Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Iodine-acetone reaction

The methyl group in compound 172 can be easily replaced by chlorine or iodine by reaction with HC1 or I2. The chlorosubstituted compound has found to be a good precursor for nucleophilic substitution reactions with NaX (X = Br, I, or SCN) in acetone (Scheme 4) <2001JCD2593>. [Pg.721]

Recent publications concern the qualitative and the quantitative determination of 3-carotene by TLC. Isomerization of a- and 3-carotene was catalyzed by iodine according to the method of Zechmeister. Fig. 2A illustrates typically developed TLC plates for a mixture of a- and 3-carotene isomers.Two-dimensional TLC was done on calcium hydroxide plates with 1.2% acetone in petroleum ether as mobile phase. Expected isomers from the iodine-catalyzed reaction are neoisomers U and B for P-carotene and neoisomers U, W, and B for a-carotene. Photoisomerization of aW-trans-a- and p-carotene solutions was also conducted by Nyambaka and Ryley. This photoisomerization of individual a3 -trans-a- and P-carotene solutions produced several isomers each. Nyambaka and Ryley apphed the separation TLC method, which was done by Schwartz and... [Pg.1390]

Though half of the label gets lost as p- Cjacetate when [1,3- C2]acetone is treated with iodine, this reaction is still a standard preparation procedure for [ " C]iodoform. This compound is an indispensable precursor for [ C] methylene iodide , which is obtained by reduction of with sodium arsenite in alkaline medium. Diiodo[ " C]methane in... [Pg.346]

Apply the test to compounds which contain chlorine or bromine. If the compound is a solid, dissolve 0 1 g. in the minimum volume of pure, dry acetone. To 1 ml. of the sodium iodide acetone reagent add 2 drops of the compound (if a hquid) or the acetone solution (if a sohd). Shake and allow to stand at room temperature for 3 minutes. Note whether a precipitate is formed and also whether the solution acquires a reddish-brown colour (liberation of iodine). If no change takes place at rocrm temperature, place the test-tube in a beaker of water at 50°. After 5 minutes, cool to room temperature, and observe whether a reaction has occurred. [Pg.1060]

In current industrial practice gas chromatographic analysis (glc) is used for quahty control. The impurities, mainly a small amount of water (by Kad-Fischer) and some organic trace constituents (by glc), are deterrnined quantitatively, and the balance to 100% is taken as the acetone content. Compliance to specified ranges of individual impurities can also be assured by this analysis. The gas chromatographic method is accurately correlated to any other tests specified for the assay of acetone in the product. Contract specification tests are performed on product to be shipped. Typical wet methods for the deterrnination of acetone are acidimetry (49), titration of the Hberated hydrochloric acid after treating the acetone with hydroxylamine hydrochloride and iodimetry (50), titrating the excess of iodine after treating the acetone with iodine and base (iodoform reaction). [Pg.98]

Alkali AletalIodides. Potassium iodide [7681-11-0] KI, mol wt 166.02, mp 686°C, 76.45% I, forms colorless cubic crystals, which are soluble in water, ethanol, methanol, and acetone. KI is used in animal feeds, catalysts, photographic chemicals, for sanitation, and for radiation treatment of radiation poisoning resulting from nuclear accidents. Potassium iodide is prepared by reaction of potassium hydroxide and iodine, from HI and KHCO, or by electrolytic processes (107,108). The product is purified by crystallization from water (see also Feeds and feed additives Photography). [Pg.365]

Trichloroacetone [921-03-9] (13a) is prepared by chlorination of acetone. The reaction is nonselective and the required compound is isolated by distillation. The selectivity has been improved by catalyzing the reaction with iodine (31). [Pg.38]

A purified fatty acid is recommended for the preparation of a pure a-sulfo acid. Purified palmitic acid (m.p. 60.8-61.4°, neutralization equivalent 256.2) is prepared by twice recrystallizing a good commercial grade of palmitic acid from acetone at 0°, using a solvent ratio of 10 ml. to 1 g. However, the reaction may be applied to commercial saturated higher fatty acids, if the iodine number is sufficiently low. The checkers obtained similar results with recrystaUized Neo-Fat 1-56 (Armour and Company, Chicago, 111.) or Eastman white label palmitic acid. [Pg.84]

A mixture consisting of 0.69 g (10.5 mmoles) of zinc-copper couple, 12 ml of dry ether, and a small crystal of iodine, is stirred with a magnetic stirrer and 2.34 g (0.7 ml, 8.75 mmoles) of methylene iodide is added. The mixture is warmed with an infrared lamp to initiate the reaction which is allowed to proceed for 30 min in a water bath at 35°. A solution of 0.97 g (2.5 mmoles) of cholest-4-en-3/ -ol in 7 ml of dry ether is added over a period of 20 min, and the mixture is stirred for an additional hr at 40°. The reaction mixture is cooled with an ice bath and diluted with a saturated solution of magnesium chloride. The supernatant is decanted from the precipitate, and the precipitate is washed twice with ether. The combined ether extracts are washed with saturated sodium chloride solution and dried over anhydrous sodium sulfate. The solvent is removed under reduced pressure and the residue is chromatographed immediately on 50 g of alumina (activity III). Elution with benzene gives 0.62 g (62%) of crystalline 4/5,5/5-methylene-5 -cholestan-3/5-ol. Recrystallization from acetone gives material of mp 94-95° Hd -10°. [Pg.112]

