Long-chain mixtures

Fig. IV-20. Film pressure-area plots for cerebronic acid (a long-chain a-hydroxy carboxylic acid) and cholesterol (see insert) and for an equimolar mixture. At low pressures the r-a plot is close to that of the average (dashed line), an unanticipated kink then appears, and finally, the horizontal portion probably represents ejection of the cholesterol. (From Ref. 239.)...

As mentioned in Section IX-2A, binary systems are more complicated since the composition of the nuclei differ from that of the bulk. In the case of sulfuric acid and water vapor mixtures only some 10 ° molecules of sulfuric acid are needed for water oplet nucleation that may occur at less than 100% relative humidity [38]. A rather different effect is that of passivation of water nuclei by long-chain alcohols [66] (which would inhibit condensation note Section IV-6). A recent theoretical treatment by Bar-Ziv and Safran [67] of the effect of surface active monolayers, such as alcohols, on surface nucleation of ice shows the link between the inhibition of subcooling (enhanced nucleation) and the strength of the interaction between the monolayer and water. 

Method 2. Place a 3 0 g. sample of the mixture of amines in a flask, add 6g. (4-5 ml.) of benzenesulphonyl chloride (or 6 g. of p-toluenesulphonyl chloride) and 100 ml. of a 5 per cent, solution of sodium hydroxide. Stopper the flask and shake vigorously until the odour of the acid chloride has disappeared open the flask occasionally to release the pressure developed by the heat of the reaction. AUow the mixture to cool, and dissolve any insoluble material in 60-75 ml. of ether. If a solid insoluble in both the aqueous and ether layer appears at this point (it is probably the sparingly soluble salt of a primary amine, e.g., a long chain compound of the type CjH5(CH2) NHj), add 25 ml. of water and shake if it does not dissolve, filter it off. Separate the ether and aqueous layers. The ether layer will contain the unchanged tertiary amine and the sulphonamide of the secondary amine. Acidify the alkaline aqueous layer with dilute hydrochloric acid, filter off the sulphonamide of the primary amine, and recrystaUise it from dilute alcohol. Extract the ether layer with sufficient 5 per cent, hydrochloric acid to remove all the tertiary amine present. Evaporate the ether to obtain the sulphonamide of the secondary amine recrystaUise it from alcohol or dilute alcohol. FinaUy, render the hydrochloric acid extract alkaline by the addition of dilute sodium hydroxide solution, and isolate the tertiary amine. 

Fats and oils are naturally occurring mixtures of glycerol tnesters Fats are mixtures that are solids at room temperature oils are liquids The long chain carboxylic acids obtained from fats and oils by hydrolysis are known as fatty acids... 

Ester hydrolysis in base is called saponification, which means soap making Over 2000 years ago the Phoenicians made soap by heating animal fat with wood ashes Animal fat is rich m glycerol triesters and wood ashes are a source of potassium car bonate Basic hydrolysis of the fats produced a mixture of long chain carboxylic acids as their potassium salts... 

Waxes are mixtures of substances that usually contain esters of fatty acids and long chain alcohols... 

Viscosity Index Improvers. VI improvers are long-chain, high molecular weight polymers that increase the relative viscosity of an oil at high temperatures more than at low temperatures. In cold oil the molecules of the polymer adopt a compressed coiled form so that the affect on viscosity is minimized. In hot oil the molecules swell, and interaction with the oil produces a proportionally greater thickening effect. Although the viscosity of the oil—polymer mixture decreases as the temperature increases, viscosity does not decrease as much as the oil alone would decrease. 

Sodium tripolyphosphate is produced by calcination of an intimate mixture of orthophosphate salts containing the correct overall Na/P mole ratio of 1.67. The proportions of the two anhydrous STP phases are controlled by the calcination conditions. Commercial STP typically contain a few percent of tetrasodium pyrophosphate and some trimetaphosphate. A small amount of unconverted orthophosphates and long-chain polyphosphates also may be present. 

