Reactions enantioselective epoxidation

Other Enantioselective Reactions. Enantioselective epoxide elimination by chiral bases has been demonstrated. More recently, the enantioselective [2,3]-Wittig rearrangement of a 13-membered propargylic ally lie ether has been performed using the lithium amide of (f ,f )-(l) as the base for deprotonation (eq 15). For this particular substrate, THF is a better solvent than ether, although pentane produces better results in a related transformation (eq 16). In fact, a change in solvent in this type of reaction has been shown to lead to a reversal of the stereoselectivity of the transformation. ... 

In 1990, Jacobsen and subsequently Katsuki independently communicated that chiral Mn(III)salen complexes are effective catalysts for the enantioselective epoxidation of unfunctionalized olefins. For the first time, high enantioselectivities were attainable for the epoxidation of unfunctionalized olefins using a readily available and inexpensive chiral catalyst. In addition, the reaction was one of the first transition metal-catalyzed... 

E The writing has again been revised at the sentence level, streamlining the presentation, improving explanations, and updating a thousand small details. Several little-used reactions have been deleted (the alkali fusion of arene-sulfonic acids to give phenols, for instance), and a few new ones have been added (the Sharpless enantioselective epoxidation of alkene.s, for instance). 

In Case study 2, mass balancing is used to compare a biocatalytic (a) and a chemical catalytic (b) enantioselective epoxidation reaction (Scheme 5.3). 

The enantioselectivity was significantly influenced by the steric factor of the thiols employed. When p-MeC6H4SH and PhSH were used, the optical yields decreased to 69% and 3%, respectively. Shibasaki et al. have reported that gallium-lithium-bi-naphthoxide (GLB) 51 became a good catalyst for the enantioselective ring opening reaction of epoxide for the production of 52 (Eq. 7.39) [46]. 

Catalytic asymmetric epaxidation (13, 51-53). Complete experimental details are available for this reaction, carried out in the presence of heat-activated crushed 3A or powdered 4A molecular sieves. A further improvement, both in the rate and enantioselectivity, is use of anhydrous oxidant in isoctane rather than in CH2C12. The titanium-tartrate catalyst is not stable at 25°, and should be prepared prior to use at -20°. Either the oxidant or the substrate is then added and the mixture of three components should be allowed to stand at this temperature for 20-30 min. before addition of the fourth component. This aging period is essential for high enantioselectivity. Epoxidations with 5-10 mole % of Ti(0-/-Pr)4 and 6-12% of the tartrate generally proceed in high conversion and high enantioselectivity (90-95% ee). Some increase in the amount of catalyst can increase the enantioselectivity by 1-5%, but can complicate workup and lower the yield. Increase of Ti(0-i-Pr)4 to 50-100 mole % can even lower the enantioselectivity. 

A more versatile method to use organic polymers in enantioselective catalysis is to employ these as catalytic supports for chiral ligands. This approach has been primarily applied in reactions as asymmetric hydrogenation of prochiral alkenes, asymmetric reduction of ketone and 1,2-additions to carbonyl groups. Later work has included additional studies dealing with Lewis acid-catalyzed Diels-Alder reactions, asymmetric epoxidation, and asymmetric dihydroxylation reactions. Enantioselective catalysis using polymer-supported catalysts is covered rather recently in a review by Bergbreiter [257],... 

Although the Sharpless catalyst was extremely useful and efficient for allylic alcohols, the results with ordinary alkenes were very poor. Therefore the search for catalysts that would be enantioselective for non-alcoholic substrates continued. In 1990, the groups of Jacobsen and Katsuki reported on the enantioselective epoxidation of simple alkenes both using catalysts based on chiral manganese salen complexes [8,9], Since then the use of chiral salen complexes has been explored in a large number of reactions, which all utilise the Lewis acid character or the capacity of oxene, nitrene, or carbene transfer of the salen complexes (for a review see [10]). 

Sn2 Reactions with epoxides and aziridines are also synthetically useful. An example of epoxide cleavage with an organocopper reagent with sp carbon moieties is the enantioselective synthesis of (3S, 4S)-4-methyl-3-heptanol (53), an elm bark beetle (Scolytus multistriatus) pheromone [42]. The chiral epoxy oxazolidine 51 [43], prepared from (R)-phenylglycinol, reacted with a propylmagnesium bromide-derived cuprate at —70 °C to afford the oxazolidine 52 in 74% yield (Scheme 9.12). Compound 52 was converted into the target molecular 53 by conventional procedures. 

A -tritylaziridine-2-(5)-carboxaldehyde. The application of a novel, sequential, trans-acetalation oxonium ene cyclization has delivered a stereoselective synthesis of the C-aromatic taxane skeleton, and a combinatorial sequence of the regioselective propiolate-ene, catalytic enantioselective epoxidation and carbonyl-ene cyclization reactions has been used to complete the synthesis of the A-ring of a vitamin D hybrid analogue. 

Scheme 2 Various strategies for enantioselective epoxide ring opening reactions.

Schneider, C. (2006) Synthesis of 1,2-difunctionalized fine chemicals through catalytic, enantioselective ring-opening reactions of epoxides., Synthesis, 3919-3944. 

