Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Lithium cation

Simplest examples are prepared by the cyclic oligomerization of ethylene oxide. They act as complexing agents which solubilize alkali metal ions in non-polar solvents, complex alkaline earth cations, transition metal cations and ammonium cations, e.g. 12—crown —4 is specific for the lithium cation. Used in phase-transfer chemistry. ... [Pg.116]

A related but distinct rhodium-catalyzed methyl acetate carbonylation to acetic anhydride (134) was commercialized by Eastman in 1983. Anhydrous conditions necessary to the Eastman acetic anhydride process require important modifications (24) to the process, including introduction of hydrogen to maintain the active [Rhl2(CO)2] catalyst and addition of lithium cation to activate the alkyl methyl group of methyl acetate toward nucleophilic attack by iodide. [Pg.180]

The method described here gives higher yields of the macrocyclic tetraethers and allows the product from furan and cyclohexanone to be formed directly in 5-10% yield, whereas this product was previously obtained only by an indirect route. The added lithium perchlorate undoubtedly accelerates the reaction, since after short reaction times the product was isolated in 20% yield when the salt was present and in only 5% yield when the salt was absent. The lithium cation is presumably acting as a template which coordinates with the oxygen atoms of... [Pg.77]

Desvergne and Bouas-Laurent have shown that photochemical ring closure of a bis-anthracene bridged by a polyether chain is effective only when lithium cation is present . They presume that cyclization is successful because the conformation is cation locked . The reaction is shown in Eq. (2.6). [Pg.16]

MonofluoToalkanes and vicinal difluoroalkanes are dehydrofluonnated if strong enough bases are applied [10 12] In 5-fluorononane and fluorocyclodo-decane, elimination by means of sodium methoxide in methanol gives cis- and trans allcenes in respective yields of 8 and 21% and in ratios of 1 2 2 2 4, however, the bulky lithium diisopropyl amide m tetrahydrofuran produces trdns-isomers almost exclusively The strength of the base does not have much effect on the rate of elimination, but the lithium cation causes considerable acceleration [10] (equation 10)... [Pg.890]

Alkyl halide Lithium Anion radical Lithium cation... [Pg.590]

The dilithium triimidochalcogenites [Ei2 E(N Bu)3 ]2 form dimeric structures in which two pyramidal [E(N Bu)3] dianions are bridged by four lithium cations to form distorted, hexagonal prisms of the type 10.13. A fascinating feature of these cluster systems is the formation of intensely coloured [deep blue (E = S) or green (E = Se)] solutions upon contact with air. The EPR spectra of these solutions (Section 3.4), indicate that one-electron oxidation of 10.13a or 10.13b is accompanied by removal of one Ei" ion from the cluster to give neutral radicals in which the dianion [E(N Bu)3] and the radical monoanion [E(N Bu)3] are bridged by three ions. ... [Pg.195]

The mechanism of the asymmetric alkylation of chiral oxazolines is believed to occur through initial metalation of the oxazoline to afford a rapidly interconverting mixture of 12 and 13 with the methoxy group forming a chelate with the lithium cation." Alkylation of the lithiooxazoline occurs on the less hindered face of the oxazoline 13 (opposite the bulky phenyl substituent) to provide 14 the alkylation may proceed via complexation of the halide to the lithium cation. The fact that decreased enantioselectivity is observed with chiral oxazoline derivatives bearing substituents smaller than the phenyl group of 3 is consistent with this hypothesis. Intermediate 13 is believed to react faster than 12 because the approach of the electrophile is impeded by the alkyl group in 12. [Pg.238]

According to the above classification, the structures of LiNb(Ta)F6 and Li2Nb(Ta)OF5 should be composed of lithium cations and isolated octahedral complex ions, Nb(Ta)F6 or Nb(Ta)OF52, respectively. It is known, however, that the structure of these compounds consists only of octahedrons linked via their vertexes in the first case, and via their sides in the second case. The same behavior is observed in compounds containing bi- and trivalent metals. [Pg.118]

During electrochemical reduction (charge) of the carbon host, lithium cations from the electrolyte penetrate into the carbon and form a lithiated carbon Li rCn. The corresponding negative charges are accepted by the carbon host lattice. As for any other electrochemical insertion process, the prerequisite for the formation of lithiated carbons is a host material that exhibits mixed (electronic and ionic) conductance. [Pg.386]

In general, lithium-ion batteries are assembled in the discharged state. That is, the cathode, for example LqCoC, is filly intercalated by lithium, while the anode (carbon) is completely empty (not charged by lithium). In the first charge the anode is polarized in the negative direction (electrons are inserted into the carbon) and lithium cations leave the cathode, enter the solution, and are inserted into the carbon anode. This first charge process is very complex. On the basis of many reports it is presented schematically [6, 74, 76] in Fig. 5. The reactions presented in Fig. 5 are also discussed in Sec. 6.2.1, 6.2.2 and 6.3.5. [Pg.432]

