Total solubility

In a conventional gasoline containing hydrocarbons or even ethers, the presence of water is not a problem in fact, water is totally soluble up to about 50 ppm at ambient temperature. Beyond this value water separates without affecting the hydrocarbon phase and the water leg can be withdrawn if necessary. On the other hand, in the presence of alcohols (ethanol and especially methanol), trace amounts of water can cause a separation of two phases one is a mixture of water and alcohol, the other of hydrocarbons (Cox, 1979). 

Absolute. This is concentrated extract obtained by treatment of a concrete or other hydrocarbon-type extract of a plant or plant part with ethanol. It is usually Hquid and should be totally soluble in alcohol. By this method, waxes, hydrocarbons (including terpenoid), as well as most of the odorless material of the concrete are removed from the extract. 

When water-miscible ionic liquids are used as solvents, and when the products are partly or totally soluble in these ionic liquids, the addition of polar solvents, such as water, in a separation step after the reaction can make the ionic liquid more hydrophilic and facilitate the separation of the products from the ionic liquid/water mixture (Table 5.3-2, case e). This concept has been developed by Union Carbide for the hydroformylation of higher alkenes catalyzed by Rh-sulfonated phosphine ligand in the N-methylpyrrolidone (NMP)/water system. Thanks to the presence of NMP, the reaction is performed in one homogeneous phase. After the reaction. 

Determination of soluble sodium chloride. By entering the graph in Figure 4-109 with the Ib/bbl of calcium chloride at the correct volume percent of water (by retort) line, the maximum amount of soluble sodium chloride can be found. If the sodium chloride content determined in Step 2 is greater than the maximum soluble sodium chloride determined from Figure 4-108, only the soluble portion should be used for calculating the total soluble salts. 

Total soluble salts (Ib/bbl) = CaClj (Ib/bbl) - soluble NaCl (Ib/bbl)... 

Information concerning the metabolic function of unusual naturally occurring plant constituents might be used to develop new growth regulators. An example of a development that arose in this way began with the observation by Tolbert (143) that as much as 30% of the total soluble phosphorus in plant roots, and sometimes in the leaves,... 

Fig. 1 Contribution of H2S and H2S to the total solubility of hydrogen sulfide (HaStotal) in liquid sulfur as a function of temperature atp(H2S)=1.013 bar (data from [8, 10])...

The gene for the dehydratase was expressed in E. coli under lac promoter, and an expression plasmid pOxD 90F was constructed. The transformant was cultivated under optimal condition at 30° C when much of the enzyme was expressed in a soluble form with more than thousand and several hundred times than the wild-type strain per culture (up to more than 50% of the total soluble protein of the... 

Total soluble polymer (solids) In each latex sample was calculated by simply summing the amounts of polymerized acrylonitrile and polymerized comonomer. 

The solubihty parameter theory can be also used for the mixed-solvent systems. The total-solubility parameter 8, is given by the sum of the individual solubihty parameters in terms of the volume fractions (pj in the mixture, according to Equation 4.6 ... 

Matrix Components The term matrix component refers to the constituents in the material aside from those being determined, which are denoted as analyte. Clearly, what is a matrix component to one analyst may be an analyte to another. Thus, in one hand for the case of analyses for elemental content, components such as dietary fibre, ash, protein, fat, and carbohydrate are classified as matrix components and are used to define the nature of the material. On the other hand, reference values are required to monitor the quality of determinations of these nutritionally significant matrix components. Hence, there is a challenging immediate need for certified values for dietary fibre, ash, protein, fat, and carbohydrate. Concomitantly, these values must be accompanied by scientifically sound definitions (e.g. total soluble dietary fibre, total sulpha-ted ash, total unsaturated fat, polyunsaturated fat, individual lipids, simple sugars, and complex carbohydrates). 

Allen et al. (2007) produced puffed snack foods with com starch and pregelatinized waxy starch, WPC and instantized WPC, and protein concentrations of 16%, 32%, and 40% and showed that the air cell size, extru-date expansion ratio, and water solubility index decreased proportionally as protein and com starch levels increased. Protein concentration significantly affected total soluble protein, water absorption index, and water-soluble carbohydrate. A covalent complex between amylase and protein formed in the presence of cornstarch, but protein-protein interactions appeared with the presence of low levels of pregelatinized waxy starch. 

Few tablets intended for oral administration are totally soluble in aqueous media, but if such a product is needed, then soluble excipients are employed. These include dextrose, lactose, mannitol, and sodium chloride, with the last of these sometimes acting as its own lubricant. Urea may also be used, but due to its known pharmacological effects, it is less desirable than the other soluble compounds cited. 

