Chemical toxic substances

It is an important pathway in the detoxification of a large variety of chemical toxic substances. Forming a mercapturate is normally a minor pathway like naphthalene... 

Contamination Introduction into water, air, and soil of microorganisms, chemicals, toxic substances, wastes, or wastewater in a concentration that makes the medium unfit for its next intended use. Also applies to surfaces of objects, buildings, and various household and agricultural use products. 

Apart from radioactive compounds the radioactive wastes may contain non-active but chemically toxic substances. The national standards and regulations describe the discharge limits for these substances, too. Heavy metals are toxic compounds, most often present in liquid radioactive wastes. The experiments showed that most of these metals are removed by UF/complexation method. The method is inefficient for removal of monovalent ions, bivalent cations and anions are retained in 25%-50%, but high retention of the metals like Mn, Fe, Co, Cu, Pb, Cr was observed. The retention factors for those metals in two-stage experiment described above, were as follows ... 

Remote detection and elemental analysis of hazardons materials, inclnding radioactive, high-temperature, and chemically toxic substances. 

The objective of this study was to analyze whether a release of this magnitude might cause long-range effects, on a scale of tens or hundreds of kilometers. The long-range consequences of major accidents should also be known when formulating international conventions on transboundary transport of chemically toxic substances. 

Toxic chemicals Toxic Substances Control Act (TSCA) 1976... 

Inhalation is the most frequently encountered route of exposure for both CW agents and toxic industrial chemicals. Toxic substances can enter the body through inhalation of gases, vapours, smoke, fumes, dusts, mists or fog. The properties of these were described in the previous chapter. Following inhalation, toxic substances can cause trauma at all levels of the respiratory tree and in the lung parenchyma before being absorbed into the circulation where further damage can occiu . 

There are three types of TAP emissions continuous, intermittent, and accidental. Both routine emissions associated with a batch process or a continuous process that is operated only occasionally can be intermittent sources. A dramatic example of an accidental emission was the release of methyl isocyanate [624-83-9] in Bhopal, India. As a result of this accident, the U.S. Congress created Tide III, a free-standing statute included in the Superfund Amendments and Reauthorization Act (SARA) of 1986. Title III provides a mechanism by which the pubHc can be informed of the existence, quantities, and releases of toxic substances, and requires the states to develop plans to respond to accidental releases of these substances. Eurther, it requires anyone releasing specific toxic chemicals above a certain threshold amount to aimuaHy submit a toxic chemical release form to EPA. At present, there are 308 specific chemicals subject to Title III regulation (37). 

Historically, the annual consumption of nickel fluoride was on the order of a few metric tons. Usage is droppiag because nickel fluoride is Hsted ia the EPA and TSCA s toxic substance iaventory. Nickel fluoride tetrahydrate is packaged ia 200—500-lb (90.7—227-kg) dmms and the 1993 price was 22/kg. Small quantities for research and pilot-plant work are available from Advance Research Chemicals, Aldrich Chemicals, Johnson/Matthey, Pfalt2 and Bauer, PCR, and Strem Chemicals of the United States, Fluorochem of the United Kingdom, and Morita of Japan. 

Toxic Substances Control Act, Public Law No. 469, 94th U.S. Congress Chemical Substance Inventory, U.S. Environmental Protection Agency, Office of Toxic Substances, Wasliiagton, D.C., 1975. 

In Delaware, the Regulation for the Management of Extremely Ha2ardous Substances Act, developed in response to the Bhopal disaster and several chemical-release incidents in Delaware, became effective in 1989 (27,28). The regulations Hst 88 toxic substances, 32 flammable substances, and 50 explosive substances. A sufficient quantity is specified for each of these materials, based on potential for a catastrophic event at a distance of 100 m from a potential source of a 1-h release. 

Information on health and safety considerations cited herein for Ryton PPS powders and pellets can be found in Reference 157. Ryton PPS [26125-40-6] is listed in the Toxic Substance Control Act (TSCA) Inventory of Chemicals. 

