Quaternary ammonium cationic monomers polymerization with acrylamide

The Polymerization of Quaternary Ammonium Cationic Monomers with Acrylamide... 

Very frequently non-optimal setpoint trajectories are used for controlling reactor temperatures in batch reactors [25,39,179,180]. Reactor temperatures maybe allowed to increase from ambient temperatures up to a maximum temperature value, in order to use the heat released by reaction to heat the reaction medium and save energy (reduce energy costs). The temperature increase is almost always performed linearly, because of hardware limitations and simplicity of controller programming. After reaching the maximum allowed temperature value, reactor temperature is kept constant for a certain time interval, for production of polymer material at isothermal conditions. At the end of the batch, the reaction temperature is increased in order to reduce the residual monomer content of the final resin, usually with the help of a second catalyst. Heuristic optimum temperature trajectories were also formulated for batch polymerizations of acrylamide and quaternary ammonium cationic monomers, in order to use the available heat of reaction [181]. The batch time was split into two batch periods an isothermal reaction period and an adiabatic reaction period. 

Kurokawa et al. [258-260] developed a novel but somewhat complex procedure for the preparation of PP/clay nanocomposites and studied some factors controlling mechanical properties of PP/clay mineral nanocomposites. This method consisted of the following three steps (1) a small amount of polymerizing polar monomer, diacetone acrylamide, was intercalated between clay mineral [hydrophobic hectorite (HC) and hydrophobic MMT clay] layers, surface of which was ion exchanged with quaternary ammonium cations, and then polymerized to expand the interlayer distance (2) polar maleic acid-grafted PP (m-PP), in addition was intercalated into the interlayer space to make a composite (master batch, MB) (3) the prepared MB was finally mixed with a conventional PP by melt twin-screw extrusion at 180°C and at a mixing rate of 160 rpm to prepare nanocomposite. Authors observed that the properties of the nanocomposite strongly dependent on the stiffness of clay mineral layer. Similar improvement of mechanical properties of the PP/clay/m-PP nanocomposites was observed by other researchers [50,261]. 

Cationic polymers include homopolymers and cationic copolymers obtained by the polymerization of a vinylic monomer with a quaternary ammonium group or a quatemized amine with another soluble monomer in water such as acrylamide and methacrylamide. The most frequently used polymers are those derived from gum guar such as guar hydroxyl propyl triamonium chloride. They are sold under the trade names Jaguar C13S, C17, etc. [12-16]. 

---