Headspace sampling for

Pranoto-Soetardhi LA, Rijk MAH, DeKruijf N, et al. 1986. Automatic headspace sampling for determination of ethylene dibromide residues in cereals. Int J Environ Anal Chem 25 151-159. 

SPME can also be used to extract target analytes from food and drug samples. Thus, it has been employed for the extraction of caffeine from coffee and tea [225], and for that of volatile impurities in drugs. Headspace SPME has also been tested for flavour analysis in foods. Thus, the SPME/GC/TOF-MS tandem was successfully used for the rapid analysis of volatile flavour compounds in apple fruit. The sample (300-450 g of apple) was subjected to static headspace sampling for 4 6 h in order to allow the volatiles... 

Headspace sampling for organic volatile impurities (OVls) is typically performed by dissolving the drug substance in a suitable solvent, rather than on the drug in the solid phase to prevent matrix-trapping effects. Subsequently, a specified volume of solution is added to a headspace vial and the solution is heated for a specified time at a specified temperature. Samples of the headspace... 

In addition, we have modified the original SBSE concept and have applied the Gerstel Twister to headspace sampling for the first time. In Fig. 28, a comparison of the chromatograms obtained by SBSE from both the aqueous and gaseous phase of a soft drink sample is depicted. Fascinating differences in the... 

Although aimed at the introductory class, this simple experiment provides a nice demonstration of the use of GG for a qualitative analysis. Students obtain chromatograms for several possible accelerants using headspace sampling and then analyze the headspace over a sealed sample of charred wood to determine the accelerant used in burning the wood. Separations are carried out using a wide-bore capillary column with a stationary phase of methyl 50% phenyl silicone and a flame ionization detector. 

The principle of headspace sampling is introduced in this experiment using a mixture of methanol, chloroform, 1,2-dichloroethane, 1,1,1-trichloroethane, benzene, toluene, and p-xylene. Directions are given for evaluating the distribution coefficient for the partitioning of a volatile species between the liquid and vapor phase and for its quantitative analysis in the liquid phase. Both packed (OV-101) and capillary (5% phenyl silicone) columns were used. The GG is equipped with a flame ionization detector. 

In the Netherlands, milk from every farmer is tested twice a year for the extent of lipolysis, using the BDI method. However, the BDI method only detects long chain FFA, which does not induce off-flavor. On the other hand, headspace sampling does detect the short chain FFA. The aim of this study is to compare the BDI method to headspace sampling. 

Raw milk was heated at 40°C and mixed in a blender for 1 min. This milk was added in different quantities (0-5 ml) to fresh raw milk to induce lipolysis. After 3 days, the milk was analyzed using the BDI method and headspace sampling. 

Solid-phase microextraction (SPME) was used for headspace sampling. The FFA were extracted from the headspace with PA, Car/PDMS, and CW/DVB fibers. It was examined whether addition of salt (NaCl) and decreasing the pH by addition of sulphuric acid (H SO ) increased the sensitivity. FFA were analyzed using gas chromatography coupled to mass spectrometry in selected ion monitoring. 

R. B. Gaines, E. B. Ledford-Jr and J. D. Stuait, Analysis of water samples for ti ace levels of oxygenated and aromatic compounds using headspace solid-phase microexti action and comprehensive two-dimensional gas clnomatography , ]. Microcolumn Sep. 10 597-604(1998). 

Gas phase stripping (purge-and-trap) techniques can iaq>rove the yield of organic volatiles from water or biological fluids by facilitating the transfer of volatiles from the liquid to the gas phase it is also more suitable than dynamic headspace sampling when the sample volume is restricted (320 23,347-351). Tbe technique is used routinely in many laboratorl B for the analysis... 

Small solid seuaples can be analyzed directly by dynamic headspace sampling using a platinum coil and quartz crucible pyrolyzer and cold trap coupled to an open tubular column (341,369,379). This method has been used primarily for the analysis of mineral samples and of additives, catalysts and byproducts in finished polymers which yield unreliable results using conventional headspace techniques owing to the slow release of the volatiles to the headspace. At the higher temperatures (450-1000 C) available with the pyrolyzer the volatiles are more readily and completely removed from the sample providing for quantitative analysis. 

