Epoxide reactions

Ethylenic compounds when oxidised with perbenzoic acid or perphthalic acid in chloroform solution yield epoxides (or oxiranes). This Is sometimes known as the Prileschajew epoxidation reaction. Thus pyrene affords styrene oxide (or 2-plienyloxirane) ... 

It is usually assumed that the epoxidation reaction proceeds initially by cis addition to the double bond. 

Pinacol-pinacolone rearrangement Prileschajew epoxidation reaction Reformataky reaction Reimer-Tiemanii reaction Rosenmund reduction Sandmeyer reaction Schiemaim reaction Schmidt reaction or rearrangement Schotten-Baumann reaction Skraup reaction Sommelet reaction. ... 

A commonly used peroxy acid is peroxyacetic acid (CH3CO2OH) Peroxyacetic acid is normally used m acetic acid as the solvent but epoxidation reactions tolerate a variety of solvents and are often earned out m dichloromethane or chloroform... 

The most striking chemical property of epoxides is their far greater reactivity toward nude ophilic reagents compared with that of simple ethers Epoxides react rapidly with nude ophiles under conditions in which other ethers are inert This enhanced reactivity results from the angle strain of epoxides Reactions that open the nng relieve this strain... 

Friedel-Crafts. 2-Phenylpropanol results from the catalytic (AlCl, FeCl, or TiCl reaction of ben2ene and propylene oxide at low temperature and under anhydrous conditions (see Friedel-CRAFTS reactions). Epoxide reaction with toluene gives a mixture of 0-, m- and -isomers (75,76). 

After epoxidation a distillation is performed to remove the propylene, propylene oxide, and a portion of the TBHP and TBA overhead. The bottoms of the distillation contains TBA, TBHP, some impurities such as formic and acetic acid, and the catalyst residue. Concentration of this catalyst residue for recycle or disposal is accompHshed by evaporation of the majority of the TBA and other organics (141,143,144), addition of various compounds to yield a metal precipitate that is filtered from the organics (145—148), or Hquid extraction with water (149). Low (<500 ppm) levels of soluble catalyst can be removed by adsorption on soHd magnesium siUcate (150). The recovered catalyst can be treated for recycle to the epoxidation reaction (151). 

The addition—reaction product of bisphenol A [80-05-07] and glycidyl methacrylate [106-91-2] is a compromise between epoxy and methacrylate resins (245). This BSI—GMA resin polymerizes through a free-radical induced covalent bonding of methacrylate rather than the epoxide reaction of epoxy resins (246). Mineral fillers coated with a silane coupling agent, which bond the powdered inorganic fillers chemically to the resin matrix, are incorporated into BSI—GMA monomer diluted with other methacrylate monomers to make it less viscous (245). A second monomer commonly used to make composites is urethane dimethacrylate [69766-88-7]. 

The presence of functional groups on the steroid nucleus can affect the course of the epoxidation reaction thus epoxidation of 3/ -chlorocholest-4-ene (11) gives the 4a,5a-epoxide in 97 % yield, whereas the 3a-chloro group hinders (presumably sterically) attack on the 4,5-double bond towards the a-face of the molecule. The 3a-acetoxy function similarly influences the selectivity of the epoxidation of cholest-4-enes, a 53 47 mixture of the respective 4 , 5a- and 4jS, 5jS-epoxides being obtained after exposure of the 3a-acetoxy-4-ene (13) to perbenzoic acid. 

Hydroxyl groups are stable to peracids, but oxidation of an allylic alcohol during an attempted epoxidation reaction has been reported." The di-hydroxyacetone side chain is usually protected during the peracid reaction, either by acetylation or by formation of a bismethylenedioxy derivative. To obtain high yields of epoxides it is essential to avoid high reaction temperatures and a strongly acidic medium. The products of epoxidation of enol acetates are especially sensitive to heat or acid and can easily rearrange to keto acetates. 

A-ring conjugated ketones do not normally interfere with the epoxidation reaction, but hydride reduction will reduce any ketone groups to alcohols. These can be reoxidized by conventional means. 

The Jacobsen-Katsuki epoxidation reaction is an efficient and highly selective method for the preparation of a wide variety of structurally and electronically diverse chiral epoxides from olefins. The reaction involves the use of a catalytic amount of a chiral Mn(III)salen complex 1 (salen refers to ligands composed of the N,N -ethylenebis(salicylideneaminato) core), a stoichiometric amount of a terminal oxidant, and the substrate olefin 2 in the appropriate solvent (Scheme 1.4.1). The reaction protocol is straightforward and does not require any special handling techniques. 

One of the most significant developmental advances in the Jacobsen-Katsuki epoxidation reaction was the discovery that certain additives can have a profound and often beneficial effect on the reaction. Katsuki first discovered that iV-oxides were particularly beneficial additives. Since then it has become clear that the addition of iV-oxides such as 4-phenylpyridine-iV-oxide (4-PPNO) often increases catalyst turnovers, improves enantioselectivity, diastereoselectivity, and epoxides yields. Other additives that have been found to be especially beneficial under certain conditions are imidazole and cinchona alkaloid derived salts vide infra). 

