Phenyl-acetic acid ether

Phenylacetamide has been obtained by a wide variety of reactions from benzyl cyanide with water at 250-260° 6 from benzyl cyanide with water and cadmium oxide at 240° 6 from benzyl cyanide with sulfuric acid 7 8 by saturation of an acetone solution of benzyl cyanide with potassium hydrosulfide 9 from benzyl cyanide with sodium peroxide 10 by electrolytic reduction of benzyl cyanide in sodium hydroxide 11 from ethyl phenyl-acetate with alcoholic 12 or aqueous 13 ammonia from phenyl-acetic acid with ammonium acetate 14 or urea 15 from diazoacetophenone with ammoniacal silver solution 16 from phenyl-acetic acid imino ether hydrochloride and water 17 from acetophenone with ammonium poly sulfide at 215° 18 from benzoic acid 19 and by heating the ammonium salt of phenyl-acetic acid.20... 

Indanyl)-phenol 16 was obtained by reacting p-methoxy-phenyl-acetic acid ethyl ester with benzylchloride to form a-benzyl-p-methoxyphenyl ethyl acetate, saponification into the acid, conversion of the acid with thionylchloride into the chloride, cyclization to 2-p-methoxy-phenyl-l-indanone, NaBH4 reduction to 2-p-methoxyphenyl-l-indanole, dehydration with p-toluene-sulphonic acid in toluene to 2-p-methoxyphenyl-indene, catalytic hydrogenation to 2-p-methoxyphenyl-indene, and treating the ether with HBr [Eq. (5)]. 

Benzaldehyde, benzyl methyl ether, benzoic acid, methyl benzoate, and phenyl-acetic acid all undergo thallation initially in the ortho position. Explain this observation. 

The mechanism of benzyl chloride carbonylation to phenyl acetic acid has been studied in some detail, and tentative mechanisms have been offered. The proposed catalytic cycle is shown in Figure 4.8. The biphasic reaction medium consists of two immiscible liquids diphenyl ether and aqueous alkali. 

Mix 6 2 ml. (6 4 g.) of pure ethyl acetoacetate and 5 ml. of pure phenylhydrazine in an evaporating-basin of about 75 ml. capacity, add 0 5 ml. of acetic acid and then heat the mixture on a briskly boiling water-bath (preferably in a fume-cupboard) for I hour, occasionally stirring the mixture with a short glass rod. Then allow the heavy yellow syrup to cool somewhat, add 30-40 ml. of ether, and stir the mixture vigorously the syrup may now dissolve and the solution shortly afterwards deposit the crystalline pyrazolone, or at lower temperatures the syrup may solidify directly. Note. If the laboratory has been inoculated by previous preparations, the syrup may solidify whilst still on the water-bath in this case the solid product when cold must be chipped out of the basin, and ground in a mortar with the ether.) Now filter the product at the pump, and wash the solid material thoroughly with ether. Recrystallise the product from a small quantity of a mixture of equal volumes of water and ethanol. The methyl-phenyl-pyrazolone is obtained... 

Phenol B.P. M.P. Bromo Com. pound Acetate Benzoate p-NItro benzoate 3 5 D. nltro- benzoate Aryloxy- acetic Acid NN-DI- phenyl- carba- mate N-O- naphthyl carba- mate p-Tolu- enesul- phonate 2 4- Dlnltro- phenyl Ether... 

To hydrolyse an ester of a phenol (e.g., phenyl acetate), proceed as above but cool the alkaline reaction mixture and treat it with carbon dioxide until saturated (sohd carbon dioxide may also be used). Whether a solid phenol separates or not, remove it by extraction with ether. Acidify the aqueous bicarbonate solution with dilute sulphuric acid and isolate the acid as detailed for the ester of an alcohol. An alternative method, which is not so time-consuming, may be employed. Cool the alkaline reaction mixture in ice water, and add dilute sulphuric acid with stirring until the solution is acidic to Congo red paper and the acid, if aromatic or otherwise insoluble in the medium, commences to separate as a faint but permanent precipitate. Now add 5 per cent, sodium carbonate solution with vigorous stirring until the solution is alkaline to litmus paper and the precipitate redissolves completely. Remove the phenol by extraction with ether. Acidify the residual aqueous solution and investigate the organic acid as above. 

The principal coloring matter in turmeric and its oleoresin is curcumin [458-37-7] (l,6-heptadiene-3,5-dione, l,7-bis[4-hydroxy-3-methoxy-phenyl] (45), an orange-yeUow, crystalline powder, insoluble in water and ether but soluble in ethanol and glacial acetic acid. It has a reported melting point of 180-183°C. 

Zincon (o-[l-(2-bydroxy-5-sulfo)-3-phenyl-5-formazono]-benzoic acid) [135-52-4] M 459.4. Main impurities are inorganic salts which can be removed by treatment with dilute acetic acid. Organic contaminants are removed by refluxing with ether. It can be recrystd from dilute H2SO4. [Fichter and Schiess Chem Ber 33 751 1900.]... 

The acetic acid mother liquor, containing the rest of the reaction product, was concentrated in vacuo. The residue was dissolved in methylene chloride and washed with ice cold sodium carbonate solution. The organic solution was dried, concentrated in vacuo to a small volume and diluted with ether and petroleum ether. Fine yellow needles of 2-chloro-methyl-4-phenyl-6-chloroquinazoline 3-oxide precipitated. The pure base was recrystallized from a mixture of methylene chloride, ether and petroleum ether, MP 133° to 134°C. 

