Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Cinnamic acids, 2+2 addition

Cinnamic acid can be readily esterified by the Fischer-Speier method without any risk of the addition of hydrogen chloride at the double bond. Proceed precisely as for the preparation of ethyl benzoate (p. 104), using 20 g. of cinnamic acid and 20 ml. of rectified spirit. When the crude product is poured into water, a sharp separation of the ester is not readily obtained, and hence the addition of about 10 ml. of carbon tetrachloride is particularly desirable. Finally distil off the carbon... [Pg.237]

Physical and Chemical Properties. The (F)- and (Z)-isomers of cinnamaldehyde are both known. (F)-Cinnamaldehyde [14371-10-9] is generally produced commercially and its properties are given in Table 2. Cinnamaldehyde undergoes reactions that are typical of an a,P-unsaturated aromatic aldehyde. Slow oxidation to cinnamic acid is observed upon exposure to air. This process can be accelerated in the presence of transition-metal catalysts such as cobalt acetate (28). Under more vigorous conditions with either nitric or chromic acid, cleavage at the double bond occurs to afford benzoic acid. Epoxidation of cinnamaldehyde via a conjugate addition mechanism is observed upon treatment with a salt of /-butyl hydroperoxide (29). [Pg.174]

The couplings of vicinal protons in 1,2-disubstituted alkenes lie in the range 6-12 Hz for cis protons (dihedral angle 0°) and 12-17 Hz for trans protons (dihedral angle 180°), thus also following the Karplus-Conroy equation. Typical examples are the alkene proton AB systems of coumarin (16a, cis) and tra 5-cinnamic acid (16b), and of the cis-trans isomers 17a and b of ethyl isopente-nyl ether, in addition to those in problems 3, 4, 8, 11, 13 and 38. [Pg.44]

Cinnamic Acid.—The reaction, which takes place when an aldehyde (aliphatic or aromatic) acts on the sodium salt of an aliphatic acid in presence of the anhychide, is known as Perkin s reaction, and has a ery wide application. Accoid-ing to the result of Fittig s researches on the properties of the unsaturated acids described below, the reaction occurs in two steps. The aldeh) de forms first an additive compound with the acid, the aldehyde caibon attaching itself to the n-carbon ii.e.i nevt the carbovyl) of the acid. A saturated hydiOKy-acid is formed, which is stable, if the a-carbon is attached to only one atom of hydrogen, as in the case of isobutync acid,... [Pg.304]

The synthesis of isoxazolines usually takes the most thermodynamically favorable course to yield solely the more stable isomer. However, cinnamic acids (38) give not only isoxazoline-4-carboxylic acids (39) but also, as a by-product, the less stable isoxazoline-5-carboxylic acids (40)" which on heating undergo retro-addition. ... [Pg.377]

As shown in Schemes 10-44 and 10-45, two products may be formed in a Meerwein reaction Scheme 10-44 shows a simple aryl-de-hydrogenation of cinnamic aldehyde, whereas Scheme 10-45 shows an aryl-de-hydrogenation combined with the addition of HC1 to the double bond of the methyl ester of cinnamic acid. No systematic studies have been made as to which of the two products will be formed in a given reaction, what experimental conditions will favor one or the other product, and what substituents or other structural characteristics of the alkene influence the ratio of the two types of product. The addition product can, in most cases, easily be converted... [Pg.244]

The ionization of benzoic acids in water at 25° was used by Hammett as the standard reaction for the original qp treatment (2a). This reaction and several analogous reactions, e.g., ionization and ester saponification rates of benzoic acids, cinnamic acids, and phenylpropiolic acids, gives ap correlations of relatively high precision. Taft and Lewis classified such reactions in an A category (2f). Reexamination of these A reactions, as well as additional analogous data which have become available subsequently, provided eight reaction series of data of apparently comparable reliability. In the para position, each of these sets of data meets the necessary condition of a minimal basis set... [Pg.17]

The trans cinnamic acid and phenyl propiolic acid data involve fits of essentially the same precision at o-, m-, and p- positions (SD =. 05 . 02). However, the RMS of these sets is quite low, and consequently, / values of. 200 prevail. The interpretation of these results is therefore uncertain. To the extent that the results of Table VII are meaningful, it is of particular interest that Kj =p°Ip =. 68 for the phenyl propiolic acid, whereas for the tram cinnamic acids, K° = 1.02. These results suggest that in contrast to the ortho substituted benzoic acids, the lines of field forces in the ortho substituted phenyl propiolic acids do (partly at least) penetrate regions of hi dielectric solvent. The results for the tram cinnamic acids would then indicate some (but not complete) exclusion of solvent resulting from the presence of the vinyl hydrogens. These interesting results from the application of eq. (1) clearly need to be confirmed by additional studies. [Pg.62]

