Salicylates acetylsalicylic acid

Salicylic acid (2) is also used as preservative of food products, but its use for this purpose is forbidden in some countries, many methyl salicylates, acetylsalicylic acid and other salicylates, dyes, as reagents in analtyical chemistry. 

Salicylic/ acetylsalicylic acids Pharmaceutical preparations UV-Vis 100-600, 300-1800 mg L-1 Sequential determinations required for a dissolution test [111]... 

Northover and Subramanian report that formation of kinin by serum and salivary kallikrein is inhibited by sodium salicylate, acetylsalicylic acid, phenylbutazone and certain other anti-inflammatory substances. The vasodepressor and vascular permeability activities of kallikrein are similarly inhibited. These findings are not, however, supported by investigations of other workers and further studies are needed to clarify the discrepancy. It is interesting to note that hexadimethrine bromide(polybrene), which is known to inhibit kinin formation in vitro, inhibits increased capillary permeability in the xylene treated skin of mice . 

It should be emphasised that salicylic acid can be readily acetylated by Method 1, and that the above preparation of acetylsalicyclic acid is given solely as an illustration of Method 2. To employ Method 1, add 10 g. of salicylic acid to 20 ml. of a mixture of equal volumes of acetic anhydride and acetic acid, and boil gently under reflux for 30 minutes. Then pour into about 200 ml. of cold water in order to precipitate the acetylsalicylic acid (11 g.) and finally recrystallise as above. Method 2, however, gives the purer product. 

Phenols, unlike amines, cannot be acetylated satisfactorily in aqueous solution acetylation proceeds readily with acetic anhydride in the presence of a little concentrated sulphuric acid as catalyst. Salicylic acid (o-hydroxy-benzoic acid) upon acetylation yields acetylsalicylic acid or aspirin ... 

Place 10 g. of dry salicylic acid and 15 g. (14 ml.) of acetic anhydride in a small conical flask, add 5 drops of concentrated sulphuric acid, and rotate the flask in order to secure thorough mixing. Warm on a water bath to about 50-60°, stirring with the thermometer, for about 15 minutes. Allow the mixture to cool and stir occasionally. Add 150 ml. of water, stir well and filter at the pump. ReorystaUise the crude acetylsalicylic acid from a mixture of equal volumes of acetic acid and water. 

The best known aryl ester is O acetylsalicylic acid better known as aspirin It is pre pared by acetylation of the phenolic hydroxyl group of salicylic acid... 

Many pharmaceutical compounds contain chromophores that make them suitable for analysis by UV/Vis absorption. Products that have been analyzed in this fashion include antibiotics, hormones, vitamins, and analgesics. One example of the use of UV absorption is in determining the purity of aspirin tablets, for which the active ingredient is acetylsalicylic acid. Salicylic acid, which is produced by the hydrolysis of acetylsalicylic acid, is an undesirable impurity in aspirin tablets, and should not be present at more than 0.01% w/w. Samples can be screened for unacceptable levels of salicylic acid by monitoring the absorbance at a wavelength of... 

The preparation of an ion-selective electrode for salicylate is described. The electrode incorporates an ion-pair of crystal violet and salicylate in a PVC matrix as the ion-selective membrane. Its use for the determination of acetylsalicylic acid in aspirin tablets is described. A similar experiment is described by Creager, S. E. Lawrence, K. D. Tibbets, C. R. in An Easily Constructed Salicylate-Ion-Selective Electrode for Use in the Instructional Laboratory, /. Chem. Educ. 1995, 72, 274-276. 

Students determine the concentrations of caffeine, acetaminophen, acetylsalicylic acid, and salicylic acid in several analgesic preparations using both CZE (70 mM borate buffer solution, UV detection at 210 nm) and HPLC (C18 column with 3% v/v acetic acid mixed with methanol as a mobile phase, UV detection at 254 nm). 

