Catalytic converter vehicles

Several parameters come into the relation between density and equivalence ratio. Generally, the variations act in the following sense a too-dense motor fuel results in too lean a mixture causing a potential unstable operation a motor fuel that is too light causes a rich mixture that generates greater pollution from unburned material. These problems are usually minimized by the widespread use of closed loop fuel-air ratio control systems installed on new vehicles with catalytic converters. 

The lead alkyls and scavengers contained in fuels cause rapid poisoning ol exhaust gas catalytic converters. They are tolerated only in trace quantities in fuels for vehicles having that equipment. The officially allowed content is 0.013 g Pb/1, but the contents observed in actual practice are less than 0.005 g Pb/1. 

As of 1 July 1991 all new vehicles registered in Europe should have been adapted for using Eurosuper. However, another quality of unleaded fuel had already appeared in 1988 and has since been well established in some countries, notably France. It is called Superplus, the highest octane level, RON 98, MON 88. Superplus is suitable for vehicles having catalytic converters as well as for a large part of the former automotive fleet requiring an RON of 97 and higher. 

However, such a level can still be considered too high for vehicles having 3-way catalytic converters. In fact, results observed in the United States (Benson et al., 1991) and given in Figure 5.20 show that exhaust pollutant emissions, carbon monoxide, hydrocarbons and nitrogen oxides, increase from 10 to 15% when the sulfur level passes from 50 ppm to about 450 ppm. This is explained by an inhibiting action of sulfur on the catalyst though... 

The implementation of very effective devices on vehicles such as catalytic converters makes extremely low exhaust emissions possible as long as the temperatures are sufficient to initiate and carry out the catalytic reactions however, there are numerous operating conditions such as cold starting and... 

Although the naturally occurring concentration of ozone at the earth s surface is low, the distribution has been altered by the emission of pollutants, primarily by automobiles but also from industrial sources which lead to the formation of ozone. The strategy for controlling ambient ozone concentrations arising from automobile exhaust emissions is based on the control of hydrocarbons, CO, and NO via catalytic converters. As a result, peak ozone levels in Los Angeles, for instance, have decreased from 0.58 ppm in 1970 to 0.33 ppm in 1990, despite a 66% increase in the number of vehicles. 

On-Board Diagnostics. State of California regulations require that vehicle engines and exhaust emission control systems be monitored by an on-board system to assure continued functional performance. The program is called OBD-II, and requires that engine misfire, the catalytic converter, and the evaporative emission control system be monitored (101). The U.S. EPA is expected to adopt a similar regulation. 

Emission Control Technologies. The California low emission vehicle (LEV) standards has spawned iavestigations iato new technologies and methods for further reducing automobile exhaust emissions. The target is to reduce emissions, especially HC emissions, which occur during the two minutes after a vehicle has been started (53). It is estimated that 70 to 80% of nonmethane HCs that escape conversion by the catalytic converter do so during this time before the catalyst is fully functional. 

Catalytic Converter an air pollution abatement device that removes pollutants from motor vehicle exhaust either by oxidizing them into carbon dioxide and water or reducing them to nitrogen. A typical catalytic oxidizer for auto emission control is illustrated in the sidebar figure. 

Besides cleaner fuels, vehicle makers have developed many emission-reducing technologies—both in cleaner combustion and in catalytic converter technologies—to comply with ever stricter tailpipe emission standards. The U.S. EPA stringent standards proposed in 1999 for model year 2004 vehicles will result in new vehicles emitting less than 1 percent of the VOC and NO, emissions of their 1960s counterparts. 

Photochemical smogs arise worldwide because of the action of sunlight on emissions from gasoline-powered vehicles. Decreased visibility, increased morbidity, and crop damage as a result of photochemical smogs led to introduction of the catalytic converter on automobiles in the United States. This has had only a small impact on the occurrence of photochemical smogs in the United States. 

Probably the most significant control technology breakthrough came m 1977, when Volvo released a computer-controlled, fuel-mjected vehicle equipped with a three-way catalyst. The new catalytic converters employed platinum, palladium, and rhodium to simultaneously reduce NO and oxidize CO and HC emissions under carefully controlled oxygen conditions. The new Bosch fuel injection system on the vehicle provided the precise air/fuel control necessary for the new catalyst to perform effectively. The combined fuel control and three-way catalyst system served as the foundation for emissions control on the next generation of vehicles. 

To counter the elevated emissions associated with enrichment, the EPA has adopted supplemental federal test procedures. The new laboratory test procedures contain higher speeds, higher acceleration and deceleration rates, rapid speed changes, and a test that requires the air conditioning to be in operation. These tests increase the probability that vehicles will go into enrichment under laboratory test conditions. Hence, manufacturers have an incentive to reduce the frequency of enrichment occurrence in the real world. Future catalytic converters and emissions control systems will be resistant to the high-temperature conditions associated with engine load, and will be less likely to require enrichment for protection. Thus, enrichment contributions to emissions will continue to decline. 

Air pollution from exhaust emissions NO t and particulate matter from exhaust emissions causing air pollution are -1% at present. By adoption of better combustion control technology, better quality fuels (or even fuel cell-based motor vehicles), and more efficient catalytic converters, researchers aim to mitigate this problem. 

Emission control from heavy duty diesel engines in vehicles and stationary sources involves the use of ammonium to selectively reduce N O, from the exhaust gas. This NO removal system is called selective catalytic reduction by ammonium (NH3-SGR) and it is additionally used for the catalytic oxidation of GO and HGs.The ammonia primarily reacts in the SGR catalytic converter with NO2 to form nitrogen and water. Excess ammonia is converted to nitrogen and water on reaction with residual oxygen. As ammonia is a toxic substance, the actual reducing agent used in motor vehicle applications is urea. Urea is manufactured commercially and is both ground water compatible and chemically stable under ambient conditions [46]. 

Transportation - production of gasoline and diesel from petroleum, fuel additives for greater efficiency and reduced emissions, catalytic converters, plastics to reduce vehicle weight and improve energy efficiency. 

Catalytic treatment of motor vehicle exhaust has been applied in all passenger cars in the USA since the 1975 models. The first cars with electronic feedback systems and three-way catalysts were 1979 Volvos, sold in California. Today all new gasoline cars sold in the Western world are equipped with catalytic converters. It... 

Ukrainian Catalytic Converter developed in Kiev. Being similar to its Western counterparts in performance, the device will be less expensive. Ukraine committed itself to the European Union that all its vehicles would be equipped with catalytic converters by 2003. 

ARCO has marketed a reformulated gasoline, EC-1 Regular (emission control-1), for older vehicles without catalytic converters, in southern California. These older vehicles were only a small segment of the total car and truck population in the region but produced about a third of the air pollution. ARCO has also marketed a premium reformulated gasoline, EC-Premium. The EPA estimated that the ARCO reformulated gasolines reduced air pollution by almost 150 tons a day in southern California. 

---