Chlorides preparation

Dinitrobenzoylation. To 0 5 g. of powdered 3,5-dinitro benzoyl chloride (preparation, p. 240) in a dry test-tube, add 2 ml. of dry methanol and warm the mixture until a clear solution is obtained. Cool and filter off the solid ester which separates. Recrystallise from petroleum (b.p. 60-80 ), and take the m.p. (M.ps., pp. 536, 537.)... 

Dinitrobenzoyl-glycine. Dissolve 0 4 g. of glycine in 10 ml. of TV.NaOH solution in a small stoppered bottle. And i-i g. of finely powdered 3 5-dinitrobenzoyl chloride (preparation, p. 242) and shake vigorously for about 1 minute. Filter if necessary and acidify with dil. 

Cuprous cyanide solution. The most satisfactory method is to dissolve the cuprous cyanide (1 mol) in a solution of technical sodium cyanide (2 5-2-6 mols in 600 ml. of water). If it is desired to avoid the preparation of solid cuprous cyanide, the following procedure may be adopted. Cuprous chloride, prepared from 125 g. of copper sulphate crystals as described under 1 above, is suspended in 200 ml. of water contained in a 1-litre round-bottomed flask, which is fitted with a mechanical stirrer. A solution of 65 g. of technical sodium cyanide (96-98 per cent.) in 100 ml. of water is added and the mixture is stirred. The cuprous chloride passes into solution with considerable evolution of heat. As the cuprous cyanide is usually emplo3 ed in some modification of the diazo reaction, it is usual to cool the resulting solution in ice. 

From the acid chloride. By the interaction of the acid chloride (prepared from the acid and thionyl chloride) and the calculated quantity of the alcohol at 0°, for example ... 

Vinyl compounds. Vinyl chloride (prepared from acetylene and hydrogen chloride) 3 ields polyvinyl chloride (P.V.C.), which is employed as a rubber substitute and for other purposes. Vinyl acetate (from... 

KBr 119.01 The commercial reagent (ACS) may contain 0.2% chloride. Prepare an aqueous solution of approximately the desired concentration and standardize it against AgNOg. 

Other acetyl chloride preparations include the reaction of acetic acid and chlorinated ethylenes in the presence of ferric chloride [7705-08-0] (29) a combination of ben2yl chloride [100-44-7] and acetic acid at 85% yield (30) conversion of ethyUdene dichloride, in 91% yield (31) and decomposition of ethyl acetate [141-78-6] by the action of phosgene [75-44-5] producing also ethyl chloride [75-00-3] (32). The expense of raw material and capital cost of plant probably make this last route prohibitive. Chlorination of acetic acid to monochloroacetic acid [79-11-8] also generates acetyl chloride as a by-product (33). Because acetyl chloride is cosdy to recover, it is usually recycled to be converted into monochloroacetic acid. A salvage method in which the mixture of HCl and acetyl chloride is scmbbed with H2SO4 to form acetyl sulfate has been patented (33). 

Mischmetal. Mischmetal [62379-61-7] contains, in metallic form, the mixed light lanthanides in the same or slightly modified ratio as occurs in the resource minerals. It is produced by the electrolysis of fused mixed lanthanide chloride prepared from either bastnasite or mona2ite. Although the precise composition of the resulting metal depends on the composition of chloride used, the cerium content of most grades is always close to 50 wt %. 

Chlorophenylacetic acid [1878-65-5] M 170.6, m 74°, pK 4.11. Crystd from EtOH/water, or as needles from C6H6 or H2O (charcoal). The acid chloride (prepared by boiling with SOCI2) has b 127-129°/15mm. [Dippy and Williams J Chem Soc 161 1934 Misra and Shukla J Indian Chem Soc 28 480 1951.]... 

Hydrogen chloride prepared by dropping concentrated sulfuric acid into a mixture of sodium chloride and concentrated hydrochloric acid may be used directly without diying. 

