Toxic materials, control

Sittig, Marshall. Pesticide Manufacturing and Toxic Materials Control Encyclopedia. Park Ridge, N.J. Noyes Data Corporation. 

SittigM, ed. 1980. Pesticide manufacturing and toxic materials control encyclopedia. Park Ridge, NJ Noyes Data Corporation, 366-373. 

Substitution of less toxic materials for asbestos (qv) is the most common control. 

The latest government regulations set forth under the Toxic Substances Control Act and in PubHc Health Service pubHcations should be checked before formulating new lubricants. Users of lubricants should request Material Safety Data Sheets for each substance involved plus certification of compliance from vendors. Lubricant compounders should insist on similar information from their suppHers for any additive packages. Manufacturers of both additives and lubricants commonly make toxicity checks on commercial products. 

Clean Air Act and its amendments ia 1970, 1977, and 1990 1967 Air Quahty Standards and National Air Pollution Acts and 1970 National Environmental PoHcy Act) (2) better waste disposal practices (1965 SoHd Waste Disposal Act 1976 Resource Conservation and Recovery Act) (see Wastes, industrial Waste treatment, hazardous wastes) (i) reduced noise levels (1972 Noise Control Act) (4) improved control of the manufacture and use of toxic materials (1976 Toxic Substances Control Act) and (5) assignment of responsibiUty to manufacturers for product safety (1972 Consumer Product Safety Act) (15,16). 

Toxic Substances Control Act (TSCA) Hazardous Materials Transportation Act (HMTA) Safe Drinking Water Act (SDWA)... 

In addition, restrictions on industrial air emissions under the Clean Air Act (CAA) as amended in 1977, the Clean Air Act Amendments (CAAA) of 1990, and other state and local statutes and regulations have universal impact on the storage of toxic materials, with direct and significant effects on the design and operation of toxic material storage facilities. Whereas the primary factors which once determined how air emissions from storage tanks were handled were fire protection and loss prevention, in recent years environmental protection concerns nearly always determine the extent and nature of the air emission controls required to be installed. 

The atmospheric movement of pollutants from sources to receptors is only one form of translocation. A second one involves our attempt to control air pollutants at the source. The control of parhculate matter by wet or dry scrubbing techniques 3delds large quantities of waste materials—often toxic—which are subsequently taken to landfills. If these wastes are not properly stored, they can be released to soil or water systems. The prime examples involve the disposal of toxic materials in dump sites or landfills. The Resource Conservation and Recovery Act of 1976 and subsequent revisions are examples of legislation to ensure proper management of solid waste disposal and to minimize damage to areas near landfills (4). 

Professional society promotes the study and control of environmental factors affecting the health and well-being of factory workers, including procedures for monitoring the exposure to toxic materials in the work place. Offers laboratory accreditation and testing programs and informational pamphlets on various health and safety topics. 

Bums and Hazzan demonstrated tlie use of event tree and fault tree analysis in tlie study of a potential accident sequence leading to a toxic vapor release at an industrial chemical process plant. The initiator of tlie accident sequence studied is event P, the failure of a plant programmable automatic controller. Tliis event, in conjunction willi the success or failure of a process water system (a glycol cooling system) mid an operator-manual shutdown of tlie distillation system produced minor, moderate, or major release of toxic material as indicated in Fig. 21.4.1. The symbols W, G, O represent tlie events listed ... 

Use of some biomass feedstocks can increase potential environmental risks. Municipal solid waste can contain toxic materials that can produce dioxins and other poisons in the flue gas, and these should not be burned without special emission controls. Demolition wood can contain lead from paint, other heavy metals, creosote, and halides used in presen a-tive treatments. Sewage sludge has a high amount of sulfur, and sulfur dioxide emission can increase if sewage sludge is used as a feedstock. 

Community Right-to-know Act TSCA = Toxic Substance Control Act, RCRA = Resource Conservation and Recovery Act, HMTA = Hazardous Materials Transportation Act... 

Kudo, A. (1983). Physical/chemical/biological removal mechanisms of mercury in a receiving stream. In Toxic Materials - Methods for Control" (N. E. Armstrong and A. Kudo, eds). The Center for Research in Water Resources, University of Texas at Austin, Austin, TX. 

---