Closed loops

Several parameters come into the relation between density and equivalence ratio. Generally, the variations act in the following sense a too-dense motor fuel results in too lean a mixture causing a potential unstable operation a motor fuel that is too light causes a rich mixture that generates greater pollution from unburned material. These problems are usually minimized by the widespread use of closed loop fuel-air ratio control systems installed on new vehicles with catalytic converters. 

The principle of operation of the hydraulic reciprocating pump is similar to the beam pump, with a piston-like sub-surface pump action. The energy to drive the pump, however, is delivered through a hydraulic medium, the power fluid, commonly oil or water. The power fluid drives a downhole hydraulic motor which in turn drives the pump. A separate surface pump delivers the hydraulic power. The power fluid system can be of the closed loop or of the open type. In the latter case, the power fluids are mixed with the produced fluid stream. The performance of the hydraulic pump is primarily monitored by measuring the discharge pressures of both surface and sub-surface pumps. 

Attractors can be simple time-independent states (points in F), limit cycles (simple closed loops in F) corresponding to oscillatory variations of tire chemical concentrations with a single amplitude, or chaotic states (complicated trajectories in F) corresponding to aperiodic variations of tire chemical concentrations. To illustrate... 

Let S be any simply connected surface in nuclear configuration space, bounded by a closed-loop L. Then, if 4>(r,R) changes sign when transported adiabatically round L, there must be at least one point on S at which (r, R) is discontinuous, implying that its potential energy surface intersects that of another electronic state. 

The phase-change nale, also known as the Ben phase [101], the geometric phase effect [102,103] or the molecular Aharonov-Bohm effect [104-106], was used by several authors to verify that two near-by surfaces actually cross, and are not repelled apart. This point is of particular relevance for states of the same symmetry. The total electronic wave function and the total nuclear wave function of both the upper and the lower states change their phases upon being bansported in a closed loop around a point of conical intersection. Any one of them may be used in the search for degeneracies. 

As discussed in detail in [10], equivalent results are not obtained with these three unitary transformations. A principal difference between the U, V, and B results is the phase of the wave function after being h ansported around a closed loop C, centered on the z axis parallel to but not in the (x, y) plane. The pertm bative wave functions obtained from U(9, <])) or B(0, <()) are, as seen from Eq. (26a) or (26c), single-valued when transported around C that is ( 3 )(r Ro) 3< (r R )) = 1, where Ro = Rn denote the beginning and end of this loop. This is a necessary condition for Berry s geometric phase theorem [22] to hold. On the other hand, the perturbative wave functions obtained from V(0, <])) in Eq. (26b) are not single valued when transported around C. 

When the gas available for regeneration is in short supply, the regeneration steps ate often carried out in a closed loop. This recycle of the bed effluent back to the inlet has the advantage of concentrating the impurity and making it easier to separate by condensation or other recovery means. 

Fig. 3. Comtrack 921 pipe prover. Liquid flow through the Comtrak s closed loop is created by the movement of a sealed piston. Flow meters being tested are installed in the loop upstream from the piston. As the piston advances, the caUbration fluid travels through the meters and returns to the back side of...

Fig. 10. An idealized view of an HDR heat mine. Water circulating ia a closed loop is heated as it passes through fractures ia the hot rock. The energy is...

In the former USSR, there reportedly are two technologies in use one is old anthrahydroquinone autoxidation technology and the other is closed-loop isopropyl alcohol oxidation technology. Production faciUties include several smaller, 100-150-t/yr isopropyl alcohol oxidation plants and a larger, 15,000-t/yr plant, which reportedly is being expanded to 30,000-t/yr. Differences in this technology as compared to the Shell Chemical Co. process are the use of oxygen-enriched air in the oxidation step and, catalytic reduction of the coproduct acetone back to isopropyl alcohol per equation 21. 

One variation in dye laser constmction is the ring dye laser. The laser cavity is a reentrant system, so that the laser light can circulate in a closed loop. The ring stmcture provides a high degree of stabiUty and a narrow spectral width. The spectral width of a conventional dye laser on the order of 40 GH2 is narrowed to a value as small as a few MH2. Such systems offer very high resolution in spectroscopic appHcations. 

Nickel sulfate also is made by the reaction of black nickel oxide and hot dilute sulfuric acid, or of dilute sulfuric acid and nickel carbonate. The reaction of nickel oxide and sulfuric acid has been studied and a reaction induction temperature of 49°C deterrnined (39). High purity nickel sulfate is made from the reaction of nickel carbonyl, sulfur dioxide, and oxygen in the gas phase at 100°C (40). Another method for the continuous manufacture of nickel sulfate is the gas-phase reaction of nickel carbonyl and nitric acid, recovering the soHd product in sulfuric acid, and continuously removing the soHd nickel sulfate from the acid mixture (41). In this last method, nickel carbonyl and sulfuric acid are fed into a closed-loop reactor. Nickel sulfate and carbon monoxide are produced the CO is thus recycled to form nickel carbonyl. 

Solids. Increasing use of bulk cars, especially of covered hopper cars, has accompanied the expansion of the tank-car fleet. The principal drawback of bulk cars is the requirement for limited use, specialized cars, which necessitates a large investment. However, if such investment can be justified, the cost of transportation for dry bulk materials ia hopper cars usually is less than those for goods ia shipping containers. In many instances, such cars are used in closed-loop service that is, they shuttle in unit trains between filling and discharge points. Similar equipment is also used in specialized highway vehicles whose tmck bodies can incorporate dump hoppers and built-in conveyors. 

The response time is equal to the ZC product, where Cis the diode capacitance, or when using an integrating amplifier, the response time is determined by the closed loop gain. 

One of the most vexing aspects of pilot-plant work can be feed and product handling as a pilot plant is neither designed nor operated as a closed-loop system like a commercial plant. Indeed, the problems involved in handling and storing feed and product materials can sometimes seem to rival the pilot-plant process problems in difficulty. 

In a three-dimensional system, an anchor involves three forces and three moments in the direction of each main axis, a directional restraint involves one force, whereas a closed loop involves three forces and three moments. Because each force or moment is counted as one unknown, a system has... 

Fossil Fuel-Fired Plants. In modem, fossil fuel-fired power plants, the Rankine cycle typically operates as a closed loop. In describing the steam—water cycle of a modem Rankine cycle plant, it is easiest to start with the condensate system (see Fig. 1). Condensate is the water that remains after the steam employed by the plant s steam turbines exhausts into the plant s condenser, where it is collected for reuse in the cycle. Many modem power plants employ a series of heat exchangers to boost efficiency. As a first step, the condensate is heated in a series of heat exchangers, usually sheU-and-tube heat exchangers, by steam extracted from strategic locations on the plant s steam turbines (see HeaT-EXCHANGETECHNOLOGy). 

Technology has been introduced for on-line estimation of the kappa number based on absorption of ultraviolet light (35). This breakthrough ia optical sensor technology permits closed-loop feedback control of digesters from on-line measurement of the kappa number. 

---