Detection and result The chromatogram was dried in a stream of warm air for 10 min, immersed in the reagent solution for 3 s and then subjected to intense UV radiation (high pressure lamp, A = 365 nm) for up to 10 min. Terephthalic (hRf 0 - 5), pimelic (hRf 55), suberic (hRf 60), sebacic (hRf 65 — 70) and benzoic acids (hRf 70 — 75) together with sorbic, malic, adipic, citric, tartaric, lactic and fumaric acids only exhibited a reaction on silica gel layers at higher concentrations. 4-Hydroxybenzoic, salicylic and acetylsalicylic acids fluoresced light blue after irradiation. The detection limit per chromatogram zone was 0.5 pg for salicylic acid and more than 5 pg for benzoic acid. 

The filtrate from this first batch will comprise a solution of 180 to 270 kg of unprecipitated acetylsalicylic acid (1.0 to 1.5 mols), 510 kg of acetic anhydrice (5.0 mols), 600 kg of acetic acid (10.0 mols) (obtained as a by-product in the acetylation step) and 1,200 kg of the diluent toluene. Into this filtrate, at a temperature of 15° to 25°C, ketene gas is now passed through a sparger tube or diffuser plate, with good agitation, until a weight increase of 420.5 kg of ketene (10 mols) occurs. The reaction mixture wiil now contain 180-270 kg of unprecipitated acetylsalicylic acid (1.0-1.5 mols) and 1,532 kg of acetic anhydride (15 mols) in 1,200 kg of toluene. This mother liquor is recycled to the first step of the process for reaction with another batch of 1,382 kg of salicylic acid. On recirculating the mother liquor, the yield of pure acetylsalicylic acid is 1,780 to 1,795 kg per batch. 

Conversion of Acid Anhydrides into Esters Acetic anhydride is often used to prepare acetate esters from alcohols. For example, aspirin (acetylsalicylic acid) is prepared commercially by the acetylation of o-hydroxybenzoic acid (salicylic acid) with acetic anhydride. 

Salicylic acid for systemic use has been replaced by acetylsalicylic acid, amides of salicylic acid (salicylamide, ethenzamide, salacetamide), salsalate and diflunisal. 

After oral administration, acetylsalicylic acid is rapidly and almost completely absorbed but in the intestinal mucosa it is partly deacetylated to salicylic acid, which also exhibits analgesic activity. The plasma half-life of acetylsalicylic acid is 15 min whereas that of salicylic acid, at low dosages of acetylsalicylic acid, is 2-3 h. Salicylic acid is eliminated more slowly when acetylsalicylic acid is administered at high dose rates because of saturation of the liver enzymes. The metabolites are mainly excreted via the kidney. 

The salicylates include aspirin (acetylsalicylic acid) and related drugp, such as magnesium salicylate and sodium salicylate. The salicylates have analgesic (relieves pain), antipyretic (reduces elevated body temperature), and anti-inflammatory effects. All the salicylates are similar in pharmacologic activity however, aspirin has a greater anti-inflammatory effect than the other salicylates. Specific salicylates are listed in the Summary Drug Table Nonnarcotic Analgesics Salicylates and Nonsalicylates. 

Salicylic acid reacts with acetic acid to produce acetylsalicylic acid the active ingredient in aspirin. It also reacts with methanol to form methyl salicylate, more commonly known as oil of wintergreen. 

Acetylsalicylic acid breaks down into salicylic acid 20 minutes after entering the bloodstream. It is the salicylic acid that is responsible for the beneficial effects of aspirin. Salicylic acid itself is too caustic to be taken orally. 

Aspirin (shown here as acetylsalicylic acid, Ka = 3.2 X 10 4) is a product of the reaction of salicylic acid with acetic anhydride. Calculate the ratio of the concentrations... 

