Nitrobenzene procedure

In the last few years several modifications to the traditional mixed acid nitration procedure have been reported. An adiabatic nitration process was developed for the production of nitrobenzene (9). This method eliminated the need to remove the heat of reaction by excessive cooling. The excess heat can be used in the sulfuric acid reconcentration step. An additional advantage of this method is the reduction in reaction times to 0.5—7.5 minutes. 

Contaminants and by-products which are usually present in 2- and 4-aminophenol made by catalytic reduction can be reduced or even removed completely by a variety of procedures. These include treatment with 2-propanol (74), with aUphatic, cycloaUphatic, or aromatic ketones (75), with aromatic amines (76), with toluene or low mass alkyl acetates (77), or with phosphoric acid, hydroxyacetic acid, hydroxypropionic acid, or citric acid (78). In addition, purity may be enhanced by extraction with methylene chloride, chloroform (79), or nitrobenzene (80). 

Di-o-nitrophenyl disulfide was first prepared by the action of hydriodic acid on o-nitrobenzene sulfochloride.1 It has also been prepared by the reduction of o-nitrobenzene sulfinic acid with hydrogen bromide 2 by the reduction of ethyl-o-nitro-phenylsulfonacetate with ammonium sulfide 3 and by the deamination of 4,4,-diamino-2,2 -dinitrodiphenyldisulfide.4 The procedure given is the method of Blanksma5 as elaborated by Wohlfahrt.6... 

One of the most important derivatives of benzene is nitrobenzene. The nitro group is —NOi. Nitrobenzene is important chiefly because it is readily converted into an aromatic amine, aniline, by reduction. One preparative procedure uses zinc as the reducing agent ... 

Procedure B. Pipette 25 mL of the diluted solution into a 250 mL conical flask containing 5mL 6 M nitric acid. Add a slight excess of standard 0.1M silver nitrate (about 30 mL in all) from a burette. Then add 2-3 mL pure nitrobenzene and 1 mL of the iron(III) indicator, and shake vigorously to coagulate the precipitate. Titrate the residual silver nitrate with standard 0.1M thiocyanate until a permanent faint reddish-brown coloration appears. 

As stated above under TNMe, in Ger during WWII, the prepn of TeNMe by this process was scaled up for use as an intermediate and as a substitute for nitric acid in the V-2 rocket (Ref 26). A pilot plant was built at Newark, NJ for prodn using this procedure. It was destroyed by an expln in 1953 and not rebuilt (Refs 33 44). Other prepns of lesser importance are by the action of Ag nitrite on iodotrinitro-methane (Ref 3) by the action of 90% nitric acid and 25% oleum on malononitrile, yield 45% (Ref 40) by the action of mixed acid on a number of aromatic nitrocompounds, of which nitrobenzene, dinitrobenzene, and nitronaphtha-lene gave the best yields (Ref 13a) and by the action of nitryl chloride on salts of TNMe. 

Montravel. In 1889 proposed treating the ingredients used in the prepn of BlkPdr with nitrobenzene. This procedure resulted in the formation of a thin coating on the grains which served as waterproofing Ref Daniel (1902), 443... 

It was mentioned earlier (Sec. 8.6) that for iodo-de-diazoniation no catalyst is necessary because the redox potential of the iodide ion (E° = 1.3 V) is sufficient for an electron transfer to the arenediazonium ion. The reaction was actually observed by Griess (1864 c). Four iodo-de-diazoniation procedures are described in Organic Syntheses. For the syntheses of iodobenzene and 4-iodophenol (Lucas and Kennedy, 1943, and Daines and Eberly, 1943, respectively) KI is used in equimolar quantity and in 1.2 molar excess. However, for 2-bromoiodobenzene and for 1,3,4-triiodo-5-nitrobenzene (replacement of a diazonio group in the 4-position by iodine), up to... 