B) Preparation of 7-Chloro-3-Methoxycarbony/-5-Phenyl-2-0xo-2,3-Dihydro-iH-Benzo [fl-1,4-Diazepine (4347 CB) A solution of 9.2 g (0.04 mol) of compound 4356 CB in 20 ml of methanol is added dropwise, in the course of one hour and 30 minutes, to a boiling solution of 9.2 g (0.05 mol) of the hydrochloride of methyl aminomalonate in 30 ml of methanol. When this is completed, heating under reflux is continued for 30 minutes and the product then concentrated to dryness under reduced pressure. The residue is taken up in water and ether, the ethereal layer separated, the product washed with water and dried over sodium sulfate. The solvent is evaporated under reduced pressure. The residue, which consists of the methyl ester, could not be obtained in the crystalline state. It is dissolved in 25 ml of acetic acid, heated under reflux for 15 minutes, the product evaporated to dryness and the residual oil taken up in ether. A colorless solid separates which... 

To a well stirred suspension of 9 g of sodium phenyl acetate and 2.4 g of magnesium turnings in 25 cc of anhydrous ether, a solution of 9.4 cc of isopropyl bromide in 50 cc of anhydrous ether are added. The mixture is refluxed for one hour (during which time propane is evolved) and then 5 cc of cyclopentanone in 25 cc of anhydrous ether are added dropwise. The mixture is then refluxed for one hour and poured over ice water containing some hydrochloric acid. The ether solution is separated and extracted with 200 cc of 5% sodium hydroxide. The alkaline solution on acidification gives the free acid which is filtered off, dried in a desiccator and recrystallized from a mixture of ethylene dichloride and petroleum ether. 

The pure dimethylaminoethanol salt was dissolved in 400 ml of 50% acetic acid at 90°C and then cooled to 5°C. The solid which precipitated was collected by filtration, washed with water, cold 50% acetic acid and finally with low-boiling petroleum ether. After drying in vacuo there was obtained 24 g of hydrated dextro-/3-(3,5-diiodo-4-hydroxy)-a-phenyl-propionic acid, MP 80° to 85°C. 

A solution of 3.1 g of (2-benzoyl-4-chlorophenyl-carbamoylmethyl)carbamic acid benzyl ester in 30 cc of 20% hydrobromic acid in glacial acetic acid was stirred for 45 minutes at room temperature. On addition of 175 cc of anhydrous ether, a gummy solid precipitated. After several minutes the ether solution was decanted. The resultant 5-chloro-2-gly-cylaminobenzophenone was not isolated, but about 155 cc of ether was added to the residue and after chilling in an ice bath, 10% sodium hydroxide was added until the mixture was alkaline. The ether layer was then separated, washed twice with water and dried over sodium sulfate. After filtration, the ether solution was concentrated to dryness in vacuo. The residue was crystallized from benzene to yield 7-chloro-5-phenyl-3H-1,4-benzodiazepin-2(1 H)-one. 

A solution containing 741 g (5.0 mols) of 1-phenyl-2-propylidenylhydrazine, 300 g (5.0 mols) of glacial acetic acid and 900 cc of absolute ethanol was subjected to hydrogenation at 1,875 psi of hydrogen in the presence of 10 gof platinum oxide catalyst and at a temperature of 30°C to 50°C (variation due to exothermic reaction). The catalyst was removed by filtration and the solvent and acetic acid were distilled. The residue was taken up In water and made strongly alkaline by the addition of solid potassium hydroxide. The alkaline mixture was extracted with ether and the ether extracts dried with potassium carbonate. The product was collected by fractional distillation, BP B5°C (0.30 mm) yield 512 g (68%). 

The 1-phenyl-2-nitropropanol thus obtained is a colorless oil, specific gravity 1.14 at 20°C, odorless when pure, volatile with steam and boiling at 150° to 165°C under a pressure of 5 mm of mercury. It is soluble in alcohol, ether, acetone, chloroform, carbon tetrachloride, benzene and glacial acetic acid. The yield of 1-phenyl-2-nltropropanol obtained by this procedure is 17.1 to 17.7 kg. 

Benzyl cyanide is first reacted with 2-butylbromide in the presence of sodium amide to give 2-phenyl-3-methylvaleronitrile which is hydrolyzed by sulfuric acid to give 3-methyl-2-phenyl-pentanoic acid. 24 g of 2-phenyl-3-methyl-pentanoic acid are heated for one hour at 175° to 185°C with 30 g of 2-diethylaminoethanol and 0.5 g of sodium methylate. The excess diethyl-aminoethanol is removed in vacuo, the residue is dissolved in 300 cc of 2 N-acetic acid, the acid solution is shaken with ether and made alkaline with concentrated potassium carbonate solution and ice. The ether solution Is washed with water, dried with sodium sulfate and evaporated. The residue is distilled under high vacuum, yielding 20 to 21 g of the basic ester (60% of the theoretical) is obtained, the ester boiling at 98° to 100°C at a pressure of 0.03 mm. The hydrochloride of the ester melts at 112° to 113°C and the methobromide at 100° to 101°C. 

R2NC1, 91, 92 phenyl acetate, Fries rearrangement of, 475 phenyacetyl halides, acylation by, 173 2-phenylbenzoic acid, cycliacylation, 185 phenyl ethers, alkylation of, 149 —, bromination of, 130 —, hydrogen exchange with, 260 —, rearrangement of, 476 phenyl ethyl mercury, mercuridemercuration of, 359, 360... 

Acylation The reagent catalyses the arylation of activated aromatic compounds by reaction with carboxylic acids. Thus methyl phenyl ether can be acylated with acetic acid in presence of trifluoroacetic anhydride in good yields. 

---