Hydrocarbons, hydrocarbon alcohols, tert

Oxygen was added as oxygenated hydrocarbon components methyl tert-butyl ether (MTBE), tert-amyl methyl ether (TAME), ethyl tert-butyl ether (ETBE), di-isopropyl ether (DIPE), ethanol, methanol, and tertiary butyl alcohol (TBA). The properties of oxygenates, as they relate to gasoline blending, are shown in Table 10-1. 

Methyl-2-hydroxy-5-hexenoic acid with 85%-H3P04 slowly distilled at 30 mm. —2,5-epoxy-2-methylhexanoic acid. Y 75%. (Bl. 1949, 24.) —Cyelization of sec. alcohols is best effected by H3P04, which, however, forms diethylenic hydrocarbons from tert. alcohols (Bl. 1949, 17). (F. e., also via dibromo alcohols, s. J. Colonge and A. Lagier, Bl. 1949, 24, 17.)... 

The authors noticed no C-H/C-D isotope effect for the reaction of 13 with methanol and ferf-butanol, but saw a KIE k Jk = 1.4) for the O-H/O-D bond, suggesting that the stronger O-H bond is activated preferentially over the weaker C-H bonds (Pig. 12). In addition, the authors observed the formation of acetone upon the oxidation of tert-butanol. Upon comparison of rate constants (which have been normalized to account for the amount of hydrogens available for abstraction), tert-butanol reacts 50 times faster than cyclohexane. The authors propose a proton-coupled electron transfer event is responsible for the observed selectivity this complex represents a rare case in which O-H bonds may be homolyzed preferentially to C—H bonds. In further study, 13 was shown to oxidize water to the hydroxyl radical by PCET [95]. Under pseudo-first-order conditions, conversion of 13 to its one-electron reduced state was found to have a second-order dependence on the concentration of water, in stark contrast to the first-order dependence observed for aUphatic hydrocarbons and alcohols. Based on the theimoneutral oxidation of water (2.13 V v. NHE in MeCN under neutral conditions [96]) by 13 (2.14 V V. NHE in MeCN under neutral conditions) and the rate dependence, the authors propose a proton-coupled electron transfer event in which water serves as a base. While the mechanism for O-H bond cleavage of alcohols and water is not well understood in these instances, the capacity to cleave a stronger O-H bond in the presence of much weaker C-H bonds is a tremendous advance in metal-oxo chemistry and represents an exciting avenue for chemoselective substrate activation. 

Without additional reagents Branched hydrocarbons from tert. alcohols, ketones, or carboxylic acids... 

The presence of thallium(0) led to an increase in activity and selectivity of metallic palladium catalysts supported on silica in aldose oxidation reactions. However, silica-supported thallium(0) had no activity by itself (entry 3). ° Similarly, the bimetallic catalyst platinum-thallium/ZSM-5, prepared by impregnation of thallium sulfate and chloroplatinic acid on Zeolite Socony Mobil-5 (ZSM-5), showed greater selectivity in propane aromatisation and almost the same catalytic activity as monometallic thallium/ZSM-5 (entry 4). Similar comparison of vanadium-caesium-copper and vanadium-caesium-copper-thallium catalysts supported on TiOa.SiC demonstrated that addition of thallium improved the catalytic activity in partial oxidation of p-tert-butyltoluene to p-tert-butyl-benzaldehyde (entry The application of solid-supported thallium-based catalysts in different processes includes (a) iron-thallium catalysts in carbon monoxide hydrogenations to form hydrocarbons and alcohols, and catalytic reforming of... 

Methyl /-Butyl Ether. MTBE is produced by reaction of isobutene and methanol on acid ion-exchange resins. The supply of isobutene, obtained from hydrocarbon cracking units or by dehydration of tert-huty alcohol, is limited relative to that of methanol. The cost to produce MTBE from by-product isobutene has been estimated to be between 0.13 to 0.16/L ( 0.50—0.60/gal) (90). Direct production of isobutene by dehydrogenation of isobutane or isomerization of mixed butenes are expensive processes that have seen less commercial use in the United States. 

Organic hydroperoxides can be prepared by Hquid-phase oxidation of selected hydrocarbons in relatively high yield. Several cycHc processes for hydrogen peroxide manufacture from hydroperoxides have been patented (84,85), and others (86—88) describe the reaction of tert-huty hydroperoxide with sulfuric acid to obtain hydrogen peroxide and coproduct tert-huty alcohol or tert-huty peroxide. 

Hydroperoxide Process. The hydroperoxide process to propylene oxide involves the basic steps of oxidation of an organic to its hydroperoxide, epoxidation of propylene with the hydroperoxide, purification of the propylene oxide, and conversion of the coproduct alcohol to a useful product for sale. Incorporated into the process are various purification, concentration, and recycle methods to maximize product yields and minimize operating expenses. Commercially, two processes are used. The coproducts are / fZ-butanol, which is converted to methyl tert-huty ether [1634-04-4] (MTBE), and 1-phenyl ethanol, converted to styrene [100-42-5]. The coproducts are produced in a weight ratio of 3—4 1 / fZ-butanol/propylene oxide and 2.4 1 styrene/propylene oxide, respectively. These processes use isobutane (see Hydrocarbons) and ethylbenzene (qv), respectively, to produce the hydroperoxide. Other processes have been proposed based on cyclohexane where aniline is the final coproduct, or on cumene (qv) where a-methyl styrene is the final coproduct. 

