Maximum strength

STRESS searches for the Yield Strength (maximum stress), then continues on to find the greatest drop in stress. From there it reverses direction to look for a peak or a point 0.004 L/Lo prior, whichever comes first. This point is taken to be the Break Point. 

Fig. 24. Tensile strength (maximum negative pressure) of pure water in glass (B12).

As might be expected, the properties of these materials depend greatly on the relative amounts of the two phases. Properties of particular interest are modulus, impact resistance, ultimate strength, maximum extensibility, viscoelastic responses, and transparency. 

Limited tests on strength properties of wood acetylated with thioacetic acid showed that MOR in static bending, impact strength, maximum crushing strength in compression and density improved. It is, therefore, evident that thioacetic acid has either no adverse effect on wood components and their interlinks or the improvements affected by modification far exceed these effects, so as to be of little consequence and ending in net gains. 

Influence of agglomerate strength maximum feed particle size... 

Water soaked, 100°C Tensile strength, maximum, MPa (kpsi) 64 (9.4) ASTM D 882... 

All the unfilled vulcanizates based on linear a,co-DHPS are distinguished by a tensile strength maximum of 1 kg/cm and a percentage elongation at rupture of 80 - 120%. 

The quantity of a material used will depend on the material density and strength (maximum allowable stress) and these must be taken into account when comparing... 

Type Grain shape Grain surface Grain density kg/m3 Density kg/m3 Water absorption M-% Grain strength Maximum mortar strength N/mm2... 

Typical concentration range 10-40 wt% carbon black 5-20 wt% (tear strength maximum at 5 wt%, tensile strength maximum at 15 wt%)... 

Stimulant Duration of Effect Available Strengths Maximum Dose... 

The regression equations obtained from Equation 6.16 had = 0.99. The kinetics of E. coli 0157 H7 inactivation estimated by the A xe value depended on the treatment temperature and EF strength. Maximum A xe value was achieved at 60°C and 15kV cm . A threshold temperature of 50°C, after which bactericidal effect of the combined treatment was significantly intensified was indicated. 

In this chapter and throughout the book, we will use English units for measurements, that is, the load in pounds and the specimen dimensions in inches. Hence, the units of stress and strength (maximum stress) are in pounds per square inch, that is, psi. 

Flexural Fatigue Strength - Maximum stress that can be sustained for a specified number of bending cycles without failure. 

The geometrical shape of a novel aperture like SNOM probe influences the imaging properties of photonic nanostructures. By using triangular shaped aperture probes a selection of the position of the electrical field strength maximum at the rim of the metallic aperture can be achieved by adjusting the polarization direction [7],... 

The general form of the curve is followed for virtually all particle size sols although the actual value of the binder solids maximum varies with particle size. The strength maximum usually occurs at about 70-80% of the maximum possible binder strength for that particle size. This is indicated in Table 12.3. 

Noryl AS alloys, which are blends of PPO/PS and special fillers, have been developed specifically for office equipment and housings. Their main features are high strength, maximum stiffness, and ability to maintain tight dimensional tolerances over a wide temperature range. They are expected to replace metals in such applications as structural chassis for typewriters and printers. 

---