Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Cation ammonium cations

Simplest examples are prepared by the cyclic oligomerization of ethylene oxide. They act as complexing agents which solubilize alkali metal ions in non-polar solvents, complex alkaline earth cations, transition metal cations and ammonium cations, e.g. 12—crown —4 is specific for the lithium cation. Used in phase-transfer chemistry. ... [Pg.116]

Cyanide Iron Blues. Cyanide iron blue, also known as Pmssian blue, is one of the oldest industrially produced, inorganic pigments. Chemically, cyanide iron blues are based on the [Fe " Fe (CN) ] anion. The charge is balanced by sodium, potassium, or ammonium cations. Modem... [Pg.14]

Salt formation with Brmnsted and Lewis acids and exhaustive alkylation to form quaternary ammonium cations are part of the rich derivati2ation chemistry of these amines. Carbamates and thiocarbamates are formed with CO2 and CS2, respectively the former precipitate from neat amine as carbamate salts but are highly water soluble. [Pg.208]

The amino group behaves as a week base, giving salts with both mineral and organic acids. The aminophenols are tme ampholytes, with no 2witterion stmcture hence they exist either as neutral molecules (4), or as ammonium cations (5), or phenolate ions (6), depending on the pH value of the solution. [Pg.310]

The existence of half-salt complex cations formed by the association of an ammonium cation B", with a neutral molecule, B, has also been postulated. [Pg.310]

Demineralizers are often used to treat raw makeup water or condensate where high purity is required, such as in large central station boHers that operate at high steam pressures. Demineralizers employ a combination of cation and anion exchange to remove additional material, including sodium and ammonium cations. VirtuaHy aH salt anions, such as bicarbonate, sulfate, and chloride, are removed and replaced by hydroxide ions in the demineralizer. [Pg.7]

Miscellaneous Compounds. Among simple ionic salts cerium(III) acetate [17829-82-2] as commercially prepared, has lV2 H2O, has a moderate (- 100 g/L) aqueous solubiUty that decreases with increased temperature, and is an attractive precursor to the oxide. Cerous sulfate [13454-94-9] can be made in a wide range of hydrated forms and has solubiUty behavior comparable to that of the acetate. Many double sulfates having alkaU metal and/or ammonium cations, and varying degrees of aqueous solubiUty are known. Cerium(III) phosphate [13454-71 -2] being equivalent to mona2ite, is very stable. [Pg.368]

It resembles tetracyanoethylene in that it adds reagents such as hydrogen (31), sulfurous acid (31), and tetrahydrofuran (32) to the ends of the conjugated system of carbon atoms suffers displacement of one or two cyano groups by nucleophilic reagents such as amines (33) or sodiomalononittile (34) forms TT-complexes with aromatic compounds (35) and takes an electron from iodide ion, copper, or tertiary amines to form an anion radical (35,36). The anion radical has been isolated as salts of the formula (TCNQ) where is a metal or ammonium cation, and n = 1, 1.5, or 2. Some of these salts have... [Pg.404]

Not long thereafter, Tarnowski and Cram reported the first example of a hinged bis-crown ether. The compound was prepared in the usual Williamson reaction by heating a mixture of 2,2, 3,3 -tetrahydroxy-l, r-binaphthyl with pentaethylene glycol ditosylate and KOH in aqueous THF solution. The product (mp 159.5—161°) shown in Eq. (3.30) was obtained in 30% yield. This compound was shown to complex bis-ammonium cations of several varieties . [Pg.35]

The true, all-aromatic system (see 18, below) described by Kime and Norymberski is unusual in the sense that all of the ether linkages bridge aromatic carbons ". Synthesis of 18, therefore, required extensive use of copper mediated coupling reactions. As expected for such reactions, yields were generally low. The aromatics such as 18 were ineffective at binding either alkali metal or ammonium cations ". ... [Pg.44]

Although the clam structures are of interest as ammonium ion binders, they are by no means the only azacrown compounds of interest in this application. Sutherland and coworkers have examined a number of azacrowns as primary ammonium ion bind-ers - . In addition, Metcalfe and Stoddart have utilized bis-azacrowns to bind secondary ammonium cations. [Pg.160]

