Hydroperoxides, organic

Present in foodstuffs and various pharmacological and cosmetics products, organic peroxides are also generated during lipid peroxidation and prostaglandin biosynthesis. They readily undergo one-electron reduction and oxidation reactions, with the formation of alkoxyl and peroxyl radicals, respectively  

In many early studies, it was assumed that peroxyl radical adducts of DMPO were responsible for spectra that looked very similar to that of the DMPO superoxide adduct (DMPO OOH), but it has since been shown that such spectra are from trapped primary alkoxyl radicals that arise via 02 addition to carbon-centred radicals arising, in turn, from the p-scission of secondary and tertiary alkoxyl radicals.131 Further evidence supporting the generation of DMPO adducts via these reactions has been furnished by Guo and colleagues, who have reported the HPLC/EPR and MS analysis of radical adducts formed from organic hydroperoxides.132 Peroxyl radical adducts of DMPO are in fact very unstable the BuOO adduct has been observed under continuous-flow conditions.133 

A major aspect of the cytotoxicity of organic hydroperoxides is their ability to decompose into free radicals which can stimulate autoxidation of organic molecules bearing labile hydrogen atoms. The autoxidation process may be decomposed in three basic steps  

In aerobic cells, polyunsaturated fatty acids of membrane phospholipids easily undergo such oxidative chain reactions [111,112]. This is because the double bonds of the polyunsaturated structure are repeatedly connected to each other by c/s-methylene units. Such bis-allylic structures enable electron delocalization on five carbon atoms, making the initial hydrogen abstraction on 

HNE[135]. In cultured human fibroblasts [136], exogenous 4-HNE is less toxic than linoleic acid hydroperoxide, but it is much more toxic than MDA[136]. 

---

Suitable catalysts are /-butylphenylmethyl peracetate and phenylacetjdperoxide or redox catalyst systems consisting of an organic hydroperoxide and an oxidizable sulfoxy compound. One such redox initiator is cumene—hydroperoxide, sulfur dioxide, and a nucleophilic compound, such as water. Sulfoxy compounds are preferred because they incorporate dyeable end groups in the polymer by a chain-transfer mechanism. Common thermally activated initiators, such as BPO and AIBN, are too slow for use in this process. 

As of this writing, the process has not been commercialized, but apparendy the alcohol can be separated from its propylene oxide coproduct process to maintain an economically competitive position. The formation of organic hydroperoxides is a concern, as it was in the Shell process. 

Organic hydroperoxides can be prepared by Hquid-phase oxidation of selected hydrocarbons in relatively high yield. Several cycHc processes for hydrogen peroxide manufacture from hydroperoxides have been patented (84,85), and others (86—88) describe the reaction of tert-huty hydroperoxide with sulfuric acid to obtain hydrogen peroxide and coproduct tert-huty alcohol or tert-huty peroxide. 

The hydroperoxide process involves oxidation of propjiene (qv) to propylene oxide by an organic hydroperoxide. An alcohol is produced as a coproduct. Two different hydroperoxides are used commercially that result in / fZ-butanol or 1-phenylethanol as the coproduct. The / fZ-butanol (TBA) has been used as a gasoline additive, dehydrated to isobutjiene, and used as feedstock to produce methyl tert-huty ether (MTBE), a gasoline additive. The 1-phenyl ethanol is dehydrated to styrene. ARCO Chemical has plants producing the TBA coproduct in the United States, Erance, and the Netherlands. Texaco has a TBA coproduct plant in the United States. Styrene coproduct plants are operated by ARCO Chemical in the United States and Japan, Shell in the Netherlands, Repsol in Spain, and Yukong in South Korea. 

The original SBR process is carried out at. 50° C and is referred to as hot polymerization. It accounts for only about 5% of aU the mbber produced today. The dominant cold polymerization technology today employs more active initiators to effect polymerization at about 5°C. It accounts for about 85% of the products manufactured. Typical emulsion polymerization processes incorporate about 75% butadiene. The initiators are based on persulfate in conjunction with mercaptans (197), or organic hydroperoxide in conjunction with ferrous ion (198). The rest of SBR is produced by anionic solution polymerization. The density of unvulcanized SBR is 0.933 (199). The T ranges from —59" C to —64 C (199). 