No systematic study of the minimal required amount of lead tetraacetate has been made. In cases where the product of the hypoiodite reaction is an iodo ether (20-hydroxy steroids) the reaction can be interrupted at the iodohydrin stage by reducing the amount of iodine to about 0.5 mole. For the oxidation of iodo ethers to lactones, chromium trioxide-sulfuric acid in acetone has been used. Silver chromate is often added to the reaction mixture but comparable yields are obtained without the addition of silver salt. [Pg.250]

The rate equation is first-order in acetone, first-order in hydroxide, but it is independent of (i.e., zero order in) the halogen X2. Moreover, the rate is the same whether X2 is chlorine, bromine, or iodine. These results can only mean that the transition state of the rds contains the elements of acetone and hydroxide, but not of the halogen, which must enter the product in a fast reaction following the rds. Scheme VI satisfies these kinetic requirements. [Pg.217]

A number of dihydroquinolines have been prepared by treating aniline derivatives with acetone or mesityl oxide in the presence of iodine. In these cases aromatization to the fully unsaturated quinoline would require the loss of methane, a process known as the Riehm quinoline synthesis. Such Skraup/Doebner-von Miller-type reactions are often low yielding due to large amounts of competing polymerization. For example, aniline 37 reacts with mesityl oxide to give dihydroquinolines 39, albeit in low yield. ... [Pg.492]

The oxygen atom at 21 is similarly an expendable group. Reaction of 241 (obtained from 185 by the usual procedure for introduction of the 9a-fluoro group) with methanesulfonyl chloride affords the 21 mesylate (242a). Replacement of the leaving group at 21 with iodine by means of potassium iodide in acetone followed by reduction of the halogen with zinc in acetic acid leads to fluorometholone (243). ... [Pg.203]

D) 4 -[N-Ethyi-1 "-Methyl-2 -(4" -Methoxyphenyl)Ethylamino]Butyi-3,4-Dimethoxybenzoate Hydrochloride 10.3 g of 4 -iodobutyl-3,4-dimethoxybenzoate and 11.0 g of N-ethyl-p-methoxyphenylisopropylamine (obtained by catalytic reduction of an alcoholic solution of an excess quantity (60%) of p-methoxy-phenyl-acetone, to which was added a 33% (weight-for-weight) aqueous solution of ethylamine, with Pt as a catalyst), were boiled in 200 ml of methyl ethyl ketone for 20 hours, cooled and the iodine ion was determined the reaction was found to be complete. Then the methyl ethyl ketone was evaporated in vacuo and the residue was dissolved in 300 ml of water and 30 ml of ether the layers were separated and the water layer was extracted twice more with 20 ml portions of ether. [Pg.901]

Differential temperature method. A differential method has been applied to a study of the iodination of acetone, a pseudo-zeroth-order reaction when [(CHj)2CO] [I2].26 It allows the determination of AW to much higher accuracy than otherwise. The reaction rate is expressed mathematically as... [Pg.177]

Cyanide and thiocyanate anions in aqueous solution can be determined as cyanogen bromide after reaction with bromine [686]. The thiocyanate anion can be quantitatively determined in the presence of cyanide by adding an excess of formaldehyde solution to the sample, which converts the cyanide ion to the unreactive cyanohydrin. The detection limits for the cyanide and thiocyanate anions were less than 0.01 ppm with an electron-capture detector. Iodine in acid solution reacts with acetone to form monoiodoacetone, which can be detected at high sensitivity with an electron-capture detector [687]. The reaction is specific for iodine, iodide being determined after oxidation with iodate. The nitrate anion can be determined in aqueous solution after conversion to nitrobenzene by reaction with benzene in the presence of sulfuric acid [688,689]. The detection limit for the nitrate anion was less than 0.1 ppm. The nitrite anion can be determined after oxidation to nitrate with potassium permanganate. Nitrite can be determined directly by alkylation with an alkaline solution of pentafluorobenzyl bromide [690]. The yield of derivative was about 80t.with a detection limit of 0.46 ng in 0.1 ml of aqueous sample. Pentafluorobenzyl p-toluenesulfonate has been used to derivatize carboxylate and phenolate anions and to simultaneously derivatize bromide, iodide, cyanide, thiocyanate, nitrite, nitrate and sulfide in a two-phase system using tetrapentylammonium cWoride as a phase transfer catalyst [691]. Detection limits wer Hi the ppm range. [Pg.959]

This experiment studies the kinetics or reaction mechanisms, and their rates, when iodine is added to acetone ... [Pg.296]

Halogens, See also Bromine (Br) Chlorine (Cl) Fluorine (F) Iodine (I) higher aliphatic alcohols, 2 5 in N-halamines, 13 98 reactions with acetaldehyde, 1 105 reactions with acetone, 1 163 reactions with acetylene, 1 180 reactions with alkanolamines from olefin oxides and ammonia, 2 125—126 reactions with aluminum, 2 284—285, 349-359... [Pg.417]


See other pages where Iodine-acetone reaction is mentioned: [Pg.297]    [Pg.73]    [Pg.279]    [Pg.292]    [Pg.197]    [Pg.175]    [Pg.257]    [Pg.258]    [Pg.892]    [Pg.366]    [Pg.318]    [Pg.52]    [Pg.80]    [Pg.758]    [Pg.12]    [Pg.171]    [Pg.177]    [Pg.272]    [Pg.897]    [Pg.1044]    [Pg.897]    [Pg.257]    [Pg.258]    [Pg.892]    [Pg.501]    [Pg.942]    [Pg.167]    [Pg.408]    [Pg.409]    [Pg.479]    [Pg.24]   
See also in sourсe #XX -- [ Pg.39 , Pg.41 ]




SEARCH



Acetone reaction with iodine

Acetone reactions

Iodine reactions

© 2024 chempedia.info