To a cooled (2-8 °C) solution of A1C13 in carbon disulphide or nitrobenzene was added dropwise an equimolar mixture of the alkynylsilane and the acid chloride (or anhydride), dissolved in a little of the same solvent. After being stirred for 30 min, the reaction mixture was poured onto dilute sulphuric acid/ice. Normal isolation procedures gave the alkynone (50-90%). 

The chemistry of indium metal is the subject of current investigation, especially since the reactions induced by it can be performed in aqueous solution.15 The selective reductions of ethyl 4-nitrobenzoate (entry 1), 2-nitrobenzyl alcohol (entry 2), l-bromo-4-nitrobenzene (entry 3), 4-nitrocinnamyl alcohol (entry 4), 4-nitrobenzonitrile (entry 5), 4-nitrobenzamide (entry 6), 4-nitroanisole (entry 7), and 2-nitrofluorenone (entry 8) with indium metal in the presence of ammonium chloride using aqueous ethanol were performed and the corresponding amines were produced in good yield. These results indicate a useful selectivity in the reduction procedure. For example, ester, nitrile, bromo, amide, benzylic ketone, benzylic alcohol, aromatic ether, and unsaturated bonds remained unaffected during this transformation. Many of the previous methods produce a mixture of compounds. Other metals like zinc, tin, and iron usually require acid-catalysts for the activation process, with resultant problems of waste disposal. 

Another proposed procedure of finding the ionic data is the application of a special salt bridge, which provides practically constant or negligible liquid junction potentials. The water-nitrobenzene system, containing tetraethylammonium picrate (TEAPi) in the partition equilibrium state, has been proposed as a convenient liquid junction bridge for the liquid voltaic and galvanic cells. 

The procedure described for the preparation of l-(m-nitro-phenyl)-3,3-dimethyltriazene is the method of Elks and Hey,2 and the preparation of m-nitrobiphenyl is also a modification of their procedure. The other principal methods for the preparation of m-nitrobiphenyl are the decomposition of N-nitroso-w-nitroacetanilide in benzene 3 and the decomposition of alkaline m-nitrobenzenediazohydroxide in benzene.4 Other methods that have been reported include the decomposition of potassium ire-nitrobenzenediazotate in benzene with acetyl chloride,6 the decomposition of m-nitrobenzoyl peroxide in boiling benzene,6 the decomposition of benzenediazonium borofluoride in nitrobenzene 7 at 70°, and the reduction of 4-(3 -nitrophenyl)-benzenediazonium acid sulfate in boiling ethanol.8... 

The heat of decomposition (238.4 kJ/mol, 3.92 kJ/g) has been calculated to give an adiabatic product temperature of 2150°C accompanied by a 24-fold pressure increase in a closed vessel [9], Dining research into the Friedel-Crafts acylation reaction of aromatic compounds (components unspecified) in nitrobenzene as solvent, it was decided to use nitromethane in place of nitrobenzene because of the lower toxicity of the former. However, because of the lower boiling point of nitromethane (101°C, against 210°C for nitrobenzene), the reactions were run in an autoclave so that the same maximum reaction temperature of 155°C could be used, but at a maximum pressure of 10 bar. The reaction mixture was heated to 150°C and maintained there for 10 minutes, when a rapidly accelerating increase in temperature was noticed, and at 160°C the lid of the autoclave was blown off as decomposition accelerated to explosion [10], Impurities present in the commercial solvent are listed, and a recommended purification procedure is described [11]. The thermal decomposition of nitromethane under supercritical conditions has been studied [12], The effects of very high pressure and of temperature on the physical properties, chemical reactivity and thermal decomposition of nitromethane have been studied, and a mechanism for the bimolecular decomposition (to ammonium formate and water) identified [13], Solid nitromethane apparently has different susceptibility to detonation according to the orientation of the crystal, a theoretical model is advanced [14], Nitromethane actually finds employment as an explosive [15],... 