The proportion of hydrochloric acid in the mobile phase was not to exceed 20%, so that complex formation did not occur and zone structure was not adversely affected. An excess of accompanying alkaline earth metal ions did not interfere with the separation but alkali metal cations did. The hthium cation fluoresced blue and lay at the same height as the magnesium cation, ammonium ions interfered with the calcium zone. [Pg.312]

In supported liquid membranes, a chiral liquid is immobilized in the pores of a membrane by capillary and interfacial tension forces. The immobilized film can keep apart two miscible liquids that do not wet the porous membrane. Vaidya et al. [10] reported the effects of membrane type (structure and wettability) on the stability of solvents in the pores of the membrane. Examples of chiral separation by a supported liquid membrane are extraction of chiral ammonium cations by a supported (micro-porous polypropylene film) membrane [11] and the enantiomeric separation of propranolol (2) and bupranolol (3) by a nitrate membrane with a A/ -hexadecyl-L-hydroxy proline carrier [12]. [Pg.130]

In the case of ions, the repulsive interaction can be altered to an attractive interaction if an ion of opposite charge is simultaneously adsorbed. In a solution containing inhibitive anions and cations the adsorption of both ions may be enhanced and the inhibitive efficiency greatly increased compared to solutions of the individual ions. Thus, synergistic inhibitive effects occur in such mixtures of anionic and cationic inhibitors . These synergistic effects are particularly well defined in solutions containing halide ions, I. Br , Cl", with other inhibitors such as quaternary ammonium cations , alkyl benzene pyridinium cations , and various types of amines . It seems likely that co-ordinate-bond interactions also play some part in these synergistic effects, particularly in the interaction of the halide ions with the metal surfaces and with some amines . [Pg.809]

Fe-HS )jds has been postulated to lead to easier anodic dissolution than that through (Fe-014)3 5. This effect of hydrogen sulphide is thought to be responsible for the acceleration of corrosion of iron observed with some inhibitive sulphur compounds, e.g. thioureas , at low concentrations, since hydrogen sulphide has been identified as a reduction product. However, the effects of hydrogen sulphide are complex, since in the presence of inhibitors such as amines , quaternary ammonium cations , thioureas ", ... [Pg.811]

The chloride ion is the most frequent cause of contact corrosion, since chlorine is present in the many chlorinated plastics, and is also frequently retained in residual amounts from reactive intermediates used in manufacture. Thus epoxides usually contain chloride derived from the epichlor-hydin used as the precursor of the epoxide. In addition to the contaminants referred to in Table 18.18, various metal and ammonium cations, inorganic anions and long-chain fatty acids (present as stabilisers, release agents or derived from plasticisers) may corrode metals on contact. [Pg.955]

At pH 7, [13]aneN3 or [12]-[15]aneN4 accommodate only two nitrogen-bound protons and these dipositive ammonium cations are apparently unable to provide sufficient electrostatic attraction to polycarboxylate anions for ion-pair formation. In contrast, the macrocyclic spermines, pentaamines and hexaamines accommodate more than three nitrogen-bound protons at pH 7 and for these ligands 1 1 associations... [Pg.122]

We saw in Sections 20.3 and 24.5 that a carboxyl group is deprotonated and exists as the carboxylate anion at a physiological pH of 7.3, while an amino group is protonated and exists as the ammonium cation. Thus, amino acids exist in aqueous solution primarily in the form of a dipolar ion, or zwitterion (German zwitter, meaning "hybrid"). [Pg.1017]

Amino acid zwitterions are internal salts and therefore have many of the physical properties associated with salts. They have large dipole moments, are soluble in water but insoluble in hydrocarbons, and are crystalline substances with relatively high melting points. In addition, amino acids are amphiprotic they can react either as acids or as bases, depending on the circumstances. In aqueous acid solution, an amino acid zwitterion is a base that accepts a proton to yield a cation in aqueous base solution, the zwitterion is an add that loses a proton to form an anion. Note that it is the carboxylate, -C02-, that acts as the basic site and accepts a proton in acid solution, and it is the ammonium cation, -NH3+, that acts as the acidic site and donates a proton in base solution. [Pg.1017]