By convention, [HA(s)] = [B(s)] = 1. Eqs. (6.1) represent the precipitation equilibria of the uncharged species, and are characterized by the intrinsic solubility equilibrium constant, Sq. The zero subscript denotes the zero charge of the precipitating species. In a saturated solution, the effective (total) solubility S, at a particular pH is defined as the sum of the concentrations of all the compound species dissolved in the aqueous solution ... 

The amount of lead that remains in solution in surface waters depends upon the pH of the water and the dissolved salt content. Equilibrium calculations show that at pH >5.4, the total solubility of lead is approximately 30 pg/L in hard water and approximately 500 pg/L in soft water. Sulfate ions, if present... 

Figure 1. Effect of hydrogen pressure and temperature on corrected total solubility 273 g ZnCl2, 50 g coal, 50 g CHsOH 60 min.

Figure 2. Effect of methanol charge and hydrogen pressure on corrected total solubility 273 g ZnCl, 50 g coal 250°C 60 min.

Figure 3. Effect of run time on corrected total solubility at 250°C and 275°C 273 g ZnCl2,50 g coal, 50 g CH3OH 800 psig H2.

Figure 7. Effect of acid wash on solubilities compared with water wash 273 g ZnClg, 50 g coal. Total solubility is the sum of benzene solubility and incremental...

Figure 9. Recovery of oxygen plus sulfur in product, relative to total solubility ...

B. megaterium, in contrast to B. subtilis, has low protease activity. It is able to grow on a wide variety of substrates. Plasmids with xylose-inducible promoter are most frequently used for high-level expression [41]. It was successfully used to express toxins and other difficult proteins where the proteins were intact after secretion into the media. Yields of about 30% of total soluble protein were obtained in some cases [42]. 

Streptomyces strains are Gram positive [54], they have good secretion capacities and extensive fermentation knowledge has been accumulated. Mostly, they were used for the production of secondary metabolites with potent biological activities, such as antibiotics, immunosuppressors or pesticides. Constitutive [55] and inducible [56] expression is possible. Up to 40% of the total soluble cellular protein was reported in the case of inducible expression. 

McFarland et al. recently [1] published the results of studies carried out on 22 crystalline compounds. Their water solubilities were determined using pSOL [21], an automated instrument employing the pH-metric method described by Avdeef and coworkers [22]. This technique assures that it is the thermodynamic equilibrium solubility that is measured. While only ionizable compounds can be determined by this method, their solubilities are expressed as the molarity of the unionized molecular species, the intrinsic solubility, SQ. This avoids confusion about a compound s overall solubility dependence on pH. Thus, S0, is analogous to P, the octanol/water partition coefficient in both situations, the ionized species are implicitly factored out. In order to use pSOL, one must have knowledge of the various pKas involved therefore, in principle, one can compute the total solubility of a compound over an entire pH range. However, the intrinsic solubility will be our focus here. There was one zwitterionic compound in this dataset. To obtain best results, this compound was formulated as the zwitterion rather than the neutral form in the HYBOT [23] calculations. 

The first hurdle encountered during the development of alfalfa as a recombinant protein production system was the relative inefficiency of the available expression cassettes. A study in which a tomato proteinase inhibitor I transgene was expressed in tobacco and alfalfa under the control of the cauliflower mosaic virus (CaMV) 35S promoter showed that 3-4 times more protein accumulated in tobacco leaves compared to alfalfa leaves [5]. Despite the low efficiency of the CaMV 35S promoter in alfalfa, bio-pharmaceutical production using this system has been reported in the scientific literature. Such reports include expression of the foot and mouth disease virus antigen [6], an enzyme to improve phosphorus utilization [7] and the anti-human IgG C5-1 [8]. In this last work, the C5-1 antibody accumulated to 1% total soluble protein [8]. 

Fig. 1.1 Promoter activity in alfalfa leaves. Accumulation ofp-glucuroni-dase achieved in transgenic alfalfa leaves expressing the gusA gene under the control of CaMV 35S and alfalfa promoters. %TSP, percentage of total soluble proteins.

Fig. 1.2 Protein blot analysis of human therapeutic protease inhibitor (HTPI) produced in alfalfa cell cultures using different promoters and subcellular targeting peptides as shown. Equal amounts of total soluble proteins from cell cultures were separated by sodium dodecylsulfate polyacrylamide gel electrophoresis (SDS-PAGE) and blotted onto a polyvinyldifluoride (PVDF) membrane. Monoclonal anti-HTPI IgGs were used for detection.

Fig. 1.3 Prediction of the most appropriate subcellular targeting strategies by agroinfiltration. The levels of an industrial enzyme (IE) are shown in agroinfiltrated and transgenic alfalfa leaves using different subcellular targeting peptides. Equal amounts of total soluble leaf proteins were separated by SDS-PAGE and blotted onto a PVDF membrane. Polyclonal anti-IE IgGs were used for detection.

---