Electrolyte system, effect

It was possible to improve the interfacial properties of Li metal anodes in liquid electrolyte solutions using additives that modify the Li-surface chemistry, such as C02 [23-27] and HF [28,29], Using PEO-based gel electrolyte systems effectively suppressed dendritic deposition of lithium [30], In Section C we report on a very good charge-discharge performance of lithium metal anodes in PVdF-HFP gel electrolyte systems. Furthermore, addition of C02 to the PVdF-HFP gel electrolyte system considerably improves the charge/discharge characteristics [31]. 

The holistic thermodynamic approach based on material (charge, concentration and electron) balances is a firm and valuable tool for a choice of the best a priori conditions of chemical analyses performed in electrolytic systems. Such an approach has been already presented in a series of papers issued in recent years, see [1-4] and references cited therein. In this communication, the approach will be exemplified with electrolytic systems, with special emphasis put on the complex systems where all particular types (acid-base, redox, complexation and precipitation) of chemical equilibria occur in parallel and/or sequentially. All attainable physicochemical knowledge can be involved in calculations and none simplifying assumptions are needed. All analytical prescriptions can be followed. The approach enables all possible (from thermodynamic viewpoint) reactions to be included and all effects resulting from activation barrier(s) and incomplete set of equilibrium data presumed can be tested. The problems involved are presented on some examples of analytical systems considered lately, concerning potentiometric titrations in complex titrand + titrant systems. All calculations were done with use of iterative computer programs MATLAB and DELPHI. 

To find the best a priori conditions of analysis, the equilibrium analysis, based on material balances and all physicochemical knowledge involved with an electrolytic system, has been done with use of iterative computer programs. The effects resulting from (a) a buffer chosen, (b) its concentration and (c) complexing properties, (d) pH value established were considered in simulated and experimental titrations. Further effects tested were tolerances in (e) volumes of titrants added in aliquots, (f) pre-assumed pH values on precision and accuracy of concentration measured from intersection of two segments obtained in such titrations. 

To conclude this section let us note that already, with this very simple model, we find a variety of behaviors. There is a clear effect of the asymmetry of the ions. We have obtained a simple description of the role of the major constituents of the phenomena—coulombic interaction, ideal entropy, and specific interaction. In the Lie group invariant (78) Coulombic attraction leads to the term -cr /2. Ideal entropy yields a contribution proportional to the kinetic pressure 2 g +g ) and the specific part yields a contribution which retains the bilinear form a g +a g g + a g. At high charge densities the asymptotic behavior is determined by the opposition of the coulombic and specific non-coulombic contributions. At low charge densities the entropic contribution is important and, in the case of a totally symmetric electrolyte, the effect of the specific non-coulombic interaction is cancelled so that the behavior of the system is determined by coulombic and entropic contributions. 

Doyle et al. [40] used a mathematical model to examine the effect of separator thickness for the PVDF.HFP gel electrolyte system and found that decreasing separator thickness below 52 pm caused only a minor decrease in ohmic drop across the cell. The voltage drops in the electrodes were much more significant. They state that their model predictions were confirmed experimentally. 

Although cyclic voltammetry in a variety of electrolyte systems, and with a variety of doped polymers, has shown strong effects due to ion transport, it has provided little understanding. In fact, one of the important uses of ion transport data from the techniques discussed in the preceding subsections is that they help to provide an understanding of the cyclic voltammetry behavior of conducting polymer films. Their importance will... 

Lithium perchlorate-dioxolane electrolyte systems are unsafe for secondary battery applications, as an explosion occurred during overnight cyclic testing of a Li/TiS2 system. The effect was duplicated under all over-discharge or cell-reversal conditions. 