All the PMBs are Hsted on the U.S. EPA s Toxic Substances Control Act NonConfidential Chemical Substances Inventory (Table 8). In the early to mid-1980s, pseudocumene, mesitylene, hemimellitene, and trimethylbenzene were coveted by TSCA Section 8(a) Preliminary Assessment Information Rule (PAIR) reporting requirements (22) and by TSCA Section 8(d) for health and safety data (23). Mesitylene is the subject of a test rule subacute oral toxicity and subchtonic oral toxicity in tats were underway in 1994 (24). The Safe Drinking Water Act (SDWA) allows monitoring for pseudocumene and mesitylene at the discretion of the State (25). Of the PMBs, only pseudocumene is subject to SARA Tide III section 313 annual release reporting (26). 

Toxic Substances Control Act. EPA regulates the manufacture, use, and exposure to ha2ardous or toxic chemicals under a number of laws. Eor the chemical industry, the law of prime concern is the Toxic Substance Control Act (TSCA) (10), which was passed by the U.S. Congress in 1976. The two main goals of TSCA are acquisition of sufficient information to identify and evaluate potential ha2ards from chemical substances, and regulation of the production, use, distribution, and disposal of these substances. 

Toxic Substances Control Act, Chemical Substances Inventory further information can be obtained from Industry Assistance Office, Pesticides and Toxic Substances, Environmental Protection Agency, Washington, D.C. 

Styrene is Hsted in the U.S. Toxic Substance Control Act (TSCA) Inventory of Chemicals. It is not confirmed as a carcinogen but is considered a suspect carcinogen. The recommended exposure limits are OSHA PEL 50 ppm, ACGIH TLV 50 ppm. For higher concentrations,... 

Vinyl chloride is Hsted as "ethene, chloro-" on the Toxic Substances Control Act (TSCA) inventory and on the Canadian Domestic Substances List (DSL). It is Hsted as "chloroethylene" on the European Inventory of Existing Commercial Chemical Substances (EINECS), bearing the identification number 2008 310 (149). 

All four butanols are registered ia the United States on the Environmental Protection Agency Toxic Substances Control Act (TSCA) Inventory, a prerequisite for the manufacture or importation for commercial sale of any chemical substance or mixture ia quantities greater than a 1000 pounds (454 kg). Additionally, the manufacture and distribution of the butanols ia the United States are regulated under the Superfund Amendments and Reauthorization Act (SARA), Section 313, which requires that anyone handling at least 10,000 pounds (4545 kg) a year of a chemical substance report to both the EPA and the state any release of that substance to the environment. 

TSCA sec. 8(d) submission 878214937/ Summary of environmental data, Dow item 1594, The Dow Chemical Company, Office of Toxic Substances, U.S. EPA, Washington, D.C., 1985. 

The two most important pieces of chemical control legislation enacted affecting the dye and pigment industries are the United States Toxic Substance Control Act (TSCA) and EEC s Classification, Packaging, and Labeling of Dangerous Substances and its amendments. Table 2 is a comparison of TSCA and the 6th Amendment of the EEC classifications. 

The Toxic Substances Control Act (TSCA) was enacted in 1976 to identify and control toxic chemical ha2ards to human health and the environment. One of the main provisions of TSCA was to estabUsh and maintain an inventory of all chemicals in commerce in the United States for the purpose of regulating any of the chemicals that might pose an unreasonable risk to human health or the environment. An initial inventory of chemicals was estabhshed by requiring companies to report to the United States Environmental Protection Agency (USEPA) all substances that were imported, manufactured, processed, distributed, or disposed of in the United States. Over 50,000 chemical substances were reported. PoUowing this initial inventory, introduction of all new chemical substances requires a Premanufacturing Notification (PMN) process. To be included in the PMN are the identity of the new chemical, the estimated first year and maximum production volume, manufacture and process information, a description of proposed use, potential release to the environment, possible human exposure to the new substance, and any health or environmental test data available at the time of submission. In the 10 years that TSCA has been in effect, the USEPA has received over 10,000 PMNs and up to 10% of the submissions each year are for dyes (382)... 

J. Houk, M. J. Doa, M. Dezube, and J. M. Rovinski, "Evaluation of Dyes Submitted Under the Toxic Substance Control Act New Chemicals Programme," Colour Chemistry, Elsevier AppHed Science, London and New York, 1991. 

---