Aromatic aliphatic index

Properties Gardner 1 hard solid sol. in aromatic, aliphatic, and chlorinated hydrocarbons, ketones, pyridine, carbon bisulfide, ethyl and butyl acetates, and turpentine insol. in water dens. 1.06 kg/l soften, pt. (R B) 75 C acid no. < 1 sapon. no. < 2 flash pt. (COC) 260 C ref. index 1.60 Piccolastic D125 [Eastman]... 

The properties of the lube oil that are set by the extraetion process are the viscosity index (VI), oxidation stability and thermal stability. These properties are related to aromatics, aliphatic sulfur, total sulfur and nitrogen levels present in the base stock. 

Properties Cl., si. yel. to brown liq. sol. in ethanol, aromatic, aliphatic and haloge-nated soivs. insol. in water, paraffin oil dens. = 1000 kg/m vise. = 1100 mPa-s flash pt. > 100 C ref. index 1.4365 Storage 1 yr. when stored in original, closed containers 1-30 C Struktol Calcium Stearate [Struktol]... 

Kovats, E. and A. Wehrli (1959), Gas-chromatography characterization of organic compounds. III. Calculation of the retention indexes of aliphatic, alicyclic and aromatic compounds . Helv. Chim. Acta, Vol. 42, p. 2709. 

Polythiosemicarbazide disulfide is the most efficient aliphatic polyamine disulfide for inhibiting the thermal oxidative breakdown of polypropylene, while polyimi-noaniline disulfide and polydiiminodiphenyloxide disulfide (Fig. 3) are the most efficient aromatic polyamine disulfides. In contrast to polyethylene, the thermal oxidative breakdown period increases as the concentration increases (Fig. 4), Depending on the concentration, the flow-melt index at 230°C increases at a lower rate than in the case of commercial stabilizer Santanox (Table 2)-... 

One can read letters through the porous PVA-PVAc film in benzene, but one cannot do so in cyclohexane nor in the case of the blank. This is supported by the fact that the refractive indices of benzene are close to that of PVA, but the refractive index of cyclohexane is far from that of PVA. When the porous film was dipped in a mixed solvent of benzene and cyclohexane (8.0 2.0 in weight), it became semi-transparent. To make this point clearer, the refractive index and the dispersive power of polymers and organic solvents were measured. The results are shown in Table 3, which shows that the refractive index of PVA is near that of benzene and that the dispersion power of aliphatic compounds is lower than that of aromatic compounds. 

Another variation of the preceding method is to apply HPLC to fractionate the cleaned-up aliphatic-aromatic fraction from flash colurim separation of soluble organic matter as it is performed in the Chevron laboratory, for example, as described in Reference 2. A Waters HPLC system equipped with a preparative Whatman Partisil 10 silica column (9.4 X 500 mm), a HPLC pump, and two detectors for separation monitoring (a UV and refractive index detector) are used, giving three fractions of aliphatic hydrocarbons, mono-, di-, and triaromatics and polar compounds. The hrst two fractions are eluted with hexane, whereas polar compounds are eluted with... 

Ethers are unaffected by sodium and by acetyl (or benzoyl) chloride. Both the purely aliphatic ethers e.g., di-n-butyl ether (C4H, )30 and the mixed aliphatic - aromatic ethers (e.g., anisole C3HSOCH3) are encountered in Solubility Group V the purely aromatic ethers e.g., diphenyl ether (C,Hj)20 are generally insoluble in concentrated sulphuric acid and are found in Solubility Group VI. The purely aliphatic ethers are very inert and their final identification may, of necessity, depend upon their physical properties (b.p., density and/or refractive index). Ethers do, however, suffer fission when heated with excess of 67 per cent, hydriodic acid, but the reaction is generally only of value for the characterisation of symmetrical ethers (R = R ) ... 

The behavior of the different amines depends on at least four factors basicity, nucleophilicity, steric hindrance and solvation. In the literature (16), 126 aliphatic and aromatic amines have been classified by a statistical analysis of the data for the following parameters molar mass (mm), refractive index (nD), density (d), boiling point (bp), molar volume, and pKa. On such a premise, a Cartesian co-ordinate graph places the amines in four quadrants (16). In our preliminary tests, amines representative of each quadrant have been investigated, and chosen by consideration of their toxicity, commercial availability and price (Table 1). 

An appendix systematically lists references to reactions of dialkylalkoxy-malonates with amines, including not only the common aliphatic and aromatic amines, but also a very wide variety of heterocyclic amines classified according to ring system. The appendix also provides systematic references to the different ring systems obtained by ring closure of the dialkylaminomethylenemalonates. The appendix should be used in conjunction with the subject index a separate subject index is provided for this monograph volume. 

This group has examples of many types of acids derived from aliphatic, aromatic and heterocyclic radicals, with carboxylic, phenolic or sulfonic or related functional substituents. Individually indexed acids are ... 

Figure 8.3 Relation of solubility parameters (solpars or Hildebrand values) to index of refraction and density, where A = density of aliphatic hydrocarbons B = index of refraction of aliphatic hydrocarbons C = index of refraction of aromatic hydrocarbons D = density of aromatic hydrocarbons.

These ABA copolymers have an index of refraction of 1.5 and water absorption of about 0.2%. Unless hydrogenated to saturated block copolymers, these unsaturated unstabilized plastics are degraded in sunlight. The polybutadiene domains are attacked by aliphatic hydrocarbon solvents, such as hexane, and the polystyrene domains arc attacked by aromatic hydrocarbon... 

Clearly, Greek or Latin numeral roots in conjunction with numerical locants can be used to indicate the number and positions of fluorine substituents in any type of organo-fluorine compound or group, ranging from monofluorinated systems, e.g. 2-fluorobutane (1), to perfluorinated entities, e.g. l,l,l,2.2,3,4,4,4-nonafluoro-3-iodobutane(2). Fluorine locants may be omitted, and often are in non-indexing situations when naming simple and therefore easily visualized fully fluorinated aliphatic/cycloaliphatic or monocyclic aromatic compounds or groups, e.g. octafluoropropane (3), hexafluorocyclopropane (4), pentafluoropropanoic acid, (5). pentafluorophenyl (6). 

Because methylene-interrupted polyunsaturates do not have strongly absorbing chromo-phores in the UV region, detection by refractive index or far-UV detection (205-214 nm) has been utilized in RP-HPLC separations of free fatty acids and their aliphatic esters. Refractive index detection is less sensitive than UV detection. However, with far-UV detection, solvents absorbing UV below 210 cannot be used. The RP-HPLC separations reported to date have generally involved derivatization designed to incorporate aromatic chromophores allowing detection by fluorescence or UV detection. 

The ring index [(R-l)/C] is the total number of aromatic and aliphatic rings per carbon for a polymeric material it is equal to R/C and can be derived from the equation 2 R/C = 2-... 

Rodds s Chemistry of Carbon Compounds, 2nd ed., ed. S. Coffey, 1964-1989. Supplementary volumes, ed. M. F. Ansell, 1973-1990 2nd supplement, ed. M. Sainsbury, Elsevier, 1991-2002. A monograph covering the whole of organic chemistry in five volumes plus supplements Vol. I, aliphatic compounds II, alicyclic compounds III, aromatic compounds IV, heterocyclic compounds and V, indexes and miscellaneous update volumes (e.g., Electrochemistry, 2002). A good source for getting a rapid overview of an unfamiliar class of compounds, for example, but now showing its age. There is a cumulative index to the whole second edition and supplements. It is available online at ScienceDirect.com. It is not known if a new edition is planned. 

---