Where is the initial analyte concentration in the liquid phase, C( the concentration of analyte in the gas phase, K the gas-liquid partition coefficient for the analyte at the analysis temperature, V, the volume of liquid phase, and V, the volume of gas phase (318-321,324,325). From equation (8.3) it can be seen that the concentration of the analyte in the headspace above a liquid in equilibrium with a vapor phase will depend on the volume ratio of the geis and liquid phases and the compound-specific partition coefficient which, in turn, is matrix dependent. The sensitivity 1 of the headspace sampling method can be increased in some instances adjusting the pH, salting out or raising the... 

Two basic methods are used for SPME direct immersion of the fibre into the sample and headspace sampling. Experimental parameters comprise the polarity of the sample matrix and coating material, solvent and salting-out. Other parameters for optimisation of SPME conditions include desorption time, injector port temperature and initial oven temperature. 

Sample pretreatment Occasional matrix clean-up Occasional matrix clean-up not for headspace sampling... 

There are basically three methods of liquid sampling in GC direct sampling, solid-phase extraction and liquid extraction. The traditional method of treating liquid samples prior to GC injection is liquid-liquid extraction (LLE), but several alternative methods, which reduce or eliminate the use of solvents, are preferred nowadays, such as static and dynamic headspace (DHS) for volatile compounds and supercritical fluid extraction (SFE) and solid-phase extraction (SPE) for semivolatiles. The method chosen depends on concentration and nature of the substances of interest that are present in the liquid. Direct sampling is used when the substances to be assayed are major components of the liquid. The other two extraction procedures are used when the pertinent solutes are present in very low concentration. Modem automated on-line SPE-GC-MS is configured either for at-column conditions or rapid large-volume injection (RLVI). 

Table 4.25 lists the main characteristics of headspace sampling. In HS-GC sample preparation is very often limited to placing a sample in a vial. Sample extraction, clean-up and preconcentration are not necessary. Elimination of solvents in preparing samples for GC has several benefits ... 

HS-GC methods have equally been used for chromatographic analysis of residual volatile substances in PS [219]. In particular, various methods have been described for the determination of styrene monomer in PS by solution headspace analysis [204,220]. Residual styrene monomer in PS granules can be determined in about 100 min in DMF solution using n-butylbenzene as an internal standard for this monomer solid headspace sampling is considerably less suitable as over 20 h are required to reach equilibrium [204]. Shanks [221] has determined residual styrene and butadiene in polymers with an analytical sensitivity of 0.05 to 5 ppm by SHS analysis of polymer solutions. The method development for determination of residual styrene monomer in PS samples and of residual solvent (toluene) in a printed laminated plastic film by HS-GC was illustrated [207], Less volatile monomers such as styrene (b.p. 145 °C) and 2-ethylhexyl acrylate (b.p. 214 °C) may not be determined using headspace techniques with the same sensitivities realised for more volatile monomers. Steichen [216] has reported a 600-fold increase in headspace sensitivity for the analysis of residual 2-ethylhexyl acrylate by adding water to the solution in dimethylacetamide. 

In static headspace sampling [301,302] the polymer is heated in a septum-capped vial for a time sufficient for the solid and vapour phases to reach equilibrium (typically 2 hours). The headspace is then sampled (either manually or automatically) for GC analysis, often followed by FID or NPD detection. Headspace sampling is a very effective method for maintaining a clean chromatographic system. Changing equilibrium temperature and time, and the volumes present in the headspace vial can influence the sensitivity of the static headspace system. SHS-GC-MS is capable of analysing volatile compounds in full scan with ppb level... 

A. J. Matich, D. D. Rowan, N. H. Banks, Solid phase microextraction for quantitative headspace sampling of apple volatiles, Anal. Chem., 68, 4114 4118 (1996). 

---