Exposure, definition

Associations between breast cancer and total and specific fruit and vegetable group intakes were examined using standardized exposure definitions (Smith-Warner and others 2001). Data sources were eight prospective studies that had at least 200 incident breast cancer cases, included assessment of usual dietary intake, and had completed a validation study of the diet assessment method or a closely related instrument. 

Multiple exposure studies may include obtaining information on possible enzymatic inhibition or induction effects as well as the possibility of bioaccumulation. In such studies, animals are dosed by gavage (or other appropriate route) for 14 days with one dose, usually the highest anticipated dose sufficient animals are used so that three data points are available at each blood sampling time. Blood samples are taken at multiple time points after dosing and analyzed for test chemical or metabolite. These results are compared to the results of the single- exposure definitive study to determine possible enzymatic inhibition or induction effects and bioaccumulation of the test chemical. 

Description Coefflcent that relates emission rate to exposure. Definition 10 (-9)... 

These low-level exposure definitions refer to the effects observed in a single exposure of less than a 24-h duration. " While a level of AChE inhibition is not mentioned for Level 3 exposures, the symptoms described can be considered cholinergic in nature, probably resulting from inhibition of synaptic AChE. This suggests that a prophylactic approach based on the reduction of the concentration of OP toxicant in the blood before it can reach its site of action (synaptic endplates) should be particularly effective potentially incapacitating or even toxic exposures could be mitigated to Level 3-type outcomes, and lower level exposures could be rendered inconsequential. 

For any study, sensitivity analyses should be performed to assess the impact of various study decisions relating to design, exposure definition, outcome definition, or choice of analytic approach. Sensitivity analyses, by demonstrating the robustness (or lack thereof) of conclusions to these design and analysis choices, can contribute to a better interpretation of study results. As should be evident by now, it is important to describe in detail any sensitivity analyses that are performed. 

Because the EPA regulates hazardous wastes in order to protect the environment (not to prevent human exposures), they define hazardous properties differently than agencies such as OSHA, whose purpose is to protect humans. According to the EPA, hazardous waste is chemical material that has been or will be discarded and it has one or more hazardous characteristics or is on one of four lists (called F, K, P, and U Lists). The characteristics regulated are flammability, corrosivity, reactivity, or toxicity. Toxicity is defined as a liquid with concentrations above those listed on the Toxicity Characteristic Leaching Procedure (TCLP) list or< > a solid that when extracted by the TCLP, has a resultant concentration about listed concentrations. This definition has little to do with the human exposure definition of toxicity that you will find in the toxicology sections of this book. 

Minimum exposure times must be observed in order to reach the requisite S/N ratio. As per EN 1435 and EN 584-1, for the different ranges of utilization (energy, wall thickness), definite film elasses are prescribed. They are characterized by the minimum gradient-to-noise ratios. Based on this, one can calculate the minimum values for the S/N ratio based on the IP systems. The exposure time and the device parameter sensitivity and dynamics (latitude) must be adjusted accordingly, with an availability of an at least 12 bit system for the digitalization. 

L exposure would produce 1 ML of adsorbates if the sticking coefficient were unity. Note that a quantitative calculation of the exposure per surface atom depends on the molecular weight of the gas molecules and on the actual density of surface atoms, but the approximations inlierent in the definition of tire Langmuir are often inconsequential. 

Before we are in a position to discuss the viscosity of polymer melts, we must first give a quantitative definition of what is meant by viscosity and then say something about how this property is measured. This will not be our only exposure to experimental viscosity in this volume—other methods for determining bulk viscosity will be taken up in the next chapter and the viscosity of solutions will be discussed in Chap. 9—so the discussion of viscometry will only be introductory. Throughout we shall be concerned with constant temperature experiments conducted under nonturbulent flow conditions. 

Several additional terms related to the absorption of x-radiation require definition energy of a x-ray photon is properly represented in joules but more conveniently reported in eV fluence is the sum of the energy in a unit area intensity or flux is the fluence per unit time and the exposure is a measure of the number of ions produced in a mass of gas. The unit of exposure in medicine is the Rn ntgen, R, defined as the quantity of radiation required to produce 2.58 x C/kg of air. The absorbed dose for a tissue is a measure of energy dissipated per unit mass. The measure of absorbed dose most... 

