Commencement dates

The NAFDAC Decree 1993 (Decree 15, 1993) was given a commencement date of 1 October 1992 while the council was inaugurated on 31 December 1992. 

For example, if we take the time factor it is appreciated that an EIA study needs a long period of time. So at first sight, the result of delayed projects appears as an economic loss. But in this evaluation there is one matter that is being overlooked, and that is the commencement date of EIA studies. An administration that knows and believes the advantages of this approach will start the environmental evaluation of a particular activity or project as soon as possible and will continue with other planning studies related with this activity in parallel with an EIA preparation. 

Periodicals, with commencing dates, include Pesticide Biochemistry and Physiology (1970), Pesticide Chemistry (1972), Advances in Pesticides (1977), and Progress in Pesticide Biochemistry (1981). For a study of the action of pollutants on ecosystems (with special reference to chlorinated hydrocarbons) see Moriarty (1983). 

Coastal engineering tender documents issued by clients may have a contract duration specified, but rarely is an exact commencement date for the works given. The typical requirement for three months validity for tenders reflects a corresponding uncertainty in the commencement date. As a result, the weather statistics during the contract may reflect a more stormy or less stormy period than anticipated (especially if the contract is only to be of six to nine months duration). 

Uncertainty about the commencement date may be controllable by the client. Often lack of confidence in the availability and timing of funding is cited as a reason for not fixing the commencement date. 

Sometimes commencement dates are expressed in the as soon as possible category. Valid reasons for this may relate to the urgency of the project. However, urgency can arise for a number of reasons. For example, this may arise due to the need to make use of particular plant as soon as available risk of failure of existing works risk of loss of funds for the project (e.g. due to the approach of the end of the financial year for public sector clients) and political urgency. 

Finally, to ensure that the effect of a suspension, revocation, or modification determination is clear to the certified individual or firm, EPA has added language to this section ensuring that the commencement date and duration of a suspension, revocation, or modification is identified in the presiding officer s decision and order. EPA has also added language to this section to clarify what steps an individual or firm must take after such an action to exercise the privileges of certification again. 

Chemical Abstracts. These were commenced by the American Chemical Society in 1907. The abstracts are very comprehensive (particularly in recent years) from the standpoint of subject matter and journals covered. Four decennial indexes have appeared—1917, 1927, 1937 and 1947—and these are widely used for locating information pub lished during the period 1907-1947. The annual indexes cover the period 1948 to date. 

To date (ca 1997), steam methods have been appHed almost exclusively in relatively thick reservoirs containing viscous cmde oils. In the case of heavy oil fields and tar sand deposits, the cycHc steam injection technique has been employed with some success. The technique involves the injection of steam at greater than fracturing pressure, usually in the 10.3—11.0 MPa (1500—1600 psi) range, foUowed by a soak period, after which production is commenced (15). 

That the landlord has good title and therefore to give possession of the date fixed for commencement of the term ... 

Difficulties arise when delays in obtaining bid approval occur, because time moves very quickly, and the work may not actually commence on the date stated in the bid documents. This causes problems when the contractors have carefully arranged their own work schedules. It is better not to be too optimistic regarding start and completion dates unless various stages to a contract document being signed are clear. 

Unless there is a clear program of works which has been mentioned in the bid documents, before accepting bids make sure that the contractor or supplier has specifically stated his commencement and completion dates. In the event that the completion date is too early or too late, resolve the matter before entering into the contract. 

Logistical issues, such as the date the selection process commences, how to apply, dates for the start of the mentoring program etc. 

All application verification and soil samples must be individually labeled with unique sample identification (ID) and other identifying information such as study ID, test substance name, sample depth, replicate, subplot and date of collection, as appropriate. Proper study documentation requires that sample lists and labels be created prior to work commencing in the field. Water- and tear-resistant labels should be used since standard paper labels may become water-soaked and easily torn during sample handling. Sample lists should have the same information on them as the labels and are a convenient place to record plot randomization, initials of the individual who collected the sample, and date of collection. As such, the sample list is important in establishing chain of custody from the point of sample collection until its arrival at the laboratory. 