Figure 10.3 Gas cliromatograms of a cold-pressed lemon oil obtained (a) with an SE-52 column in the stand-by position and (b) with the same column showing the five heart-cuts (c) shows the GC-GC chiral chromatogram of the ti ansfeired components. The asterisks in (b) indicate electric spikes coming from the valve switcliing. The conditions were as follows SE-52 pre-column, 30 m, 0.32 mm i.d., 0.40 - 0.45 p.m film tliickness cairier gas He, 90 KPa (stand-by position) and 170 KPa (cut position) oven temperature, 45 °C (6 min)-240 °C at 2 °C/min diethyl-tert-butyl-/3-cyclodextrin column, 25 m X 0.25 mm i.d., 0.25 p.m film thickness cairier gas He, 110 KPa (stand-by position) and 5 KPa (cut position) oven temperature, 45 °C (6 min), rising to 90 °C (10 min) at 2 °C/min, and then to 230 °C at 2 °C/min. Reprinted from Journal of High Resolution Chromatography, 22, L. Mondello et al, Multidimensional capillary GC-GC for the analysis of real complex samples. Part IV. Enantiomeric distribution of monoterpene hydrocarbons and monoterpene alcohols of lemon oils , pp. 350-356, 1999, with permission from Wiley-VCH.

Amylose complexes (wet precipitates) were prepared with fluoro-benzene, 1,1,2,2-tetrachloroethane, 1,1,2,2-tetrabromoethane, bromo-form, and ferf-butyl alcohol. The conformation and packing of the amylose chains complexed with halogen-substituted hydrocarbons are the same as found in the complex with tert-butyl alcohol, namely,... 

The propargylic alcohol 102, prepared by condensation between 100 and the lithium acetylide 101, was efficiently reduced to the hydrocarbon 103, which on treatment with potassium tert-butoxide was isomerized to the benzannulated enyne-allene 104 (Scheme 20.22) [62], At room temperature, the formation of 104 was detected. In refluxing toluene, the Schmittel cyclization occurs readily to generate the biradical 105, which then undergoes intramolecular radical-radical coupling to give 106 and, after a prototropic rearrangement, the llJ-f-benzo[fo]fluorene 107. Several other HJ-f-benzo[fo]fluorenes were likewise synthesized from cyclic aromatic ketones. 

Reduction of benzaldehyde and p-alkylbenzaldehydes to the corresponding hydrocarbons was carried out by lithium in liquid ammonia and tetrahydro-furan in the presence of tert-h xiy alcohol or ammonium chloride (yields 90-94%) [775]. 

Reduction of esters by trichlorosilane in tetrahydrofuran in the presence of tert-butyl peroxide and under ultraviolet irradiation gave predominantly ethers from esters of primary alcohols, while esters of tertiary alcohols were cleaved to acids and hydrocarbons. Esters of secondary alcohols gave mixtures of ethers and acids/hydrocarbons in varying ratios. 1-Adamantyl trimethylacetate, for example, afforded 50-100% yields of mixtures containing 2-42% of 1-adamantyl neopentyl ether and 58-98% of adamantane and trimethylacetic acid [1033]. 

Of the seven hydroxyl-containing peroxides listed in Table 2, six are tert-butylperoxy derivatives. Although the fert-butyl group kinetically stabilizes the peroxide so that its combustion enthalpy can be measured, its presence makes finding suitable reference compounds such as hydrocarbons and ethers to compare in reactions 2-9 more difficult. Reaction 6 is the only reaction for which there are enthalpy of formation data for the requisite comparison compounds. Three hydroxy peroxides, all from the same source, have remarkably consistent enthalpies of reaction 6 in both the liquid and gas phases. The mean values derived from the viciwaZ-dioxygen substimted alcohols, 2-tert-butylperoxyethanol, 2-fert-pentylperoxyethanol and 3-fert-butylperoxy-1,2-propanediol, are —304.0 + 4.1 kJmol (Iq) and —257.1 + 6.0 kJmol (g). However, these values... 

The more acidic fluorene in tert-butyl alcohol solution, or in DMSO solution, reacts by a process that involves the carbanion in equilibrium with hydrocarbon. Thus, fluorene and 9,9-dideuteriofluorene oxidize at identical rates. We have established that the oxidation of the anion of fluorene can be catalyzed by a variety of electron acceptors (v), including various nitroaromatics (18). The catalyzed oxidation rates were found to follow the rates of electron transfer measured by ESR spectroscopy in the absence of oxygen. These results established the catalyzed reaction as a free radical chain process without shedding light upon the mechanism of the uncatalyzed reaction. 

Materials. Chemically pure solvents and reagent grade ceric ammonium nitrate were used as received. Cumene hydroperoxide was purified via the sodium salt. Lucidol tert-butyl hydroperoxide was purified by low temperature crystallization. Tetralin hydroperoxide, cyclohexenyl hydroperoxide, and 2-phenylbutyl-2-hydroperoxide were prepared by hydrocarbon oxidation and purified by the usual means. 1,1-Diphenyl-ethyl hydroperoxide and triphenylmethyl hydroperoxide were prepared from the alcohols by the acid-catalyzed reaction with hydrogen peroxide (10). 

---