A Good Example

A large underground mine had a write-on board erected in the area where the miners collected their cap lamps at the beginning of their shift. The board listed all the underground near miss incident reports and a separate column on the board showed what action had been taken for each reported event as well as the completed dates. Miners could follow the progress of their reports each day because of this system. 

---

Systems involving an interface are often metastable, that is, essentially in equilibrium in some aspects although in principle evolving slowly to a final state of global equilibrium. The solid-vapor interface is a good example of this. We can have adsorption equilibrium and calculate various thermodynamic quantities for the adsorption process yet the particles of a solid are unstable toward a drift to the final equilibrium condition of a single, perfect crystal. Much of Chapters IX and XVII are thus thermodynamic in content. 

In the experimental and theoretical study of energy transfer processes which involve some of the above mechanisms, one should distingiush processes in atoms and small molecules and in large polyatomic molecules. For small molecules a frill theoretical quantum treatment is possible and even computer program packages are available [, and ], with full state to state characterization. A good example are rotational energy transfer theory and experiments on Fie + CO [M] ... 

A good example is the spectnun of naphthalene. The two lowest excited states have 62 and synnnetries and are allowed for one-photon transitions. A weak transition to one of these is observable in die two-photon spectnun [33], presumably made allowed by vibronic effects. Much stronger two-photon transitions are observable at somewhat higher energies to a and an A state lying quite close to the energies predicted by theory many years earlier [34]. 

One of the motivations for studying Van der Waals complexes and clusters is that they are floppy systems with similarities to the transition states of chemical reactions. This can be taken one stage further by studying clusters that actually are precursors for chemical reactions, and can be broken up to make more than one set of products. A good example of this is H2-OH, which can in principle dissociate to fonn either H2 + OH or H2O + H. Indeed, dissociation to H2 O -t H is energetically favoured the reaction H2 + OH—> H2 O -t H is exothennic by about 5000... 

When an element has more than one oxidation state the lower halides tend to be ionic whilst the higher ones are covalent—the anhydrous chlorides of lead are a good example, for whilst leadfll) chloride, PbCl2, is a white non-volatile solid, soluble in water without hydrolysis, leadflV) chloride, PbC, is a liquid at room temperature (p. 200) and is immediately hydrolysed. This change of bonding with oxidation state follows from the rules given on p.49... 

The last compound is a good example of the principle of latest position the stem nuclei are assigned to divisions I, II and III respectively, but the substance is assigned to the latest division III. 

One route to o-nitrobenzyl ketones is by acylation of carbon nucleophiles by o-nitrophenylacetyl chloride. This reaction has been applied to such nucleophiles as diethyl malonatc[l], methyl acetoacetate[2], Meldrum s acid[3] and enamines[4]. The procedure given below for ethyl indole-2-acetate is a good example of this methodology. Acylation of u-nitrobenzyl anions, as illustrated by the reaction with diethyl oxalate in the classic Reissert procedure for preparing indolc-2-carboxylate esters[5], is another route to o-nitrobenzyl ketones. The o-nitrophenyl enamines generated in the first step of the Leimgruber-Batcho synthesis (see Section 2.1) are also potential substrates for C-acylation[6,7], Deformylation and reduction leads to 2-sub-stituted indoles. 

The binomial distribution describes a population whose members have only certain, discrete values. A good example of a population obeying the binomial distribution is the sampling of homogeneous materials. As shown in Example 4.10, the binomial distribution can be used to calculate the probability of finding a particular isotope in a molecule. 

When the sample is a solid, a separation of the analyte and interferent by sublimation may be possible. The sample is heated at a temperature and pressure below its triple point where the solid vaporizes without passing through the liquid state. The vapor is then condensed to recover the purified solid. A good example of the use of sublimation is in the isolation of amino acids from fossil mohusk shells and deep-sea sediments. ... 

A good example of a prescriptive approach to quality assessment is the protocol outlined in Figure 15.2, published by the Environmental Protection Agency (EPA) for laboratories involved in monitoring studies of water and wastewater. Independent samples A and B are collected simultaneously at the sample site. Sample A is split into two equal-volume samples, and labeled Ai and A2. Sample B is also split into two equal-volume samples, one of which, Bsf, is spiked with a known amount of analyte. A field blank. Dp, also is spiked with the same amount of analyte. All five samples (Ai, A2, B, Bsf, and Dp) are preserved if necessary and transported to the laboratory for analysis. 