Toxicology. The acute oral and dermal toxicity of naphthalene is low with LD q values for rats from 1780—2500 mg/kg orally (41) and greater than 2000 mg/kg dermally. The inhalation of naphthalene vapors may cause headache, nausea, confusion, and profuse perspiration, and if exposure is severe, vomiting, optic neuritis, and hematuria may occur (28). Chronic exposure studies conducted by the NTP ia mice for two years showed that naphthalene caused irritation to the nasal passages, but no other overt toxicity was noted. Rabbits that received 1—2 g/d of naphthalene either orally or hypodermically developed changes ia the lens of the eye after a few days, foUowed by definite opacity of the lens after several days (41). Rare cases of such corneal epithelium damage ia humans have been reported (28). Naphthalene can be irritating to the skin, and hypersensitivity does occur. 

The unusual physical complaints and findings in workers overexposed to teUurium include somnolence, anorexia, nausea, perspiration, a metallic taste in the mouth and garlic-like odor on the breath (48). The unpleasant odor, attributed to the formation of dimethyl teUuride, has not been associated with any adverse health symptoms. Tellurium compounds and metaboUc products have been identified in exhaled breath, sweat, urine, and feces. Elimination is relatively slow and continuous exposure may result in some accumulation. No definite pathological effects have been observed beyond the physical complaints outlined. Unlike selenium, teUurium has not been proved to be an essential biological trace element. 

Tb allium, which does not occur naturaHy in normal tissue, is not essential to mammals but does accumulate in the human body. Levels as low as 0.5 mg/100 g of tissue suggest thallium intoxication. Based on industrial experience, 0.10 mg /m of thallium in air is considered safe for a 40-h work week (37). The lethal dose for humans is not definitely known, but 1 g of absorbed thallium is considered sufficient to kHl an adult and 10 mg/kg body weight has been fatal to children. In severe cases of poisoning, death does not occur earlier than 8—10 d but most frequently in 10—12 d. Tb allium excretion is slow and prolonged. For example, tb allium is present in the feces 35 d after exposure and persists in the urine for up to three months. 

For exposure of reasons of observable discrepancy of results of the analysis simulated experiment with application synthetic reference samples of aerosols [1]. The models have demonstrated absence of significant systematic errors in results XRF. While results AAA and FMA depend on sort of chemical combination of an elements, method of an ashing of a material and mass of silicic acid remaining after an ashing of samples. The investigations performed have shown that silicic acid adsorbs up to 40 % (rel.) ions of metals. The coefficient of a variation V, describing effect of the indicated factors on results of the analysis, varies %) for Mn and Fe from 5 up to 20, for Cu - from 10 up to 40, for Pb - from 10 up to 70, for Co the ambassador of a dry ashing of samples - exceeds 50. At definition Cr by a method AAA the value V reaches 70 %, if element presences an atmosphere in the form of Cr O. At photometric definition Cr (VI) the value V is equal 40%, when the element is present at aerosols in the form of chromates of heavy metals. 

In cases where an adverse effect was confirmed, a definite, causative link with exposure to an environmental chemical or chemicals needed to be established. 

Refer to the handbook s Glossary. The definitions provided are universally recognized. Many of these terms are not just pertinent to inhalation hazards. It would be remiss not to mention other risks beyond inhalation from chemical exposure in a work environment and to the general public. 

Typical units for LDjq values are milligrams or grams of material per kilogram of body weight (mg/kg or g/kg, recall that 1 kg = 2.2 pounds). Never be exposed to an LD50 dose of a hazardous chemical- by definition, there is a 50% chance this will kill you and if you survive you are not going to be in good shape. Pay close attention to the permissible exposure level (PEL) instead. This is a more realistic determination of the maximum safe exposure to a material and is usually based on the known effects of the chemical on humans, rather than laboratory animals. 

Two other methods worth discussing are wet air oxidation and regeneration by steam. Wet oxidation may be defined as a process in which a substance in aqueous solution or suspension is oxidized by oxygen transferred from a gas phase in intimate contact with the liquid phase. The substance may be organic or inorganic in nature. In this broad definition, both the well known oxidation of ferrous salts to ferric salts by exposure of a solution to air at room temperature and the adsorption of oxygen by alkaline pyrogallol in the classical Orsat gas analysis would be considered wet oxidations. 

---