56] determined polychlorinated biphenyls and chlorinated insecticides in River Elbe estuary sediments by a procedure in which the sediments were pretreated with acetic acid, mixed with silica and Soxhlet-extracted with benzene/hexane. Humic material and elemental sulphur were removed by passing the extract through a chromatographic column containing basic alumina, on which sodium sulphite and sodium hydroxide were adsorbed. Silica fractionation was followed by gas chromatography to analyse chlorinated pesticides, polychlorinated biphenyls and polyaromatic hydrocarbons. Recovery experiments with standard solutions gave recoveries of 90-102%. 

---