Aerosols can be produced as a spray of droplets by various means. A good example of a nebulizer is the common household hair spray, which produces fine droplets of a solution of hair lacquer by using a gas to blow the lacquer solution through a fine nozzle so that it emerges as a spray of small droplets. In use, the droplets strike the hair and settle, and the solvent evaporates to leave behind the nonvolatile lacquer. For mass spectrometry, a spray of a solution of analyte can be produced similarly or by a wide variety of other methods, many of which are discussed here. Chapters 8 ( Electrospray Ionization ) and 11 ( Thermospray and Plasmaspray Interfaces ) also contain details of droplet evaporation and formation of ions that are relevant to the discussion in this chapter. Aerosols are also produced by laser ablation for more information on this topic, see Chapters 17 and 18. 

The water quahty criteria for each species should be deterrnined from the Hterature or through experimentation when Hterature information is unavailable. Synergistic effects that occur among water quahty variables can have an influence on the tolerance a species has under any given set of circumstances. Ammonia is a good example. Ionized ammonia (NH ) is not particularly lethal to aquatic animals, but unionized ammonia (NH ) can be... 

Aquatic animals are susceptible to a variety of diseases including those caused by viruses, bacteria, fungi, and parasites. A range of chemicals and vacciaes has been developed for treating the known diseases, although some conditions have resisted all control attempts to date and severe restrictions on the use of therapeutants ia some nations has impaired that abiUty of aquaculturists to control disease outbreaks. The United States is a good example of a nation ia which the variety of treatment chemicals is limited (Table 6). 

Antibiotics. Solvent extraction is an important step in the recovery of many antibiotics (qv) such as penicillin [1406-05-9] streptomycin [57-92-17, novobiocin [303-81-1J, bacitracin [1405-87-4] erythromycin, and the cephalosporins. A good example is in the manufacture of penicillin (242) by a batchwise fermentation. Amyl acetate [628-63-7] or -butyl acetate [123-86-4] is used as the extraction solvent for the filtered fermentation broth. The penicillin is first extracted into the solvent from the broth at pH 2.0 to 2.5 and the extract treated with a buffet solution (pH 6) to obtain a penicillin-rich solution. Then the pH is again lowered and the penicillin is re-extracted into the solvent to yield a pure concentrated solution. Because penicillin degrades rapidly at low pH, it is necessary to perform the initial extraction as rapidly as possible for this reason centrifugal extractors are generally used. 

Flow around a cylinder with axis normal to the flow provides a good example of the many unusual features of such flows. These are illustrated in Figure 3. 

Pure amorphous polymers, being homogeneous materials, are transparent. Atactic polystyrene is a good example. The crystalline syndiotactic form is not transparent. Alack of transparency does not necessarily indicate crystallinity, however. It can also be caused by inorganic fillers, pigments, gas bubbles (as in a foam), a second polymer phase, etc. 

Removal of tert-AW Groups, Alkyl groups on a phenol nucleus can be removed selectively to produce a desired synthetic result. The oxidative coupling of phenol offers a good example. 2,6-Di-/ f2 -butylphenol can be coupled under oxidative conditions to... 

The N-oxides readily undergo nucleophilic addition followed by elimination, which forms the basis of several useful syntheses of 2-substituted pyridines. Chlorination of (13) with POCl to give 2-chloropyridine (17) is a good example (eq. 4) some chlorination may occur also at C-4 (11). 

Under mechanical and environmental stresses, composites are dimensionally stable. They maintain their shape and functionaHty, a critical requirement in such appHcations as dish antennas, constmction girders, and in appHance and business machines. Color and surface texture can often be molded into an FRP product for long lasting, low maintenance permanent surface appearance. Boats are a good example. The surface color is molded in and requires minimum maintenance, an advantage in saltwater environments. 

Deformation is the relative displacement of points of a body. It can be divided into two types flow and elasticity. Flow is irreversible deformation when the stress is removed, the material does not revert to its original form. This means that work is converted to heat. Elasticity is reversible deformation the deformed body recovers its original shape, and the appHed work is largely recoverable. Viscoelastic materials show both flow and elasticity. A good example is SiEy Putty, which bounces like a mbber ball when dropped, but slowly flows when allowed to stand. Viscoelastic materials provide special challenges in terms of modeling behavior and devising measurement techniques. 

Metal Deactivation. Compounds capable of forming coordination complexes with metal ions are needed for this purpose. A chelating agent such as ethylene-diaminetetraacetic acid (EDTA) is a good example. 

Chemical pigments or synthetics may be metal compounds. A good example is white titanium dioxide. Other chemical pigments include cadmium sulfide colors, iron blue, and several synthetic versions of iron oxides. 

---