Glutathione peroxidase [9013-66-5] oxidizes glutathione, and helps to remove inorganic and organic hydroperoxides (221] It exhibits antiinflammatory activity in experimental uveitis of rats (234). 

Because the epoxidation with Tl(III) is stoichiometric to produce Tl(I), reoxidation is needed. Halcon has patented processes based on such epoxidation to yield ethylene oxide (200—203). The primary benefits of such a process are claimed to be high yields of ethylene oxide, fiexibihty to produce either propylene oxide or ethylene oxide, and the potential of a useful by-product (acetaldehyde). Advances usiag organic hydroperoxides ia place of oxygen for reoxidation offer considerable promise, siace reaction rates are rapid and low pressures can be used. 

Materials that promote the decomposition of organic hydroperoxide to form stable products rather than chain-initiating free radicals are known as peroxide decomposers. Amongst the materials that function in this way may be included a number of mercaptans, sulphonic acids, zinc dialkylthiophosphate and zinc dimethyldithiocarbamate. There is also evidence that some of the phenol and aryl amine chain-breaking antioxidants may function in addition by this mechanism. In saturated hydrocarbon polymers diauryl thiodipropionate has achieved a preeminent position as a peroxide decomposer. 

Organic peroxide-aromatic tertiary amine system is a well-known organic redox system 1]. The typical examples are benzoyl peroxide(BPO)-N,N-dimethylani-line(DMA) and BPO-DMT(N,N-dimethyl-p-toluidine) systems. The binary initiation system has been used in vinyl polymerization in dental acrylic resins and composite resins [2] and in bone cement [3]. Many papers have reported the initiation reaction of these systems for several decades, but the initiation mechanism is still not unified and in controversy [4,5]. Another kind of organic redox system consists of organic hydroperoxide and an aromatic tertiary amine system such as cumene hydroperoxide(CHP)-DMT is used in anaerobic adhesives [6]. Much less attention has been paid to this redox system and its initiation mechanism. A water-soluble peroxide such as persulfate and amine systems have been used in industrial aqueous solution and emulsion polymerization [7-10], yet the initiation mechanism has not been proposed in detail until recently [5]. In order to clarify the structural effect of peroxides and amines including functional monomers containing an amino group, a polymerizable amine, on the redox-initiated polymerization of vinyl monomers and its initiation mechanism, a series of studies have been carried out in our laboratory. 

Pavlinec and Lazar [39] reported that organic hydroperoxide and piperidine(PD) could be used as an initiator for MMA polymerization. In our laboratory, we also found that TBH-NMMP, TBH-NEMP [20], TBH-PD(piperidine) [31], TBH-NEP(N-ethylpiperdine) [31], TBH-TMDAPM (N,N -tertramethyl-diamin-odiphenyl-methane), and TBH-TMEDA(MN.NW -tera-methylethylenediamine) [15] systems could initiate MMA to polymerize. The kinetic equation of MMA polymerization initiated with CHP-DMT system has been investigated in our laboratory and the rate equation of polymerization is shown as follows ... 

Epoxidation systems based on molybdenum and tungsten catalysts have been extensively studied for more than 40 years. The typical catalysts - MoVI-oxo or WVI-oxo species - do, however, behave rather differently, depending on whether anionic or neutral complexes are employed. Whereas the anionic catalysts, especially the use of tungstates under phase-transfer conditions, are able to activate aqueous hydrogen peroxide efficiently for the formation of epoxides, neutral molybdenum or tungsten complexes do react with hydrogen peroxide, but better selectivities are often achieved with organic hydroperoxides (e.g., TBHP) as terminal oxidants [44, 45],... 

Also, see under Organic Hydroperoxides in Vol 7, H224-R to H227-R and under Ozonides in this Vol... 