From the research on electrocodeposition to date, a number of variables appear to be influential in the process, which include hydrodynamics, current density, particle characteristics, bath composition, and the particle-bath interaction. The influence that a particular variable has on the process is typically assessed by the change in the amount of particle incorporation obtained when that variable is adjusted. Although the effect of each of these process variables has been reported in the literature, the results are often contradictory. The effects of the process variables, of which many are interrelated, can also vary for different particle-electrolyte systems and electrodeposition cell configurations used. This review will summarize these effects and the contradictions in the literature on electrocodeposition. 

It should be noted that the local composition model is not consistent with the commonly accepted solvation theory. According to the solvation theory, ionic species are completely solvated by solvent molecules. In other words, the local mole fraction of solvent molecules around a central ion is unity. This becomes unrealistic when applied to high concentration electrolyte systems since the number of solvent molecules will be insufficient to completely solvate ions. With the local composition model, all ions are, effectively, completely surrounded by solvent molecules in dilute electrolyte systems and only partially surrounded by solvent molecules in high concentration electrolyte systems. Therefore, the local composition model is believed to be closer to the physical reality than the solvation theory. 

A second type of ternary electrolyte systems is solvent -supercritical molecular solute - salt systems. The concentration of supercritical molecular solutes in these systems is generally very low. Therefore, the salting out effects are essentially effects of the presence of salts on the unsymmetric activity coefficient of molecular solutes at infinite dilution. The interaction parameters for NaCl-C02 binary pair and KCI-CO2 binary pair are shown in Table 8. Water-electrolyte binary parameters were obtained from Table 1. Water-carbon dioxide binary parameters were correlated assuming dissociation of carbon dioxide in water is negligible. It is interesting to note that the Setschenow equation fits only approximately these two systems (Yasunishi and Yoshida, (24)). 

The semi-empirical Pitzer equation for modeling equilibrium in aqueous electrolyte systems has been extended in a thermodynamically consistent manner to allow for molecular as well as ionic solutes. Under limiting conditions, the extended model reduces to the well-known Setschenow equation for the salting out effect of molecular solutes. To test the validity of the model, correlations of vapor-liquid equilibrium data were carried out for three systems the hydrochloric acid aqueous solution at 298.15°K and concentrations up to 18 molal the NH3-CO2 aqueous solution studied by van Krevelen, et al. 

It is shown that the properties of fully ionized aqueous electrolyte systems can be represented by relatively simple equations over wide ranges of composition. There are only a few systems for which data are available over the full range to fused salt. A simple equation commonly used for nonelectrolytes fits the measured vapor pressure of water reasonably well and further refinements are clearly possible. Over the somewhat more limited composition range up to saturation of typical salts such as NaCl, the equations representing thermodynamic properties with a Debye-Hiickel term plus second and third virial coefficients are very successful and these coefficients are known for nearly 300 electrolytes at room temperature. These same equations effectively predict the properties of mixed electrolytes. A stringent test is offered by the calculation of the solubility relationships of the system Na-K-Mg-Ca-Cl-SO - O and the calculated results of Harvie and Weare show excellent agreement with experiment. 

In conclusion, in the presence of a concentrated adsorbing electrolyte, the effect of the electrode charge on AG° is greater. Moreover, for both systems, an increase in concentration of the electrolyte leads to the enhancement of the attractive interaction between the Ac dipoles and an... 

A fundamental improvement in the facilities for studying electrode processes of reactive intermediates was the purification technique of Parker and Hammerich [8, 9]. They used neutral, highly activated alumina suspended in the solvent-electrolyte system as a scavenger of spurious impurities. Thus, it was possible to generate a large number of dianions of aromatic hydrocarbons in common electrolytic solvents containing tetraalkylammonium ions. It was the first time that such dianions were stable in the timescale of slow-sweep voltammetry. As the presence of alumina in the solvent-electrolyte systems may produce adsorption effects at the electrode, or in some cases chemisorption and decomposition of the electroactive species, Kiesele constructed a new electrochemical cell with an integrated alumina column [29]. 