Stabilization of crude and purified anthocyanin extracts from agai by the addition of tannic acid resulted in a 65% half-life increase of anthocyanins from the crude extract and 610% of the half-life of the purified one. Although tannic acid was considered an efficient copigment,in general all cinnamic acids give unpleasant odors and tastes to solutions. [Pg.266]

Several additional benzoic and cinnamic acid derivatives were tested (28-31). [Pg.167]

For PMMA/additive dissolutions, it was not possible to identify any additive characteristic mass peaks, either by direct laser desorption or with matrix-assistance (dithranol, DHBA or sinapinic acid, 4-hydroxy-3,5-dimethoxy-cinnamic acid). This has again been ascribed to very strong interaction between PMMA and additives, which suppresses desorption of additive molecules. Also, partial depolymerisation of pho-tolytically labile PMMA by laser irradiation may play a role, which leads to saturation of the detector by PMMA fragment-ions and disappearance of additive mass peaks below noise level. Meyer-Dulheuer [55] has also reported MALDI-TOFMS analysis of a coating/2-ethylhexyldiphenylphosphate sample. Quantitative determination of the additives by means of MALDI-ToFMS proved impossible. Possibly the development of reproducible (automated) sample handling procedures or thin films might overcome this problem. [Pg.708]

The chiral center would be installed from either Unear carbamate 15 or branched carbamate 16 via the asymmetric addition of malonate anion to the 7i-allyl Mo complex reported by Trost et al. [11] to afford the branched chiral malonate derivative 17. Decarboxylation of 17 should provide the mono-carboxylic acid 18. Masa-mune homologation with 18 affords our common precursor 14. Linear carbamate 15 was obtained from the corresponding cinnamic acid, and branched 16 was prepared in one pot from the corresponding aldehyde. [Pg.49]

An example of this reveals an additional substituent effect (Fig. 2.18).121 Ordinarily, the phenyl and carboxyl groups anchor the double bond approximately equally (notice the sixth entry in Table 2.3 and cinnamic acid in Fig. [Pg.51]

A single-to-single crystal phase transition was found to take place at 333 K in a new polymorph of ort/zo-ethoxy-trans-cinnamic acid [77]. In this study, the structures of the title compound obtained at two temperatures above the transition point were determined in addition to the structures of the stabilized forms existing at lower temperatures. It was found that the phase transition involved a cooperative conformational transformation coupled with a shift in layers of the constituent molecules. [Pg.273]

Simple phenolic compounds include (1) the phenylpropanoids, trans-cinnamic acid, p-coumaric acid and their derivatives (2) the phenylpropanoid lactones called coumarins (Fig. 3.4) and (3) benzoic acid derivatives in which two carbons have been cleaved from the three carbon side chain (Fig. 3.2). More complex molecules are elaborated by additions to these basic carbon skeletons. For example, the addition of quinic acid to caffeic acid produces chlorogenic acid, which accumulates in cut lettuce and contributes to tissue browning (Fig. 3.5). [Pg.92]

A series of subsequent reactions after PAL first introduces a hydroxyl at the 4-position of the ring of cinnamic acid to form p- or 4-coumaric acid (i.e., 4-hydroxycinnamic acid). Addition of a second hydroxyl at the 3-position yields caffeic acid, whereas O-methylation of this hydroxyl group produces ferulic acid (see Fig. 3.3). Two additional enzymatic reactions are necessary to produce sinapic acid. These hy-drocinnamic acids are not found in significant amounts in plant tissue because they are rapidly converted to coenzyme A esters, or glucose esters. These activated intermediates form an important branch point because they can participate in a wide range of subsequent reactions. [Pg.93]

Cinnamic acid esters can be converted to dienals via Grignard addition and Vilsmeier reaction (equation 184)306. [Pg.464]

The mechanism of the formation of compound 67 has been studied by Higa and Krubsack [41] in detail, as shown in Scheme 15. Namely, the initial step of the reaction of the cinnamic acid derivative 66 with thionyl chloride is an electrophilic addition of thionyl chloride across the double bond of cin-namoyl chloride to form the sulfinyl chloride intermediate (66a), which is then converted to 68 by the Pummerer reaction. Dehydrochlorination of 68... [Pg.184]