The modified Sharpless reagent was also successfully applied288 for the asymmetric oxidation of a series of 1,3-dithiolanes 248 to their S-monooxides 249 (equation 134). It was observed that the optical induction on sulphur (e.e. from 68 to 83%) is not significantly affected by the substituents R1 and R2. Asymmetric oxidation of a few aryl methyl sulphides by organic hydroperoxides in the presence of a catalytic amount of the optically active Schiff base-oxovanadium(IV) complexes gave the corresponding sulphoxides with e.e. lower than 40%289. 

Polidoro G, Dillio C, Arduini A, et al. 1982. Glutathione peroxidase and glutathione S-transferase activities in human fetal tissues. Inability of acidic forms of glutathione S-transferase to catalyze the reduction of organic hydroperoxides. Biochem Int 4 637-645. 

Organic hydroperoxides, such as -butyl hydroperoxide, (0113)30—0-OH, likewise induce polymerization in vinyl monomers through the action of free radicals formed as primary intermediates in their decomposition. The following compounds, or classes of compounds, also are effective polymerization initiators at temperatures where they undergo slow thermal decomposition by mechanisms which are believed to involve the release of free radicals as indicated ... 

Vinyl monomers may be polymerized at favorable rates in an aqueous medium containing an emulsifier and a water-soluble initiator. A typical simple Tecipe would consist of the following ingredients with their proportions indicated in parts by weight 100 of monomer, 180 of water, 2 to 5 of a fatty acid soap, and 0.1 to 0.5 of potassium persulfate. Cationic soaps (e.g., dodecylamine hydrochloride) may be used instead of the fatty acid soap, and various other initiators may replace the persulfate (e.g., hydrogen peroxide and ferrous ion, or a water-soluble organic hydroperoxide). 

Organic hydroperoxides have also been used for the oxidation of sulphoxides to sulphones. The reaction in neutral solution occurs at a reasonable rate in the presence of transition metal ion catalysts such as vanadium, molybdenum and titanium - , but does not occur in aqueous media . The usual reaction conditions involve dissolution of the sulphoxide in alcohols, ethers or benzene followed by dropwise addition of the hydroperoxide at temperatures of 50-80 °C. By this method dimethyl sulphoxide and methyl phenyl sulphoxide have been oxidized to the corresponding sulphone in greater than 90% yields . A similar method for the oxidation of sulphoxides has been patented . Unsaturated sulphoxides are oxidized to the sulphone without affecting the carbon-carbon double bonds. A further patent has also been obtained for the reaction of dimethyl sulphoxide with an organic hydroperoxide as shown in equation (19). 

In the field of free radicals and liver injury there is a vast body of work concerning a group of compounds that have proven to be of great value as experimental models but are of little clinical significance. The most frequently used compounds are quinones (particularly menadione), paraquat and diquat, bromobenzene, and organic hydroperoxides, particularly cumene hydroperoxide and r-butyl hydroperoxide (see Poli et al., 1989b). 

The class II secreted fungal heme peroxidases include the LMPs LiP, MnP and VP [70]. All of these enzymes are extracellular and contain protoporphyrin IX (heme) as prosthetic group. They use H2O2 or organic hydroperoxides as electron accepting cosubstrates during the oxidation of diverse compounds. They are secreted as glycosilated, 35-38 kDa size proteins. 

Oxirane A general process for oxidizing olefins to olefin oxides by using an organic hydroperoxide, made by autoxidation of a hydrocarbon. Two versions are commercial. The first to be developed oxidizes propylene to propylene oxide, using as the oxidant f-butyl hydroperoxide made by the atmospheric oxidation of isobutane. Molybdenum naphthenate is used as a... 

In the field of enzyme catalysis, heme-proteins such as cytochrome P450, for example, exhibit both types of 0-0 bond cleavages in organic hydroperoxides and peroxy acids (178). Heterolytic cleavage of HOOH/ROOH yields H20 or the corresponding alcohol, ROH and a ferryl-oxo intermediate (Scheme 4). Homolytic 0-0 bond cleavage results in the formation of a hydroxyl (HO ) or an alkoxyl (RO ) radical and an iron-bound hydroxyl radical. 

The kinetics and mechanism of decomposition of organic hydroperoxides in presence of transition metal complexes has been reviewed. 

---