Two-stage

Amidines are best made in two stages a nitrile reacts with dry HCl and anhydrous alcohols to give an imidic ester (imino-ether) which yields an amidine with NH3. 

Bi-Gas process A high-pressure operation for the conversion of solid fuel into substitute natural gas (SNG) using two stages of gasification. 

In two stages with recycle to the second stage, the conversion per pass is approximately 50 wt. % and the selectivity to middle distillates is maximal 75 to 80 wt. %. However, the investment is clearly higher and is justified only when feedstocks are difficult to convert and that their content in nitrogen is high. Figure 10.11 represents two variants of the hydrocracking process. 

Capital and operating costs will increase as more separator stages are added to the process line, so a balance has to be struck between increased oil yield and cost. It is uncommon to find that economics support more than 3 stages of separation and one or two stage separation is more typical. The increased risk of separation shut down is also a contributing factor in limiting numbers. 

Number of polygons in the outer Isosurface hull (wireframe representation) before and after two stages of polygon reduction... 

An example of a two-stage hydrolysis is that of the sequence shown in Eq. IV-69. The Idnetics, illustrated in Fig. IV-29, is approximately that of successive first-order reactions but complicated by the fact that the intermediate II is ionic [301]... 

An example of the time effects in irreversible adsorption of a surfactant system is shown in Fig. XI-8 for barium dinonylnapthalene sulfonate (an oil additive) adsorbing on Ti02 (anatase). Adsorption was ineversible for aged systems, but much less so for those equilibrating for a short time. The adsorption of aqueous methylene blue (note Section XI-4) on TiOi (anatase) was also irreversible [128]. In these situations it seems necessary to postulate at least a two-stage sequence, such as... 

There appear to be two stages in the collapse of emulsions flocculation, in which some clustering of emulsion droplets takes place, and coalescence, in which the number of distinct droplets decreases (see Refs. 31-33). Coalescence rates very likely depend primarily on the film-film surface chemical repulsion and on the degree of irreversibility of film desorption, as discussed. However, if emulsions are centrifuged, a compressed polyhedral structure similar to that of foams results [32-34]—see Section XIV-8—and coalescence may now take on mechanisms more related to those operative in the thinning of foams. 

Figure Bl.7.17. (a) Schematic diagram of a single acceleration zone time-of-flight mass spectrometer, (b) Schematic diagram showing the time focusing of ions with different initial velocities (and hence initial kinetic energies) onto the detector by the use of a reflecting ion mirror, (c) Wiley-McLaren type two stage acceleration zone time-of-flight mass spectrometer.

Let us now consider the case where tliere is more tlian one exciton in tlie given molecular ensemble. The presence of two or more excess excitons not only creates two or more holes in tlie ground state (see case (a) above) but it also opens up tlie possibility of two excitons being found on neighbouring molecules. Then tlie following two-stage process can take place [26] ... 

Lead(IV) oxide can be prepared by the action of an alkaline chlorate(I) solution on a solution of a lead(II) salt. The reaction can be considered in two stages ... 

As we have discussed, a common strategy in conformational analysis is to perform two-stage process involving first, the generation of a large number of minimum enerj... 

In dissimilarity-based compound selection the required subset of molecules is identified directly, using an appropriate measure of dissimilarity (often taken to be the complement of the similarity). This contrasts with the two-stage procedure in cluster analysis, where it is first necessary to group together the molecules and then decide which to select. Most methods for dissimilarity-based selection fall into one of two categories maximum dissimilarity algorithms and sphere exclusion algorithms [Snarey et al. 1997]. 

It is not advisable to distil the mixture almost to dryness, since, towards the end of the distillation, the inflammable butylene is formed. Butylene formation is avoided by conducting the distillation in two stages as described. 

Free radical addition is a two stage process involving an addition step followed by an atom transfer step. 

The picture of the process of substitution by the nitronium ion emerging from the facts discussed above is that of a two-stage process, the first step in which is rate-determining and which leads to a relatively stable intermediate. In the second step, which is relatively fast, the proton is lost. The transition state leading to the relatively stable intermediate is so constructed that in it the carbon-hydrogen bond which is finally broken is but little changed from its original condition. 