The effect of a range of additives on enantioselective hydrogenation of the cinnamic acid precursor is shown in Scheme 36.15. One trend that emerges from this screen is the positive effect of the monodentate phosphines, in particular, tri-p-tolylphosphine. [Pg.1268]

But catalytic reduction of the same phenyl propionic acid gives cis cinnamic acid. Therefore by adding hydrogen under various conditions, one can obtain a desired isomer. The conversion of acetylene into olefinic compounds has been carried out not only for the sake of obtaining the adduct, but Michael studied the various addition reactions for the sake of obtaining a desired product cis or trans. For example, he found that the addition of bromine to acetylene-dicarboxylic acid leads predominantly to the formation of trans isomer. [Pg.113]

The driving force for growth of the crystal in the b direction is the energy released by formation of the NH O bonds of the ribbon motif. E-Cinnamic acid in the stable synplanar conformation 2a can replace a E-cinnamide molecule at the end of the ribbon however, at the site of the additive, the attractive NH O bond (- 6 kcal/mol) is replaced by repulsion between the adjacent oxygen lone-pair electrons of the bound additive molecule and of the oncoming cinnamide molecule (1-2 kcal/mol), which leads to an overall loss in energy of 7-8 kcal/mol at the site of the additive (Scheme 6 on page 16). [Pg.14]

As predicted, the presence of cinnamic acid in solution caused cinnamide to crystallize as flat prisms with prominent 011 faces (Figure 4b). The crystal morphology was modified along c by the use of amide additives that contain a bulky Cl substituent at the a- or P-carbons of cinnamide. When replacing a substrate molecule, these additive molecules interfere with the deposition of the next Oil layers (Figure 3), yielding 011 platelike crystals (Figure 4d). [Pg.15]

The hydrogenation reaction is carried out with a substituted cinnamic acid. The acetamido group is of particular importance because it functions as a secondary complexation function in addition to the alkene functionality. In the first step the alkene co-ordinates to the cationic rhodium species (containing an enantiopure phosphine DIPAMP in Figures 4.4 and 4.5 with the chirality at phosphorus carrying three different substituents, Ph, o-An, CH2) for which there are several diasteromeric structures due to ... [Pg.80]

One last remark concerning the two catalysts we have discussed in more detail, cationic rhodium catalysts and the neutral chloride catalyst of Wilkinson. The difference of the catalytic system discussed above from that of the Wilkinson catalyst lies in the sequence of the oxidative addition and the alkene complexation. The hydrogenation of the cinnamic acid derivative involves a cationic catalyst that first forms the alkene complex the intermediate alkene (enamide) complex can be observed spectroscopically. [Pg.86]

In addition to the substances cited elsewhere in this section, a variety of natural materials of vegetable origin have been analyzed using RPC. These include benzoic and cinnamic acids from plants (504) and a variety of phenolic compounds from tobacco (505). Alktdoids have been analyzed... [Pg.319]

It is also important to understand that most allelopathic effects apparently result from the combined actions of several allelochemicals, often with each below a threshold concentration for impact. In allelopathic situations which implicate phenolic acids, soil concentrations have ranged from below 10 to above 1000 ppm for each compound. The lower end of the spectrum is below a concentration required for an effect in current bioassays. Additive and synergistic effects have been demonstrated, however, for combinations of cinnamic acids (102), benzoic acids (103), benzoic and cinnamic acids (10 ). and -hydroxybenzaldehyde with coumarin (105). It appears that such combined interactions may be very important under field conditions. [Pg.17]


See other pages where Cinnamic acids, 2+2 addition is mentioned: [Pg.298]    [Pg.130]    [Pg.769]    [Pg.305]    [Pg.86]    [Pg.319]    [Pg.358]    [Pg.434]    [Pg.282]    [Pg.334]    [Pg.358]    [Pg.110]    [Pg.83]    [Pg.143]    [Pg.1486]    [Pg.87]    [Pg.83]    [Pg.452]    [Pg.380]    [Pg.216]    [Pg.92]    [Pg.58]    [Pg.212]   
See also in sourсe #XX -- [ Pg.14 ]




SEARCH



Acids cinnamic acid

Bromine addition, cinnamic acid

Cinnamate

Cinnamates

Cinnamic 4-

Cinnamic acid

Cinnamic acid/cinnamate

Cinnamic addition

Cinnamics

© 2024 chempedia.info