Methylated, quantitation

The other peaks demonstrate the power of NMR to identify and quantitate all the components of a sample. This is very important for die phannaceutical industry. Most of the peaks, including a small one accidentally underlying the methyl resonance of paracetamol, arise from stearic acid, which is connnonly added to paracetamol tablets to aid absorption. The integrals show diat it is present in a molar proportion of about 2%. The broader peak at 3.4 ppm is from water, present because no attempt was made to dry the sample. Such peaks may be identified either by adding fiirther amounts of the suspected substance, or by the more fiindamental methods to be outlined below. If the sample were less concentrated, then it would also be... 

I he methyl iodide is transferred quantitatively (by means of a stream of a carrier gas such as carbon dioxide) to an absorption vessel where it either reacts with alcoholic silver nitrate solution and is finally estimated gravimetrically as Agl, or it is absorbed in an acetic acid solution containing bromine. In the latter case, iodine monobromide is first formed, further oxidation yielding iodic acid, which on subsequent treatment with acid KI solution liberates iodine which is finally estimated with thiosulphate (c/. p. 501). The advantage of this latter method is that six times the original quantity of iodine is finally liberated. 

The first quantitative studies of the nitration of quinoline, isoquinoline, and cinnoline were made by Dewar and Maitlis, who measured isomer proportions and also, by competition, the relative rates of nitration of quinoline and isoquinoline (1 24-5). Subsequently, extensive kinetic studies were reported for all three of these heterocycles and their methyl quaternary derivatives (table 10.3). The usual criteria established that over the range 77-99 % sulphuric acid at 25 °C quinoline reacts as its cation (i), and the same is true for isoquinoline in 71-84% sulphuric acid at 25 °C and 67-73 % sulphuric acid at 80 °C ( 8.2 tables 8.1, 8.3). Cinnoline reacts as the 2-cinnolinium cation (nia) in 76-83% sulphuric acid at 80 °C (see table 8.1). All of these cations are strongly deactivated. Approximate partial rate factors of /j = 9-ox io and /g = i-o X io have been estimated for isoquinolinium. The unproto-nated nitrogen atom of the 2-cinnolinium (ina) and 2-methylcinno-linium (iiiA) cations causes them to react 287 and 200 more slowly than the related 2-isoquinolinium (iia) and 2-methylisoquinolinium (iii)... 

The nucleophilic reacbvity of the C-5 oxygen is well documented however, no quantitative data are available. A-2-Thiazoline-5-ones (212) react at oxygen with acetyl chloride or acetic anhydride (447. 452). benzoyl chloride (447). methyl or phenyl isocyanate (467). carbamoyl chloride (453, 467). or phosphorus derivatives (468, 428) in the presence of bases to give 213, 214, 215. or 216 (Scheme 109). Strong bases such as... 

In practice this reaction is difficult to carry out with simple aldehydes and ketones because aldol condensation competes with alkylation Furthermore it is not always possi ble to limit the reaction to the introduction of a single alkyl group The most successful alkylation procedures use p diketones as starting materials Because they are relatively acidic p diketones can be converted quantitatively to their enolate ions by weak bases and do not self condense Ideally the alkyl halide should be a methyl or primary alkyl halide... 

Noncatalytic Reactions Chemical kinetic methods are not as common for the quantitative analysis of analytes in noncatalytic reactions. Because they lack the enhancement of reaction rate obtained when using a catalyst, noncatalytic methods generally are not used for the determination of analytes at low concentrations. Noncatalytic methods for analyzing inorganic analytes are usually based on a com-plexation reaction. One example was outlined in Example 13.4, in which the concentration of aluminum in serum was determined by the initial rate of formation of its complex with 2-hydroxy-1-naphthaldehyde p-methoxybenzoyl-hydrazone. ° The greatest number of noncatalytic methods, however, are for the quantitative analysis of organic analytes. For example, the insecticide methyl parathion has been determined by measuring its rate of hydrolysis in alkaline solutions. 

Methyl mercaptan adds to acrolein in neatly quantitative yields in the presence of a variety of basic catalysts (72,73). Other aLkylmercaptopropionaldehydes produced by the reaction of acrolein with a mercaptan are known. Table 8 Hsts a variety of these and their boiling points (74). 

Mechanical and Thermal Properties. The first member of the acrylate series, poly(methyl acrylate), has fltde or no tack at room temperature it is a tough, mbbery, and moderately hard polymer. Poly(ethyl acrylate) is more mbberflke, considerably softer, and more extensible. Poly(butyl acrylate) is softer stiU, and much tackier. This information is quantitatively summarized in Table 2 (41). In the alkyl acrylate series, the softness increases through n-octy acrylate. As the chain length is increased beyond n-octy side-chain crystallization occurs and the materials become brittle (42) poly( -hexadecyl acrylate) is hard and waxlike at room temperature but is soft and tacky above its softening point. 

