Cyclopentadiene catalysts

The utility of bis(oxazoline)-Cu(II) complexes as catalysts for the Diels-Alder reaction has been examined in a number of other systems. Aggarwal et al. (205) demonstrated that a-thioacrylates behave as effective two-point binding substrates for these catalysts. With cyclopentadiene, catalyst 271d induces the reaction at -78°C to provide the cycloadduct in 94 6 diastereoselectivity and >95% ee. Aggarwal proposes that the metal binds to the carbonyl oxygen and to the sulfur atom. The sulfur substituent is placed opposite the ligand substituent thereby shielding the bottom face of the alkene. Considerably lower selectivities are observed with 5-Me substrates. 

Endo-exo product mixtures were isolated using the following procedure. A solution of cyclopentadiene (concentration 2-10" M in water and 0.4 M in oiganic solvents) and the dienophile (concentration 1-5 mM) in the appropriate solvent, eventually containing a 0.01 M concentration of catalyst, was stirred at 25 C until the UV-absorption of the dienophile had disappeared. The reaction mixture (diluted with water in the case of the organic solvents) was extracted with ether. The ether layer was washed with water and dried over sodium sulfate. After the evaporation of the ether the... 

Interestingly, G jrey et al.", employing a similar tryptophan-derived catalyst (3.4), observed a 99% enantiomeric excess (ee) in the Diels-Alder reaction of 2-bromoacrolein with cyclopentadiene... 

In Chapter 2 the Diels-Alder reaction between substituted 3-phenyl-l-(2-pyridyl)-2-propene-l-ones (3.8a-g) and cyclopentadiene (3.9) was described. It was demonstrated that Lewis-acid catalysis of this reaction can lead to impressive accelerations, particularly in aqueous media. In this chapter the effects of ligands attached to the catalyst are described. Ligand effects on the kinetics of the Diels-Alder reaction can be separated into influences on the equilibrium constant for binding of the dienoplule to the catalyst (K ) as well as influences on the rate constant for reaction of the complex with cyclopentadiene (kc-ad (Scheme 3.5). Also the influence of ligands on the endo-exo selectivity are examined. Finally, and perhaps most interestingly, studies aimed at enantioselective catalysis are presented, resulting in the first example of enantioselective Lewis-acid catalysis of an organic transformation in water. 

Tire results of a study of the effect of these catalysts on the model Diels-Alder reaction of methyl vinyl ketone (4.8) with cyclopentadiene (4.6) are summarised in Table 4.1... 

As anticipated from the complexation experiments, reaction of 4.42 with cyclopentadiene in the presence of copper(II)nitrate or ytterbium triflate was extremely slow and comparable to the rate of the reaction in the absence of Lewis-acid catalyst. Apparently, Lewis-acid catalysis of Diels-Alder reactions of p-amino ketone dienophiles is not practicable. 

The allyl-substituted cyclopentadiene 122 was prepared by the reaction of cyclopentadiene anion with allylic acetates[83], Allyl chloride reacts with carbon nucleophiles without Pd catalyst, but sometimes Pd catalyst accelerates the reaction of allylic chlorides and gives higher selectivity. As an example, allylation of the anion of 6,6-dimethylfulvene 123 with allyl chloride proceeded regioselectively at the methyl group, yielding 124[84]. The uncatalyzed reaction was not selective. 

Fluoroaliphatic Thermolytic Routes. The reaction of diduorocarbene (generated from CHCIF2 at 600°C) with cyclopentadiene to give duoroben2ene (70% yield) has been scaled up in a pilot-plant/semiworks faciUty (capacity = several dozen t/yr) (77,78). The same process can now be effected under Hquid-phase conditions in the presence of phase-transfer catalysts (79,80). 

Gyclopentadiene/Dicyclopentadiene-Based Petroleum Resins. 1,3-Cyclopentadiene (CPD) is just one of the numerous compounds produced by the steam cracking of petroleum distillates. Due to the fact that DCPD is polymerized relatively easily under thermal conditions without added catalyst, resins produced from cycloaHphatic dienes have become a significant focus of the hydrocarbon resin industry. 

Table 3 provides typical specifications for isoprene that are suitable for Al—Ti polymerization (89). Traditional purification techniques including superfractionation and extractive distillation are used to provide an isoprene that is practically free of catalyst poisons. Acetylenes and 1,3-cyclopentadiene are the most difficult to remove, and distillation can be supplemented with chemical removal or partial hydrogenation. Generally speaking distillation is the preferred approach. Purity is not the main consideration because high quaUty polymer can be produced from monomer with relatively high levels of olefins and / -pentane. On the other hand, there must be less than 1 ppm of 1,3-cyclopentadiene. 

Diels-Alder reaction of 2-bromoacrolein and 5-[(ben2yloxy)meth5i]cyclopentadiene in the presence of 5 mol % of the catalyst (35) afforded the adduct (36) in 83—85% yield, 95 5 exo/endo ratio, and greater than 96 4 enantioselectivity. Treatment of the aldehyde (36) with aqueous hydroxylamine, led to oxime formation and bromide solvolysis. Tosylation and elimination to the cyanohydrin followed by basic hydrolysis gave (24). 