Quaternary ammonium compounds are usually named as the substituted ammonium salt. The anion is Hsted last (3). Substituent names can be either common (stearyl) or lUPAC (octadecyl). If the long chain in the compound is from a natural mixture, the chain is named after that mixture, eg, taHowalkyL Prefixes such as di- and tri- are used if an alkyl group is repeated. Complex compounds usually have the substituents Hsted in alphabetical order. Some common quaternary ammonium compounds and their appHcations in patent Hterature are Hsted in Table 1. 

The composition of montan wax depends on the material from which it is extracted, but all contain varying amounts of wax, resin, and asphalt. Black montan wax may be further processed to remove the resins and asphalt, and is known as refined montan wax. White montan wax has been reacted with alcohols to form esters. The wax component of montan is a mixture of long-chain (C24—C q) esters (62—68 wt %), long-chain acids (22—26 wt %), and long-chain alcohols, ketones, and hydrocarbons (7—15 wt %). Cmde montan wax from Germany typically has a melting point of 80°C, an acid number of 32, and a saponification number of 92. 

Surfactants in E/ectroc/eaners. Surfactants typically consist of a long-chain hydrocarbon molecule having a solubilising or water-loving group which can be anionic, cationic, or nonionic when solubilized. Thousands of surfactant products are marketed, usually under trade names (32). In commercially formulated electrocleaners, surfactants are usually anionic, and often mixtures of anionics and nonionics. 

The production of linear alkyl benzenes (LABs) is carried out on a large scale for the production of surfactants. The reaction involves the reaction between benzene and a long-chain alkene such as dodec-l-ene and often gives a mixture of isomers. Greco et al. have used a chloroaluminate(III) ionic liquid as a catalyst in the preparation of LABs [83] (Scheme 5.1-53). 

Paraffins are relatively inactive compared to olefins, diolefins, and aromatics. Few chemicals could be obtained from the direct reaction of paraffins with other reagents. However, these compounds are the precursors for olefins through cracking processes. The C -Cg paraffins and cycloparaffms are especially important for the production of aromatics through reforming. This section reviews some of the physical and chemical properties of C1-C4 paraffins. Long-chain paraffins normally present as mixtures with other hydrocarbon types in different petroleum fractions are discussed later in this chapter. 

The catalytic oxidation of long-chain paraffins (C18-C30) over manganese salts produces a mixture of fatty acids with different chain lengths. Temperature and pressure ranges of 105-120°C and 15-60 atmospheres are used. About 60 wt% yield of fatty acids in the range of C12-C14 is obtained. These acids are used for making soaps. The main source for fatty acids for soap manufacture, however, is the hydrolysis of fats and oils (a nonpetroleum source). Oxidation of paraffins to fatty acids may be illustrated as ... 

Most of the inhibitors in use are organic nitrogen compounds and these have been classified by Bregman as (a) aliphatic fatty acid derivatives, b) imidazolines, (c) quaternaries, (d) rosin derivatives (complex amine mixtures based on abietic acid) all of these will tend to have long-chain hydrocarbons, e.g. CigH, as part of the structure, (e) petroleum sulphonic acid salts of long-chain diamines (preferred to the diamines), (/) other salts of diamines and (g) fatty amides of aliphatic diamines. Actual compounds in use in classes (a) to d) include oleic and naphthenic acid salts of n-tallowpropylenediamine diamines RNH(CH2) NH2 in which R is a carbon chain of 8-22 atoms and x = 2-10 and reaction products of diamines with acids from the partial oxidation of liquid hydrocarbons. Attention has also been drawn to polyethoxylated compounds in which the water solubility can be controlled by the amount of ethylene oxide added to the molecule. 

Waxes are mixtures of esters of long-chain carboxylic acids with long-chain alcohols. The carboxylic acid usually has an even number of carbons from 16 through 36( while the alcohol has an even number of carbons from 24 through 36. One of the major components of beeswax( for instance, is triacontyl hexadecanoate, the ester of the C30 alcohol triacontanol and the C16 acid hexa-... 

---