Methyl- and 3-phenyl-4-hydroxy-2-oxo-2//-pyrido[2,1 -Z)]oxazinium inner salts were prepared in the reaction of 2-pyridone and 2-substituted malonyl chloride, prepared in situ from 2-substituted malonic acid with PCI5 in CH2CI2 (00JCS(P2)2096). 

Step A Preparation of (2 -isopropylidenedioxy)-propyl o-nitrobenzoate-SSS g of 2 -di-methyl4-hydroxymethyl-1 -dloxolane were dissolved under agitation In 60 cc of anhydrous pyridine. The solution was cooled to i-5 G and 86.5 g of o-nitrobenzoyl chloride (prepared by Leckermann et a., 8er. vol. 80,p.488,1947) were slowly introduced Into it. The reaction mixture was agitated for a period of two hours at room temperature and then was poured into 500 cc of ether. The mixture was filtered and the filtrate was washed successively with 0.5 N sulfuric acid solution, with aqueous sodium bicarbonate solution and finally with water until the wash waters were neutral. The washed solution was dried over sodium sulfate and filtered again. The filtrate was distilled to dryness under vacuum to obtain 116.5 g (being a yield of 92%) of (2,3-isopropylidenedioxy)-propyl o-nitrobenzoate in the form of a yellow oil which distilled at 178 to 180°C at a pressure of 1 mm. 

Procedure (copper in copper(I) chloride). Prepare an ammonium iron(III) sulphate solution by dissolving 10.0 g of the salt in about 80 mL of 3 M sulphuric acid and dilute to 100 mL with acid of the same strength. Weigh out accurately about 0.3 g of the sample of copper(I) chloride into a dry 250 mL conical flask and add 25.0 mL of the iron(III) solution. Swirl the contents of the flask until the copper(I) chloride dissolves, add a drop or two of ferroin indicator, and titrate with standard 0.1 M cerium(IV) sulphate. 

Notes. (1) A suitable solution for practice may be prepared by evaporating 20.0 mL of 0.02M sodium chloride, prepared from the salt, to about 1.5 mL on a water bath. 

The conjugate addition of trichloromethylmagnesium chloride, prepared from 2.7 equivalents of isopropylmagnesium chloride and one equivalent of carbon tetrachloride at 110 C, to 8 (R1 = CH3) gave 9 with overall selectivity of 98 2 in 99% yield31. 

Z-Arginine hydrochloride, 12, 4 Arsanilic acid, 16, 85 Arsonoacetic acid, 10,108 Arylarsonic acid, preparation, IS, 59 y-Arylbutyric esters, 18, 25 Arylsulfur chlorides, preparation, 15, 45... 

N-Silylated peptide esters are acylated by the acid chloride of N-Cbo-glycine to N-acylated peptide bonds [11]. Likewise, acid chlorides, prepared by treatment of carboxylic acids with oxalyl chloride, react with HMDS 2 at 24°C in CH2CI2 to give Me3SiCl 14 and primary amides in 50-92% yield [12]. Free amino acids such as L-phenylalanine or /5-alanine are silylated by Me2SiCl2 48 in pyridine to 0,N-protected and activated cyclic intermediates, which are not isolated but reacted in situ with three equivalents of benzylamine to give, after 16 h and subsequent chro-... 

The stereospecific conversion of menthyl arenesulphinates into chiral aryl methyl sulphoxides may also be achieved by means of methyllithium . The reaction of methyllithium with diastereoisomerically or enantiomerically pure arenesulph-inamides 283 was found to give optically active aryl methyl sulphoxides 284 (equation 156). The preparation of optically active sulphoxides 285 and 286, which are chiral by virtue of isotopic substitution (H - D and - respectively), involves the reaction of the appropriate non-labelled menthyl sulphinates with fully deuteriated methyl magnesium iodide (equation 157) and with benzylmagnesium chloride prepared from benzyl chloride labelled with carbon (equation 158). 

---