Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Results of Initial Testing

The results of the these experiments showed that the damping fluid, Krytox , and hydrocarbon oils all could be successfully removed using supercritical carbon dioxide at pressures in the range of 1200-3000 psi and temperatures in the range of 90 to 185°F. The Krytox lubricant was easily removed at the lower extremes, while the hydrocarbon oil was the most difficult to remove. [Pg.206]

Determining the optimum parameters was a long process which required many hours of engineering and technician time and spanned a time period of over one year. In addition to these initial multivariant experiments, a large number of independent experiments were conducted to verify the predicted results. [Pg.206]


After positive result of initial test for indigo. [Pg.295]

Results of initial tests carried out on a four-cylinder 2.0L naturally aspirated (NA) engine, without EGR or oxidation catalyst, to investigate the effect of a part load/full load nozzle under simulated FTP72 conditions are shown in the upper right of Fig. 9. [Pg.41]

The result of initial tests indicated that a very large amount of reference data would be needed in order to define the parameters. With a relatively small number of data, some properties could be predicted with reasonable accuracy, but the lowest eigenvalues of the parameter Hessian were found to be extremely small. The implication of this was that the values of the parameters were ill-defined. In any valid method, each parameter must have a purpose or function. Thus the /8 values are essential for the one-electron two-center integrals, which in turn have a strong influence on the heat of formation and on the geometry, A zero or very low eigenvalue for the parameter Hessian means that at least one parameter is redundant. [Pg.2083]

In contrast to chlordiazepoxide and diazepam, lorazepam and oxazepam are not metabolized into active compounds in the liver. Instead, they are excreted by the kidneys following glucuronidation. This is important because many alcohol-dependent patients have compromised liver function. Therefore, when treatment is initiated before the results of blood tests for liver function are known, as is often the case in outpatient clinics, lorazepam and oxazepam may be preferred. Patients with liver disease may still be treated with diazepam and chlordiazepoxide, but at lower doses. This can be accommodated with the loading technique, although hourly dosing with 5 mg of diazepam or 25 mg of chlordiazepoxide may be sufficient. [Pg.537]

The results of these tests and the fluid formulations axe shown in Table IV. The adverse effect on fluid rheology of adding potassium, KC1, Test B, and TKPP, Test C, is evident. Both salts cause increases in yield point, YP, and initial gel strength. TKPP produced only about half as much increase as did KC1 and can be added in much higher concentrations before the rheological properties of the drilling mud become unacceptable. [Pg.627]

The model was claimed to compute 5000-6000 molecules per min. The predictive ability of the model was validated by four approaches. In the first approach, a set of 20 compounds was randomly selected as an initial validation test set. A model was developed from the remaining 86 compounds with an MAE of 0.33, from which the test set values were then predicted. The results of this test prediction were very good and provided momentum for support of the three structure descriptors. In the second approach, a full cross-validation test of the model was investigated. The data set of 102 compounds was divided... [Pg.530]

In one case study, anorexia was reported in a man who washed his hands with diesel fuel over several weeks (Crisp et al. 1979). Effects resulting from inhalation versus dermal exposure could not be distinguished in this case. An epidemiological study found a significant increase in neurasthenia (i.e., fatigue, depressed mood, lack of initiative, dizziness, and sleep disturbances) in workers who were chronically exposed to jet fuels by either inhalation, oral, and/or dermal exposure (Knave et al. 1978). Also, attention and sensorimotor speed were impaired in the exposed workers, but no effects were found on memory function or manual dexterity. Results of EEG tests suggest that the exposed workers may have instability in the thalamocortical system. The limitations of the study were discussed in detail in Section 2.2.1.2 under Respiratory Effects. [Pg.73]

With regard to reclassification, the new legislation requires that where a change of classification of a medicinal product has been authorised on the basis of significant pre-clinical tests or clinical trials, the competent authority shall not refer to the results of those tests or trials when examining an application by another applicant or another MAH for a change of classification of the same substance for 1 year after the initial change was authorised. [Pg.522]