As the solvent mixture also contained 225 mg of tetramethyl ammonium hydroxide pentahydrate per liter at a high water content (75%), the surface of the reverse phase would have been largely covered with the tetramethyl ammonium hydroxide pentahydrate. This would have acted as an adsorbed ion exchange stationary phase. It is clear that the free acids, salicylic acid, acetylsalicylic acid (aspirin) and benzoic acid were retained largely by ionic interactions with adsorbed basic ion exchanger and partly by dispersive interactions with the exposed reversed phase. The acetaminophen and the caffeine, on the other hand, being unionized substances, were retained only by dispersive interactions with the exposed reversed phase. 

C7Hft03 69-72-7) see Acetylsalicylic acid Balsalazide sodium Flavoxate Hydroxyethyl salicylate Mesalazine Salazosulfapyridine Salsalate salicylic acid sodium salt... 

Irreversible reaction of [18] iodine with acetylsalicylic acid, aethaverine, amidopyrine, ascorbic acid, benzo-caine, quinine, dihydrocodeine, fluorescein, glycine, hydrocortisone acetate, isoni-azid, metamizole, papaverine, paracetamol, phenacetin, phenol-phthalein, piperazine, resorcinol, salicylic acid, salicylamide, sulfaguanidine, thymol, triethanolamine, tris buffer detection by reaction chromatography... 

Only four years after Kekule proposed the ring structure for benzene, and before the configuration of salicylic acid was established, Kraut concluded on the basis of sound chemical evidence that the products obtained on heating acetylsalicylic acid possess chain structures formed through intermolecular esterification. He assigned the dimeric and tetrameric formulas... 

C=0) is linked to both an alkyl group (or hydrogen atom) and a hydroxyl group. The medicinal activity of salicylic acid suggests that it is this phenolic precursor (phenol, Fig. 13.4.3), not acetylsalicylic acid (Fig. 13.4.4), that is the prime pain... 

Aspirin, also known as acetylsalicylic acid (ASA), can be synthesized when the carboxyl group in acetic acid (----COOH) reacts with the (--------OH group in the salicylic acid molecule ... 

A simple compound to begin our presentation is acetylsalicylic acid (aspirin, 7.44), the well-known analgesic and anti-inflammatory drug whose primary metabolite, salicylic acid (7.45), is also an anti-inflammatory agent but not an analgesic. Extensive kinetic data have been published on the chemical hydrolysis of acetylsalicylic acid as a function of temperature and... 

A variety of hydrolases catalyze the hydrolysis of acetylsalicylic acid. In humans, high activities have been seen with membrane-bound and cytosolic carboxylesterases (EC 3.1.1.1), plasma cholinesterase (EC 3.1.1.8), and red blood cell arylesterases (EC 3.1.1.2), whereas nonenzymatic hydrolysis appears to contribute to a small percentage of the total salicylic acid formed [76a] [82], A solution of serum albumin also displayed weak hydrolytic activity toward the drug, but, under the conditions of the study, binding to serum albumin decreased chemical hydrolysis at 37° and pH 7.4 from tm 12 1 h when unbound to 27 3 h for the fully bound drug [83], In contrast, binding to serum albumin increased by >50% the rate of carboxylesterase-catalyzed hydrolysis, as seen in buffers containing the hydrolase with or without albumin. It has been postulated that either bound acetylsalicylic acid is more susceptible to enzyme hydrolysis, or the protein directly activates the enzyme. 

The case of aspirin in Table 8.3 is of special interest. Indeed, its acetyl ester group is particularly labile to enzymatic and nonenzymatic hydrolysis (see Sect. 7.4), and the reaction is even faster when the carboxy group is neutralized by esterification. A true ester prodrug of acetylsalicylic acid must fulfill the condition that its hydrolysis liberates aspirin rather than a prodrug of salicylic acid. An investigation of several aspirin prodrugs confirmed the interest of carbamoylmethyl esters and showed the (ATV-diethylcarbamoyl)methyl ester (Table 8.3) to liberate the highest proportion (ca. 60%) of aspirin [37], In... 

---