Another circumstance which could change the most commonly observed characteristics of the two-stage process of substitution has already been mentioned it is that in which the step in which the proton is lost is retarded because of a low concentration of base. Such an effect has not been observed in aromatic nitration ( 6.2.2), but it is interesting to note that it occurs in A -nitration. The A -nitration of A -methyl-2,4,6-trinitroaniline does not show a deuterium isotope effect in dilute sulphuric acid but does so in more concentrated solutions (> 60 % sulphuric acid kjj/kjj = 4 8). ... 

It IS customary to combine the two stages hydroboration and oxidation m a sm gle equation with the operations numbered sequentially above and below the arrow... 

The two stage reaction sequence is called ozonolysis and is represented by the gen eral equation... 

The reaction occurs in two stages Only the first stage involves nucleophilic substitution It IS the rate determining step... 

Section 12 2 The mechanism of electrophilic aromatic substitution involves two stages attack of the electrophile on the tt electrons of the ring (slow rate determining) followed by loss of a proton to restore the aromaticity of the ring... 

The mechanism for formation of benzaldehyde diethyl acetal which proceeds m two stages is presented m Figure 17 9 The first stage (steps 1-3) involves formation of a hemiacetal m the second stage (steps 4-7) the hemiacetal is converted to the acetal Nucleophilic addition to the carbonyl group characterizes the first stage carbocation chemistry the second The key carbocation intermediate is stabilized by electron release from oxygen... 

The mechanism of acid catalyzed ester hydrolysis is presented m Figure 20 4 It IS precisely the reverse of the mechanism given for acid catalyzed ester formation m Section 19 14 Like other nucleophilic acyl substitutions it proceeds m two stages A... 

Mechanistically amide hydrolysis is similar to the hydrolysis of other carboxylic acid derivatives The mechanism of the hydrolysis m acid is presented m Figure 20 7 It proceeds m two stages a tetrahedral intermediate is formed m the first stage and disso ciates m the second... 

In the Strecker synthesis an aldehyde is converted to an a ammo acid with one more carbon atom by a two stage procedure m which an a ammo nitrile is an mterme diate The a ammo nitrile is formed by reaction of the aldehyde with ammonia or an ammonium salt and a source of cyanide ion Hydrolysis of the nitrile group to a car boxylic acid function completes the synthesis... 

Genes are DNA and carry the inheritable characteristics of an organism and these characteristics are normally expressed at the molecular level via protein synthesis Gene expression consists of two stages transcription and translation, both of which involve RNAs Sections 28 11 and 28 12 describe these RNAs and their roles m transcription and translation... 

Addition-elimination mechanism (Section 23 6) Two stage mechanism for nucleophilic aromatic substitution In the addition stage the nucleophile adds to the carbon that bears... 

Two-Stage Resins. The ratio of formaldehyde to phenol is low enough to prevent the thermosetting reaction from occurring during manufacture of the resin. At this point the resin is termed novolac resin. Subsequently, hexamethylenetetramine is incorporated into the material to act as a source of chemical cross-links during the molding operation (and conversion to the thermoset or cured state). 

Our approach to the problem of gelation proceeds through two stages First we consider the probability that AA and BB polymerize until all chain segments are capped by an Aj- monomer then we consider the probability that these are connected together to form a network. The actual molecular processes occur at random and not in this sequence, but mathematical analysis is feasible if we consider the process in stages. As long as the same sort of structure results from both the random and the subdivided processes, the analysis is valid. 

This polymerization is carried out in the two stages indicated above precisely because of the insolubility and infusibility of the final product. The first-stage polyamide, structure [IX], is prepared in polar solvents and at relatively low temperatures, say, 70°C or less. The intermediate is then introduced to the intended application-for example, a coating or lamination-then the second-stage cyclization is carried out at temperatures in the range 150-300°C. Note the formation of five-membered rings in the formation of the polyimide, structure [X], and also that the proportion of acid to amine groups is 2 1 for reaction (5.II). 

Figure 8.1(c) illustrates schematically the kind of process occurring in Auger electron spectroscopy (AES). The process occurs in two stages. In the first, a high-energy photon ejects an electron from a core orbital of an atom A ... 

A commercial technology (69), the SABRE process, treats contaminated water and soil ia a two-stage process by adding a readily degradable carbon and an inoculum of anaerobic bacteria able to degrade the contaminant. An initial aerobic fermentation removes oxygen so that the subsequent reduction of the contaminant is not accompanied by oxidative polymerization. 

The urea solution is evaporated in a two-stage system (99.8%) if the final product is prills, and a single-stage system (+95%) if granules are to be provided. 

---