Derivatives of poly

Strauss and Williamst have studied coil dimensions of derivatives of poly(4-vinylpyridine) by light-scattering and viscosity measurements. The derivatives studied were poly(pyridinium) ions quaternized y% with n-dodecyl groups and (1 - y)% with ethyl groups. Experimental coil dimensions extrapolated to 0 conditions and expressed relative to the length of a freely rotating repeat unit are presented here for the molecules in two different environments ... 

Currem field characteristics measured wiih conjugated polymers sandwiched between an indium-tin oxide (ITO) anode and an aluminum cathode are usually hole dominated and are, consequently, appropriate for testing injection/lransport models for the case of unipolar current How. Data shown in Figure 12-1 refer to injection-limited currents recorded on typically 100 nm thick spin-coated films of derivatives of poly(y d/"fi-phenylenevinylene) (PPV) and a planarized poly(/ /" -pheny-leue) employing a Keilhley source measure unit. The polymers were ... 

Even in solution the relative rigidity of the polymer support can play a significant role in the reactivity of attached functional groups. Contrasting studies conducted with chloromethylated derivatives of poly(arylene ether sulfone) (Tg 175°C), phenoxy resin (Tg= 65°C) and polystyrene (Tg= 105°C) allow evaluation of chain rigidity effects. We have shown that the rates of quaternization of chloromethylated poly(arylene ether sulfones) and phenoxy resin deviate from the anticipated second order process at... 

Figure 13 shows the irreversible conversion of a nonconjugated poly (p-phenylene pentadienylene) to a lithiun-doped conjugated derivative which has a semiconducting level of conductivity (0.1 to 1.0 S/cm) (29). Obviously, the neutral conjugated derivative of poly (p-phenylene pentadienylene) can then be reversibly generated from the n-type doped material by electrochemical undoping or by p-type compensation. A very similar synthetic method for the conversion of poly(acetylene-co-1,3-butadiene) to polyacetylene has been reported (30), Figure 14. This synthesis of polyacetylene from a nonconjugated precursor polymer containing isolated CH2 units in an otherwise conjugated chain is to be contrasted with the early approach of Marvel et al (6) in which an all-sp3 carbon chain was employed.

Hurwitz et al. [256] used a hydrazide derivative of poly(glutamic acid) as a carrier for daunamycin. This was less toxic than free drug against mouse lymphoma in vitro, but it was as effective, or more effective, against the same lymphoma in vivo. 

Photocrosslinking. The second class of photopolymer chemistry that is used in some commercial products is based on the reaction of unsaturated moieties attached to an organic polymer. These photopolymer materials include the [2+2] cycloaddition of the ethylenic groups in poly(vinyl cinnamate) polymers and in the newer styryl pyridinium (10) and thiazolium (77) derivatives of poly(vinyl alcohol). The main advantage of this chemistry is that, unlike free-radical photopolymerization, they are insensitive to the presence of oxygen. This photopolymer mechanism is principally used in applications employing a washout development process (e.g. resists). 

F. Cacialli, R.H. Friend, N. Haylett, R. Daik, W.J. Feast, D.A. dos Santos, and J.L. Bredas, Efficient green light-emitting diodes from a phenylated derivative of poly(p-phenylene vinylene), Appl. Phys. Lett., 69 3794-3796, 1996. 

L.S. Swanson, J. Shinar, Y.W. Ding, and T.J. Barton, Photoluminescence, electroluminescence, and optically detected magnetic resonance study of 2,5-dialkoxy derivatives of poly(p-phenylene acetylene) (PPA) and PPA-based light-emitting diodes, Synth. Met., 55 1-6, 1993. 

While this work has focused on certain allylic and benzylic ether derivatives of poly(4-hydroxystyrene) it is possible to extend the concept to the corresponding t-butoxy substituted polymers although the preparation of such polymers is relatively more difficult than in the present case. 

The derivatives of poly-L-lysine having pendant nucleic acid bases, that is, adenine, thymine and uracil were prepared as shown in the following scheme ... 

Allen TM, Hansen C, Martin F, Redemann C, Yau-Young A. Liposomes containing synthetic lipid derivatives of poly(ethylene glycol) show prolonged circulation half-lives in vivo. Biochim Biophys Acta 1991 1066 29. 

Kirsh et al. 42) prepared apolar derivatives of poly(4-vinylpyridine) by benzylation. With nitrophenyl acetate as the substrate the benzylated catalyst is 100 times more effective than 4-ethylpyridine. A double-displacement mechanism was observed. The rate constants for deacylation of the acylpoly(vinylpyridine) derivatives were about 4 x 10" /sec. The comparable value for a-chymotrypsin is 8 x 10 /sec. The factor of 20 seems small, but it should be kept in mind that deacetylation of a-chymotrypsin is very slow compared with the deacylation reactions involving the natural substrates of the enzyme. 