Initial studies on the Jacobsen-Katsuki epoxidation reaction identified conjugated eyelie and acyelic cw-disubstituted olefins as the class of olefins best suited for the epoxidation reaetion. " Indeed a large variety of c/s-disubstituted olefins have been found to undergo epoxidation with a high degree of enantioselectivity. 2,2"-Dimethylehromene derivatives are especially good substrates for the epoxidation reaetion. Table 1.4.1 lists a variety of examples with their corresponding reference. 

The Jacobsen-Katsuki epoxidation reaction has found wide synthetic utility in both academia and industrial settings. As described previously, the majority of olefin classes, when conjugated, undergo Mn(salen)-catalyzed epoxidation in good enantioselectivity. In this section, more specific synthetic utilities are presented. 

The first application of the Jacobsen-Katsuki epoxidation reaction to kinetic resolution of prochiral olefins was nicely displayed in the total synthesis of (+)-teretifolione B by Jacobsen in 1995. 

Jacobsen-Katsuki epoxidation reaction in total synthesis Scheme 1.4.11... 

The Jacobsen-Katsuki epoxidation reaction has been widely used for the preparation of a variety of structurally diverse complex molecules by both academia and the pharmaceutical industry. Summarized below are a few examples. 

CDP840 is a selective inhibitor of the PDE-IV isoenzyme and interest in the compound arises from its potential application as an antiasthmatic agent. Chemists at Merck Co. used the asymmetric epoxidation reaction to set the stereochemistry of the carbon framework and subsequently removed the newly established C-O bonds." Epoxidation of the trisubstituted olefin 51 provided the desired epoxide in 89% ee and in 58% yield. Reduction of both C-O bonds was then accomplished to provide CDP840. 

The epoxidation reaction usually takes place under mild conditions and with good to very good yield. Functional groups that are sensitive to oxidation should not be present in the starting material with carbonyl groups a Baeyer-Villiger reaction may take place. 

A model for the catalytically active species in the Sharpless epoxidation reaction is formulated as a dimer 3, where two titanium centers are linked by two chiral tartrate bridges. At each titanium center two isopropoxide groups of the original tetraisopropoxytitanium-(IV) have been replaced by the chiral tartrate ligand ... 

In order to obtain good yields, it is important to use dry solvent and reagents. The commercially available t-butyl hydroperoxide contains about 30% water for stabilization. For the use in a Sharpless epoxidation reaction the water has to be removed first. The effect of water present in the reaction mixture has for example been investigated by Sharpless et al. for the epoxidation of (E)-a-phenylcinnamyl alcohol, the addition of one equivalent of water led to a decrease in enantioselectivity from 99% e.e. to 48% e.e. 

Compounds are prepared by a fairly standard sequence which consists of condensation of an appropriate phenol with epichlorohydrin in the presence of base. Attack of phenoxide can proceed by means of displacement of chlorine to give epoxide (45) directly. Alternatively, opening of the epoxide leads to anion 44 this last, then, displaces halogen on the adjacent carbon to lead to the same epoxide. Reaction of the epoxide with the appropriate amine then completes the synthesis. 

The oxidation of alkenes and allylic alcohols with the urea-EL202 adduct (UELP) as oxidant and methyltrioxorhenium (MTO) dissolved in [EMIM][BF4] as catalyst was described by Abu-Omar et al. [61]. Both MTO and UHP dissolved completely in the ionic liquid. Conversions were found to depend on the reactivity of the olefin and the solubility of the olefinic substrate in the reactive layer. In general, the reaction rates of the epoxidation reaction were found to be comparable to those obtained in classical solvents. 

Epoxidation with hydrogen peroxide has also been tried. The epoxidation reaction is catalyzed with compounds of As, Mo, and B, which are claimed to produce propylene oxide in high yield ... 

Whenever a chiral product is formed by reaction between achiral reagents, the product is racemic that is, both enantiomers of the product are formed in equal amounts. The epoxidation reaction of geraniol with m-chloroperoxybenzoic acid, for instance, gives a racemic mixture of (2R,3S) and (2S,3R) epoxides. 

In light of the previous discussions, it would be instructive to compare the behavior of enantiomerically pure allylic alcohol 12 in epoxidation reactions without and with the asymmetric titanium-tartrate catalyst (see Scheme 2). When 12 is exposed to the combined action of titanium tetraisopropoxide and tert-butyl hydroperoxide in the absence of the enantiomerically pure tartrate ligand, a 2.3 1 mixture of a- and /(-epoxy alcohol diastereoisomers is produced in favor of a-13. This ratio reflects the inherent diasteieo-facial preference of 12 (substrate-control) for a-attack. In a different experiment, it was found that SAE of achiral allylic alcohol 15 with the (+)-diethyl tartrate [(+)-DET] ligand produces a 99 1 mixture of /(- and a-epoxy alcohol enantiomers in favor of / -16 (98% ee). 

The emergence of the powerful Sharpless asymmetric epoxida-tion (SAE) reaction in the 1980s has stimulated major advances in both academic and industrial organic synthesis.14 Through the action of an enantiomerically pure titanium/tartrate complex, a myriad of achiral and chiral allylic alcohols can be epoxidized with exceptional stereoselectivities (see Chapter 19 for a more detailed discussion). Interest in the SAE as a tool for industrial organic synthesis grew substantially after Sharpless et al. discovered that the asymmetric epoxidation process can be conducted with catalytic amounts of the enantiomerically pure titanium/tartrate complex simply by adding molecular sieves to the epoxidation reaction mix-... 

---