Very limited investigations have been conducted with this alloy system. The results obtained to date suggest that A1 co-deposits with Fe from solutions of Fe(II) in both AlCl3-EtMeImCl at 25 °C [46] and AlCl3-NaCl at 160 °C [100]. In both studies, the A1 co-deposition process was found to commence at nearly the same potential as the Fe(II) reduction reaction therefore, it was difficult to observe a well-defined voltammetric limiting current for the latter process, regardless of the technique that was employed. This behavior is nearly identical to that seen in the Ni-Al system [47], However, a comparison of the voltammetric results recorded for some of the other... 

If we accept a date of around AD 1000 for the commencement of the distillation of zinc on a large scale, then, following the work of Craddock (1978), all earlier brasses should contain less than 28% Zn, as this is the approximate upper limit for the calamine process at around 1000 °C. Above this temperature, the process is more efficient, but it is said that the brass produced melts and the active surface area for the process is thus reduced. By granulating the copper and therefore increasing the surface area, the maximum can be pushed to around 33% Zn, but it is unlikely that this was done in Europe until the 18th Century (see Section 6.4). This model is supported by the analytical data Craddock s work on Roman brass indeed shows an upper limit of about 28% zinc. 

Boatbuilders who use composites have, at most, just one more year before they have to reduce emissions to meet National Emission Standards for Hazardous Air Pollutants (NESH AP), also known as Maximum Achievable Control Technology (MACT) standards. By 23rd Aug. 2004, most boat manufacturing facilities subject to NESHAP must comply with 40 Code of Federal Regulations (CFR) Part 63, Subpart VVW. The deadline applies to existing boat manufacturing facilities that are major sources of hazardous air pollutants (HAPs). Existing sources are those that commenced construction on or before July 14, 2000. ( New sources , those that commenced construction after this date, must comply with emission limits at startup.) Major sources are facilities that have the potential to... 

The WFD has established a framework for the protection of inland surface water, transitional waters and groundwater which aims at achieving good ecological potential and good surface water chemical status within 15 years from the date of commencement of the Directive, i.e. 22 December, 2000 (Directive 2000/60/EC, L327/1, Official Journal of the EU). 

In order for the contributions to be deductible, payments for both cash and accrual basis taxpayer may be made no later than the due date of the income tax return. If a contribution is made in excess of the 15% or 7500 limitations, the excess is subject to a yearly 6% excise tax penalty until such excess contribution is fully utilized. Distributions under a Keogh Plan may not commence before an individual reaches age 59%, except for reasons of disability or death. Like the individual retirement account, distributions must commence no later than the taxable year in which the individual attains age 70%. 

Is there a clear description of what source data will be recorded directly into the CRF and what will be recorded in the medical records Normally, the protocol identification number, the date of consent, the date of commencement of the study, the visit dates, the start and finish dates of the administration of study drug and/or treatment, concurrent medication, adverse events and... 

The protocol should specify what should be recorded directly into the CRF and what will also be recorded in the medical records. The CRF will contain all the pertinent data associated specifically with the clinical trial but some will be repeated in the medical records, for example, the protocol identification number, date of consent, date of commencement of the study, key baseline medical findings, visit dates, start and finish dates of the study drug/placebo or treatment, concurrent medication, adverse events and key efficacy and any unscheduled or scheduled actions or interventions (such as escape medication). Additional information obtained from biopsy reports, radiographs and similar documents will provide confirmation that the data in the CRF are recorded correctly. Monitors, QA auditors and inspectors need to see all the medical records available to the investigator. It is not appropriate to create copies of data from CRFs or checklists derived from medical records and claim that these are source documents. 

There are two levels of evaluation of applications for clinical trials of medicines under the CTX scheme. A 30 working day period for evaluation of a CTX application applies when the supporting data relate only to chemical, pharmaceutical and biological issues. A 50 working day period applies for applications supported by chemical, pharmaceutical and biological, preclinical and clinical data. These evaluation times commence from the date of acceptance of the apphcation or receipt of the appropriate fee. The fee for a 30 day CTX application is currently AUD 1240 and for a 50 day application AUD 15300. 

---