Miniaturized instrumentation miniaturization

A fuller description of the microchannel plate is presented in Chapter 30. Briefly, ions traveling down the flight tube of a TOF instrument are separated in time. As each m/z collection of ions arrives at the collector, it may be spread over a small area of space (Figure 27.3). Therefore, so as not to lose ions, rather than have a single-point ion collector, the collector is composed of an array of miniature electron multipliers (microchannels), which are all connected to one electrified plate, so, no matter where an ion of any one m/z value hits the front of the array, its arrival is recorded. The microchannel plate collector could be crudely compared to a satellite TV dish receiver in that radio waves of the same frequency but spread over an area are all collected and recorded at the same time of course, the multichannel plate records the arrival of ions not radio waves. 

The major STEM analysis modes are the imaging, diffraction, and microanalysis modes described above. Indeed, this instrument may be considered a miniature analytical chemistry laboratory inside an electron microscope. Specimens of unknown crystal structure and composition usually require a combination of two or more analysis modes for complete identification. 

A type of miniature globe valve, needle valves are used in instrument systems for throttling of small volumes. They have metal to metal seats, but due to the small size, can be used for positive shut-off (Figure 15-8). Needle valves have small passageways that may plug easily and limit their use to very small flow rates. 

A smaller, less expensive, but less accurate instrument, known as the texturemeter, has been discussed by Walls, Kemp, and Stier (37) and by Lee (22). Because of its small size it should be applicable to field use. Kramer (18) has indicated that another instrument, which amounts to a miniature tenderometer adaptable to field use, is in the process of development. 

The resolution of the ToF analyser is dependent upon the ability to measure the very small differences in time required for ions of a similar m/z to reach the detector. Increasing the distance that the ions travel between source and detector, i.e. increasing the length of the flight tube, would accentuate any such small time-differences. The implication of such an increase is that the instrument would be physically larger and this goes against the current trend towards the miniaturization of all analytical equipment. 

The current trend in analytical chemistry applied to evaluate food quality and safety leans toward user-friendly miniaturized instruments and laboratory-on-a-chip applications. The techniques applied to direct screening of colorants in a food matrix include chemical microscopy, a spatial representation of chemical information from complex aggregates inside tissue matrices, biosensor-based screening, and molec-ularly imprinted polymer-based methods that serve as chemical alternatives to the use of immunosensors. 

Proceedings of the 2nd International Symposium on Miniaturized Total Analysis Systems, Analytical Methods and Instrumentation, Special Issue pTAS 96, pp. 9-15, Basel (1996). 

Adjustable Workbench (PAW) instrument assembly. The SH shown in Figs. 3.15 and 3.16 contains the electromechanical transducer (mounted in the center), the main and reference Co/Rh sources, multilayered radiation shields, detectors and their preamplifiers and main (linear) amplifiers, and a contact plate and sensor. The contact plate and contact sensor are used in conjunction with the IDD to apply a small preload when it places the SH holding it firmly against the target. The electronics board contains power supplies/conditioners, the dedicated CPU, different kinds of memory, firmware, and associated circuitry for instrument control and data processing. The SH of the miniaturized Mossbauer spectrometer MIMOS II has the dimensions (5 x 5.5 x 9.5) cm and weighs only ca. 400 g. Both 14.4 keV y-rays and 6.4 keV Fe X-rays are detected simultaneously by four Si-PIN diodes. The mass of the electronics board is about 90 g [36],... 

The instrument MIMOS 11 is extremely miniaturized compared to standard laboratory Mossbauer spectrometers and is optimized for low power consumption and high detection efficiency (see Sect. 3.3) and [326, 327, 336-339]. All components were selected to withstand high acceleration forces and shocks, temperature variations over the Martian diurnal cycle, and cosmic ray irradiation. Mossbauer measurements can be done during day and night covering the whole diurnal temperature... 

The miniaturized Mossbauer instruments have proven as part of the NASA Mars Exploration Rover 2003 mission that Mossbauer spectroscopy is a powerful tool for planetary exploration, including our planet Earth. For the advanced model of MIMOS II, the new detector technologies and electronic components increase sensitivity and performance significantly. In combination with the high-energy resolution of the SDD, it will be possible to perform XRF analysis in parallel to Mossbauer spectroscopy. In addition to the Fe-mineralogy, information on the sample s elemental composition will be obtained. 

Specifically for triazines in water, multi-residue methods incorporating SPE and LC/MS/MS will soon be available that are capable of measuring numerous parent compounds and all their relevant degradates (including the hydroxytriazines) in one analysis. Continued increases in liquid chromatography/atmospheric pressure ionization tandem mass spectrometry (LC/API-MS/MS) sensitivity will lead to methods requiring no aqueous sample preparation at all, and portions of water samples will be injected directly into the LC column. The use of SPE and GC or LC coupled with MS and MS/MS systems will also be applied routinely to the analysis of more complex sample matrices such as soil and crop and animal tissues. However, the analyte(s) must first be removed from the sample matrix, and additional research is needed to develop more efficient extraction procedures. Increased selectivity during extraction also simplifies the sample purification requirements prior to injection. Certainly, miniaturization of all aspects of the analysis (sample extraction, purification, and instrumentation) will continue, and some of this may involve SEE, subcritical and microwave extraction, sonication, others or even combinations of these techniques for the initial isolation of the analyte(s) from the bulk of the sample matrix. 

During the last few years, miniaturization has become a dominant trend in the analysis of low-level contaminants in food and environmental samples. This has resulted in a significant reduction in the volume of hazardous and expensive solvents. Typical examples of miniaturization in sample preparation techniques are micro liquid/liquid extractions (in-vial) and solvent-free techniques such as solid-phase microextraction (SPME). Combined with state-of-the-art analytical instrumentation, this trend has resulted in faster analyses, higher sample throughputs and lower solvent consumption, whilst maintaining or even increasing assay sensitivity. 

---