Because the polymerization occurs totally within the monomer droplets without any substantial transfer of materials between individual droplets or between the droplets and the aqueous phase, the course of the polymerization is expected to be similar to bulk polymerization. Accounts of the quantitative aspects of the suspension polymerization of methyl methacrylate generally support this model (95,111,112). Developments in suspension polymerization, including acryUc suspension polymers, have been reviewed (113,114). 

Instmmental methods of analysis provide information about the specific composition and purity of the amines. QuaUtative information about the identity of the product (functional groups present) and quantitative analysis (amount of various components such as nitrile, amide, acid, and deterruination of unsaturation) can be obtained by infrared analysis. Gas chromatography (gc), with a Hquid phase of either Apiezon grease or Carbowax, and high performance Hquid chromatography (hplc), using siHca columns and solvent systems such as isooctane, methyl tert-huty ether, tetrahydrofuran, and methanol, are used for quantitative analysis of fatty amine mixtures. Nuclear magnetic resonance spectroscopy (nmr), both proton ( H) and carbon-13 ( C), which can be used for quaHtative and quantitative analysis, is an important method used to analyze fatty amines (8,81). 

Early Synthesis. Reported by Kolbe in 1859, the synthetic route for preparing the acid was by treating phenol with carbon dioxide in the presence of metallic sodium (6). During this early period, the only practical route for large quantities of sahcyhc acid was the saponification of methyl sahcylate obtained from the leaves of wintergreen or the bark of sweet bitch. The first suitable commercial synthetic process was introduced by Kolbe 15 years later in 1874 and is the route most commonly used in the 1990s. In this process, dry sodium phenate reacts with carbon dioxide under pressure at elevated (180—200°C) temperature (7). There were limitations, however not only was the reaction reversible, but the best possible yield of sahcyhc acid was 50%. An improvement by Schmitt was the control of temperature, and the separation of the reaction into two parts. At lower (120—140°C) temperatures and under pressures of 500—700 kPa (5—7 atm), the absorption of carbon dioxide forms the intermediate phenyl carbonate almost quantitatively (8,9). The sodium phenyl carbonate rearranges predominately to the ortho-isomer. sodium sahcylate (eq. 8). 

In contrast to the hydrolysis technology, the methanolysis process allows for the one-step synthesis of organosdoxane oligomers and methyl chloride without formation of hydrochloric acid (64,65). The continuous methanolysis can also yield quantitatively linear sdanol-stopped oligomers by recycle of the cycHc fraction into the hydrolysis loop. 

The dimsyl ion also adds to carbon—carbon double bonds, and if the mixture is heated for several hours, methanesulfenate is eliminated. The overall result is methylation, and for compounds such as quinoline or isoquinoline (eq. 20), yields ate neady quantitative (50). The reaction sequence for isoquinoline to 1-methyhsoquinoline is as follows ... 

Later it was synthesized in a batch process from dimethyl ether and sulfur thoxide (93) and this combination was adapted for continuous operation. Gaseous dimethyl ether was bubbled at 15.4 kg/h into the bottom of a tower 20 cm in diameter and 365 cm high and filled with the reaction product dimethyl sulfate. Liquid sulfur thoxide was introduced at 26.5 kg/h at the top of the tower. The mildly exothermic reaction was controlled at 45—47°C, and the reaction product (96—97 wt % dimethyl sulfate, sulfuhc acid, and methyl hydrogen sulfate) was continuously withdrawn and purified by vacuum distillation over sodium sulfate. The yield was almost quantitative, and the product was a clear, colorless, mobile Hquid. A modified process is deschbed in Reference 94. Properties are Hsted in Table 3. 

Aroclor 1248, Aroclor 1254, and Aroclor 1260. Quantitation is by comparison of chromatograms with standard concentrations of pure compounds treated in an identical manner. The phenoxy acid herbicides (2,4-dichlorophenoxy)acetic acid (2,4-D), sUvex, and (2,4,5-trichlorophenoxy)acetic acid (2,4,5-T) can be deterrnined by electron-capture detection after extraction and conversion to the methyl esters with BF.-methanol. The water sample must be acidified to pH <2 prior to extraction with chloroform. 

Organic solutions of HOCl can be prepared in near quantitative yield (98—99%) by extraction of CU -containing aqueous solutions of HOCl with polar solvents such as ketones, nitriles, and esters (131). These organic solutions of HOCl have been used to prepare chlorohydrins (132) and are especially useful for preparation of water-insoluble chlorohydrins. Hypochlorous acid in methyl ethyl ketone has also been used to prepare Ca(OCl)2, by reaction with CaO or Ca(OH)2 (133), and hydrazine by reaction with NH3 (134). 

---