Fatty polyamines

Related to these compounds are alkyl polyamino car-boxylates, which can be derived from fatty polyamines. 

Emulsifiers are incorporated in oil and synthetic mud formulations to maintain a stable emulsion of the internal brine phase. These materials include calcium and magnesium soaps of fatty acids and polyamines and amides and their mixtures (123,127). The specific chemistry of these additives depends on the nature of the continuous phase of the mud, ie, whether diesel oil, mineral oil, or a synthetic Hquid. Lime is added along with the fatty acid to form the... 

Substituted Amides. Monosubstituted and disubstituted amides can be synthesized with or without solvents from fatty acids and aLkylamines. Fatty acids, their esters, and acid halides can be converted to substituted amides by reaction with primary or secondary aLkylamines, arylamines, polyamines, or hydroxyaLkylamines (30). Di- -butylamine reacts with oleic acid (2 1 mole ratio) at 200—230°C and 1380 kPa (200 psi) to produce di-A/-butyloleamide. Entrained water with excess -butylamine is separated for recycling later (31). 

Dermal Toxicity. Fatty alkylamines are not considered especially toxic with regard to skin penetration and systemic absorption into the body certain polyamines may be absorbed through the skin to a much greater degree. The acute dermal LD q of decylamine in rabbits has been reported to be... 

Fats, Oils, or Fatty Acids. The primary products produced direcdy from fats, oils, or fatty acids without a nitrile iatermediate are the quatemized amidoamines, imidazolines, and ethoxylated derivatives (Fig. 3). Reaction of fatty acids or tallow with various polyamines produces the iatermediate dialkylarnidoarnine. By controlling reaction conditions, dehydration can be continued until the imidazoline is produced. Quaternaries are produced from both amidoamines and imidazolines by reaction with methyl chloride or dimethyl sulfate. The amidoamines can also react with ethylene oxide (qv) to produce ethoxylated amidoamines which are then quaternized. 

Additives for lubricating oils providing a combination of viscosity index improvement (VII) and dispersancy have also been reported. These additives are prepared from ethyleneamines by reaction with various Vll-type polymers that have been chlorinated or modified in some other way to provide an ethyleneamine reaction site. Antimst additives for lubricating oils have been prepared by reaction of polyamines with fatty acids followed by reaction with polyalkylenesuccinic anhydrides (178,179). 

Other modifications of the polyamines include limited addition of alkylene oxide to yield the corresponding hydroxyalkyl derivatives (225) and cyanoethylation of DETA or TETA, usuaHy by reaction with acrylonitrile [107-13-1/, to give derivatives providing longer pot Hfe and better wetting of glass (226). Also included are ketimines, made by the reaction of EDA with acetone for example. These derivatives can also be hydrogenated, as in the case of the equimolar adducts of DETA and methyl isobutyl ketone [108-10-1] or methyl isoamyl ketone [110-12-3] (221 or used as is to provide moisture cure performance. Mannich bases prepared from a phenol, formaldehyde and a polyamine are also used, such as the hardener prepared from cresol, DETA, and formaldehyde (228). Other modifications of polyamines for use as epoxy hardeners include reaction with aldehydes (229), epoxidized fatty nitriles (230), aromatic monoisocyanates (231), or propylene sulfide [1072-43-1] (232). 

Polyamide Resins. Another class of polyamide resins, in addition to the Hquid resins used as epoxy hardeners, are the thermoplastic type, prepared generaHy by the condensation reaction of polyamines with polybasic fatty acids. These resins find use in certain hot-melt adhesives, coatings, and inks. Diamines, typicaHy EDA (233), are the principal amine reactant however, tri- and tetramines are sometimes used at low levels to achieve specific performance. 

Fabric Softeners, Surfactants and Bleach Activators. Mono- and bisamidoamines and their imidazoline counterparts are formed by the condensation reaction of one or two moles of a monobasic fatty acid (typically stearic or oleic) or their methyl esters with one mole of a polyamine. Imidazoline formation requires that the ethyleneamine have at least one segment in which a secondary amine group Hes adjacent to a primary amine group. These amidoamines and imidazolines form the basis for a wide range of fabric softeners, surfactants, and emulsifiers. Commonly used amines are DETA, TETA, and DMAPA, although most of the polyethylene and polypropane polyamines can be used. 