A novel concept of using bioadhesive polymers as enzyme inhibitors has been developed [97]. Included are derivatives of poly acrylic acid, polycarbophil, and car-bomer to protect therapeutically important proteins and peptides from proteolytic activity of enzymes, endopeptidases (trypsin and a-chymotrypsin), exopeptidases (carboxypeptidases A and B), and microsomal and cytosolic leucine aminopeptidase. However, cysteine protease (pyroglutamyl aminopeptidase) is not inhibited by polycarbophil and carbomer [97]. 

On zinc phosphate conversion coatings, the "Mannich" derivatives of poly-4-vinylphenol have demonstrated performance equivalent to chromic chromate systems in salt spray, humidity, and physical testing. In addition. Table III illustrates results observed with automotive body paint systems evaluated by the "scab" or "cycle" test which causes failure more typical of actual end use conditions than do salt spray evaluations. Again, results equivalent to chromic-chromate post-treatments were obtained. In addition, the humidity resistance and adhesion tests were essentially equivalent to the chromium controls. 

Alkyl and aryl derivatives of poly(dichlorophosphazene) are not efficiently synthesized by nucleophilic reaction of LXXXIV with metal alkyls or aryls. The halogen substitution reaction occurs but is accompanied by polymer chain cleavage. Use of poly(difluorophosphazene) or introduction of aryl and alkyl groups at the monomer stage offer some improvement, but neither method is fully satisfactory. The best route to alkyl and aryl derivatives is polymerization of A-(trimethylsilyl)-/).P-dialkyl-.P-halophosphoranimines at moderate temperatures (25-60°C) in the presence of a Lewis acid [Allcock et al., 1996, 2000, 2001a,b Neilson and Wisian-Neilson, 1988]. The reaction proceeds as a cationic chain polymerization ... 

He et al. (2) prepared a hydrolyzably crosslinked biodegradable network consisting of poly(propylene fumarate) crosslinked with the diacrylate derivative of poly(propylene fumarate), (I). 

Some derivatives of poly(acrylamide), such as the (2-aminoethyl) derivative, may be dried by lyophilization, but other derivatives should not be dried. Some derivatives may be stored in the wet state in buffer solution at low temperature, but others may not be so stored. In general, poly(acrylamide) derivatives should be used immediately after preparation. It is especially important that poly(acrylamide) derivatives should not be subjected to alternate freezing and thawing, as such treatment will cause fragmentation of the poly(acrylamide) beads. 

Carboxylate derivatives of poly(vinyl alcohol) are biodegradable and function in detergents as cobuilders, although they are too cosdy to be practical as of 1996. Vinyloxyacetic acid has been polymerized (5) (101,102), and Lever has patented polymers, eg, poly(vinyloxyaspartic acid) (6), based on vinyl carbamates obtained from the reaction of vinjd chloroformates and amino acids such as aspartic and glutamic acids (103). Both hydrolyze to poly(vinyl alcohol) and then biodegrade. 

The effect of the side chain bulkiness has been further studied on a series of chloro derivatives of poly(ethyl methacrylate)(PEMA). Though poly(2-chloroethyl methacrylate) exhibits69 a pronounced peak at Ty = 117 K, poly(2,2,2-trichloroethyl methacrylate), poly(2,2,2-trichloro-l-methoxyethyl methacrylate), and poly(2,2,2-trichloro-l-ethoxyethyl methacrylate) do not show (Fig. 6) any low-temperature loss maximum above the liquid nitrogen temperature157. However, these three polymers probably display a relaxation process below 77 K as indicated by the decrease in the loss modulus with rising temperature up to 100 K. Their relaxation behavior seems to be similar to that of PEMA rather than of poly(2-chloroethyl methacrylate) which is difficult to explain. 

Derivatives of poly(vinyl alcohol) by reaction with aldehydes Grafted polymers... 

Figure 2. Helicoidal structure of Amadori-lype sugar derivatives of poly-L-lysine.

The materials (metals and conjugated polymers) that are used in LED applications were introduced in the previous chapter. The polymer is a semiconductor with a band gap of 2-3 eV. The most commonly used polymers in LEDs today are derivatives of poly(p-phenylene-vinylene) (PPV), poly(p-phenylene) (PPP), and polythiophene (PT). These polymers are soluble and therefore relatively easy to process. The most common LED device layout is a three layer component consisting of a metallic contact, typically indium tin oxide (ITO), on a glass substrate, a polymer film r- 1000 A thick), and an evaporated metal contact4. Electric contact to an external voltage supply is made with the two metallic layers on either side of the polymer. 

---