Solid polymer and gel polymer electrolytes could be viewed as the special variation of the solution-type electrolyte. In the former, the solvents are polar macromolecules that dissolve salts, while, in the latter, only a small portion of high polymer is employed as the mechanical matrix, which is either soaked with or swollen by essentially the same liquid electrolytes. One exception exists molten salt (ionic liquid) electrolytes where no solvent is present and the dissociation of opposite ions is solely achieved by the thermal disintegration of the salt lattice (melting). Polymer electrolyte will be reviewed in section 8 ( Novel Electrolyte Systems ), although lithium ion technology based on gel polymer electrolytes has in fact entered the market and accounted for 4% of lithium ion cells manufactured in 2000. On the other hand, ionic liquid electrolytes will be omitted, due to both the limited literature concerning this topic and the fact that the application of ionic liquid electrolytes in lithium ion devices remains dubious. Since most of the ionic liquid systems are still in a supercooled state at ambient temperature, it is unlikely that the metastable liquid state could be maintained in an actual electrochemical device, wherein electrode materials would serve as effective nucleation sites for crystallization. 

In summary, these trends in the change of conductivity with m, xec, and T can be consistently interpreted in terms of the change of e and r] with these same variables. Since these factors and their effect on ion conductivity are not unique to the system illustrated, LiPFe/EC/DMC, these trends should provide general guidance as to how ion conductivities of other electrolyte systems with similar compositions would change with these same variables, and they should constitute a useful database for the understanding of more complex systems, such as ternary or quaternary mixtures. 

When the poor anodic stability of DMC or EMC alone on a similar cathode surface is considered, the role of EC in stabilizing the solvent system becomes obvious. A conclusion that could be extracted from these studies is that the existence of EC not only renders the electrolyte system with superior cathodic stability by forming an effective SEI on the carbonaceous anode but also acts as a key component in forming a surface layer on the cathode surface that is of high breakdown potential. It is for its unique abilities at both electrodes that EC has become an indispensable cosolvent for the electrolyte used in lithium ion cells. 

Prospects for TR Electrolyte SBs. In view of the harmful effects often cited in the literature of even small traces of water on the operation of non-aqueous batteries with alkali metal anodes, it might be supposed that electrolytes of the TR composition cannot be applied in such batteries. This same idea may dominate when molten salt SBs are considered. Such a general conclusion cannot be justified. A dilute solution of water in a salt has the structure either of this salt proper or its adjacent hydrate, and the energy, properties and reactions of this water are quite different from those of pure water or of dilute solutions of various compounds in it. On the other hand, a small amount of water in the electrolyte system will decrease its melting point and increase its conductivity. Mixtures of water with such liquids as some alcohols or dioxane and other aprotic and even proton-forming substances, may open new prospects for... 

Cardiovascular Effects. Most studies of humans exposed to carbon tetrachloride by inhalation have not detected significant evidence of cardiovascular injury, even at exposure levels sufficient to markedly injure the liver and/or kidney. Changes in blood pressure, heart rate, or right- sided cardiac dilation have sometimes, but not always, been observed (Ashe and Sailer 1942 Guild et al. 1958 Kittleson and Borden 1956 Stewart et al. 1961 Umiker and Pearce 1953), and are probably secondary either to fluid and electrolyte retention resulting from renal toxicity, or to central nervous system effects on the heart or blood vessels. Carbon tetrachloride also may have the potential to induce cardiac arrhythmias by sensitizing the heart to epinephrine, as has been reported for various chlorinated hydrocarbon propellants (Reinhardt et al. 1971). 

Other Systemic Effects. In rabbits exposed dermally to isophorone at doses up to 3160 mg/kg, no systemic pathological effects were found by gross necropsy (Hazleton Labs 1964), but histological examinations were not performed. In this study, the site of application was occluded for 24 hours to prevent evaporation of isophorone from the skin. No significant differences between pre-exposure and post-exposure levels of serum electrolytes, blood glucose and sulfhydride radicals, SGOT,... 

---