Methylene iodide

Fig. X-13. Advancing contact angles for methylene iodide-decalin mixtures on polyethylene. (From Ref. 172.)...

Methylene bromide (CHjBfj) and methylene iodide (CHjIj) are easily prepared by the reduction of bromoform or iodoform respectively with sodium arsenite in alkaline solution ... 

In a 1-litre three-necked flask, fitted with a mechanical stirrer, reflux condenser and a thermometer, place 200 g. of iodoform and half of a sodium arsenite solution, prepared from 54-5 g. of A.R. arsenious oxide, 107 g. of A.R. sodium hydroxide and 520 ml. of water. Start the stirrer and heat the flask until the thermometer reads 60-65° maintain the mixture at this temperature during the whole reaction (1). Run in the remainder of the sodium arsenite solution during the course of 15 minutes, and keep the reaction mixture at 60-65° for 1 hour in order to complete the reaction. AUow to cool to about 40-45° (2) and filter with suction from the small amount of solid impurities. Separate the lower layer from the filtrate, dry it with anhydrous calcium chloride, and distil the crude methylene iodide (131 g. this crude product is satisfactory for most purposes) under diminished pressure. Practically all passes over as a light straw-coloured (sometimes brown) liquid at 80°/25 mm. it melts at 6°. Some of the colour may be removed by shaking with silver powder. The small dark residue in the flask solidifies on cooling. 

If the temperature falls below 40°, a precipitate of sodium arsenate will gradiially separate and this will tend to produce an emulsion of the methylene iodide, thus rendering filtration and separation difficult. 

The reaction itself works by the action of Na or K from NaOH or KOH which form what is called a catechoxide dianion with the two OHs of the catechol species. This makes the two ripe for an attack by a methylene halide which can be either DCM (methylene chloride, or dichloromethane), DBM (methylene bromide, or di-bromomethane) or DIM (methylene iodide, or diiodomethane). DCM is cheap and works pretty well, but DBM and DIM work better yet are more expensive. 

Methylene iodide [75-11-6], CH2I2, also known as diio dome thane, mol wt 267.87, 94.76% I, mp 6.0°C, and bp 181°C, is a very heavy colorless Hquid. It has a density of 3.325 g/mL at 20°C and a refractive index of 1.7538 at 4°C. It darkens in contact with air, moisture, and light. Its solubiHty in water is 1.42 g/100 g H2O at 20°C it is soluble in alcohol, chloroform, ben2ene, and ether. Methylene iodide is prepared by reaction of sodium arsenite and iodoform with sodium hydroxide reaction of iodine, sodium ethoxide, and hydroiodic acid on iodoform the oxidation of iodoacetic acid with potassium persulfate and by reaction of potassium iodide and methylene chloride (124,125). Diiodoform is used for determining the density and refractive index of minerals. It is also used as a starting material in the manufacture of x-ray contrast media and other synthetic pharmaceuticals (qv). 

Methylene iodide (i, 57).—The methylene iodide obtained after vacuum distillation melts at 6°. 

In 1958 Simmons and Smith described a new and general synthesis of cyclopropanes by treatment of olefins with a reagent prepared from methylene iodide and a zinc-copper couple in ether solution. 

In this process the lOjS-methyl-3-keto-A -steroid is formed directly using a reagent prepared in situ with an approximately 1 1 molar ratio of zinc and methylene iodide. A one-step mechanism proceeding from the dienol (18) formed by Lewis acids present in solution has been proposed. ... 

A mixture consisting of 0.69 g (10.5 mmoles) of zinc-copper couple, 12 ml of dry ether, and a small crystal of iodine, is stirred with a magnetic stirrer and 2.34 g (0.7 ml, 8.75 mmoles) of methylene iodide is added. The mixture is warmed with an infrared lamp to initiate the reaction which is allowed to proceed for 30 min in a water bath at 35°. A solution of 0.97 g (2.5 mmoles) of cholest-4-en-3/ -ol in 7 ml of dry ether is added over a period of 20 min, and the mixture is stirred for an additional hr at 40°. The reaction mixture is cooled with an ice bath and diluted with a saturated solution of magnesium chloride. The supernatant is decanted from the precipitate, and the precipitate is washed twice with ether. The combined ether extracts are washed with saturated sodium chloride solution and dried over anhydrous sodium sulfate. The solvent is removed under reduced pressure and the residue is chromatographed immediately on 50 g of alumina (activity III). Elution with benzene gives 0.62 g (62%) of crystalline 4/5,5/5-methylene-5 -cholestan-3/5-ol. Recrystallization from acetone gives material of mp 94-95° Hd -10°. 