Reactions of acetylene and iron carbonyls can yield benzene derivatives, quinones, cyclopentadienes, and a variety of heterocycHc compounds. The cyclization reaction is useful for preparing substituted benzenes. The reaction of / fZ-butylacetylene in the presence of Co2(CO)g as the catalyst yields l,2,4-tri-/ f2 butylbenzene (142). The reaction of Fe(CO) and diphenylacetylene yields no less than seven different species. A cyclobutadiene derivative [31811 -56-0] is the most important (143—145). 

Cyclopentadiene itself has been used as a feedstock for carbon fiber manufacture (76). Cyclopentadiene is also a component of supported metallocene—alumoxane polymerization catalysts in the preparation of syndiotactic polyolefins (77), as a nickel or iron complex in the production of methanol and ethanol from synthesis gas (78), and as Group VIII metal complexes for the production of acetaldehyde from methanol and synthesis gas (79). 

Mention has already been made in this chapter of metallocene-catalysed polyethylene (see also Chapter 2). Such metallocene catalysts are transition metal compounds, usually zirconium or titanium. Incorporated into a cyclopentadiene-based structure. During the late 1990s several systems were developed where the new catalysts could be employed in existing polymerisation processes for producing LLDPE-type polymers. These include high pressure autoclave and... 

The monomer, norbomene (or bicyclo[2.2.l]hept-2-ene), is produced by the Diels-Alder addition of ethylene to cyclopentadiene. The monomer is polymerised by a ring-opening mechanism to give a linear polymer with a repeat unit containing both an in-chain five-membered ring and a double bond. Both cis-and trans- structures are obtainable according to the choice of catalyst used ... 

Chiral aluminum catalyst 2, prepared from Et2AlCl and a Vaulted biaryl ligand, is reported to be an effective Lewis acid catalyst of the Diels-AIder reaction between methacrolein and cyclopentadiene, affording the adduct in 97.7% ee [4] (Scheme 1.2). Although the Diels-AIder reaction with other a,/ -unsaturated aldehydes has not been described, that only 0.5 mol% loading is sufficient to promote the reaction is a great advantage of this catalyst. 

Table 1.1 Asymmetric Diels-Alder reactions of cyclopentadiene catalyzed by CAB catalyst 3 [5a,b ...

Another chiral titanium reagent, 11, was developed by Corey et al. [17] (Scheme 1.24). The catalyst was prepared from chiral ris-N-sulfonyl-2-amino-l-indanol and titanium tetraisopropoxide with removal of 2-propanol, followed by treatment with one equivalent of SiCl4, to give the catalytically-active yellow solid. This catalyst is thought not to be a simple monomer, but rather an aggregated species, as suggested by NMR study. Catalyst 11 promotes the Diels-Alder reaction of a-bro-moacrolein with cyclopentadiene or isoprene. 

Wulff and coworkers have applied their aluminum catalyst 2 containing a vaulted biphenanthrol ligand (VAPOL, Section 2.1) to the Diels-Alder reaction between methyl acrylate and cyclopentadiene [25] (Scheme 1.32). In this Diels-Alder reaction auto-induction is observed, because of a cooperative interaction between the product... 

Evans s bis(oxazolinyl)pyridine (pybox) complex 17, which is effective for the Diels-Alder reaction of a-bromoacrolein and methacrolein (Section 2.1), is also a suitable catalyst for the Diels-Alder reaction of acrylate dienophiles [23] (Scheme 1.33). In the presence of 5 mol% of the Cu((l )-pybox)(SbF5)2 catalyst with a benzyl substituent, tert-butyl acrylate reacts with cyclopentadiene to give the adduct in good optical purity (92% ee). Methyl acrylate and phenyl acrylate underwent cycloadditions with lower selectivities. 

Since Evans s initial report, several chiral Lewis acids with copper as the central metal have been reported. Davies et al. and Ghosh et al. independently developed a bis(oxazoline) ligand prepared from aminoindanol, and applied the copper complex of this ligand to the asymmetric Diels-Alder reaction. Davies varied the link between the two oxazolines and found that cyclopropyl is the best connector (see catalyst 26), giving the cycloadduct of acryloyloxazolidinone and cyclopentadiene in high optical purity (98.4% ee) [35] (Scheme 1.45). Ghosh et al., on the other hand, obtained the same cycloadduct in 99% ee by the use of unsubstituted ligand (see catalyst 27) [36] (Scheme 1.46, Table 1.19). 

A quinoline-phosphine ligand has been developed by Buono et ah, and its complex 29 with Cu(OTf)2 found to be an effective catalyst for the Diels-Alder reaction between acryloyl-oxazolidinone and cyclopentadiene, affording the cycloadduct... 

---