Using dilatometry in parallel with cyclic voltammetry (CV) measurements in lmolL 1 LiC104 EC-l,2-dimethoxy-ethane (DME), Besenhard et al. [87] found that over the voltage range of about 0.8-0.3 V (vs. Li/Li+), the HOPG crystal expands by up to 150 percent. Some of this expansion seems to be reversible, as up to 50 percent contraction due to partial deintercalation of solvated lithium cations was observed on the return step of the CV. It was concluded [87] that film formation occurs via chemical reduction of a solvated graphite intercalation compound (GIC) and that the permselective film (SEI) in fact penetrates into the bulk of the HOPG. It is important to repeat the tests conducted by Besenhard et al. [87] in other EC-based electrolytes in order to determine the severity of this phenomenon. [Pg.435]

The smaller ion may intercalate faster into the graphite galleries. Reaction (5) may be the rate-determining step for the solvent co-intercalation process, and if so, molecules that form large and stable solvated lithium cations will have a smaller tendency for co-intercalation into the graphite. [Pg.435]

Room-temperature molten salts are a relatively new subgroup of liquid nonaqueous electrolytes. They share their advantages and disadvantages. Unfortunately, until now, no useful room-temperature molten salt based on lithium cations has been available. [Pg.457]

As far as investigated77, most reactions of the allyllithium-sparteine complexes with electrophiles proceed antarafacially, either as SE2 or anti-SE2 reactions. As a working hypothesis it is assumed that the bulky ligand obliterates the Lewis acid properties of the lithium cation. [Pg.239]

The stereochemistry of the carboxylation of 4-substituted ( + )-(/ S)-fra ,v-1-(4-mcthylphcnyl-sulfinylmethyl)cyclohexane after metalation with methyllithium and quenching with carbon dioxide was reported64. The results listed in Table 1 show that the d.r. of around 75 25 under kinetic control changes to 25 75 under thermodynamic control. This is the result of the equilibration of the two diastereomeric metalated species. As shown by the experiment in hexamethylphosphoric Iriamide (IIMI A) (d.r. = 57 43 under kinetic control) an electrophilic assistance of the lithium cation to the electrophilic approach is probably involved. [Pg.646]

The presence of a large excess of lithium salt decreases the stereoselectivity when the reaction is performed under kinetic control. These results and those reported for deuteration (see Section D. 1.1.1.5.) show that this effect is only observed when electrophilic assistance of the lithium cation is involved. [Pg.647]

In these reactions (Table 3, entries 1 - 6) the diastereoselectivity increases with increasing size of the alkoxy substituent. The results can be explained by postulating a six-membered chelate 6 involving a N-atom (or perhaps both N-atoms), the lithium cation and the acetal oxygen which is the farthest away from the alkoxy substituent. Attack of the nucleophile takes place from the less hindered side4. [Pg.713]

Solladie and coworkers545 confirmed the earlier result of Nishihata and Nishio546 that the carbonation of the a-sulphinyl carbanion proceeds under kinetic control with retention of configuration at the metallated carbon atom. However, they also found that the stereochemical outcome of this reaction depends on other factors. They observed that 90% of asymmetric induction may be achieved under kinetic control (reaction time < 0.5 min) by using a base with low content of lithium salts, a result consistent with an electrophilic assistance by the lithium cation (equation 286)545. [Pg.339]

A similar reasoning may explain the difference in reactivities of the lithium and sodium ion-pairs in THF. The larger ionic radius of the sodium than that of the lithium cation, favoring the formation of loose pairs, makes the sodium pair much more reactive than the lithium salt at lower temperatures. However, at higher temperatures the sodium salt becomes less reactive than the lithium salt as it looses its solvation more readily than the latter. [Pg.116]

Initially the LP-DE effect was ascribed to the high internal pressure generated by the solubilization of the salt in diethyl ether [34]. Today the acceleration is explained in terms of Lewis-acid catalysis by the lithium cation [35]. The contribution of both factors (internal pressure and lithium cation catalysis) has also been invoked [36]. [Pg.268]

LP-DE has a weaker catalytic activity than BF3-Et20, AICI3 and TiCU because the Lewis acidity of the lithium cation is moderated by complex-ing with diethyl ether and perchlorate anion [37], but it becomes a highly oxophilic Lewis acid when concentrated solutions are used [38]. The concentration of LP-DE is therefore sometimes essential for the success of the reaction. [Pg.268]

The proportion of hydrochloric acid in the mobile phase was not to exceed 20%, so that complex formation did not occur and zone structure was not adversely affected. An excess of accompanying alkaline earth metal ions did not interfere with the separation but alkali metal cations did. The lithium cation fluoresced blue and lay at the same height as the magnesium cation, ammonium ions interfered with the calcium zone. [Pg.165]


See other pages where Lithium cation is mentioned: [Pg.10]    [Pg.590]    [Pg.47]    [Pg.416]    [Pg.436]    [Pg.15]    [Pg.76]    [Pg.30]    [Pg.619]    [Pg.49]    [Pg.33]    [Pg.63]    [Pg.235]    [Pg.325]    [Pg.276]    [Pg.939]    [Pg.107]    [Pg.138]    [Pg.250]    [Pg.237]    [Pg.489]    [Pg.152]    [Pg.139]    [Pg.1358]   
See also in sourсe #XX -- [ Pg.144 ]

See also in sourсe #XX -- [ Pg.144 ]

See also in sourсe #XX -- [ Pg.429 ]

See also in sourсe #XX -- [ Pg.161 , Pg.235 , Pg.440 ]




SEARCH



© 2024 chempedia.info