According to investigations performed by Pakhomov and Kaidalova [204], the crystal structure of NF NbC consists of infinite chains made up of distorted octahedral ions (NbOF4 ) linked by oxygen atoms. Ammonium cations, NH/, occupy the spaces between the chains, as shown in Fig. 30. The packing of the structural units in the NH4NbOF4 crystal can be described as a CsCl type structure in which CF ions are replaced by Nb02F4 complexes and Cs" ions are replaced by ammonium ions. [Pg.86]

The conductivity of a number of bromine containing complexes with different quaternary ammonium cations was studied by Gerold (see Ref. 156]) with respect to the dependence on temperature and bromine... [Pg.184]

In the context of Scheme 11-1 we are also interested to know whether the variation of K observed with 18-, 21-, and 24-membered crown ethers is due to changes in the complexation rate (k ), the decomplexation rate (k- ), or both. Krane and Skjetne (1980) carried out dynamic 13C NMR studies of complexes of the 4-toluenediazo-nium ion with 18-crown-6, 21-crown-7, and 24-crown-8 in dichlorofluoromethane. They determined the decomplexation rate (k- ) and the free energy of activation for decomplexation (AG i). From the values of k i obtained by Krane and Skjetne and the equilibrium constants K of Nakazumi et al. (1983), k can be calculated. The results show that the complexation rate (kx) does not change much with the size of the macrocycle, that it is most likely diffusion-controlled, and that the large equilibrium constant K of 21-crown-7 is due to the decomplexation rate constant k i being lower than those for the 18- and 24-membered crown ethers. Izatt et al. (1991) published a comprehensive review of K, k, and k data for crown ethers and related hosts with metal cations, ammonium ions, diazonium ions, and related guest compounds. [Pg.299]

The ammonium cation of an ammonium salt may be oxidized by an anion that has oxidizing character, such as a nitrate. The products depend on the temperature of the reaction ... [Pg.746]


See other pages where Cation ammonium cations is mentioned: [Pg.292]    [Pg.292]    [Pg.30]    [Pg.2777]    [Pg.2784]    [Pg.19]    [Pg.185]    [Pg.450]    [Pg.62]    [Pg.62]    [Pg.449]    [Pg.452]    [Pg.19]    [Pg.339]    [Pg.317]    [Pg.326]    [Pg.196]    [Pg.314]    [Pg.515]    [Pg.19]    [Pg.63]    [Pg.15]    [Pg.130]    [Pg.107]    [Pg.188]    [Pg.4]    [Pg.62]   
See also in sourсe #XX -- [ Pg.71 ]




SEARCH



Acrylamide ammonium cationic monomers

Alkyl ammonium cations

Ammonium cation acidity

Ammonium cation complexes

Ammonium cation formal charge

Ammonium cation, tetraalkylelectroreduction

Ammonium cation, tetraalkylelectroreduction mediator

Ammonium cations

Ammonium cations intercalation

Ammonium cations, binding

Ammonium cations, dithiolene electrical

Ammonium radical cations, alkylalkane oxidation

Ammonium-centered cationic

Binding of Ammonium Cations by Three Dimensional Hosts

Cation chromatography Quaternary ammonium ions

Cation fixation ammonium

Cation, lipid soluble quaternary ammonium

Cationic ammonium surfactants

Cationic monomers, quaternary ammonium

Cationic monomers, quaternary ammonium polymerization with acrylamide

Cationic surfactants ammonium compounds

Cationic surfactants quaternary alkyl ammonium

Fifth group of cations magnesium, sodium, potassium, and ammonium

Ionic ammonium cation

Lariat ethers ammonium cation binding

Molybdenum ammonium cation)

Organic ammonium cation exchange, clay

Organic ammonium cation exchange, clay minerals

Organoclays quaternary ammonium cations

Oxidative quaternary ammonium cations

Polymerization quaternary ammonium cationic monomers

Quarternary ammonium cation

Quaternary ammonium cationic starch

Quaternary ammonium cations

Quaternary ammonium cations room-temperature ionic liquids

Quaternary ammonium salts cationic surfactants

Quaternary ammonium salts with weakly basic cationics

Quaternary ammonium-based cationic

Quaternary ammonium-based cationic fluorinated

Quaternary ammonium-based cationic surfactants

Smectites quaternary ammonium cations

Substituted ammonium cations

Surfactant quaternary ammonium cation

© 2024 chempedia.info