Condensed fumes

The body of evidence points to the oxidation of the flammable material (condensed fumes) on activated carbon as the ignition source. There is no doubt that cooler evening temperatures caused the vapors in the tanks to contract. Air was drawn into the drums. Autoignition of the turpentine on carbon occurred and the resulting flame traveled back to the tanks. [11,12]... 

Administration of condensed fumes from both types of coal tar pitches and both types of asphalt resulted in benign tumors (papillomas, kerato-acanthomas, fibromas, and unclassified benign epitheliomas) and malignant tumors such as squamous cell carcinoma and fibrosarcomas (seen more often in C3H/HeJ mice) (Niemeier et al. 1988). CD-I mice had a much lower incidence of malignant tumors than C3H/HeJ... 

Copal oil n. Another name for the condensed fumes obtained during the running of natural copals. 

Axial Flow Propeller fan Tubeaxlal (duct) fan Vane axial fan Moves large quantities of air low static pressure used for relatively clean air and no duct resistance common for general ventilation Fabricated in a round duct used for condensable fumes, pigments and other materials that collect on blades larger diameters at slow speeds are better for abrasives and accumulating material Develops higher pressures than other axial flow fans more economical in horsepower and space... 

The Kjeldahl flasks used should be made of borosilicate glass or silica (100- to 250-ml nominal capacity) fitted with an extension to the neck by means of a standard ground joint. The extension serves to condense fumes into an acid-fume condenser and carries a tap funnel through which the reagents are introduced. A suitable apparatus is shown in Fig. 22. 

About 0.5 g of iodine is placed in a small flask fitted with a long reflux air condenser and 15 cm of fuming nitric acid (b.p. 380 K) are added. The mixture is then heated on a water bath at 385-390 K in a fume cupboard until the reaction seems to be complete. This takes about an hour. The solution is then transferred to an evaporating basin and evaporated to dryness on a steam bath. The iodic acid... 

Add 15 g, of chloroacetic acid to 300 ml. of aqueous ammonia solution d, o-88o) contained in a 750 ml. conical flask. (The manipulation of the concentrated ammonia should preferably be carried out in a fume-cupboard, and great care taken to avoid ammonia fumes.) Cork the flask loosely and set aside overnight at room temperature. Now concentrate the solution to about 30 ml. by distillation under reduced pressure. For this purpose, place the solution in a suitable distilling-flask with some fragments of unglazed porcelain, fit a capillary tube to the neck of the flask, and connect the flask through a water-condenser and receiver to a water-pump then heat the flask carefully on a water-bath. Make the concentrated solution up to 40 ml. by the addition of water, filter, and then add 250 ml. of methanol. Cool the solution in ice-water, stir well, and set aside for ca. I hour, when the precipitation of the glycine will be complete. 

Assemble in a fume-cupboard a 3-necked flask fitted with a stirrer, a reflux condenser, and a dropping-funnel, the apparatus... 

This preparation must be performed in a fume-cupboard, because nitrous fumes are evolved during the nitration. A ground-glass flask and air condenser (Fig. 22(a) and (c), p. 43) should preferably be used. 

Place 0 5 ml. of the pyridine in a 200 ml. round- or flat-bottomed flask and add 34 ml. (30 g.) of benzene. Fit the flask with a reflux water-condenser, and then place it in a cold water-bath. If the experiment is conducted in a fume-cupboard, the top of the condenser can be closed with a calcium chloride tube bent downwards (as in Fig. 61, p. 105 or in Fig. 23(A), p. 45, where the outlet-tube A will carry the calcium chloride tube) and the hydrogen bromide subsequently allowed to escape if, however, the experiment is performed in the open laboratory, fit to the top of the condenser (or to the outlet-tube A) a glass delivery-tube which leads through a piece of rubber tubing to an inverted glass funnel, the rim of which dips just below the surface of some water... 

For this preparation, which must be performed in the fume-cupboard, assemble the apparatus shown in Fig. 67(A). C is a 150 ml. distilling-flask, to the neck of which is fitted a reflux single-surface water-condenser D, closed at the top E by a calcium chloride tube. The side-arm of C carries a cork F which fits the end E of the condenser for subsequent distillation. The side-arm of C is meanwhile plugged by a small rubber cork, or by a short length of glass rod. (Alternatively, use the ground-glass flask and condenser (Fig. 22 (a) and (c), p. 43), and... 

Assemble in a fume-cupboard the apparatus shown in Fig. 67(A). Place 15 g. of 3,5-dinitrobenzoic acid and 17 g. of phosphorus pentachloride in the flask C, and heat the mixture in an oil-bath for hours. Then reverse the condenser as shown in Fig. 67(B), but replace the calcium chloride tube by a tube leading to a water-pump, the neck of the reaction-flask C being closed with a rubber stopper. Now distil off the phosphorus oxychloride under reduced pressure by heating the flask C in an oil-bath initially at 25-30, increasing this temperature ultimately to 110°. Then cool the flask, when the crude 3,5-dinitro-benzoyl chloride will solidify to a brown crystalline mass. Yield, 16 g., i.e,y almost theoretical. Recrystallise from caibon tetrachloride. The chloride is obtained as colourless crystals, m.p. 66-68°, Yield, 13 g Further recrystallisation of small quantities can be performed using petrol (b.p. 40-60°). The chloride is stable almost indefinitely if kept in a calcium chloride desiccator. 