Typical VNS consists of a reaction between a nitroarene such as nitrobenzene and a carbanion containing a leaving group X at the carbanionic center. In the first step, addition of the carbanion to the nitroarene results in the formation of o-adduct, which undergoes P-elimination of HX to form the nitrobenzylic carbanion, which is subsequently protonated during the work-up procedure (Scheme 9.7). 

The polyester domains of suberized walls can also be depolymerized using chemical and/or enzymatic approaches similar to those used for cutin. The aromatic domains are far more difficult to depolymerize as C-C and C-O-C crosslinks are probably present in such domains. Therefore, more drastic degradation procedures such as nitrobenzene, CuO oxidation, or thioglycolic... 

Procedure Weigh accurately about 0.2 g of chlorobutol in a flask and dissolve in 5 ml of alcohol. Add to it 5 ml of sodium hydroxide solution, and boil under a reflux condenser for 15 minutes. Cool, dilute with 20 ml of DW, add 5 ml of nitric acid, 1 ml of nitrobenzene and 50 ml of 0.1 N silver nitrate solution. Shake the contents vigorously for 1 minute, add 4 ml of ferric ammonium sulphate solution and titrate the excess of silver nitrate with 0.1 N ammonium thiocyanate solution. Each ml of 0.1N silver nitrate is equivalent to 0.005917 g of C4H7C130. 

This procedure is based upon a study 1 of the method outlined in the patent literature.2 The procedure is a general one and may be used for the condensation of succinic anhydride with naphthalene and with the mono- and dimethylnaphthalenes, although in no other case are the purification and separation of isomers so easily accomplished. In this particular type of condensation, as well as in certain other types of Friedel-Crafts reactions, nitrobenzene is far superior to the solvents which are more frequently employed. This is partly because of its great solvent power and partly because it forms a molecular compound with aluminum chloride, and so decreases the activity of the catalyst in promoting side reactions. 

A method with LOQ at ppt levels was developed based on LLE followed by GC-AFID for the determination of trace concentrations of nitrobenzene, l-chloro-2-nitrobenzene and synthetic fragrances such as musk xylene (223) and musk ketone (224). The method was applied to study the distribution of these compounds in environmental samples of North Sea waters460. GC with atomic emission detection (AED) has been successfully applied to the determination of nitro musks in human adipose tissues, at ppb concentration levels. A clean-up procedure for nonpolar substances and element-specific detection with AED enabled for the first time target screening analysis for lipophilic nitro aromatic compounds. The lack of sensitivity of AED was compensated by higher concentrations of the extracts... 

Carbon nanotubes have been decorated with metal nanoparticies of Au, Ag, Pt, Pd and Co employing different procedures such as the click reaction [107], microwave treatment [106], electroless plating [108] and laser irradiation of mixtures of the individual components [109]. Pt-carbon nanotube hybrids have been used as catalysts for the conversion of nitrobenzene to aniline [110]. Tessonier et al. report that MWNTs covered with Pd nanoparticies on the interior walls can be employed for... 

Monomers. BTDA and APA were obtained from Gulf Chemicals. BTDA was recrystallized from acetic anhydride prior to use, and APA was distilled under reduced pressure. Diamines la-d were prepared from 1-fluoro-4-nitrobenzene and the appropriate glycol according to the known procedure (4). 

Titanium ions can also he used as redox catalysts for the indirect cathodic reduction of nitro compounds (417). The electroreduction is carried out in an H20-H2S04/Ti(S04)2-(Pb/Cu) system at 45 80°C under 5 20Am . Nitrobenzene, dinitrobenzene, nitrotoluene, 2,4-dinitrotoluene, 2-nitro-m-xylene, nitro-phenol, 2,4-dinitrophenol, nitrophenetole, o-nitroanisole, 4-nitrochlorotoluene, ni-trobenzenesulfonic acid, and 4,4 -dinitro-stilbene-2,2 -disulfonic acid can all be reduced by this procedure to the corresponding amino compounds (418) in good yields (Scheme 146) [513-516]. Tin... 

---