The tra x-[Ru (0)2(por)] complexes are active stoichiometric oxidants of alkenes and alkylaro-matics under ambient conditions. Unlike cationic macrocyclic dioxoruthenium I) complexes that give substantial C=C bond cleavage products, the oxidation of alkenes by [Ru (0)2(por)] affords epoxides in good yields.Stereoretentive epoxidation of trans- and cw-stilbenes by [Ru (0)2(L)1 (L = TPP and sterically bulky porphyrins) has been observed, whereas the reaction between [Ru (0)2(OEP)] and cix-stilbene gives a mixture of cis- and trani-stilbene oxides. Adamantane and methylcyclohexane are hydroxylated at the tertiary C—H positions. Using [Ru (0)2(i)4-por)], enantioselective epoxidation of alkenes can be achieved with ee up to 77%. In the oxidation of aromatic hydrocarbons such as ethylbenzenes, 2-ethylnaphthalene, indane, and tetrahydronaphthalene by [Ru (0)2(Z>4-por )], enantioselective hydroxylation of benzylic C—H bonds occurs resulting in enantioenriched alcohols with ee up to 76%. ... 

Snapper and Hoveyda reported a catalytic enantioselective Strecker reaction of aldimines using peptide-based chiral titanium complex [Eq. (13.11)]. Rapid and combinatorial tuning of the catalyst structure is possible in their approach. Based on kinetic studies, bifunctional transition state model 24 was proposed, in which titanium acts as a Lewis acid to activate an imine and an amide carbonyl oxygen acts as a Bronsted base to deprotonate HCN. Related catalyst is also effective in an enantioselective epoxide opening by cyanide "... 

This method has proven to be an extremely useful means of synthesizing enantiomerically enriched compounds. Various improvements in the methods for carrying out the Sharpless oxidation have been developed.48 The reaction can be done with catalytic amounts of titanium isopropoxide and the tartrate ester.49 This procedure uses molecular sieves to sequester water, which has a deleterious effect on both the rate and enantioselectivity of the reaction. Scheme 12.9 gives some examples of enantioselective epoxidation of allylic alcohols. 

The use of a chiral hydroperoxide as oxidant in the asymmetric Baeyer-ViUiger reaction was also described by Aoki and Seebach, who tested the asymmetric indnction of their TADOOH hydroperoxide in this kind of reaction . Besides epoxidation and snlfoxidation, for which they found high enantioselectivities with TADOOH (60), this oxidant is also able to induce high asymmetry in Baeyer-ViUiger oxidations of racemic cyclobntanone derivatives in the presence of DBU as a base and LiCl as additive (Scheme 174). The yields and ee values (in parentheses) of ketones and lactones are given in Scheme 174 as... 

Even in the case of the Sharpless epoxidation reaction, where the stereochemical course has been confirmed in many examples, exceptions have been reported. As an illustration On enantioselective epoxidation in the presence of L-( + )-DIPT, meso-1,5-hcxadiene-3,4-diol (24a) gave epoxide 25 (formed in an unexpected mode) as the main product136 227 whereas, ( )-ben-zyl ether 24b, obtained from 24a by monobenzylation, on kinetic resolution in the presence of l.( + )-dipt yielded monoepoxide (+)-26, which belongs to the enantiomeric series (see also pp 420, 449 and 470) 37. 

Enantioselective epoxidation of allylic alcohols using hydrogen peroxide and chiral catalysts was first reported for molybdenum 7B) and vanadium 79) complexe. In 1980, Sharpless 80) reported a titanium system. Using a tartaric acid derivative as chiral auxiliary it achieves almost total stereoselection in this reaction. 

The haem peroxidases are a superfamily of enzymes which oxidise a broad range of structurally diverse substrates by using hydroperoxides as oxidants. For example, chloroperoxidase catalyses the regioselective and stereoselective haloge-nation of glycals, the enantioselective epoxidation of distributed alkenes and the stereoselective sulfoxidation of prochiral thioethers by racemic arylethyl hydroperoxides [62]. The latter reaction ends in (i )-sulfoxides, (S)-hydroperoxides and the corresponding (R)-alcohol, all In optically active forms. 

The enantioselective epoxidation using [diphenylazepinium] [TRISPHAT] salts as catalysts is an easily reproducible procedure that requires no particular precautions except in the handling of Oxone . Although moderate levels of enantiomeric excess are observed, this reaction can be applied to a wide range of olefins, and both enantiomers of the catalyst are readily available through the use of the S) or (R) enantiomers of 3,3-dimethylbutan-2-amine. The results of a small screen using [6-A-((5)-3,3-dimethylbutan-2-yl)-5/7-dibenz[c,e]azepinium][rac-TRISPHAT] salt as catalyst are reported in Table 6.1... 

Asymmetric epoxidation of a,jS-unsaturated ketones represents an efficient method for the preparation of optically active a,jS-epoxy ketonesJ Recently, a new and very efficient catalytic system for enantioselective epoxidation of ( )-a,jS-enones to the corresponding trans-epoxy ketones has been developed based on a BlNOL-zinc complexJ Very high yields and excellent diastereo- and enantioselectivities are achieved at room temperature using cumene hydroperoxide (CMHP) as the terminal oxidant and performing the reaction in diethyl ether. A combination of enantio-merically pure BINOL and diethylzinc readily affords the active catalyst in situ (Figure 6.13). ... 

---