Oven

At low pressures, it is often permissible to neglect nonidealities of the vapor phase. If these nonidealities are not negligible, they can have the effect of introducing a nonrandom trend into the plotted residuals similar to that introduced by systematic error. Experience here has shown that application of vapor-phase corrections for nonidealities gives a better representation of the data by the model, oven when these corrections... 

The composition of coal tar varies with the carbonization method but consists, largely, of mononuclear and polynuclear aromatic compounds and their derivatives. Coke oven tars are relatively low in aliphatic and phenolic content while low-temperature tars have much higher contents of both. 

A bitumen sample is oxidized at high temperature under well defined conditions and its physical characteristics are measured before and after this artificiai ageing process. The method is defined in France as AFNOR T 66-032 and in the USA by ASTM D 2872 (Rolling Thin-Film Oven Test). 

RTFOT rolling thin film oven test... 

Figure B2.5.12 shows the energy-level scheme of the fine structure and hyperfme structure levels of iodine. The corresponding absorption spectrum shows six sharp hyperfme structure transitions. The experimental resolution is sufficient to detennine the Doppler line shape associated with the velocity distribution of the I atoms produced in the reaction. In this way, one can detennine either the temperature in an oven—as shown in Figure B2.5.12 —or the primary translational energy distribution of I atoms produced in photolysis, equation B2.5.35.

In most laboratories, drying ovens maintained at about 50° are available for the final drying of glass apparatus of all kinds. 

Dissolve 8 8 g. (9 0 ml.) of cyclohexanone in 50 ml. of glacial acetic acid, add 8 ml. of phenylhydrazine, and boil the solution under reflux for 5 minutes. Cool the solution, when the tetrahydrocarbazole will crystallise out. Filter at the pump, drain well, and recrystallise either from aqueous ethanol or (better) from aqueous acetic acid. The recrystallisation should be performed rapidly, for the tetrahydrocarbazole undergoes atmO" spheric oxidation in hot solutions after recrystallisation, the compound should be dried in a vacuum desiccator and not in an oven. Repeated recrystallisation should be avoided. The tetrahydrocarbazole, after thorough drying, is obtained as colourless crystals, m.p. 118° yield of recrystallised material, 11 g. 

Many chloroplatinates separate from aqueous solution with water of crystallisation. If this is suspected, the chloroplatinate should be dried to constant weight in the oven before analysis, to ensure elimination of water of crystallisation. Aniline, p-toluidine and pyridine all give anhydrous chloroplatinates, and can be conveniently used in the above determination no attempt should be made to recryrtallise their chloroplatinates. 

Before assembling, the constituent parts of the apparatus should be washed in turn with warm cone, nitric acid, distilled water, acetone, and dried in an oven. 

Digestion. 20-25 mg. of the substance whose nitrogen content is to be estimated are weighed out in a stoppered weighing-tube and then transferred to the flask L that has been previously dried in an oven at izo C. With care, the substance may be transferred directly into the bulb of the flask without any adhering to the sides. If any material sticks on the way down, the flask should be tapped gently to cause the substance to fall to the bottom. 2 G. of the catalyst mixture (32 g. of potassium sulphate, 5 g. of mercury sulphate and ig. of selenium powder, well mixed) are added and 3 ml. of A.R. cone, sulphuric acid are measured out carefully and poured into the digestion... 

To prepare the funnel G, fit it to the filter-flask and wash it by passing distilled water, ethanol and acetone through the glass plate H. Remove G from the bung J, wipe it with a clean cloth, and dry it in an oven for 15 minutes at 140°. Then carefully wipe it again with the cloth, and place it in the balance case on the carrier D (Fig. 90) for 15 minutes to attain an equilibrium with the air. Then transfer it to the balance pan and weigh. 

We can sample the energy density of radiation p(v, T) within a chamber at a fixed temperature T (essentially an oven or furnace) by opening a tiny transparent window in the chamber wall so as to let a little radiation out. The amount of radiation sampled must be very small so as not to disturb the equilibrium condition inside the chamber. When this is done at many different frequencies v, the blackbody spectrum is obtained. When the temperature is changed, the area under the spechal curve is greater or smaller and the curve is displaced on the frequency axis but its shape remains essentially the same. The chamber is called a blackbody because, from the point of view of an observer within the chamber, radiation lost through the aperture to the universe is perfectly absorbed the probability of a photon finding its way from the universe back through the aperture into the chamber is zero. 

For solids which melt above 100° and are stable at this temperature, drying may be carried out in a steam oven. The crystals from the Buchner funnel should then be placed on a clock glass or in an open dish. The substance may sometimes be dried in the Buchner funnel itself by utilising the device illustrated in Fig. 77, <33, 1. An ordinary Pyrex funnel is inverted over the Buchner funnel and the neck of the funnel heated by means of a broad flame (alternatively, the funnel may be heated by a closely-fltting electric heating mantle) if gentle suction is applied to the Alter flask, hot (or warm) air will pass over the crystalline solid. 

Frequently the water or other solvent is so firmly held that it cannot be completely removed in a vacuum desiccator at the ordinary temperature. These substances are dried in a vacuum oven at a higher temperature. A convenient laboratory form of vacuum oven is the so-called... 

Granular magnesium sulphate Is prepared by heating the heptahydrate gently (at 150-175°) in an oven until most of the water of hydration has been... 

Absorbent cotton (cotton wool). This material is an excellent drying agent for use in the so-called calcium chloride tubes, i.e., drying tubes, placed at the top of dropping funnels, reflux condensers, etc., to exclude moisture. It is more convenient than calcium chloride, and should preferably be dried in an oven at 100° before use. 

Cuprous bromide. The solid salt may be prepared by dissolving 150 g. of copper sulphate crystals and 87 5 g. of sodium bromide dihydrate in 500 ml. of warm water, and then adding 38 g. of powdered sodium sulphite over a period of 5-10 minutes to the stirred solution. If the blue colour is not completely discharged, a little more sodium sulphite should be added. The mixture is then cooled, the precipitate is collected in a Buchner funnel, washed twice with water containing a little dissolved sulphurous acid, pressed with a glass stopper to remove most of the liquid, and then dried in an evaporating dish or in an air oven at 100 120°. The yield is about 80 g. 

Silver nitrite. Warm concentrated solutions of silver nitrate (containing 48 g. of AgNOj) and potassium nitrite (containing 30 g. of KNOj) are mixed, and the mixture is allowed to cool. The silver nitrite which separates is filtered off and washed with water. It may be recrystallised from water at 70°, and is dried either in a vacuum desiccator or in an air oven at about 40° the yield is about 90 per cent. Silver nitrite should be stored in an tightly-stoppered amber bottle. 

---