Desiccators, vacuum

Beakers 10 to 1000-ml. volumetric flasks 1-ml. volumetric pipet, serological pipet steam bath vacuum desiccator vacuum pump and water aspirator are also required. 

Demethylation of a phenolic ether by hydriodic acid, 22, 91 Desiccator, vacuum, dumb-bell type, 23,105... 

Preparation of films for sufficiently volatile molecules can also be perfonned by evaporating tire molecules in vacuum (gas-phase deposition) or by tire use of a desiccator which contains tire substrate and tire dilute solution in a vessel separately and which is evacuated to 0.1 mbar and kept under vacuum for several hours ( 24 h). This also results in a vapour-phase-like deposition of tire molecules onto tire substrates. 

The solution obtained is evaporated somewhat, cooled in a vacuum desiccator and the crystals of the tetraoxo-acid filtered off too drastic evaporation causes formation of the heptaoxodiphosphoric acid by loss of water. 

A very effective universal filling for vacuum desiccators is obtained by having concentrated sulphuric acid C in the bottom of the desiccator, and flake sodium hydroxide D in the inverted glass collar supported on the shoulders of the desiccator, the collar then being covered... 

Drying of crystals. Whenever possible crystals should be dried in a smdl vacuum desiccator containing a suitable desiccant. The latter depends upon the nature of the solvent used c/. p. 19). However for most purposes anhydrous calcium chloride is satisfactory. If a hydrocarbon has been used in the recrystallisation, a few thin fresh shavings of paraffin wax are efficacious. 

The oxime is freely soluble in water and in most organic liquids. Recrystallise the crude dry product from a minimum of 60-80 petrol or (less suitably) cyclohexane for this purpose first determine approximately, by means of a small-scale test-tube experiment, the minimum proportion of the hot solvent required to dissolve the oxime from about 0-5 g. of the crude material. Then place the bulk of the crude product in a small (100 ml.) round-bottomed or conical flask fitted with a reflux water-condenser, add the required amount of the solvent and boil the mixture on a water-bath. Then turn out the gas, and quickly filter the hot mixture through a fluted filter-paper into a conical flask the sodium chloride remains on the filter, whilst the filtrate on cooling in ice-water deposits the acetoxime as colourless crystals. These, when filtered anddried (either by pressing between drying-paper or by placing in an atmospheric desiccator) have m.p. 60 . Acetoxime sublimes rather readily when exposed to the air, and rapidly when warmed or when placed in a vacuum. Hence the necessity for an atmospheric desiccator for drying purposes. 

The camphorquinone can be purified in either of two ways, (i) To save time, the drained but still damp material can be recrystallised from water containing 10% of acetic acid, the hot filtered solution being cooled and vigorously stirred. The quinone separates as brilliant yellow crystals (yield, 2 5 g.), m.p. 192-194 , increased to 196-197 by a second reciystal-lisation. (ii) The crude camphorquinone can be dried in a vacuum desiccator (weight of dry quinone, 5 g.), and then recrystallised from petroleum (b.p. 100-120 ), the hot solution being filtered through a fluted paper in a pre-heated funnel. The quinone separates in beautiful crystals, m.p. 196-197 , 2 8 g. 

It is advisable in any case before an experiment to place the weighed aluminium isopropoxide overnight in a shallow dish in a vacuum desiccator over sodium hydroxide. The isopropanol should be dried over anhydrous sodium sulphate, and the clear liquid decanted off before use. 

To prepare a sample of the hydrochloride, add 0-5 ml. of the base to 10 ml, of dilute hydrochloric acid in an evaporating basin and evaporate to dryness, preferably in a vacuum desiccator. Recrystallise the dry residue from petroleum (b.p. 60-80°). The hydrochloride separates as white crystals, m.p. 90°. 

The hydrochloride of the amine may be prepared precisely as that of the primary amine. For recrystallisation, boil a suspension of the powdered salt in petroleum (b.p. 60-80°), and then add acetone slowly in small drops until the boiling suspension just becomes clear allow the stirred solution to cool until crystallisation starts, and then chill in ice-water before collecting the colourless plates of the hydrochloride, which after drying in a vacuum desiccator have m.p. 132-134°. 

Cyclohexanone oxime. Add 20 g. (21 ml.) of cyclohexanone to a solution of 17 g. of hydroxylamine hydrochloride in 40 ml. of water, and cool the mixture in ice-water. Add a solution of 13 g. of anhydrous sodium carbonate in 40 ml. of water slowly to the mixture, stirring the latter with a 100° thermometer, and maintaining the temperature of the mixture at 20-25° meanwhile. The oxime rapidly separates. Stir the complete mixture at intervals, and after 10 minutes filter the oxime at the pump, drain thoroughly and dry it in a (vacuum) desiccator. Yield of crude oxime, 20 g. Recrystallise from petroleum (b.p. 100-120 ) and dry over paraffin wax (p. 19). Yield of pure oxime, 16 g., m.p. 88°. 

Note. Dimethylamine hydrochloride is a deliquescent substance the sample if damp must be dried in a vacuum desiccator and then rapidly weighed before use. 

Preparation of REAOENTS.t It is essential for this preparation that the zinc powder should be in an active condition. For this purpose, it is usually sufficient if a sample of ordinary technical zinc powder is vigorously shaken in a flask with pure ether, and then filtered off at the pump, washed once with ether, quickly drained and without delay transferred to a vacuum desiccator. If, however, an impure sample of zinc dust fails to respond to this treatment, it should be vigorously stirred in a beaker with 5% aqueous sodium hydroxide solution until an effervescence of hydrogen occurs, and then filtered at the pump, washed thoroughly with distilled water, and then rapidly with ethanol and ether, and dried as before in a vacuum desiccator. The ethyl bromoacetate (b.p. 159 ) and the benzaldehyde (b.p. 179 ) should be dried and distilled before use. 

Dissolve 8 8 g. (9 0 ml.) of cyclohexanone in 50 ml. of glacial acetic acid, add 8 ml. of phenylhydrazine, and boil the solution under reflux for 5 minutes. Cool the solution, when the tetrahydrocarbazole will crystallise out. Filter at the pump, drain well, and recrystallise either from aqueous ethanol or (better) from aqueous acetic acid. The recrystallisation should be performed rapidly, for the tetrahydrocarbazole undergoes atmO" spheric oxidation in hot solutions after recrystallisation, the compound should be dried in a vacuum desiccator and not in an oven. Repeated recrystallisation should be avoided. The tetrahydrocarbazole, after thorough drying, is obtained as colourless crystals, m.p. 118° yield of recrystallised material, 11 g. 

---