Estr-5(10)-ene-3a,17 -diol (10 g, 36.2 mmoles) is added over a period of 1 hr to a refluxing mixture consisting of 60 g (0.92 moles) of zinc-copper couple, 350 ml of dry ether and 180 g (54 ml, 0.67 moles) of methylene iodide. After the addition is complete, half of the solvent is removed by distillation and 200 ml dry ether is added. The reaction mixture is then transferred to a sealed stainless steel tube and maintained for 3 hr at 92° before being cooled in an ice bath and poured into 500 ml of saturated aqueous sodium bicarbonate solution. The resultant mixture is extracted with ether and the extracts are dried over anhydrous sodium sulfate and concentrated to yield a solid residue which gives 8.4 g (80%) 5,19-cyclo-5a,10a-androstane-3a,17) -diol mp 161-163° [aJo 40° (CHCI3), on crystallization from acetone. 

To a stirred solution consisting of 5 g (9.45 mmoles) 3, 17) -dibenzoyloxy-5a-androst-7-en-6a-ol in a mixture of 150 ml of dry ether and 150 ml of glyme is added lOg (0.16 moles) of zinc-copper couple and 26.7 (8 ml, 0.1 moles) methylene iodide. The mixture is heated under reflux for 4 hr, cooled to room temperature, diluted with 200 ml of ether and filtered. The filtrate is washed with a saturated solution of sodium chloride and water, and dried over anhydrous sodium sulfate. The ether is removed under reduced pressure and the residue is crystallized from acetone-hexane to yield 4.4 g (86%) of 3, 17 -dibenzoyloxy-7a,8a-methylen-5a,8a-androstan-6a-ol mp 166-167° [ ]d -62° (CHCI3). 

The reactions of dichlorocarbene with morpholine and piperidine enamines derived from cyclopentanone and cyclohexanone have been reported to lead to ring expanded and a-chloromethylene ketone products (355,356). Similarly a-chloro-a, -unsaturated aldehydes were obtained from aldehyde derived enamines (357). Synthesis of aminocyclopropanes (353,359) could be realized by the addition of diphenyldiazomethane (360) and the methylene iodide-zinc reagent to enamines (367). 

Ciamician reported the formation of 3-halogenopyridines in low yield from the reaction of pyrryl potassium with chloroform, or bromo-form, in ether. Similar reactions of pyrrole with benzal chloride and methylene iodide gave 3-phenylpyridine and traces of pyridine, respectively. These reactions were later reinvestigated by Alexander... 

More useful for synthetic purposes, however, is the combination of the zinc-copper couple with methylene iodide to generate carbene-zinc iodide complex, which undergoes addition to double bonds exclusively to form cyclopropanes (7). The base-catalyzed generation of halocarbenes from haloforms (2) also provides a general route to 1,1-dihalocyclopropanes via carbene addition, as does the nonbasic generation of dihalocarbenes from phenyl(trihalomethyl)mercury compounds. Details of these reactions are given below. 

The preparation of cyclopropane derivatives has been greatly facilitated by the development of carbene-type intermediates (see Chapter 13) and their ready reaction with olefins. The preparation of phenylcyclopropane from styrene and the methylene iodide-zinc reagent proceeds in only modest yield, however, and the classical preparation of cyclopropane derivatives by the decomposition of pyrazolines (first employed by Buchner in 1890) is therefore presented in the procedure as a convenient alternative. 

Methyl-arsonsaure, /. methylarsonic (meth-anearsonic) acid, -ather, m. methyl ether, -blau, n. methyl blue, -chlorid, -chlordr, n. methyl chloride, chloromethane. Methylen-blsu, n. methylene blue, -gruppe, /. methylene group, -jodid, n. methylene iodide, diiodomethane. 

Phenylcyclopropane has been prepared by the base catalyzed decomposition of 5-phenylpyrazoline (33 %),2 by the reaction of 1,3-dibromo-l phenylpropane with magnesium (68%),3 and by the reaction of 3-phenylpropyltrimethylammomum iodide with sodium amide in liquid ammonia (80%)4 However, the method frequently used at present is the reaction of styrene with the methylene iodide-zinc reagent (32%)5... 

Methylene Iodide, 1, 57 7, 90 0-Methyl Esculetin, 4, 45 df-METHYL Ethyl Acetic Acid, 5,75 Methyl formate, 3, 67 a-M ETHYL d-GLUCOSIDE, 6, 64... 

Cyclohexene, purification of, 41, 74 reaction with zinc-copper couple and methylene iodide, 41, 73 2-CyclohEXENONE, 40,14 Cydohexylamine, reaction with ethyl formate, 41, 14... 

Melhylenecydobutane-l,2-dicar-boxylic anhydride, 43,27 Methylenecydobutanes by addition of allenes to alkenes, 43, 30 Methylenecyclohexane, 40, 66 Methylene iodide, reaction with zinc-copper couple and cyclohexene, 41, 73... 

Zinc-copper couple, 41, 72 reaction with methylene iodide and cyclohexene, 41, 73... 

---