Source definition

Drift From the Chalk Point Natural Drift Brackish Water Cooling Tower Source Definition, Downwind Measurements, Transport Modeling... 

PSD No-Net-Increase Provisions Under the PSD program, the affected source is the entire plant. This source definition allows a company to determine the most cost-effective means to control pollution any time a plant is modified. Emission increases associated with a new process or production line may be compensated for by emission increases at other parts of the plant. As long as the entire site net emissions increase is maintained below the levels identified in Table 22-5, a PSD review is not required. 

Source Definitions and data from Raskin et al. (1997), Green and Hoffnagle (2004). 

Problem (a) was addressed by writing light-weight wrappers (cf. Sect. 5.7) for the data sources. To solve the second problem, the data structure definition file for the Aspen Batch.21 system was extended by additional specifications that define the source of data for each piece of information stored in the Aspen Batch.21 system. The data source definition specifies which wrapper to contact for the data, which function to call, which parameters to pass, etc. 

The P-diagram is a tool used to conceptualize the System Design Specification (SDS). The system spedlication establishes boundaries, describes the organization that is responsible for the requirements, and acts as a source definition of the essential requirements for the component. The system specification will also eventually link requirements to the design verification methods, which are tests that are designed to prove functionality. 

Seismic Source Type Seismic Source Description Seismic Source Definition ... 

TABLE 4.17 Major Source Definitions and Offset Ratios in Ozone Nonattainment Areas... 

States have the option of choosing a major source definition of 5 tpy (and accepting other conditions) in order to avoid complying with a requirement that emissions be reduced 15 percent over the first 6 yr. See Section 182(b)(l)(A)(ii). 

Source definition. Use geologic data and historical earthquake record to define the locations and dimensimis of earthquake sources. 

The paper presents the results from systematic comparisons of contrast and resolution obtained with different types of radiation sources on steel thicknesses from 5 to 40 mm. These results have been taken into account with the definitions of the European standard for radiographic inspection of weldments (EN 1435) that is approved since 1997. Conclusions from practical investigations on pipe line sites, in petrochcemical plants and in nuclear power stations will be discussed as well. Furthermore, the presentation will stipulate a variety of advantages obtained from the new source in terras of coUimation and radiation protection. 

Since there is a definite phase relation between the fiindamental pump radiation and the nonlinear source tenn, coherent SH radiation is emitted in well-defined directions. From the quadratic variation of P(2cii) with (m), we expect that the SH intensity 12 will also vary quadratically with the pump intensity 1 ... 

An experimental teclmique that is usefiil for structure studies of biological macromolecules and other crystals with large unit cells uses neither the broad, white , spectrum characteristic of Lane methods nor a sharp, monocliromatic spectrum, but rather a spectral band with AX/X 20%. Because of its relation to the Lane method, this teclmique is called quasi-Laue. It was believed for many years diat the Lane method was not usefiil for structure studies because reflections of different orders would be superposed on the same point of a film or an image plate. It was realized recently, however, that, if there is a definite minimum wavelengdi in the spectral band, more than 80% of all reflections would contain only a single order. Quasi-Laue methods are now used with both neutrons and x-rays, particularly x-rays from synclirotron sources, which give an intense, white spectrum. 

In spectroscopy it is common for transitions to be observed as absorptive lines because the Boltzmaim distribution, at equilibrium, ensures a higher population of the lower state than the upper state. Examples where emission is observed, which are by definition non-equilibrium situations, are usually cases where excess population is created in the higher level by infiising energy into the system from an external source. 

The appropriate quantum mechanical operator fomi of the phase has been the subject of numerous efforts. At present, one can only speak of the best approximate operator, and this also is the subject of debate. A personal historical account by Nieto of various operator definitions for the phase (and of its probability distribution) is in [27] and in companion articles, for example, [130-132] and others, that have appeared in Volume 48 of Physica Scripta T (1993), which is devoted to this subject. (For an introduction to the unitarity requirements placed on a phase operator, one can refer to [133]). In 1927, Dirac proposed a quantum mechanical operator tf), defined in terms of the creation and destruction operators [134], but London [135] showed that this is not Hermitean. (A further source is [136].) Another candidate, e is not unitary. 

The controlled thermal decomposition of dry aromatic diazonium fluoborates to yield an aromatic fluoride, boron trifluoride and nitrogen is known as the Schiemann reaction. Most diazonium fluoborates have definite decomposition temperatures and the rates of decomposition, with few exceptions, are easily controlled. Another procedure for preparing the diazonium fluoborate is to diazotise in the presence of the fluoborate ion. Fluoboric acid may be the only acid present, thus acting as acid and source of fluoborate ion. The insoluble fluoborate separates as it is formed side reactions, such as phenol formation and coupling, are held at a minimum temperature control is not usually critical and the temperature may rise to about 20° without ill effect efficient stirring is, however, necessary since a continuously thickening precipitate is formed as the reaction proceeds. The modified procedure is illustrated by the preparation of -fluoroanisole ... 

Other sources that have computatonal chemistry definitions are... 

Hemicellulose [9034-32-6] is the least utilized component of the biomass triad comprising cellulose (qv), lignin (qv), and hemiceUulose. The term was origiaated by Schulze (1) and is used here to distinguish the nonceUulosic polysaccharides of plant cell walls from those that are not part of the wall stmcture. Confusion arises because other hemicellulose definitions based on solvent extraction are often used in the Hterature (2—4). The term polyose is used in Europe to describe these nonceUulosic polysaccharides from wood, whereas hemicellulose is used to describe the alkaline extracts from commercial pulps (4). The quantity of hemicellulose in different sources varies considerably as shown in Table 1. 

---