Many of the surfactants made from ethyleneamines contain the imidazoline stmcture or are prepared through an imidazoline intermediate. Various 2-alkyl-imidazolines and their salts prepared mainly from EDA or monoethoxylated EDA are reported to have good foaming properties (292—295). Ethyleneamine-based imida zolines are also important intermediates for surfactants used in shampoos by virtue of their mildness and good foaming characteristics. 2- Alkyl imidazolines made from DETA or monoethoxylated EDA and fatty acids or their methyl esters are the principal commercial intermediates (296—298). They are converted into shampoo surfactants commonly by reaction with one or two moles of sodium chloroacetate to yield amphoteric surfactants (299—301). The ease with which the imidazoline intermediates are hydrolyzed leads to arnidoamine-type stmctures when these derivatives are prepared under aqueous alkaline conditions. However, reaction of the imidazoline under anhydrous conditions with acryflc acid [79-10-7] to make salt-free, amphoteric products, leaves the imidazoline stmcture essentially intact. Certain polyamine derivatives also function as water-in-oil or od-in-water emulsifiers. These include the products of a reaction between DETA, TETA, or TEPA and fatty acids (302) or oxidized hydrocarbon wax (303). The amidoamine made from lauric acid [143-07-7] and DETA mono- and bis(2-ethylhexyl) phosphate is a very effective water-in-od emulsifier (304). 

The derivatives used in corrosion inhibitor formulations for down-hole use constitute a significant industrial appHcation for polyamines. Again, mono- and bisarnidoamines, imidazolines, and polyamides made from the higher polyamines are the popular choices. The products made from DETA and fatty acids have been widely used (308). A wide variety of other polyamine-based, corrosion inhibiting derivatives have been developed, generally incorporating some form of oil-soluble or od-dispersible residue. Sulfur and its derivatives are also used in these polyamine-based corrosion inhibitors on... 

Polyamides provide RT cure of epoxy-terrninated resins as weU as flexibiHzation they are derived by reaction of dimerized vegetable oil fatty acids (dimer acids) with polyamines. 

The simplest polyamines are the aliphatic types such as diaminoethane, but these readily carbonate when exposed to the atmosphere as a thin him, so adducts (pre-reacted epoxy polyamines) are preferred. An alternative system is the polyaminoamides which are made by reacting dimerised fatty acids with an excess of polyamine. These themselves act as corrosion inhibitors and are noted for excellent adhesion. 

Amines are ammonia derivatives in which one or more hydrogen atoms have been replaced by an organic radical. Amines are sometimes called nitrogen bases. Basic chemistries include fatty amines (as primary, secondary, tertiary, and polyamines), amine salts, quaternary ammonium compounds, amine oxides, and amides. 

Quatemized imidazolines with an amido moiety are suitable formulations for general oil and gas field applications. The synthesis of such compounds is detailed in the literature [1218]. For aqueous systems that contain sulfide compounds, a mixture has been described [262] that consists of an aqueous solution of an alcohol such as diethylene glycol monobutyl ether, butyl cellosolve, additional orthophosphoric acid, a fatty acid (from tall oil), substituted imidazoline, an ethoxylated fatty diamine (polyamines such as ethylenediamine, diethylenetriamine, etc.), and a molybdate compound. 

Branched polyesters contain oxalkylated primary fatty amines or oxalkyl-ated polyamines together with at least trivalent oxalkylated alkanol that is responsible for branching. The condensation is achieved with a dicarboxylic acid or a dicarboxylic acid anhydride [216]. In this way, branched polyoxyalkylene mixed polyesters are formed. Suitable solvents are water or organic solvents, such as methanol, isopropanol, butanol, or aromatic hydrocarbons (e.g., toluene, xylene). 

One type of cationic surfactant was the fatty acid derivatives of polyamines. The properties of the derivatives of fatty acids and ethylenediamine have been described in the literature (7-9). It appeared from these reports that the 2-alkyl-2-imidazolines would not impart sufficient hydrophobicity to soils. However, the analogous series of homologous compounds from the fatty acids and diethylene-triamine (BETA) appeared likely to do so because of their higher molecular weight. 

Emulsifiers and wetting agents (detergents and/or surfactants) are composed of anionic, cationic, or nonionic detergents, metal soaps, polyamines, and tall oils or fatty acids [28]. They facilitate the formation of a stable dispersion of insoluble liquids in water (invert-emulsion). Wetting agents are used to ensure that the solids in mud... 

Fabric softeners - [ALKANOLAMOSIES - ALKANOLAMINES FROM OLEFIN OXIDES AND AMMONIA] (Vol 2) - [AMINES - FATTY AMINES] (Vol 2) - [SUGARALCOHOLS] (Vol 23) -from polyamines [DIAMINES AND HIGHER AMINES ALIPHATIC] (Vol 8)... 

Amines. Aliphatic mono-, di-, and polyamines derived from fatty and main acids make up this class of surfactants. Primary, secondary, and tertiary monoamines with Qg alkyl or alkenyl chains constitute the bulk of diis class. The products are sold as acetates, naphdienales, or oleates. Principal uses are as ore-flotation agents, corrosion inhibitors, dispersing agents, wetting agents for asphalt, and as intermediates for the production of more highly substituted derivatives... 

---