The 6-month regimen Ordinarily this consists of an initial 2-month phase of rifampin, isoniazid, and pyrazinamide and, if clinically indicated, streptomycin or ethambutol, followed by 4 months of rifampin and isoniazid. Reassess the need for a fourth drug when the results of susceptibility testing are known. If community rates of INH resistance are currently less than 4%, an initial treatment regimen with less than 4 P.1008... [Pg.1715]

Results of initial criteria establishment qualified as readily pass or a batch was tested according to SCM and the test results failed both stage 1 and stage 2 criteria. [Pg.35]

A prototype vessel was built and installed in the Big Lake field in mid-1977. With the above equations, this vessel has a design water capacity of 48,000 B/D (7631 m3/d). This rate is 150% of the desired throughput of 32,000 B/D (5088 m3/d). Initial water throughput was approximately 25,000 B/D (3975 m3/d). Figs. 3 and 4 display the results of several tests run at that time to determine effectiveness of this design. [Pg.202]

The potential therapeutic effects of herbal drugs have not been extensively tested or conclusively proven. However, scientific study of herbals is under way in the United States and abroad, and many herbs may well prove to be useful. The results of initial studies on many herbals, such as saw palmetto and St. John s wort, are promising. [Pg.228]

U50 000 psi IB, minimum = 60 psi and linear expansion, maximum = 0.25. Properties of all examples given in Table II substantially surpass the comercial standard and also surpass the properties of the PF control boards with respect to linear expansion, thickness swelling, and absorption in the one-hour boil test. Internal bonds, both initial and after the one-hour boil test, and water immersion results of the HDA experimental boards were slightly inferior to results of these tests for the PF control boards. Properties of urea-formaldehyde control boards were similar to the PF control boards excepting in the one-hour boil test where complete failure of all bonding took place in about 15 minutes. [Pg.182]

Effect of Parvlene-C Coating on Historic Silk Fabric. The results of tensile testing of coated and uncoated historic silk fabric are given in Table 5. For modern, strong silk (original, uncoated breaking-load >250 N, strain-to-break >15%), a 0.75 )Un thick layer of Parylene-C increased the tensile properties, with the exception of the initial modulus, as was shown in Table 1. [Pg.131]

Initial tests, as shown in Figures 14-19, demonstrate clearly that the performance goals have been achieved. These goals are shown in Table 2. While Fig. 19, a composite of photographic recording and a photometric scan of the line spectrum at the fiber optic interface, demonstrates the result of these tests. [Pg.312]

T his chapter is a report of the results of conventional testing pro-cedures carried out on a series of kraft paper samples at the Library of Congress. The chemiluminescence emission from the paper samples was measured concurrently in a study at Battelle s Columbus Laboratories, and the results of that study have been presented elsewhere (1). In summary, the chemiluminescence maxima from the papers in humid or dry atmospheres adhered fairly well to a conventional Arrhenius expression from 25° to 100°C, which suggested a continuity in the oxidative mechanism over this temperature range, at least in the initial stages of aging. [Pg.176]


See other pages where Results of Initial Testing is mentioned: [Pg.517]    [Pg.206]    [Pg.271]    [Pg.206]    [Pg.501]    [Pg.517]    [Pg.206]    [Pg.271]    [Pg.206]    [Pg.501]    [Pg.124]    [Pg.1316]    [Pg.101]    [Pg.155]    [Pg.73]    [Pg.226]    [Pg.245]    [Pg.271]    [Pg.362]    [Pg.44]    [Pg.131]    [Pg.47]    [Pg.261]    [Pg.277]    [Pg.167]    [Pg.231]    [Pg.371]    [Pg.344]    [Pg.296]    [Pg.533]    [Pg.5]    [Pg.58]    [Pg.134]    [Pg.41]    [Pg.109]    [Pg.109]    [Pg.417]    [Pg.200]   


SEARCH



Initial Results

Initial Testing

Test initiation

Test result

Testing results

© 2024 chempedia.info