Tert methyl

The mobile phase is usually based on pentane or hexane, containing modifiers, such as dichlorometh-ane, methyl tert. methyl ether, or alcohols. Pentane is important because of its easy purification, the absence of oxidation products, and the ease of transfer to GC. Also, polar solvents can be used as long as they are free of water. 

Kinetic data are available for the nitration of a series of p-alkylphenyl trimethylammonium ions over a range of acidities in sulphuric acid. - The following table shows how p-methyl and p-tert-h xty augment the reactivity of the position ortho to them. Comparison with table 9.1 shows how very much more powerfully both the methyl and the tert-butyl group assist substitution into these strongly deactivated cations than they do at the o-positions in toluene and ferf-butylbenzene. Analysis of these results, and comparison with those for chlorination and bromination, shows that even in these highly deactivated cations, as in the nitration of alkylbenzenes ( 9.1.1), the alkyl groups still release electrons in the inductive order. In view of the comparisons just... 

Note 1. The lithiation of monoalky1al 1 enes is not completely regiospecific. The ratio of a- to ylithiated allene varies from about 80 20 for methyl-allene to 93 7 for hexylallene. tert.-Butylallene, however, is metallated exclusively on the terminal carbon atom. 

To a mixture of 50 ml of dry THF and 0.050 mol of l-tert.-butoxy-2-pentyne (prepared by ethylation of HC-CCH O-tert.-Ci,H9 in liquid ammonia was added 0.055 mol of butyilithium in about 35 ml of hexane in 10 min at -30°C. After stirring for 20 min at -25°C the solution was cooled to -50°C and 0.06 mol of methyl iodide was added in one portion, followed 10 min later by 50 ml of water. The aqueous layer was separated and extracted twice with diethyl ether. The solutions were dried over magnesium sulfate and concentrated in a water-pump vacuum. 

The rate of the reaction decreases with increasing number of substituents in the acetylenic halide, and it is higher with acetylenic bromides than with the corresponding chlorides. Methyl magnesium iodide gives equal amounts of 1,1- and 1,3--substitution products, whereas tert.-butylmagnesium bromide does not react. However, for some tert.-butyl substituted allenes there exists an attractive com-... 

If a disubstituted cyclohexane has two different substituents then the most stable conformation is the chair that has the larger substituent m an equatorial orientation This IS most apparent when one of the substituents is a bulky group such as tert butyl Thus the most stable conformation of cis 1 tert butyl 2 methylcyclohexane has an equatorial tert butyl group and an axial methyl group... 

Add methyl group to axial position at C 3 so that It IS trans to tert butyl group... 

The properties of tert butyl cation can be understood by focusing on its structure which IS shown m Figure 4 9 With only six valence electrons which are distributed among three coplanar ct bonds the positively charged carbon is sp hybridized The unhybridized 2p orbital that remains on the positively charged carbon contains no elec Irons Its axis is perpendicular to the plane of the bonds connecting that carbon to the three methyl groups... 

FIGURE 4 9 tert Butyl cation (a) The positively charged carbon is sp hybridized Each methyl group IS attached to the positively charged carbon by a cr bond and these three bonds he in the same plane (b) The sp hybridized car bon has an empty 2p orbital the axis of which is perpen dicular to the plane of the carbon atoms... 

Methyl cation Ethyl cation (primary) Isopropyl cation (secondary) tert Butyl cation (tertiary)... 

Of the two extremes experimental studies indicate that the planar sp model describes the bonding m alkyl radicals better than the pyramidal sp model Methyl rad ical IS planar and more highly substituted radicals such as tert butyl radical are flattened pyramids closer m shape to that expected for sp hybridized carbon than for sp ... 

Similarly sodium methoxide (NaOCHj) is a suitable base and is used m methyl alco hoi Potassium hydroxide m ethyl alcohol is another base-solvent combination often employed m the dehydrohalogenation of alkyl halides Potassium tert butoxide [K0C(CH3)3] is the preferred base when the alkyl halide is primary it is used m either tert butyl alcohol or dimethyl sulfoxide as solvent... 

Together these two products contain all eight carbons of the starting alkene The two carbonyl carbons correspond to those that were doubly bonded m the original alkene One of the doubly bonded carbons therefore bears two methyl substituents the other bears a hydrogen and a tert butyl group The alkene is identified as 2 4 4 trimethyl 2 pentene (CH3)2C=CHC(CH3)3 as shown m Figure 6 15... 

The first order rate constant for ethanolysis of the allylic chloride 3 chloro 3 methyl 1 butene is over 100 times greater than that of tert butyl chloride at the same temperature... 

Both compounds react by an S l mechanism and their relative rates reflect their acti vation energies for carbocation formation Because the allylic chloride is more reactive we reason that it ionizes more rapidly because it forms a more stable carbocation Struc turally the two carbocations differ m that the allylic carbocation has a vinyl substituent on Its positively charged carbon m place of one of the methyl groups of tert butyl cation... 

The reaction of N bromosuccimmide with the following com pounds has been reported in the chemical literature Each compound yields a single product in 95% yield Identify the product formed from each starting material (a) p-tert Butyltoluene (b) 4 Methyl 3 nitroanisole... 

All alkyl groups not just methyl are activating substituents and ortho para direc tors This IS because any alkyl group be it methyl ethyl isopropyl tert butyl or any other stabilizes a carbocation site to which it is directly attached When R = alkyl... 

When two positions are comparably activated by alkyl groups substitution usually occurs at the less hindered site Nitration of p tert butyltoluene takes place at positions ortho to the methyl group m preference to those ortho to the larger tert butyl group This IS an example of a stenc effect... 

---