Add 60 ml. of concentrated hydrochloric acid with shaking to 30 ml. of aniline in the flask, cool the mixture to about 50, and then add 45 ml. of paraldehyde and some fragments of unglazed porcelain assemble the apparatus without delay in a fume-cupboard with the condenser inclined at an angle of about 60°. 

Some alcohols react readily with phenylisocyanate at room temperature, and others require heating, preferably in petroleum. Phenylisocyanate is poisonous and should not be heated outside a fume-cupboard except under a condenser. 

Method 1. Mix 1 0 g. of 3 5-dinitrobenzoic acid (Section IV,168) with 4 ml. of thionyl chloride in a dry 50 ml. conical flask fit a reflux condenser, carrying a plug of cotton wool at the upper end, into the flask and heat on a water bath for 15-30 minutes. Remove the condenser and heat the flask in a boiling water bath FUME CUPBOARD 1) until the excess of thionyl chloride has evaporated. Use the resulting 3 5-dinitrobenzoyl chloride (about 10 g.) immediately. 

In a 1500 ml. round-bottomed flask, carrying a reflux condenser, place 100 g. of pure cydohexanol, 250 ml. of concentrated hydrochloric acid and 80 g. of anhydrous calcium chloride heat the mixture on a boiling water bath for 10 hours with occasional shaking (1). Some hydrogen chloride is evolved, consequently the preparation should be conducted in the fume cupboard. Separate the upper layer from the cold reaction product, wash it successively with saturated salt solution, saturated sodium bicarbonate solution, saturated salt solution, and dry the crude cycZohexyl chloride with excess of anhydrous calcium chloride for at least 24 hours. Distil from a 150 ml. Claisen flask with fractionating side arm, and collect the pure product at 141-5-142-5°. The yield is 90 g. 

In a 200 ml. distilling flask place 64 g. (50 ml.) of dry n-butyl bromide and 80 g. of dry silver nitrite (1). Insert a reflux condenser, carrying a cotton wool (or calcium chloride) guard tube, into the mouth of the flask and close the side arm with a small stopper. Allow the mixture to stand for 2 hours heat on a steam bath for 4 hours (some brown fumes are evolved), followed by 8 hours in an oil bath at 110°. Distil the mixture and collect the fraction of b.p. 149-151° as pure 1-nitro-n-butane (18 g.). A further small quantity may be obtained by distilling the fractions of low boihng point from a Widmer flask. 

Fit a 3-litre rovmd-bottomed flask with a long reflux condenser and a dropping funnel (1). Place a mixture of 400 ml. of concentrated nitric acid and 600 ml. of water in the flask and heat nearly to boiling. Allow 100 g. (116 ml.) of cycZopentanone (Section 111,73) to enter the hot acid dropwise, taking care that the first few drops are acted upon by the acid, otherwise an explosion may occur the addition is complete in 1 hour. Much heat is evolved in the reaction so that the flame beneath the flask must be considerably lowered. Omng to the evolution of nitrons fumes, the reaction should be carried out in the fume cupboard or the fumes... 

Place a mixture of 1 0 g. of the hydrocarbon, 10 ml. of dry methylene chloride or ethylene dichloride or syw.-tetrachloroethane, 2 5 g. of powdered anhydrous aluminium chloride and 1-2 g. of pure phthalic anhydride in a 50 ml. round-bottomed flask fitted with a short reflux condenser. Heat on a water bath for 30 minutes (or until no more hydrogen chloride fumes are evolved), and then cool in ice. Add 10 ml. of concentrated hydrochloric acid cautiously and shake the flask gently for 5 min utes. Filter oflf the solid at the pump and wash it with 10-15 ml. of cold water. Boil the resulting crude aroylbenzoic acid with 10 ml. of 2 -5N sodium carbonate solution and 0 2 g. of decolourising carbon for 5 minutes, and filter the hot solution. Cool, add about 10 g. of crushed ice and acidify... 

Place 18 g. (12 ml.) of fuming nitric acid, sp. gr. 1 5, and 30 g. (16-5 ml.) of concentrated sulphuric acid and a few fragments of broken glass in a 250 or 500 ml. round-bottomed flask. Add gradually, in small portions, 14 g. of p-nitrotoluene do not allow the temperature to rise above 50 and cool the flask, if necessary, by immersion in cold water. Place a small funnel in the mouth of the flask and heat on a water bath at 90-95° for 30 minutes. Allow to cool almost to the laboratory temperature and pour the reaction mixture slowly into about 500 ml. of ice water containing a few small pieces of ice. Filter the crude dinitrotoluene through a Buchner funnel at the pump, wash it thoroughly with cold water, and drain as completely as possible. RecrystalUse from the minimum volume of hot methyl alcohol (flask, reflux condenser, and water bath experimental details as in Section IV,12). The yield of pure 2 4-dinitrotoluene, m.p. 71°, is 12 -5 g. 

Equip a 500 ml. three necked flask with a reflux condenser, a mercury-sealed mechanical stirrer and separator funnel, and support it on a water bath. Attach an absorption device (Fig. II, 8, 1, c) to the top of the condenser (1). Place 134 g. (152 ml.) of A.R, benzene and 127 g. of iodine in the flask, and heat the water bath to about 50° add 92 ml. of fuming nitric acid, sp. gr. 1-50, slowly from the separatory funnel during 30 minutes. Oxides of nitrogen are evolved in quantity. The temperature rises slowly without the application of heat until the mixture boils gently. When all the nitric acid has been introduced, reflux the mixture gently for 15 minutes. If iodine is still present, add more nitric acid to the warm solution until the purple colour (due to iodine) changes to brownish-red. 

---